Having problems with your GE GLD6700NBB / GLD6700NWW / GLD6700NCC Dishwasher ?
Dishwasher does not fill with water. The valve is open and door securely latched. What might be causing this problem?
Repair Help & Product Troubleshooting for GE GLD6700NBB / GLD6700NWW / GLD6700NCC Dishwasher
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Dishwasher does not fill with water. The valve is open and door securely latched. What might be causing this problem?
... GE GLD6700NBB / GLD6700NWW / GLD6700NCC Dishwasher
Have a Bosch shy56a05uc dishwasher that suddenly stopped working to a point. I believe it is related to the door latch switch, because I don't feel the door securely latch shut when I close it, and I also don't get any cycle lights or times registered on the LED readout. If I depress the on switch, the drain pump will start even with the door open, and, depending on how long I leave the switch on, water will start to fill in the dishwasher, open or not.
Does your dishwasher electronic control or mechanical timer? if mechanical timer, I encounter a similar problem n change the mechanical timer. that problem solved.\015\012\015\012Prince P ... Dishwashers
No Heat Had the blinking clean light problem, reset, and it fills and runs, but element not heating. Element reads 10.6 ohms, both door switches seem to be making. What else might be causing it not to heat? Is it possible to find a wiring diagram or schematic?
Should be a tech sheet stuck to inside of the bottom toe panel.Switches may check OK with no load applied. There is also an over temperature thermostat that may be open. If all checks OK, control may have failed. ... Whirlpool 24 in. DU1100XTPS Built-in Dishwasher
Whirlpool dishwasher part #3385181. Machine had gone thru wash cycle and was starting to dry. Smelled electrical burning smell, opened washer door and washer was filled with smoke. Turned everything off, cleared smoke, and the washer water dispenser is very hard to turn. Washer has symptoms of burnt up motor that turns water dispenser. Machine is 12 years old. With cost of replacement motor and possible part (pump?) that might have clogged and caused motor freeze up, is it worth fixing or junk
The opening latch on the amana sofsound II dishwasher came loose. To avoid a service call, I would like to disconnect the door and haul the door to the repair shop. How do I disconnect the door? This same problem has happend before and I tried to replace the opening latch myself but I ended up having to have a guy come out and fix it.
... Amana 24 in. ADB2200AW Built-In Dishwasher
Item: Whirlpool Ultra Dishwasher Age: 3 yrs Problem: Not enough water to effectively wash the dishes. State: When the dishwasher is started, the fill valve opens as normal. Only about 1/2 the amount of water is let in when the pump turns on and the washing cycle begins. Opening the door shows that the water level does not reach the bottom of the float. When I close the door, the wash cycle begins again but stops after a few seconds. This is when the water begins to fill again. This time, the wat
Larry,The float is generally for overflow conditions and will interrupt power to the fill valve solenoid. If you are not filling completely in the time allowed by the timer, it is most likely a flow restriction in the water ... Whirlpool GU2400XTP Built-in Dishwasher
KitchenAid Dishwasher KUDP01FL: Called repairman to replace balance link kit. Then door extremely stiff to open & heard loud pop when one of the ropes came off the roller. Repairman came back & put rope back on & replaced door seal, then the door won't close & he claims need a new door latch. When he left, door again extremely stiff to open & heard same loud pop when one of the ropes came off the roller. Now he says he can't fix it and to call someone else. I now have three problems: (1) The doo
May have bent door hinges,, need to check all alignment of door, hinges and latches... ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher
Kenmore Elite 13133K started to fill, the door was opened. Now it won't resume, drain or fill, the geen light is flashing. I turned the power supply off for 5 minutes and the problem still exists.
My GE dishwasher's door is stuck shut ~ I'm assuming a broken latch. I was told to fix the latch, the dishwasher has to be taken out from under the counter top (in order to get the door open). My problem is: with the dishwasher door stuck shut, it's impossible to unscrew the dishwasher from the countertop... Any helpful hints? Pleeeeeeeease (all of my silverware is stuck INSIDE the locked dishwasher - LOL!)
Well I'll try to help you get this opened. I don't know how much space you have at the top side edge of the dishwasher. You need a long stiff rod like a metal clothes hanger straightened so it can reach from the side to a little past the dishwasher m ... GE Profile PDW9880NSS Stainless Steel Dishwasher
Whirlpool DU927QWDG1 Hi, The problem I'm having with my dishwasher pertains to the door cover for the area I place the soap. There is a small spring which helps the door pop open to release the soap when washing. I cant figure out how to place the spring so that the pops open.....right now when I run the unit the door stays latched and the soap doesn't get dispensed. Any ideas on how to repair this or where I could maybe get a parts manual??? Your expertise will be greatly appreciated!!!!
... Whirlpool GU2400XTP Built-in Dishwasher
I have the Fridgeadair Dishwasher FDB1502RGS model. It worked fine for several months but now it does not clean or rinse the dishes properly. It does not get hot any more. It used to be that when you open the door after washing is done it was hot and steam would come out. Now it is cold when you open the door. Please advise what the problem might be.
... Frigidaire FDB1502RGS Built-in Dishwasher
WE HAVE A 3 YEAR OLD BOSCH DISHWASHER WHICH NOW HAS PRESENTED US WITH A PROBLEM. DURING A WASH CYCLE IT APPEARED TO MAKE SLIGHT NOISE WHEN WE DECIDED TO INTRRUPT THE CYCLE BY OPENING THE DOOR AND CHECK THE CAUSE OF THE PROBLEM. WE NOTICED THE WATER IN THE APPLIANCE HAD NOT DRAINED. WE PROCEEDED TO CHECK THE FILTER WHICH SEEM TO BE FREE OF ANY REMANANTS OF FOOD AND ANY OBJECTS. THEN WE FOLLOWED WITH THE CHECK ON THE PUMP FOR SAME AND FOUND NOTHING THAT WOULD CAUSE A BLOCKAGE. WE DECIDED TO R
... Bosch Dishwashers
Maytag Model MDB7160AWW S/N 10337613WQ Symptons: Fills with water OK, shuts off water OK, does not start any cycle, or drain. After a power off/power on reset, problem remains. Flashes CLEAN & LIGHT WASH. My understanding is this is an error condition for low motor current, which makes sense as the motor never starts. I know both door switches are good (I checked them with a DVM) and both engage when the door is closed. Tripping the water float switch opens the valve and water fills the tub
We lost electricity very briefly today which caused the dishwasher, washing, drying, clean buttons to blink when the electricity came back on. I opened the door to do a load of dishes hours after the electricity came back on and the basin was filled with water which caused water to spill out of the dishwasher. The basin was empty last night when we used it. It seemed to fill up when it was not running.
It seems unit fill valve is stuck open and water is coming in even when machine is off.fill valve opens up only when u start the unit.2 chks this u can open the door and look at the hole inside from where water comes in.if water is coming in with do ... Frigidaire 24 in. PLD2850 Built-in Dishwasher
I have a Maytag DWU8250BAX and the thing leaks like crazy. I just replaced the door gasket, but that is not the problem. When I took a closer look at the door it seems as though the water is getting up and into the door through a space in the bottom of the door. It seems to me like there should be another door seal to fill a gap that sits between the door hinges. If anyone knows if there should be a seal here and then what the part number might be that would be great. Thanks!
There is an airgap under the door..it should spray up and run down the door not spray up under it..look for crack or hole in spray arm..if there is the wrong soap in it it will flood out with lots of bubbles..just have to flush it out. lastly, if you ... Dishwashers
Quit working during wash cycle, about 6 liters of water left in bottom, looks like it quit during rinse cycle. There is power to the door switch and door switch works shutting off power when door is opened. However the control panel does not respond to any push button. I have had a problem in the past with moisture from the door vent getting into the control panel area causing the push buttons to become eratic.
The capacitors in the control panel could be bad or have burnt out. Do check all connnections and if necessary, check the continuity of the power to and from the control panel with an ohm/voltmeter. ... Dishwashers
I've had an LG LDF6810ST dishwasher for about three years with no problems. All of a sudden it won't close. It finished the wash, I emptied it, and when I went to close the door it wouldn't close all the way. It was as if something was getting caught not allowing the door to close completely. I searched and found nothing blocking, then I looked at the door latch and it looks as if the child lock feature is engaged. So the door is locked while open. I turned the child lock on and off through the
If all else fails.... kick it! at least you will feel better! ... LG LDF6810ST Stainless Steel Built-in Dishwasher
Kenmore dishwasher. The upper rack is not getting clean. Even very light residue remains. And, detergent is left in door at end of cycle. The bottom is filling up, so I don't think it's the intake valve. Also, all the blade openings appear clear. I am noticing that hot water is not filling the dishwasher when I first run the cycle. Even if I have hot water running in the sink, the dishwasher fills with cold or warm water. So, I think this is the problem. What should I do? Thank you in advance!
I find it odd that the dishwasher is filling with cold water if the water is hot at the sink. It sounds like the dishwasher is connected to the cold water line rather than the hot. Check under your sink; if you've got standard plumbing, the dishwas ... Dishwashers
I have a whirlpool dishwasher type 280-2 and the detergent door will not open automatically anymore. The compartment is thoroughly cleaned and wont even open if its empty so gook or over filling is not the problem. I believe I probably knocked off some part that makes it open at the proper time. If someone could explain how the process works and/or submits a picture of the parts, I could perhaps deduce what is missing. Thank you in advance as this is driving me nuts!
We have a Whirlpool mod# DU1055XTVD0 dishwasher .. the blue latch designed to keep the lid to the detergent dispenser closed after filling has come loose from the inside door panel and now will not stay in place to keep the detergent lid shut. We did find a small o-ring in the bottom of the tub that apparently is part of what helps maybe hold this latch in place, but obviously there must be something else that fits inside the hole the latch goes in that keeps it secure. This
... Whirlpool Dishwashers
Prima lpr601 problem- filled dishwasher up sa normal set the wash pressed button on far right (dont know what it is but needs to be done), closed door and loud raattling so i opened door to make sure all spray arms were clear which they were, closed the door , again the rattling . now the green light has gone out on far right and cant get it back on so program wont start at all. Any advice?? please help
The detergent dispenser [Main Wash] door doesn't stay closed. It seems like there is something wrong with the latch, but we can't what. We've cleaned it, but don't know what else to try. There don't seem to be pieces missing or broken. But no matter what, when we put in the detergent [we use the cubes] the door always just pops open and the detergent ends up falling to the bottom on the dishwasher. The dishes are still getting relatively clean, but we want to solve the problem with the door
... Frigidaire FDB1200RG 24 in. Built-in Dishwasher
Stuck door latch - GE dishwasher GSD8000
... GE 24 in. GSD6660GSS Built-in Dishwasher
GU1500XTLS3 Periodically won't start. Dishwasher has power because pressing cancel causes dishwasher to start draining (even though there is no water). Door switch works because opening door prevents starting drain cycle. No other button on control panel will work except for the 'air dry' / 'lockout' button. Turning off circuit breaker for 15-30 minutes and then turning circuit breaker back on seems to fix the problems but only for a couple uses and then it stops working again. Need ad
This could be the 'fill switch', which is the level sensor. Could be a plastic tube that exerts air pressure into the tube as it fills, make sure it's clear and open. The dishwasher has a sensor that monitors the door being closed too. Some use a hig ... Dishwashers
Model KUDI24SEWH2 - the dishwasher was operating, I opened the door to add another dish. When I closed the door, there was a small click and nothing happened. The lights indicated to me there was rinsing and drying going on, but in reality, nothing happened.rn We were told it might be the thermal fuse, but have just check that and it is fine. It will fill, just not pump or drain. Any help?
... KitchenAid Dishwashers