Having problems with your GE HDA3500NWW Dishwasher ?

Dishawasher drains but right after lets all the

\015 Dishawasher drains but right after lets water back in after the draining cycle is done and the water smells. Is it dishwasher or plumbing problem?\015

Answers :

The check valve might be stuck. The valve is supposed to let the water out but stop it from flowing back in. Also make sure you discharge line has a loop. And check your air gap at the sink(if you have one) and make sure it is not plugged.
Make sure dishwasher discarge line is strapped staight up as high as possible after it comes through cabinate wall before it wastes through disposal,this will stop water from getting back in to dishwasher.
Repair Help & Product Troubleshooting for GE HDA3500NWW Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishawasher drains but right after lets all the


The check valve might be stuck. The valve is supposed to let the water out but stop it from flowing back in. Also make sure you discharge line has a loop. And check your air gap at the sink(if you have one) and make sure it is not plugged. ... GE HDA3500NWW Dishwasher

I have a Bosch SHU66C02. I opened the door to stop it from running temporarily, while it was sitting not running, it leaked all of the water out of the bottom right corner of the door, and when I went to start it later it just hummed but the timer didn't go down for over an hour. I tried to put more water in but as soon as I started I could hear the water added to drain. I turned the breaker in the fuze box off to it and let it sit for over an hour, but when I restarted, the timer was still at


... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

I have a hoda pressure washer it stats right up and while i was cleanning the wood fence i let go of trigger during about 10 min, and the motor started dying i pulled the trigger and it pick right up again any ideal what would make that do that? but one time i let it quit and i couldn't get it started,i had to wait about 5 min. then it started back up again.thanks


A couple of things, what makes the engine change tone and revs is pressure, depending on the age, it may have excessive calcium build up in the pump, there may have also been a build up of crud or a wasps nest in the end of the hose when you connecte ... Devilbliss DeVILBISS Devap DVH2600 Gas-Powered Pressure Washer

Kenmore Ultra Wash Quiet Guard - will not drain at end of cycle. After cycle is complete, water (not clean) sits at the bottom of the washer but I still unload the dishes and then turn the cycle dial around again - going past all the water heating and filling and washing - and land on the drain cycle, it will drain. Any ideas why it will not drain when I let a cycle run, but will drain once I cycle it through to the drain option?


... Frigidaire 24 in. PLD2850 Built-in Dishwasher

I am trying to figure out which is the drain...there's a cup in the front right corner of dishwasher bed (is that the drain)? there's also a filter like base that's screwed down but not with normal screws that you can use a flat or phillips screwdriver with? is that the drain? I was going to pour a baking soda mixture followed by vinegar and then hot water to see if drain is clogged by I need to be able to tell which is the drain.


Normally the drain is in the center of the maching under the center wash arm. Some models have a food macerator or grinder installed as well that is made to grind smalls food and hard bits to avoid clogging the drain hoses. Most have some sort of gri ... Dishwashers

My catering boss has installed a new midi 50 but the drain is to high and it won't drain. I'm I right in thinking this is a manual drain machine without a drain pump.our old machine had a drain pump. Is there any legal height that a commercial dishwasher has to be installed off the floor in regard to health and safety. thanks.


Lower height can be a violation, higher won't be. Pumps are only used to drain in a high volume environment. Many commercial clippers and washers don't have them. ... Dishwashers

Drain problems I have a Kenmore 665.17292992 portable dishwasher. I've changed the filter and the seals however it still does not want to drain. It will drain but extremely slowly and since it's on a timer, it only drains maybe 10% of the water out. My next step was/is going to be the Check Valve... but I am at a loss right now. I thought for sure it would be the filter. Any advice would be appreciated. Thanks, PM


This may not be the solution, but look for an air in-take somewhere on the top/back of the unit. It's probably covered by a stainless steel cover that can be taken off. Unscrew this cover and see if the air intake is blocked with lint. This is usua ... Dishwashers

We have a GE profile dishwasher that will not drain. We have replaced the keypad control and control module and it still will not drain. When we put it in service mode, we can get it to drain that way but when it is taken out of service mode, it goes right back to the same problem.


Its the timer issue:--\015\012what the timer does is control the motor and drain valve. If the timer doesn't work properly, the water may not drain and you need to replace the timer. This problem is common. ... GE 24 in. Profile PDW7800 Built-in Dishwasher

I have model 363.14779100 that has a problem. When a drain cycle is at the end and the fresh water starts coming in, the draining won't stop therefor all clean water goes right back out the drain. I can open the door latch and reshut it and the cycle will complete but the same thing happens on the next drainout. Is there a switch that needs replacing??


... Kenmore Dishwashers

Hi, I have a Siemens SE44 dishwasher with Aquastop, which I bought recently. It was doing great for first 3-4 wash cycles and then it stopped functioning :( Now all it does is let the water in, and then drains it out- it doesnt do anything else. I can hear the water going in and then the machine drains the water,and this repeats. I tired resetting the dishwasher, checked the drain pipe, aquastop etc, and all seem to be in order to me. Any suggestions? Many thanks, stonerockyy


... Dishwashers

Water will not drain out. do not have a drain airGap. when opened dishwasher this afternoon still had water in the bottom of it. Emptied the dishes, closed the door, pushed cancel/drain. the green light came on and i could hear the dishwasher running but not hear the water draining out. Let it run the 2 minute cycle for cancel/drain opened the door and the water is still there.


Hi,Here is a tip that I wrote that will help you with your dishwasher not drainingproblem...Dishwasher Problems - Waterwill not drain out ... KitchenAid 24 in. KUDM01TJ - Multiple Color Built-in Dishwasher

Bosch dishwasher SHX46A05UC/40 is making noise when draining. I have cleaned the screen and hose back to the drain and removed all debris. So it seem to be the 'drain pump'. But replacing it - now that seem complex - is it? Looks like I would have to stand the DW on its head and remove the base and then replace the pump. Anyone know if I am on the right track? Could it be something else?


... Dishwashers

I've had my Nautilus for 6 years and it cleans very well - but now, it won't drain fully and pools at the bottom of the unit. I have made sure that my garbage disposal was cleared first, too. and that water was draining properly in the sinks. I will need special tools to unscrew the drain filter in the dishwasher, right, or can I just use a pair of pliers to turn the little knobs? I am always careful to rinse all food off the dishes before putting them in the washer, but I guess I wasn't careful


If your model has the screen across the back with the filter, then yes use your fingers or a plier to unscrew the pop up valve assembly at the very back center of the dishwasher. Most likely, the cone shapped part has deteriorated and is not sealing ... GE Nautilus 24" Built-in Dishwasher

Frigidaire Dishwasher I have a frigidaire dishwasher that won't drain. it run through the entire cycle, the dishes are clean but the dishwasher is filled with the dirty water. I have unhooked the hose and let the water drain out that way but when i connect evrything back it still doesn't drain.


A common problem with dishwashers is the non-draining machine. If you are having trouble, check to see if the drainpipe and sink trap are clogged. If you still have drainage problems after doing this, check your drain hose to make sure there are no k ... Frigidaire 24 in. FDB510LC Free-standing Dishwasher

Intake drain The dishwasher is an excellent machine but the intake drain problem is driving us crazy. I have had pumps changed twice and that has not been the problem. I start the dishwash and within a minute the intake drain light comes on right after the first cycle. I need help!!


... Miele 24 in. Touchtronic Platinum Built-in Dishwasher

Water is running in and draining right back out. Leaving the dishes completely dry and dirty. I found a part laying on the floor when I took the cover off. I put it back where it came off of and now this problem. Yesterday it was the water not draining at all, now after putting that part back on it drains and doesnt wash.


Was it the float? try this empty machine put 1cup of vinegar or CLR and let it run through machine and clean jets and spray arm as well as soap dispenecer,You may want to try cascade they have rechanged it .Try this and let me know thanks ... Crosley 24 in. CDU600 Built-in Dishwasher

Miele NOVOSTELLA PLUS Dishwasher Drain Light is on. The dishawasher does not drain properly. I removed the pieces and cleaned them.


... Miele 24 in. G881SCI Built-in Dishwasher

My Dishwasher will not drain, it works fine, but when gets to drain cycle it just does not let water out


Most common faults with dishwashers is a drain fault. Check for any kinked hoses and check the drain spigot under the sink where the drain hose connects into the u bend. Usually this is where food gets trapped due to the spigot not being drille ... Sears 24 in. 14181 Built-in Dishwasher

Hello, I have a Frigidaire Dishwasher, model FDB750RCC1. It will not fully drain. There is water in the bottom of the unit after the cycle is complete. As it is not full of water or leaking out of the unit when I open the door I am suspecting it is the pump that has broken? (the water must be draining to the overflow point and then stopping as there is nothing pumping it) Any thoughts or ideas for me anyone? Am I on the right track?


... Frigidaire 24 in. FDB750RCC Stainless Steel Built-in Dishwasher

I have a EuroTech dishwasher Model# EDW254E/SB. It was working fine but now it gives the Err code:er1 Its not letting incoming water in i know that. As well I have been told to try reducing the water pressure at the facet. Did that nothing.It drains but wont cycle to the next stage and let water in. I am presuming there is a valve of some sort not opening? And does the dishwasher have to be completly romoved to fix. Thanks


Hi and welcome to FixYa. I am Kelly. \015\012\015\012This is a water level sensing problem. Look inside your lower wash tub area and see if you either see a circular device off to one side or a finger like device sticking up about 2 inc ... Dishwashers

My GE Nautilus DW doesn't fully drain. When it is drained as much as it will it leaves water in the sump at the rear right. If you run the pump at that point, it sucks water out of the sump, but when you open the door and the pump stops water flows back into it. It seems like there is a check valve that isn't working. I have cleaned the sump and the screen which runs accross the rear. I also have taken the plunger out and cleaned it. Then I took the housing for the plugner off the bottom. I don'


HI. check the following areas for fualts.1. Air gap / Drain hosesIf there is an air gap (located in the sink, near the faucet), check to see if it is clogged. Unscrew the top cap and see if there is anything blocking inside. Note: I ... Dishwashers

Dishwasher is not draining. Everything sounds right but it just doesn't drain.


If this a new installation - check the knockout plug is removed from the garbage disposal.If it has worked in the past - check the pump inlet screen at the bottom of the unit for clogging.And if the screen is clear - and the m ... GE Dishwashers

HI dishwasher will not drain if i remove all the water will run thro cycle and stops with a couple of cms of water left have tryed to find filter inside and failed, removed sides and can see a pump on right hand side can turn impeller easily, is this the drain pump? if not how do i get at pump and or filter. is it possible that plastic chamber on left hand side could be blocked assume this transfers heat Robert


... Bosch 18 in. SRS55L02 Logixx Slim-Line Free-standing Dishwasher

Unit won't pump out, checked the lower impeller and it was very loose, is there a drain valve on this unit? Model 587.14249991 The upper impeller is a fixed unit right to the motor but it appears the lower impeller is a push fit over a rubber sleeve. I only saewa check valve in the drain hose, is there any thing else I should check? hose is clear and the switch for the float is working ok.


At the bottom of the unit where the hose goes is a check valve. check to see if clogged. ... Dishwashers

Does it have a timer or something to tell it when to stop draining the water out. the pump is new, there are no clogs, the drain line is right. i even had a repair man say nothing is wrong with it . but it will leave about 2inches of water in it.


Yes it does your fill valve might be putting to much water in the dish washer it ia in the front left corner ... GE Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1021 seconds