Having problems with your GE Nautilus 24" Built-in Dishwasher ?

Found purple plastic large "ring" "gasket?"after washing dishes. Where does it belong?


Answers :

It belonged around my utensil basket.
Repair Help & Product Troubleshooting for GE Nautilus 24" Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Found purple plastic large "ring" "gasket?"after washing dishes. Where does it belong?


It belonged around my utensil basket. ... GE Nautilus 24" Built-in Dishwasher

I purchased a Bosch dishwasher SHU43C02uc/22 about 4 years ago. Recently during the last 2 washes, the machine has been giving off a smell like hot rubber during the wash cycle. It otherwise runs perfectly (dishes are clean, drains okay, etc). I have done just the routine maintenance like checking for large pieces of food but have found nothing so far. Any suggestions as to where I should look for where the smell might be coming from?


... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

I have an SKT51 series (silver edition) Bosch free-standing dishwasher. The problem is that a few days ago, when the washing was over and I started emtpying the dishwasger I found in the dishwasher a grey plastic part with the number 5603000027 on it. Obviously, it got loose from somewhere, but I cannot find where it was. The washing quality since then is definitely lower, food remaining on the dishes, which are not properly dried. What could be wrong?


Hello. The best way to find that part is to get your model number. If you are not sure where to look for it go to this link\015\012\015\012 ... Bosch Dishwashers

The disk washer doesn't drain at the end of the rinse cycle. There is a humming sound but no water is forced through the hose to the sink/garbabe disposal. At the end of the wash, there is a large amount of dirty water in the bottom of the washer. I removed the spray arms, the spray arm holder and the screen and then removed the water, and found a couple of pieces of plastic. But I don't see how I can remove additional parts from the washer bottom. What could the problem be? Is there a fi


Is the dishwasher drain hooked to the garbage disposer? If so is it new? If so did you knockout the plug in the disposer? If so then you either have something clogging the drain or pump. Or the pump motor is bad. ... Dishwashers

Maytag model mdbtt70aww. After the end cycle. open the door and found detergent tab on the bottom and the main wash cover is opened. Maytag diswasher model MDBTT70AWW. Put dishes and so forth in the dishwasher. Put detergent tab and jet-dry rinse agent in the pre-wash section. and close the cover. Start wash cycle after done over door and found the detergent tab on the bottom new the heater. The cover to the main wash is opened. Dishes are are clean. Wish someone would tell me


... Dishwashers

We have a model # 1385 Asko dishwasher. For the last few months we have found a film over all our dishes and pans washed in the dishwasher. We have found vinegar removes the film, but the need to constantly wash the already-washed dishes in vinegar to be defeating the purpose of using the dishwasher! We have used Cascade Complete for years, but we have tried different brands now, but nothing solves the problem. Can you please help us??????? Nancy Vocci


Hi \015\012Try running the hot water through the sink faucet, right before you start the dishwasher, so that hot water will instantly be there to run in the dishwasher, instead of it starting cold and having to warm up wh ... Asko Dishwashers

I have washed and rewashed my dishes with no soap and my glasses have a horrible white film and any of my plastics now have white film almost as if the soap is not rinsing off. I have resorted to hand washing and some of the glasses seem to be etched with this white residue....difficult to remove. Please help! I have read possible heating element problems but I just ran the dishes thru a wash cycle with no soap and when I opened the door the heating element seems to be functioning fine -- all


Hi,The scum, film and white residue problems have started since the reduction of phosphates in dishwasher detergents.Here is a tip that will help you to solve the problem of films, residue, and scum in your ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

I have a model 665.17791790. It goes from wash to dry (the dial is 3/4 way through wash cycle) and the dishes appear rinsed, but then it gets stuck and the dishes continue to heat indefinitely. I have deformed plastic cups and started to burn to a darker color the dish rack coating. What is the problem do you think?


... Kenmore Dishwashers

Hi. My problem is with my dishwasher detergent dispenser. It does open (at least it is open at completion of cleaning cycle), appears to deliver soap to dishes (as they appear clean), however, from the dispenser to the bottom of the door, there remains a very large amount of soap residue after wash is complete. This residue only continues to build up after each wash? The dispenser does not appear to be clogged and also appears to be delivering soap to dishes so I am not sure what to check for


\012Hi,\012\012There\012are three common problems that cause the Soap Dispenser or Cup not to\012open. I have a tip that will explain these problems in\012detail....Dishwasher Repair Problem ... Maytag MDBH985AWB / MDBH985AWS 24 in. Built-in Dishwasher

Kenmore model 665.16509200 Does not clean very well and now dry cycle not working. Wash cycle takes almost 2 hours, and still dishes had gradoo and white detergent on them, even ones that were clean when they went in. The drying coil had plastic melted on it once before, so that could have caused that malfunction. I am not so concerned about that, it is the dirty dishes after 2 hours that is driving me nuts. The short wash cycle leaves EVERYTHING dirty, so I just quite even trying that.


... Kenmore 13599 / 13594 / 13592 Built-in Dishwasher

DWI612C wash cycle runs on and on and on. Believing to be a problem with water heating I tried putting a couple large pan fulls of boiling water into machine during wash cycle and this did move it on from wash to rinse. How do I replace the heating element I cant see it it is not in the dish washing compartment? I dont want to call out a repair agent as one can probably buy a new machine for what that will cost. Thank you.


... Smeg 24 in. DWI612 Built-in Dishwasher

I have a KitchenAid dishwasher KUDS01FLB6. The center wash arm assembly keeps falling off during the wash cycle. Two questions: 1. should the water release slots on the wash arm assembly be facing up toward the ceiling of the washer, or down toward the dishes? 2. why would the assembly keep coming loose - could the plastic connection be worn?


Yes the connection is worn or even brokenPlease rate/vote this response thanks ... Dishwashers

Found plastic item at the bottom of LG dish washer want to know we're it shoul go


... Dishwashers

Its an old inglis superb dishwasher model UD-23081, after I run the cycle, the dishes have an awful white film on and its hard to wash off (have to scrub & rewash all the dishes by hand). Also can the circular plastic screen in the bottom be taken out to clean? Thank you in advance for your help, its greatly appreciated.


... Dishwashers

Makes rumbling noise during wash cycle. I've pulled the pump and found no debris. It's been making this noise for about a year now. No problems with our dishes getting washed. Do you think the bearings inside the motor may be bad? If so, would I need to replace the motor and pump assembly?


... GE 24 in. GLD5560LSS Stainless Steel Built-in Dishwasher

Hi I have a Bosch dish washing machine. The glasses come out cloady and white when washed. It was perfect in the beginning but it is getting worde. The salt is full, the rinsing liquid is full and set right. I used to use the 3 in one capsules, but now I am trying the seperate salt, powder and liquid but nothin gis working. I have also cleaned the washer with that plastic holder filled with liquid a few times, but it doess/t make a difference. Please help. Melani


First thing to try is to use the capsules and see if they work. Try reducing the detergent a little. ... Bosch Dishwashers

Inglis MOD#IPU58460 Dishes not cleaned properly...thought that enough water was not being filled into tub because more water added manually and washes great! I checked inlet water valve operation and lines for possible lime buildup and timed "fill" time. All was good and time right to spec! Water level after fill is just to bottom of mesh screens. Under further trouble shooting I held door open slightly while holding door switch closed to observe wash cycle and found as pump starts water shoots


The sprayer arm may be clogged with debris.Here's a step-by-step troubleshooting guide. ... Dishwashers

Have SHU43C and have had no problems with it. We usually run it on the Quick Wash cycle, but ran it on the Regular Wash cycle yesterday because the glasses seemed to be coming out spotty. After it ran, there were no lights on the display like there usually are. The washer had run and the dishes were clean, but it has not drained completely. There is still about an inch of water in the bottom, despite removing and checking both the Large Object Trap and Fine Filter (neither which were clogged


The drain pump needs to be replaced or cleared of obstruction. ... Bosch 24 in. SHU43 Built-in Dishwasher

3 loose plastic rings found in primary filter The 3 identical rings are of pliable plastic and are 30mm in dia and 4mm width. The cross section of the outer ring is 'V' shaped. I cannot see where these belong. Are they part of the dishwasher? Thanks Richard


What you are describing is known as an 'olive' the sealing part of a water union known as a kinko and olive, i would nt worry to much they have been caught by the filter and it is just doing its job ....unless of course there is a leek then you will ... Westinghouse Dishwashers

My kenmore 16482 dishwasher was noisy and not cleaning very well. I removed the large motor underneath and found what looks like the plastic pieces that are on the electric motor shredded and worn and possibly some worn plastic in what im guessing is the pump housing. can these parts be serviced separate from the motor and where can i get them? thanks in advance


... Kenmore 24 in. 16482 / 16484 / 16489 Built-in Dishwasher

Cancel wash working fine. when ready to wash get humming sound. pumpmotor not turning. A glass dish broke a week ago and work fine till know remove screen today found some small brokeb glass - like when a harden glass brakes? if something is in the pump how do i remove pump


In\015\012most dishwashers, the water pump is located under the lower sprayer\015\012arm. This component pumps the water through the dishwasher. The pump\015\012has two impellers, top and bottom. These, as well as other components,\015\012can become ... KitchenAid 24 in. KUDM01TJ - Multiple Color Built-in Dishwasher

My Kenmore Elite dishwasher doesn't wash dishes properly. I think that it is not getting enough water in the machine. It only allows about an inch of water to get into machine and then starts. I do not think that there is enough water to spin wash arms. I have 40 PSI coming into the house. I am on well water and found debris in the intake orfice. I did my best to flush. Could it still be bad?


I am having the same problem with my brand new Dishwasher. ... Kenmore Dishwashers

Frigidaire dishwasher PLD2855RFC rinse aid leaks around cap. How to fix? New cap? Is this a recurring problem? I have found rinse aid on door below cap (residue) plus have found rinse aid itself on dish below dispenser. I have to refill the rinse aid reservoir about every 7 or 8 wash loads. Also, the dishwasher is very noisy when running (should be quieter). Not very happy with this model ...


... Frigidaire PLD2855RFC Dishwasher

Large rubber band? And missing "main wash" cover


... Whirlpool Dishwashers

F2 Code Hey, I have a single drawer built in Fisher & Paykel dish drawer and today I pulled the spray arm, filter and large metal screen out to clean them as we have been starting to get a bit of stuff left behind after washing lately. That was all good After putting it all back in though I went to use the dishwasher and it stopped and came up with an F2 fault, I thought I may not have put the bits back in properly so pulled them out again and noticed that on the rotor that connects the motor to


Fault F2 means the rotor is not rotating. If you say some of the vanes have broken off, they could have been jamming it. This should spin freely with minimal force when installed correctly. If you removed the rotor itself, you do ned to take care whe ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1379 seconds