Having problems with your GE Nautilus 24" Built-in Dishwasher ?

Dishwasher stopped in mid cycle and won't drain


Answers :

Repair Help & Product Troubleshooting for GE Nautilus 24" Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Not draining caloric dishwasher is not draining...was working fine before i stopped it mid cycle to take out a glass...then the next time i used it i put it on the pots and pan cycle and after it dialed to off i opened up and found a "block" of detergent and it hadnt drained... i just put it back on the normal cycle and am trying again... we'll see ?


Does the motor come on when it is supposed to drain? If it does then by stopping the unit mid cycle you could have had a freak instance of food particulate blocking the air gap located on the back of your kitchen sink (if you have one) It would loo ... Caloric 24 in. CDU210C Built-in Dishwasher

Shu9925uc/14 bosch dishwasher leaves standing water in the bottom of the pump. The pump seems to be bad because it wont drain out the back hose. I have run the diswasher full cycle and put the drain hose into the sink to test. It wont drain at all now and I dont hear the pump. Perhaps unrelated: Pump seemed to stop working after the back hose disconnected itself from the back of the unit spilling water all over the floor. When I reconnected the unit to the wall the pump now seems to be disfunct


Hi Dishwasher not draining issue occurs due to kinked drain pipe, clogged drain filter or drain pump. Check the drain hose for any visible clogging, remove if present. If no visible lint is present then remove then turn off the dish ... Bosch SHU9925UC Built-in Dishwasher

Kenmore Elite - 9 Year old Dishwasher - A circuit blew and the dishwasher stopped in mid-cycle and did not drain.... I reset the circuit breaker and "manually" took the water out of the dishwasher. When I push buttons to restart the "95" shows up for the normal cycle. However, when I push start the "95" becomes a "--". Suggestions???


... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

My Maytag dishwasher MDB6759AWS3 just stopped working. I had to stop it mid cycle and then I pushed cancel drain and now some of the buttons light up but not the start button


... Maytag 24 in. MDBH950AWS Built-in Dishwasher

Hi, My haier dishwasher is getting stuck mid cycle. Could you tell me why this keeps happening. It gets stuck mid cycle after the wash and rinse and then it wont drain or dry dishes properly. It has never been used before. Please help. Kind regard Katie Hopkins.


... Haier Dishwashers

Washing up liquid put into dishwasher, had to stop in mid cycle belling BID602 now wont stop stuck in wash cycle


... Belling Dishwashers

My Blomberg dishwasher wont stop drain cycle


A common cause of this condition results from water in the base pan. This may result from a leak in the dishwasher or the drain hose (to the sink drain) backing up. First check the base pan (the very bottom assembly that all other components are moun ... Blomberg DWT14210

Beko Dishwasher DW450 stopped mid cycle, not draining


... Beko Dishwashers

MY TECHNIKA DISHWASHER WONT DRAIN THE WATER SO IT STOPS HALFWAY IN THE CYCLE. THIS HAPPENED BEFORE AND THE TECHNICIAN MAUALLY DRAINED IT BY PRESSING A SERIES OF BUTTONS AND IT WORKED FINE. WHERE CAN i FIND OUT WHAT BUTTONS TO PRESS TO DRAIN IT MYSELF. THANKS


... Dishwashers

My Kenmore Dishwasher Model # 665.13832K601, wont change from wash cycle to dry cycle. It stays on wash until you stop the cycle and drain the water


... Dishwashers

Candy CDI1012 Integrated dishwasher. When I turn on the dishwasher and start it - for some reason it can not go the whole way through the cycle. When I open the door the - programme light is flashing and water is still in the bottom of the dishwasher - ie mid cycle. The water will only drain if I put it into another program to drain away - but as the dishwasher was mid cycle - the dishes are not clean


Hello mm1973,It could be because of bad door latch switches / blown thermal fuse / blown or oversensitive control board. In all these scenarios, a dismantling of the machine is required. If you have no prior experience, I'd recommend get ... Dishwashers

FDW40 My dishwasher has just stopped working mid cycle. The rinse and prewash lights are both flashing and the water will not drain away. I tried to empty the existing water out........put it onto a new cycle.......the water came in but again wouldnt empty.... Please advise


This is a blocked pump,Strip down pump and remove blockage. ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Bosch dishwasher I have a month old Bosch dishwasher. It was stopped mid cycle. I drained the water at the bottom, but the active light keeps flashing, and when I press the start,reset button, then turn it off, it does the same thing when I turn it back on. active light keeps flashing and the wash light is on. It won't even lock the door. How do I fix this because there is no Bosch dealers here to help with the problem.


... Hotpoint 23 in. BF41 Built-in Dishwasher

Dishwasher wont fill with water. just before it stopped filling i was turning the dial (a lot) between the wash cycles back and forth to attempt to get it to fill and drain (I didn't let it go through a cycle). We also removed the hose from the machine as it had split and replaced it and we had the machine tilted on it's side. the dial still clicks round but it sounds like the pump is going and it doesn't seem to be filling with water. Help


Hi. I suspect that the timer mechanism will be the culprit here, but i recommended to inspect and test the water inlet valve, before replacing the timer. The valve is a known problem area, as well. Follow the valve inspection procedure below, careful ... Fisher DS603W / DS603B / DS603I Dishwasher

Ariston afa370x dishwasher will not fill with water after stopping in mid cycle when water would not drain out. Water removed but dishwasher not working.


... Dishwashers

What causes this dishwasher to stop mid cycle and not finish... also water won't drain unless you put it on the risne hold cycle?


... Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher

Kudlo2frss3. Dishwasher runs, stops, starts blinking and wont drain. Cleaned it out. might run 1 cycle then the next it shuts off and is not draining.


... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

My Bosch Dishwasher does not drain all the water out of the dish washer after the finishing cycle...I usually start the washer and then push the drain cycle and it starts to pump for about 10 seconds and stops and starts and pumps again for 10 seconds and stops and then pumps for about 25 seconds and stops....doing this manual drain twice empties the dishwasher of the excess water....what may the problem be?


... Bosch 24 in. SHE43C05UC Stainless Steel Free-Standing Dishwasher

I have a zanussi ZSF2440 dishwasher, when it turned on by the power button on the front you can choose a cycle and start it, Once the cycle is started it fills up with water but doesn't stop until it over flows setting off the flood protection, which cuts the power, so all the lights on the display go off and stops the water flow and drains the dishwasher and keeps draining the dish washer while the flood protection is on. It seems as if the dishwasher doesn't know when its reached its correct


... Zanussi Dishwashers

BF41 Dishwasher with a leak stuck in mid cycle Hi, I have a 'general domestic Appliance Ltd' BF41 (95+G709394) dishwasher which recently started leaking at the door. After replacing the seal the problem seemed to ease, then recently the problem started all over again and the leaking got worse. A couple of day ago I couldn't stop it leaking and now it's stuck in mid cycle and even though the water is washing inside the machine it never gets hot inside or finishes the cycle. Ive tried stopping and


... Dishwashers

Why does our dishwasher stop mid-cycle?


... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Hi My dishwasher stopped mid rinse cycle, with a little water still in it. Lots of beeping later i managed to set it back to start but it wont go, just beeps. The line to sink seems to be clear. There is no gurgle sound when i try to start it. model number SB907WJ*00


Hi,Is there my error code there?If you set the appliance to drain do you hear the pump running?Bail the water out manually and then take the filters out.Bail out the water below the filters.Take off the ... Dishwashers

My Dishwasher starts, then stops after 30secs and won't continue draining. Everytime I turn it back on it comes up on the steam cycle and won't go to any other cycle, drains for 30secs and stops again. Power light is flashing. Have tried holding power button down for 10secs with no effect. Filter is clean, pipes are straight-no kinks. How do I get it to start working again? It is a whirlpool dishwasher, ADP5550.


... Dishwashers

I have a Fisher & Paykel DW60CDX1 and it stopped working mid wash. It beeped and showed E1. It now wont reset or work at all and there is water in the bottom of the dishwasher that has not drained


... Dishwashers

My GE dishwasher stopped running mid-cycle. There is still water in the bottom...do they shut off when the water won't drain?


... GE 24 in. GSD6660GSS Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2312 seconds