Having problems with your GE Nautilus 24" Built-in Dishwasher ?

Canot get the diswasher to drain. Tried CLR-no

\015 Canot get the diswasher to drain. Tried CLR-no luck. Please advise. Allan Silberstein\015

Answers :

Hi, please check to make sure which style d/w you have as outlined above. The direct drive dishwashers have a drain solenoid attached to the motor and pump or a separate drain valve that must be checked with a ohm or volt meter. The drain solenoid and valve energize and opens the drain port to allow the water to pump out. For a "no drain" problem, always start with the common stuff first...a kinked or clogged drain hose. The drain hose must be checked and cleaned out and if you have to, remove the drain hose(s) to fully check and clean them. Don't forget the drain system sometimes consists of a self cleaning body that also can get clogged and stop the dishwasher from draining. If your drain hose needed to be lengthened a hose connector was probably used, these hose connectors are slightly smaller than the drain hose and food bits often get clogged there, also the tail pipe piece that connects the drain hose from your d/w to the house drain is also another popular place to get a clog. On the forward/reversing style of dishwashers that won't drain, make sure the motor is reversing to drain the water out. If the motor does not reverse to drain, the motor, wires ( especially where the doors bends to open and close ) and timer will have to be checked. If the motor is reversing and running, the pump impellor inside the motor and pump assembly may be damaged and is incapable of pushing the water out to drain. If the drain solenoid or drain valve checks ok on the direct drive motor and pump, the impellor inside may also be damaged as mentioned above.
\015\012Always check the drain spout under the sink for a d/w that will not drain, also if the Air gas is leaking this is a clogged air gap or drain and normally not a d/w problem.
Repair Help & Product Troubleshooting for GE Nautilus 24" Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Canot get the diswasher to drain. Tried CLR-no


Hi, please check to make sure which style d/w you have as outlined above. The direct drive dishwashers have a drain solenoid attached to the motor and pump or a separate drain valve that must be checked with a ohm or volt meter. The drain solenoid an ... GE Nautilus 24" Built-in Dishwasher

DU915 undercunter diswasher. the spary tower became disattached from the nozzle cap cannot seem to get anything else apart to try to re-connect found no loose washers or nuts in the bottom of the diswasher


... Whirlpool 24 in. DU900PCD Built-in Dishwasher

We used our LG diswasher to clean our grill grates, which was a bad idea, because now the unit will not clean the dishes. We cleared the washer arms of debris, but the unit still is leaving the dishes on both racks dirty and is leaving the liquid soap dispensed into the unit undissolved on the door of the unit. There are no kinks in the water inlet, and water is getting into the unit, but the dishes are not getting cleaned.


Hi\015\012\015\012\015\012Thanks for using FixYa. Please make sure the dishes are loaded properly or\015\012dishwasher is not overloaded. Also check that the dishwasher is filling\015\012properly. It will fill with water up to ... LG LDF6810ST Stainless Steel Built-in Dishwasher

I have a Bosch SHU033A diswasher that is not draining. I have checked the lines but cannot figure out how to get to the drain pump. I have turned on its back but there seems to be no easy way to get the large white plastic bottom removed so that i can access the pump.


Hi\015\012\015\012\015\012 \015\012\015\012Thanks for using FixYa. First check whether the drain is not clogged or blocked and\015\012the line is not kinked. Check all the hoses for blockages & also clean the\015\012air gap. If you h ... Bosch Dishwashers

Our maytag is about ten years old. No big problems that a little vinegar wouldn't solve once in awhile. Lately, we ran out of water softener salt and a white film was on dishes and not getting clean. I filled the water softener again, and did the vinegar wash, which helped a little. Now dishes not getting clean. I got desperate and did an empty load with CLR in it. Still, not effective. I feel as if something is clogged with lime or calcium since a pan placed in there on bottom shelf still had


The problem is hard water. www.dishwasherfilter.com has a product to solve this problem once and for all. It filters the water going into your dishwasher and removes the ... Maytag 24 in. MDB4100 Built-in Dishwasher

Asko diswasher Dishwasher will not get water. Lines all checked, water on. Pump runs even when in off. Problem started when there was a water clog in the sink next to the dishwasher, and the dishwasher backfilled with water. We used a shop vac to get the dirty water out. Next day tried to use dishwasher, runs, but no water and empying pump will not stop running. Ideas?


Check for water leaks or not draining/overfilling fault ... Asko D1776 Stainless Steel Built-in Dishwasher

Top arm does not seem to be going around when diswasher is running. Top shelf articles are not getting clean. Black scummy material gets stuck in the top arm jet.


HI-\015\012If you can remove the spray arm, usually they screw or pull off, then put it under the faucet and start picking out all the stuff out of the jets. The best tool i've found for this is a large safety pin, bend a little hook on the end of i ... GE Dishwashers

I have a GE diswasher model # GSD3900L00BB, the top part of the washer tower broke off and I can't get it reattached. My dishes are not as clean. The rinse agent wont work and some of the detergent in not getting rinsed all the way out of the dispenser. Could all this be cause by the broken water tower? What do I do?


... Dishwashers

Motor removal Our dishwasher (Model LDS 5811WW) has LE come up when you turn it on. We were told by LG that it needs a new motor...so how do we get one? Also do you have any instructions as to properly getting it out? The clsest repair person suggested is 1 hr. from us and it would cost 3/4 of what the diswasher cost originally.


I am having a same problem. You can open dishwasher sump assembly from inside the dishwasher and check if something is blocking white impeller. I tried to open impeller and sheared screw head as I did't realized it is left handed screw. Even after cl ... LG 24 in. LDS 5811 Built-in Dishwasher

Kenmore 665.16529000 When we put the dial to pots and pans the diswasher fills up and cycles through, when the dials moves to normal wash, it fills up and cycles through again. When the dial gets to light wsh we can hear the motor running but nothing is happening, but the soap door opens soon after. The heating light comes on and the inside of the dishwasher gets so hot that it has melted our big plastic tumbler cups on the top rack and makes the counter top extremely hot to the touch. The dial


... Dishwashers

Dishwasher starts and runs to 2nd rinse cycle, when pump starts to pump water out, all lights on front display flash along with key pab lights blinking. you can turn off and restart, but is does the same. Diswasher will also try to start when in off mode. Replaced circuit board and it does to same. Did I get a bad circuit board or is there another problem. Also when I try water service test, I get a Rinse aid fault.


U REPLACED THE CIRCUIT BOARD IN THE DOOR, THE ONE BEHIND THE CONTROL BUTTONS? THAT IS THE TIMER, IT IS KNOWN AS THE CCU OR CENTRAL CONTROL UNIT, THAT IS WHAT CONTROLS ALL TIMED FUNCTIONS, SO THAT REALLY IS THE ONLY PART THAT CAN CAUSE THIS PROBLEM ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Im not getting eough water pressure out of my appiance it leaving spots and stainn on dishes i ran a cycle of clr but i still get same result


The problem is most likely that there is still water residue at the bottom of your machine. If the machine is not fully drained it picks up some of the residue and sprays that onto the dishes during the final rinse, leaving an unhealthy and unsightl ... LG 24 in. LDF 7811 Stainless Steel Built-in Dishwasher

My Kenmore diswasher gets stuck between the quick rinse and drying cycle


The timer went bad. Need to replace ... Kenmore 16602 / 16604 / 16609 Built-in Dishwasher

Do beko Diswasher DWD 4311S spray jets open up? they are clogged and i cant get the little musli or grains out


... Dishwashers

Bought new plactic part for the latch system but canot figure out how to get the spring back in to work correctly


Go and buy it www. repairclinic.com God bless you ... GE 24 in. Profile PDW8280JSS Built-in Dishwasher

I have the maytag quiet series 100 dishwaher, the washing cycle works great until it gets to the draining then i hear a low humming for a couple of minutes then the diswasher just shuts off, can you offer any advice??


Take the hose off that goes to the air gapget a bucket and put the hose in it put the unit into drain does the unit drain?I am assuming that you have a garbage disposalplease let me know ... Maytag 24 in. MDB9750AW Dishwasher

My kitchenaid diswasher is not cleaning the dishes, it seems to run through the cycles and there is water in there but they're not getting clean at all. the detergent cube doesn't seem to dissolve either


If the spray arm isn't moving, you either have a loose or broken drive belt that drives the spray arm. This would explain why the dishwasher runs through the cycles but doesn't clean or why the detergent isn't dissolving. The water is merely fillin ... Dishwashers

My diswasher does not drain properly and the cycle is block How to get out water manually I have ASKO D3121


The ONLY way to get the water out is to bail it out and then soak the rest up with a large towel. Not a pretty solution, but an honest answer. I hope this helps you! ... Dishwashers

My general electric model number pdw8200j03ww dishwasher continually leaves my glasses with small food particles in the inside. i am not sure where i need to ''cleaning'' the diswasher out to get rid of this problem. i am also not sure to take everything apart


... GE Dishwashers

No power the diswasher is a haier es 312. the outlet has 110 volts at the plug. i'm getting power to the wire nuts in the j box under the washer. no power ,no lights..


... Haier ESD312 24 in. Built-in Dishwasher

Gd morning We have Bosch Hydro Sensor diswasher which is not getting hot during wash cycle. Only cold water ? Thank You


Hello tacfire,\015\012\015\012 There is a in line heater that is underneath the unit which has probably gone out. If I remember right it is connected to the circulating motor. I don't recommend doing it yourself, as it is ve ... Dishwashers

We have water in the bottom of the diswasher we havegfot down to a part that we cant get off, i think there is food trapped and that is what is stopping it from draining any suggestions


DWs always have a residual amount of wtare left in them after every wash cycle as a means to prevent the heater buring out when it is switched on. With the power and water supply turned off you can either ladle out the water with a small cup or sipho ... Kenmore Dishwashers

Heating element i have just fitted a heating element to my candy diswasher but is still does not get hot is there a trip anywhere or a reset. what else can it be thanks andrew


Welcome to fixya.I'm Huuum at your service.Here is an interesting report I just read.Repair or replace? When to pull the plug on your old Appliance It nearly always makes sense to unde ... Candy 17 in. CS455 Built-in Dishwasher

Hello I recentley repaired a broken door latch on chef electronic diswasher the push button type not the rotary switch style. i had to disconnect the circuit board I wrote down the were the wires connected i have discovered that when I reconnected everything i had not got all the wires in the right place is there any way I can get a wiring diagram so I can connect the wires correctly thank you


Unfortunately as i know it is difficult to find a wiring diagram. Better try an authorized service station where they may have similar appliances. ... Dishwashers

Whirlpool ADG993, door fault: Hi, a few weeks ago soemthing broke on the door to my diswasher and it falls open wide with no stopping half way as usual. That was fine as the machine could still work, but now the door won't close. All seems fine until you get all but closed and then the door raises slightly from the bottom right corner, preventing it from closing. It looks like something may be jammed in there which pushes the door up at the last minute. There's a man coming out on Friday,


... Whirlpool Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0952 seconds