Having problems with your GE Nautilus 24" Built-in Dishwasher ?

My GSD2020F00BB is not draining properly, drain hose appears clear. What's the next step?


Answers :

Repair Help & Product Troubleshooting for GE Nautilus 24" Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My GSD2020F00BB is not draining properly, drain hose appears clear. What's the next step?


... GE Nautilus 24" Built-in Dishwasher

Water not draining after wash cycle. Pressed cancel button to start draining per manual, but nothing happens, although sounds like motor is humming. Drain hole in sink appears clear, but haven't checked the hose. What's my next step? Mine is model kudko2cr


Hi,Checkout this tip that I wrote about that problem...http://www.fixya.com/support/r4225828-dishwasher_repair_problem_detergen ... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

My dishwasher leaks water from the top of my sink when in the drain cycle mode causing a mess on the counter top. How do I stop this leak? The plastic cover to the part which is located next to the faucet is cracked but there appears to be no leaks on the hose or on the part itself. Also, what is the purpose of this part? Is this the actual drain for the dishwasher and if so, why doesn't it tie directly into the drain?


... Whirlpool Dishwashers

I have a whirlpool gold model GU1500 diswasher. When the rinse cycle ends the water pumps out into the garbage disposal like it should, but then water backs-up from somewhere into the bottom of the dishwasher. The overfill protection drain seems OK...the water doesn't overflow. It doesn't have a air gap on the sink. The drain hose goes directly from the dishwasher to the inlet on the garbage disposal. It appears to be properly installed per the installation instructions. The washer is about 4 ye


Seems you answered your own question here. You need to make an air gap in the drain hose - take as much slack as possible and make a curve (upside down U) under you sink as high as you can go. Make sure you clip ot to back of the cabinet to stabili ... Whirlpool 24 in. GU1500XTLS Stainless Steel Built-in Dishwasher

Hi I have a GE Dishwasher model gsd2200g -03 and I am getting C1 & C2 error codes but it seems to be working fine. I disconnected the drain hose and the water appears to be draining properly


Hello there: if you have installed a new garbage disposal make sure the knock out has been removed if removed then check the drain valve in the pump hope this helps you out sincerely D.Jones ... GE Profile PDW9880NSS Stainless Steel Dishwasher

The dishwasher did not drain properly a couple of washes ago. Then the next washing cycle is did drain. Now the machine does not work on any cylce and there appears to be a leak from the bottom of the machine. Can you help?


Hi \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Dishwasher not draining properly or not draining at all issues\015\012can arise due to different reasons. Usually, th ... Bosch 24 in. SGS47E02 Exxcel Free-standing Dishwasher

Greetings! My Bosch SHE3305UC/UC12 has worked faithfully until last week when we had to pull it out of its home to retile the floor. Upon reconnecting all of the connections, it no longer works properly. The initial drain cycle works, so the flood switch is fine. But after draining, it just quietly hums. The test cycle actually seems to move to the next step for about 30 seconds, before also just humming. I'm thinking I need to check the valve, but not sure how to do it on this mod


Hi\015\012\015\012The hum sound indicates a bad motor and it should be\015\012replaced. Hope this helps...please post back for further assistance.\015\012\015\012Daniel ... Dishwashers

My kitchenAid dishwasher won't drain well. the hoses are clear. solenoid seems to be opening and closing. What is my next step?


Hello there again I am really sorry we got disconnected Please try this The water doesn't drain from the machine\015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\0 ... KitchenAid Dishwashers

I have a Kenmore Ultra Wash Dishwasher model 665.1312 and it suddenly stopped draining. After cleaning out the 2 filters, I noticed that there are some drainage but it still has a good inch of water at the bottom. What would be the next step? The hose do not have any kinks in it.


... Kenmore Dishwashers

Water drainage I have followed the manual instructions for clearing all appropriate filters on the intake and outflow side but the cycle does not complete and leaves a pool of water in the base. What next? I have the G568/858 Plus Incognito unit (thisis the closest part # to my actual unit--can't even find teh right # listed...), and aI m dealing with the sme issue. I have followed all of the recommended steps in cleaning the filters, traps, etc. There are no kinked hoses. The water drains to b


YOU NEED TO REMOVE THE LOWER SPRAY ARM AND REMOVE THE SHELL THAT IS COVERING THE PUMP AND FOOD SHREDDER ,HERE IS WHERE YOU LOOK FOR A CLOG. ... Miele 24 in. G892SCU Plus Built-in Dishwasher

Model MDB5600AWB Serial Prefix(16)Dishwasher will not completely drain.After the 2 Min. drain cycle, water still is visible outside of the sump area! About 2" out from sump.If I hit cancel/drain again,the water will finish draining to the proper level.The drain hose is not clogged,the hose is properly installed.The pump impellers are fine.Please Help!!!!!! Respond to [email protected]


... Maytag Dishwashers

My WHirlpool dishwasher won't drain - basin is full of water. Machine starts and runs the drain cycle, but something is clogged. I opened up the bottom, and pulled off the drain hose to the disposal, and that had no water in it, so the clog is somewhere before the water gets to the hose. If I run the dishwasher drain cycle, it is not pumping water into the hose. What next?


The clog could be in the hose,or on up in the mouth of the drain,air pressure might dislodge the clog,or dissasible of the drain pan in the machine. ... Dishwashers

My asko d3250 thinks the drain hose is blocked. but when i pour water in the dishwasher to see if the water is being drained, the dishwasher is draining properly. Yet the dishwasher after it has drained the water, will shutoff and start flashing the Large Pot icon (drain hose is blocked error code). Is there a sensor that is faulty?


Yes, it sounds like it is to me. I'm not able to pull your model up on my data base,if I could I would be able to tell you where it is located. I would assume that it's located either inside the pump or close to it. Sorry I couldn't be more help. ... Asko Dishwashers

We're trying to install our dishwasher and there is a 3rd hose attached on the side. It appears to be a drain of some kind, part number, we think, printed on it is FRU 10967 19/07/04 08:33 Can you tell us what it is and where and how to attach. The one it's replacing only had the water hose and the drain hose, no third hose. Thanks


I just installed my Bosch dishwasher a few days ago and wondered about the same thing. The instructions for hooking up water supply and drain lines did not mention this third hose at all. \012\012However, 'the third hose' (which appears open on ... Bosch 24 in. SHU43 Built-in Dishwasher

Kenmoore Quiet quard 3 Model #665.74363K1 Serial #FS3502091 The unit will not drain properly. When in drain mode, it will drain slowly when diconnected from the disposal and lowerd to floor, and drains even slower at disposal level, or hooked to disposal. Disposal nipple is clear. I removed the hose and flushed it out with high pressure, found no blockages, hose flows freely and did not fix the problem. The motor is turning and seems to pump water fine, all wands are truning with powerfull spray


... Kenmore Dishwashers

The Intake/ Drain light is on. It appears that the machine is not draining and that possibly the pump is not working properly. The drain line appears to be clear though I haven't pulled out the unit to check the drain line at the machine. Any suggestions?


... Miele Touchtronic G832SC Built-in Dishwasher

Miele dishwasher makes grinding noise when turned on, there is a light on front next to inlet/drain. So I poured some boiling water into the dishwasher and then left it turned on and could feel the boiling water coming out of the drain hose so I am assuming it is an inlet problem, as it will drain but will not fill or otherwise work.There are a few small cracks in the outer hose of he inlet hose just below the grey box thing, could that be enough to cause the problem? They are only small so I di


... Dishwashers

Kitchen Aid dishwasher Model# KUDP01FLSS. 2 problems #1 Won't run unless you press in on the door and hold it for a few minutes then it runs through cycle normally. Problem #2 It won't drain water out at the end of the cycle when I open the door there is water laying in the bottom of the tub. I have checked the drain hose for clogging and it appears normal. I am able to remove the hose from the disposal and suck the water out of the tub using a shop vac this indicates to me that the drain is ope


... Dishwashers

We have a Viking DFUD142 (DW20.3) that is 5 years old and it has never drained properly. We followed all the directions to the letter and we can't figure out what to do next. There is also a ter


... Viking DFUD142 Built-in Dishwasher

I can not get the water to drain during a normal wash cyclr. When I press the start/restart button twice it makes noise but no water comes out the end of the drain hose. I have put a shop vac on the end of the hose and can get water out that way but it appears not to be pumping. The washer sits for up to 6 months at a time without being used. Thanks for any help Ted Berry Placencia, Belize Central America


Teddy,\015\012\015\012Buy a new one...then go fishin!\015\012\015\012Richard Vantine (ret'd Colonel...USAF) \015\012Bingelrade, The Netherlands ... GE GSD5310D Dishwasher

I am having issues with my dishwasher where it appears to be working but does not clean. Hot water does enter the unit and drains properly but is not cleaning. Muck is still on the door, the arms are wet. Also, normal cycle with no extra features selected (i.e. High Heat, etc.) takes over 1 hour and 20 minutes. Sounds appear to be normal, draining, filling, etc. Thanks!


No\015\012 you need not wash the dishes but just cleaning of the debris and then \015\012putting it in the dishwasher for proper cleaning will help you to \015\012prevent the drain from getting blocked.\015\012\015\012 ... Dishwashers

Dishwasher not draining, not getting dishes clean. detergent still present in its space, filters at the bottom appear clean and hose to drain appears unclogged Nautalis GE 24"


Sometimes this drain motors get stuck..you have to turm them a couple times with your hand, make sure you shut off power....also sounds like you have problem with cycling...i wish a can take a look on it....turn you drain pump...and try to start agai ... GE Nautilus 24" Built-in Dishwasher

Unit won't pump out, checked the lower impeller and it was very loose, is there a drain valve on this unit? Model 587.14249991 The upper impeller is a fixed unit right to the motor but it appears the lower impeller is a push fit over a rubber sleeve. I only saewa check valve in the drain hose, is there any thing else I should check? hose is clear and the switch for the float is working ok.


At the bottom of the unit where the hose goes is a check valve. check to see if clogged. ... Dishwashers

I have a moffat dishwasher MSD 2000 p00ww I checked the drain hose, ran water trough it had no problem, hooked it back on to the dish washer. I blew into the hose an could see the the air bubbles no problem in the dishwasher. But it still won't drain. Just wondering if you could hep me, on what to try next. Your help would be great.


... Dishwashers

Magic Chef DU4K is not draining all the water. There's at least a gallon of water standing in the bottom. I have cleaned the air gap assembly and drain line completely. They were even sanitized in hot water. I do not hear the water draining like it use to. When it worked properly you could always hear water draining into the GD. Now I can hear any draining. Again, there is no clogging anywhere in the drain line assembly. Is it a bad pump. I don't know where to go next with this.


... Magic Chef Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1369 seconds