Having problems with your GE Profile PDW8480JSS Built-in Dishwasher ?

WILL NOT RE SET FROM DELAYED START - GE Profile PDW8480JSS Built-in Dishwasher


Answers :

Repair Help & Product Troubleshooting for GE Profile PDW8480JSS Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

WILL NOT RE SET FROM DELAYED START - GE Profile PDW8480JSS Built-in Dishwasher


... GE Profile PDW8480JSS Built-in Dishwasher

I set my dishwasher to wash last night (delay 2 hrs.) and I checked it this morning and it never washed. Yesterday, I had to turn off the dishwasher at the breaker box because it wouldn't reset. Now, the normal wash and heated dry lights are on, but it won't start. Also, it usually beeps when I close the dishwasher door, and now it won't even do that. We bought the dishwasher about a week ago. It a GE Profile dishwasher. Thanks, Chris


\015\012\015\012\015\012First off all try to close the door tightly with your hand till you hear a beep.dont force very much.\015\012as you mentioned that unit normally gives a beep when door is closed.but not it is not giving that beep w ... GE Dishwashers

Jenn-Air 24 in. JDB1080AWS built-in dishwasher green lights flash on and off on their own sometimes - not able to start dishwasher sometimes - not able to use settings (lights don't light when pushing top setting buttons - dishwasher seems hot about 8 - 12 hours after use = cleans very well though - dishwasher wasn't used much from 2005-2007


... Jenn-Air 24 in. JDB1080AWS Built-in Dishwasher

I have a bosch dishwasher model number SGS0902GB/05. I use tablets instead of detergent. I put the tablet in the Dispenser and close the lid, noproblem. I then set the programme and shut the door, I usually set the programme to delay start so that it washes dishes in the small hours when all are in bed, however, when I have set the programme and close the door within a minute the dispenser assembly opens and the tablet falls into the dishwasher, I then try and put the tablet back in the dispe


Hello Andrew,\015\012\015\012I'm more than happy to give step-by-step instructions for replacing the detergent dispenser, however it's not cheap (about \302\24350) and it probably doesn't need to be replaced. Some of the smaller component ... Bosch Dishwashers

I have a Frigidaire 1500 series with fully electronic control dishwasher. When I try to start it all the lights come on the display but not water enters the dishwasher. I have tried various settings including delay start but still the same outcome. The over-fill protector in the bottom of the dishwasher moves freely. What else should I try?


... Frigidaire Dishwashers

My built in dishwasher ser no sm843049B-Model number GSD696ON1OSS will not reset. I mistakenly used the delay wash setting. It is set at 1 hr. I have used the start/reset button several times and the delay continues to show 1 hr. I don't see that the timer is moving in any way. It seems to be "stuck" at 1 hr . Is there a way of "erasing" the previous input? D Bafkas


Hi,\015\012\015\012Try to do a hard reset by unpluging all the cords for 1hour and then plug it back.\015\012\015\012Goodluck,\015\012Please don't forget to rate the solution ... Dishwashers

Model IGV 659.1 Dishwasher When switched on the 'time display' takes longer than 2 minutes to display the planned wash duration. The display works fine to set a delayed start. After cycling the start delay round to 0, or after RESET (buttons A and C pressed) the unit is then 'nudged' into displaying a time. After, at last, a time is displayed the unit works fine.


... Kuppersbusch Dishwashers

GE PROFILE DISHWASHER HOW TO RESET DELAYED START


... GE 24 in. Profile PDW7800 Built-in Dishwasher

I have a fridgidaire dishwasher, model FDB1250REC0. When I push the "start" button, the green washing light flashes on and off, but the washer does not start. There is no cycle delay set.


... Dishwashers

My GE PDW9280 dishwasher wont start - GE 24 in. Profile PDW9280JSS Built-in Dishwasher


... GE 24 in. Profile PDW9280JSS Built-in Dishwasher

I have a GE Profile CDW9000 series that all cycles and setting appear to work on ok BUT several of the blue lights on the control panel don't work?are burned out. As a result its hard to know what the settings are..The selection lights for 1 of the 5 clean cycles is out, the 8 hr delay light is out , as is the heated dry light and the start / reset light.My question is can these be replaced ? individually? or is it a single unit ? if so any helo with what the parts are called/ numbers and hard c


... GE 24 in. Profile PDW9800J Built-in Dishwasher

How to set Bosch Dishwasher delay start?


... Bosch Dishwashers

GE dishwasher control panel stuck on delay hrs setting


... GE 24 in. PDW7880JSS Built-in Dishwasher

My kitchen aid dishwasher will not start I replaced the interface control board thinking that was the obvious problem. When you go to set the dishwasher to start some of the settings don't always light up then when you push the start button the lights will flash then start but it's not flashing and won't start. I get lucky once in a while and get it to flash then start. I don't know where else to look. I don't want to start replacing parts one at a time till I get lucky. My model # is KUDIO1F


Check all cables especially the ribbon cables from the user interface to the electronic control assembly as steam from dishwashings will create small amounts of corrosion and inhibit signals to and from these 2 components,unplug each,inspect,and reco ... KitchenAid Dishwashers

How do you turn off the delay wash start? - Frigidaire 24 in. FDBB540 Built-in Dishwasher


... Frigidaire 24 in. FDBB540 Built-in Dishwasher

Maytag Dishwasher - Front load - Model # MDB-4 - Delay stuck on 9 - will wash for a short time (9minutes?) shuts off - then re-starts. Can't get back to normal setting - any ideas?


... Dishwashers

How to cancel the delay start? - Miele 23 in. Novotronic G841 Built-In Dishwasher


... Miele 23 in. Novotronic G841 Built-In Dishwasher

Willnotstart - GE Profile PDW8480JSS Built-in Dishwasher


... GE Profile PDW8480JSS Built-in Dishwasher

Have hoover nextra megaload dishwasher but have not got the manual. How do I set the time delay without the machine starting? Thanks.


... Dishwashers

Our ge profile dishwasher 6 years old does not shut off at the end of the cycle, even after 3 to 4 hours, you put your hand on the door and you can feel slight vibration if you open the door and close it , it will start what ever cycle you had it set on all over again. It cleans and dries the dishes, but I have to turn the breaker off. at the end . Paul


... GE 24 in. Profile PDW9700JII Built-In Dishwasher

I cannot turn off the delay wash feature. - GE 24 in. Profile PDW9880JSS Built-in Dishwasher


... GE 24 in. Profile PDW9880JSS Built-in Dishwasher

Regarding Maytag Dishwasher, model # mdb4651aww3. Most of the lights on the control panel will not light up. You can't change cycles or set the delay timer etc. You can hit the start button and it runs a perfect cycle, and ends up with clean dishes. You just have no idea what cycle it runs.


I have same problem with my Maytag. Had a repair guy come out and he said it's the 'controller card', not the button touchpanel. The controller card is $127 and not in stock and there's a 'several month wait'. I'm not going to wait, going to buy ... Maytag 24 in. MDB4651A Built-in Dishwasher

My fridgidaire dishwasher model FBD1050REC4 will not run. When I depress the start button the washing light comes but nothing happens. The delay wash is not set. Last I turned the machine and this morning the clean light was on but the washer never ran.


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If the clean light flashes, pauses, and then repeats. When\015\012the dishwasher doesn't sense a water t ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Start button and delay button not responding - Jenn-Air 24 in. JDB1100AWS Built-in Dishwasher


Sounds like the whole board needs to be replaced, notorius for this problem. Be sure you have power (any lights). If you do, it would probably be the board. ... Jenn-Air 24 in. JDB1100AWS Built-in Dishwasher

To operate the Delay Start Option ? - Maytag MDC4650AW Built-in Dishwasher


... Maytag MDC4650AW Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2339 seconds