Having problems with your GE Profile PDW8600J Built-in Dishwasher ?

GE Profile Dishwasher Model GSD4330Y72WW is leaving dishes with a dry powder on them after a wash. Seems like the upper sprayer is not working.What do I look for to repair?


Answers :

Repair Help & Product Troubleshooting for GE Profile PDW8600J Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

GE Profile Dishwasher Model GSD4330Y72WW is leaving dishes with a dry powder on them after a wash. Seems like the upper sprayer is not working.What do I look for to repair?


... GE Profile PDW8600J Built-in Dishwasher

The dishwasher doesn't seem to have nearly enough water in it. The upper sprayer arm doesn't seem to be spinning when running (I open the door and look really quick) and the lower one looks like it barely spins and barely sprays water. The dishes are barely wet and the soap is just laying on the bottom. The water is on, there are no kinks in the supply line. It sounds like it is running, and pumps pumping, but being brand new I am not sure what it should sound like. It certainly doesn't sound li


I would lift the drain pipe higher. approx. 1/2 the height of the dishwasher . also rechack incomming water supply. Make sure no blockages and the like. Try again. ... Bosch Dishwashers

The dishes are not clean when we run the wash cycle. It looks like the water flow from the top sprayer is NOT working. The door, when we open it, has undesolved soap stuck in globs on the top of the door. The top dishes are not clean and some of the botom dishes are not clean. We've run some clear washes to see if we can find the problem. The water flow looks suspect. Is it in the electronics or in the water mechanics. I called the repair guy who ususally comes out and says buy a new one! The re


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... LG 24 in. LDS 5811 Built-in Dishwasher

FDW60 dishwasher Hi My dishwasher is about 15 months old and the problem I have is that it seems to stay on pump and the Ecco45 light is flashing.  A repair company looked at the machine and said that the motor looked like it was leaking and water was getting in the bottom setting off the micro-switch.  He contacted Hotpoint who fitted a new motor today at a cost of £89.85.  Went to use dishwasher tonight and we still have the same problem.  The dishwasher started the washing programme for about


I've just (as of 10 minutes ago) had the same problem. I followed the advice given elsewhere in this forum and removed the bottom cover - water running out so needed a big towel to mop it up. I stood the machine upright and restarted it - no problem! ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Asko 1375 unit will not wash drains and fills ok  motor at back of unit runs well. Suspect impeller   Does motor have to come off for impeller replacement?? My 1375 is leaking a bit, looks like the seal which was mentioned in the impeller repair case,may be the problem? The other problem I noted was a clogged screen at the bottom of the dishwasher which is on the suction side of the pump, the screen had calcium buildup etc. I cleaned it off with vinigar and reran the dishwasher seemed ot fix th


Do you mean to say that the washer does not go into the wash cycle at all, or washes poorly?An answer to both can be found HERE.This article ... Asko 1375 Dishwasher

Kenmore Dishwasher model 665.1675592 doesn't seem to wash as well as it used to. Seems to have a low water level. Filler valve works, allows water in, but never seems to fill enough. No spray reaches top shelf, I think due to insufficient water level. It's like the timer doesn't stay on long enough for it to fill. Also cycle time seems WAY up, but if the timer is slow, how does it time out filling so fast? Looks like it would be slow all the time. Suggestions?


... Kenmore Dishwashers

Kenmore dishwasher type 573-D, model 665.16034402. Items on top rack don't get washed. Items on bottom rack are washed fine. Appears top sprayer and maybe middle sprayer aren't getting water. At rear of washer, top rubber flapper valve (which feeds middle sprayer when top rack is in raised position) is stuck open, bottom flapper valve looks OK. We use top rack in raised position so this doesn't seem to be the problem.


... Kenmore Dishwashers

PDW9280J10SS dishwasher has been in use for about 3 years. The control panel is not working properly. I use the up/down arrows and it turns on heated dry etc. When I push the heated dry button, it changes the lights to the different cycles (which is what the arrow keys used to do). The normal wash light won't come on, the only setting that seems to wash a full cylce is antibacterial. It seems like something burned out. What should I be looking at as a possible cause/fix. Unfortunately, I don't h


... GE 24 in. Profile PDW9280JSS Built-in Dishwasher

I have a kenmore ultra wash quietguard 3 . It fills but not enough to cover the heating coil. It washes poorly and leaves schmutz on the dishes. I have checked all the sprayers. They are not clogged. The top rack doesn't seem to wash as well as the bottom. What should I look at next?


Hi, \012 \012I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms onli ... Kenmore Dishwashers

We have a Sears Ultra Wash III dishwasher, model 665.1677993, bought in October, 1995. It is not filling with enough water to get the dishes clean. I took the water valve out and looked at it and it seems okay. It doesn't look like the valve is opening all the way - just my guess. A small stream of water comes out with good pressure, but it is a small stream. I can't find any screens or filters in the water line coming in. The fill cycle lasts only about a minute. Is that adequate? Steve


There should be another letter after the p in your model number. If it's just a B then there are no parts available for that model. Typically a dishwasher will fill for 90 seconds or more. One minute or less sounds like you have a control board is ... Whirlpool GU2400XTP Built-in Dishwasher

Have spent $300 in the last week on Haier HDW101ss repairs. It still isnt fixed. The repair guy 'thinks' it is now a faulty timer. The unit hangs at certain points in the cycle. At these points the timer (ticking) noise stops but the machine carries on washing. It will hang at this point indefinately. I have taken the timer out, and it looks brand new (the unit is only 4yr old). Any advise, does this sound like a timer issue, or could it be something else? Where can i source a cheap (2nd hand)


... Haier Dishwashers

I had a service tech at my house to repair my refrigerator. He also took a look at my Maytag WU504 dishwaser, which was not cleaning the dishes anymore. He was less familiar with dishwasher diagnosis, but found that the lower spray arm was pumping out water through the jets properly in the cycles, but that the spray arm was not rotating. He seemed stumped and called his supervisor, who suggested it might be the wash impeller. I have looked at the parts diagram on partselectdotcom and taken t


You are absolutely correct!!\015\012\015\012The support retaining nut allows the arm to spin without falling off.\015\012\015\012And it would definately cause dishes not to clean if the arm didnt rotate.\015\012\01 ... Dishwashers

In between wash cycles, water seems to back up into the dishwasher. I had a plumber take a look at the drain and disposal in the kitchen sink to see if there was an issue there. He suggested to have appliance repair tech to come look and indicated that he believed that the issue may be the "cylianoid" valve. Does the this valve prevent water from backing up into the dishwasher after it has drained?


... KitchenAid 24 in. KUDI02CRBS stainless Steel Built-in Dishwasher

Dishes on upper rack are not being cleaned. Seems like upper sprayer is not working properly.


Hi Please check if something is blocked near the top spray arm, also make sure that all holes are oopen. Use a sharp metal pin to clean the holes on the top spray arm. Make sure the water pressure is not low. under the screen and yo ... Bosch 24 in. SHU43 Built-in Dishwasher

I have a Candy CD650 dishwasher which is not washing properly. Basically, the detergent tablets seem to be getting stuck in the tray. Most times I open the door, the tablet is a pile of mush inside the tray. Other times it is on the bottom of the dishwasher - again a pile of mush! Sometimes, it starts the program & sounds like it's about to start a wash cycle, but then gives up! it gives one short woosh, the stops again. Any ideas how to fix this? I don't have a manual so can't look there.


... Candy 24 in. CD650 Free-standing Dishwasher

GE PDW7300 dishwasher - must slam the door shut to get a light on the panel and when the START button is pressed, it looks like the dishwasher is cycling thru a wash, but there is no water. When I press the START cycle again, it seems like it thinks its pumping the water out for a few minutes, then the light will go off. If I start it again and push really hard against the door, I can hear the water go on. But if I stop pushing the door, the water stops. The dishwasher was installed in 2001, but


... GE 24 in. Profile PDW7300G Built-in Dishwasher

Hello. my dishwasher leaves gunk on the inside of glasses that were wiped clean before washing. It seems like that would mean the drain to the disposal is clogged but the hose is clear and the impellar is free. I blew on the hose and got movement in the disposal. the impellar is clean and new looking. I thought it would be a little dirty? Any help would be greatly appreciated. I will answer any question you have in case i didn't explain it well.


There are many probable causes of failure .A dishwasher's water inlet valve is its most common part to fail. When \015\012your dishes are not being fully cleaned, quite often a faulty water \015\0 ... Dishwashers

Kenmore elite ultra wash 4-5 years old. Only a portion of our dishes are getting clean -- it seems like not all the jets are working for the top load. This happens even when there are just a few dishes on the bottom. Do I need to call for a repair?


Solution> Please on the sprayer spindles there are little holes that will buildup a soap substance around it. Take a wire and clean them or run vinegar through it on a regular watcher run and that will improve it but not all together fix it. ... Dishwashers

We have a ASKO D3450, and it have worked perfectly well for 8 years. Today we have a problem with it. It look like the children-secure is activated becouse the AUTO-lamp is lightning. We try to turn it off, by turn off the power, hold the two keybuttons and turn it on again, press program; and then the AUTO-light should be turned off, but this dosent happend. When we close the door, the machine start to wash, but it seems that no program is activated, and the soap chamber does not open at all.


You have lost the control board.... ... Asko 24 in. D3450 Dishwasher

Kenmore ultra wash #15765 will not drain. purchased 1996, web says no such model exist, but i have the manual, and it does, i need help . I have taken out the lower sprayer arm and the spinner that chops up the food left, even removed about 10 screws that hold down what looks like a filler but it did not allow me to remove it. How do i access the drain to see if it is stopped up. Do i need to pull it out from the counter and go from the drain hose,or somehow go in from the bottom??


... Kenmore Dishwashers

I fell on to the dishwasher door when it was open and now the door will not close properly,therefore can't use it. hinge seems to be bent need to see what the hinge looks like before attempting repair


You'll have to pull the dishwasher out from under the cabinet to get to them. ... Dishwashers

Kenmore 665.16032401 dishwasher. My lower spraybar works fine but my upper and top sprayers seem to be not spinning during wash rinse cycles. Water is running from them but still not spinning.


... Kenmore 15892 Built-in Dishwasher

I have a MDB4630AWS1 series dishwasher that is only a couple of weeks old. Suddenly, it now starts the wash cycle but then the Cancel/Drain light turns red, and it drains and stops the cycle. Check for items blocking the sprayers and looked for anything clogging the interior. It does this with all the settings. Seems to work for a few minutes, but then it just drains and stops. Any help would be greatly appreciated.


... Maytag MDB4630AWS Dishwasher

The door on my built in Frigidaire dishwasher is falling open. it seems like a spsring or something has broken. I am looking for a repair manual, possibly an exploded diagram so that I can see what parts i might need. Thank you, Brenda


Here is the way the springs hook up.\015\012\015\012\015\012Here is the break down.\015\012 ... Frigidaire Dishwashers

I have kemore (whirlpool) dishwasher, model 665.13842K601 after a wash , there is black residue , which looks like black greese in front along the edge.The sears repair person said this normal ??? Daa ! Has anyone else seen this ?


... Kenmore Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1476 seconds