Having problems with your Haier 24 in. ESD100 Built-in Dishwasher ?

Hi threr I have the following problem with my Haier DW12-EFM dishwasher: The dishwasher seems to operate properly for the first several minutes untill program selector knob stops betwin position 2 and 3. After I turn it manually it keeps on turning and than it stops again after I turn it again it operates till the end of the program but the dishes are not clean enough to be used. I also noticed that the heater does not operate (water is cold). Do you know wht the problem might be. Reg


Answers :

Repair Help & Product Troubleshooting for Haier 24 in. ESD100 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hi threr I have the following problem with my Haier DW12-EFM dishwasher: The dishwasher seems to operate properly for the first several minutes untill program selector knob stops betwin position 2 and 3. After I turn it manually it keeps on turning and than it stops again after I turn it again it operates till the end of the program but the dishes are not clean enough to be used. I also noticed that the heater does not operate (water is cold). Do you know wht the problem might be. Reg


... Haier 24 in. ESD100 Built-in Dishwasher

Miele Diamante G 2150 SCU Dishwasher problem ----The program cycle indicators "Rinse", "Drying" and "End" flash at the same time. The drain pump is running when the door is open. I have reset the power and cleaned the drain pump and non return valve and Spun the propeller several times in both directions to check for obstructions. Still has the same problem. Water is being drained continuously even with power switch on dishwasher turned off.. Had to shut the breaker off to get it to stop. A


Hi\015\012\015\012Plugged system or a jammed drain pump can cause these issues, also make sure the drain hose is not blocked. Check the drain hose for any visible clogging, remove if present. If no visible lint is present then remo ... Dishwashers

My LG dishwasher upper rack has stopped cleaning. The uppermost arm is seemingly getting no water at all and the arm on the underside of the upper rack is getting some water, but not enough to turn it. I have already disassembled and cleaned all the way down to the diverter assembly and it has not fixed the problem. I think this is a problem with a the (?) diverter pump or perhaps a sensor that sends water to the upper arms. I am trying to figure out how to further diagnose the problems. The


Hi,\012\012\012\012\012I\012have an older dishwasher also and recently my wife also complained\012about it not cleaning right... so me being the man I am tried in vain\012to clean the things... Bought new ... LG LDF6810 Built-in Dishwasher

Hi, I have a zanussi DE6744S. I can select any program and water fills as normal. The problem is that the cycle runs and runs and dosn't stop unless I turn the machine off. When I restart the machine it just carries on until I press the current program button in for a about 10 seconds and the program stops. On the odd occasion it ends normally on the economy cycle (30 mins) but its pot luck. It does wash as normal but dosn't seem to get past constant washing (no drying) . Hope you can help, S


... Zanussi 24 in. DE6544 Built-in Dishwasher

I have a Whirlpool DU1048 that started out with a blinking clean light. I reset the dishwasher by pressing the heated dry and normal buttons twice. That worked the clean light stopped blinking. The problem now is the dishwasher seem to be stuck in the wash cycle. I finally have to turn it off after over an hour washing. Is this possibly a heating element problem? is that user replaceable?


... Dishwashers

ASKO dishwasher D3122 drain pump wont stop pumping and the machine wont respond when we press any of the program or start/stop buttons. the program light is flashing. We can turn the power off with the main switch on top of the door but when turning it back on the pump starts pumping again. please tell me how to fix this problem so we can get it up and running again.


... Asko D3122XLSS Stainless Steel Dishwasher

A GE triton dishwasher causes hammer noise when stops filling. The sink faucet works fine as do all the other faucets in the house. I cleaned all of the traps in the dishwasher. Because the sink works, I don't think it is a sink valve problem. I turned off the water to the house and drained the system, the air chambers should be good. Is there some component of the dishwasher that could be causing the noise? Would cleaning the pump help? If so, how would I do that?


The cause of the hammering noise, (slamming) is due to the water inlet valve on the Dishwasher (DW) shutting off abrutly once the DW reaches the proper amount of water.\015\012\015\012If this is an older DW, you might want to replace the ... GE Dishwashers

I have two problems with my GUI1500 dishwasher. The 1st is that when water starts entering the dishwasher I hear a loud hammering/vibrating sound. It's strange, but the sound will stop if I turn on a faucet in the house. The other problem I have is that the soap dispensor will no longer stay closed. The Plastic tab that holds it shut has basically disintegrated. Will this cause the dishes to not come clean? Can this part be replaced? I don't see any visable screws holding it onto the door.


Hi - welcome to FixYa,\015\012\015\012The first problem isn't a fault with the washer, it's a plumbing problem called "water hammer", which is a resonating vibration through your pipes. It's usually caused by a toilet flush valve, but can ... Whirlpool 24 in. GU1500XTLS Stainless Steel Built-in Dishwasher

PROBLEM! Hello, When we turn on the dishwasher and set it to any setting it beeps once, appears to work, then beeps again, and the first light flashes. Then the inside noises stop and the light continues to flash until it is turned off. We have cleaned the filter, and added salt, but this has not affected it at all. Please help! Thank you.


... Indesit 18 in. D41 Slim-Line Free-standing Dishwasher

I have a model DU840SWLQ0 dishwasher,everytime we turn it on it trips the breaker in the breaker box,prior to thi problem the drain was stopped up,cleaned the drain now this problem


... Whirlpool Dishwashers

The Simpson Silencio 850 door does not shut properly and the dishwasher stops operating,but once you push hard on the door,the dishwasher starts again. There are no leaks ,but the door must have a sensor registering the correct pre-load force against the door seal , which in turn,allows the machine to operate. My machine does not work until you push hard against the closed door. What is the problem please?


... Dishwashers

Bosch she4am Unit starts briefly, then stops about a minute into the operation and lights the CLEAN led. I located the diagnostics code paper, ran the test a few times, and come up with the same code...the CLEAN led lit indicates a door switch problem. I removed the door switch, it's a magnetic hall effect transistor..seems to work but not sure it's showing proper voltages. It reads 8vdc or so across the switch with door open, and about 11.7vdc with door closed. Seems too narrow a range to me


... Dishwashers

Hi - my Viking dishwasher has developed a problem where the pump runs continuously, whether the power switch is ON or OFF. After the power is turned ON, the troubleshooting guide indicates that there is too much water in the dishwasher. (One of the pot symbols on the display flashes continuously to show this indication.) I am unable to switch between programs, e.g., from quick rinse to pots & pans. I cleaned all the filters to no avail. I had to secure the circuit breaker in order to turn t


If you open the kick plate, you'll see the pan below the motor and check for leaks. The leaks will trigger the sensor to pump water out. Once you dry out the pan, the pump motor will stop and you should be able to reset the program. ... Viking DFUD042 Built-in Dishwasher

I have F&P DD603 with problem with bottom draw. Once a programme is selected and door is closed, the dishwasher beeps three times then tries to start itys cycle. It then starts but stops every 1-2 minutes (like pause botton has been pressed). If you press start again it starts for 1-2 mins then stops again. I have tried turning off the power and totally cleaned out the dishwasher but no change? Any suggestions?


Hi \015\012When you pull out the drawer, pay attention to the bottom near the bottom front panel, you will see a little tab. this tab is at both sides of the drawer, press these tabs in and pull the drawer fur ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

My dishwasher will start any program, it drains, fills, empties & beeps continually within a few minutes. The rinse light stays on until the machine is turned off & re-set. Aditonally, the ater heating has been hit & miss for some time! A service guy cleaned the water sensor with hot water fro a ketle + tooth brush, but the problem came back after a couple of weeks. Having removed item he cleaned, it looks fine and appears to switch OK. Not sure if its actually faulty. Is the themperature sensor


... Whirlpool 24 in. ADG7540 Built-in Dishwasher

Whirlpool Dishwasher ADP 252 model (old) It will start with the program and then just stopped. I have to turn the knob to carry on with the next step of the program. Maybe dirty? Can I clean it somehow?


Sounds like you have a heating problem. Machines with a timer are controlled by the thermostat, so it wont click on until the machine reaches the correct temperature. Is the water hot? If yes then you need to replace the thermostat and high limit sta ... Whirlpool Dishwashers

Neff 4456 water resevoir not filling. Checked float switch and all OK. Checked water supply and all OK. Filled resevoir manually from top of resevoir and program cycle starts but stops when rinse is required.Have stripped down and cleaned switch with float switches as I have had that problem before getting clogged. Any ideas


... Neff 24 in. S4456 Built-in Dishwasher

Dishwasher model en50242 after cleaning both filters and turning on the valve etc no water is going into machine. The control panel shows 2 lights one above the tap sign the other above the programe light. The pump runs for a few seconds then stops and nothing further happens. We are in a high water calcium area.


... Siemens Dishwashers

Hello I have a Miele G1235 SCU economic model, my problem is the departure of the machine. When you turn on any water stops after 1 minute and I get error f14.Ho clean the inlet water, but always crashes! Thank you for your attention! Angelo


... Miele Premier-Plus Built-in Dishwasher

We have a Zanussi ZIDW 956 built in dishwasher. Problem is hat it gets a short way into the program and then stops and then a light at the top is flashing ''A''. Cant see any blockage. Machine is regularly cleaned. Can you help Ben


Hi\015\012 \015\012If you have checked the drain hose and there is no blockage, and assuming that you have also checked the water inlet valve for any blockages. The issue can be with the door switch that is bad or the c ... Dishwashers

Brand new Miele 2170/2180 dishwasher. First time we try to use it, it stops after a few minutes, the warning beep beeps incessantly, and all of the program lights are flashing. According to the manual, we should turn it off and on and then try again, which we did. The problem persisted. The manual says that this may indicate "a technical fault" and we should contact customer service. Unfortunately, they are closed for a three-day weekend. Any suggestions?


It is just possible you have a problem with the drain.if you plumbed the drain to a spigot on the sink trap, did you make sure the spigot is not blanked? the sink spigot will be blanked if it has not been used before to stop water from the sink ... Miele Dishwashers

Dishwasher fix water does not go through the spray,. the upper hand an lower hand are clean , the pump does operate to empty the dishwasher . I do smell like some burning smell when I turn the dishwaher on, the water start running for 1 minute or 2 than stop shortly and doesn t reach the arm then the dishwasher becomes hot inside . Thank you


Something has gotten passed the screen and is jamming your pump impeller pull lower spray arm pull screen and see if you can find what is jamming the impeller and remove it drain pump is separate ... Maytag MDB7100AWB Dishwasher

Hi I have a diplomat dishwasher adp8322. When I turn it on it works for 10 mins and stop. Then it starts beeping. When I open the door the program has been transferred into rinse. Any idea what the problem is?


Problem with your board(or)pump.\015\012 ... Dacor Dishwashers

My fridge just stopped working this morning. Whenever I turn on the power the safety switch (fuse panel) trips off. How can I fix the problem by myself? I have cleaned up all the dust at the back and unloaded all the stuffs out.


I'm sorry but I think this is bad news for you. This is not something that you can fix yourself. The compressor is probably bad and is siezed up. This causes a high pull of power when is tries to start and cannot. This trips your breaker. Depending o ... Dishwashers

I have some problems with a Whirlpool DWF 406 dishwasher: The other day, my wife complained about it not finishing a program (just stopped and started bleeping). I saw a post at this forum where it said to clean out the black grid down my the sump. I did that, and then the dishwasher worked fine a couple of times. Today when I got home from work, the machine just bleeped at me and and the green LED light by the start button flashed 9 times over and over again. Does anyone know what those 9 flash


We have the same problem. The dishwasher is 10 years old. In one of the German forums they said that usually it's because the sieve ahead of the membrane has a fine layer of sludge and the pump cannot pump out the dirty waste water. They said that yo ... Whirlpool Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1912 seconds