Having problems with your Haier ESD312 24 in. Built-in Dishwasher ?

No power the diswasher is a haier es 312. the outlet has 110 volts at the plug. i'm getting power to the wire nuts in the j box under the washer. no power ,no lights..


Answers :

Repair Help & Product Troubleshooting for Haier ESD312 24 in. Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

No power the diswasher is a haier es 312. the outlet has 110 volts at the plug. i'm getting power to the wire nuts in the j box under the washer. no power ,no lights..


... Haier ESD312 24 in. Built-in Dishwasher

Woke up this morning and the unit acts as if it has no power. no lights, no sounds, nothing. I checked the power and it has power. I checked the wire nuts in the box with the power coming in and they are fine...it is only 1 and a half years old...Please help.


... Haier ESD311 24 in. Built-in Dishwasher

Bosch APEXX model number SHY99A05UC/14 lost power. Power input line appears to have arced (white power line and wire nut show signs of stress). The power breaker did not throw at the junction box. Already cut back wire and re-attached new wire nut along with replacing the breaker at the junction box. Still no power. There are no other visible signs of power stress or water damage underneath the unit or inside the doo panel.


I do not have access to the user or service manual for this model.\015\012However, such symptoms could be result of heater element or thermal overload fuse blowing. Do you remember having a very hot dishwasher when the it lost power.\015 ... Bosch Dishwashers

I am installing a Kenmore dishwasher model 13743. I have direct wired the washer?s terminal box wires to the wall power via a BX wire and the washer doesn?t respond. None of the panel buttons are active. With a multimeter, I find that there is voltage on the wall wires and on the dishwasher end of the BX cable wires that hard wired to the wall current. Even though, when I connect the dishwasher?s terminal box wires to the BX wires as directed in the Installation Instructions (white to white,


Next step to check the door switch...the door must close and the switches on the door must close to send power to the control...let me know ... Dishwashers

Dishwasher model# FGHD2433KBI. washer was purchesed mid July, used 4 times. I just put in some dirty dish's and closed the door. A couple minutes later the washer turned on. No lights were on. After a few minutes I pushed the cancel button. Nothing happened. I opened the door and it sounded like a sucking sound and the pump stopped. No water in unit. I closed the door it started again. I cut the power at the circut box. Waited a few minutes and turned power back on. Power failure light came on.


... Frigidaire 24 in. PLD2850 Built-in Dishwasher

My electrolux dish washer model eidw6105gso stopped before it completed the cycle. All the selection lights were flashing and i could not get any functions to change. I killed the power at the breaker to try to reset and that didn't work either. I removed the panel on the front on the bottom to see if there was a reset button and found another display that is showing a light on the turbidity location. what is this and what might i do to get my washer back working?


... Electrolux Dishwashers

Maytag Dishwasher Model MDB4100AWQ When I start the Light Wash Cycle: Washer fills with water, heater comes on (I checked it with a volt meter--120 volts), timer runs, motor never runs, before the timer gets to "rinse" the heating delay light on the door comes on and the timer stops. The heater is still on (120volts) nothing further happens it just boils away on the water in the washer. Note: If I manually forward the timer to "rinse" the motor will kick in and run but does not pump out w


Most common d/w power is 120 volts, check for 120 volts with a  ... Dishwashers

MY BOSCH DISHWASHER MODEL #SHU43C06UC/17 WILL NOT START. NONE OF THE LIGHTS TURN ON AS IF THERE IS NO POWER GETTING TO IT. I HAVE CHECKED THE POWER CORD AND THE BREAKER BOX AND EVERYTHING IS O.K., BUT I STILL CAN NOT GET IT TO TURN ON. AT ONE TIME THE LED LIGHT LIT UP FOR A BRIEF SECOND, BUT NEVER AGAIN. ANY OTHER SUGGESTION?


Hi-Check if there is a fuse at the back of the unit or inside of it. Replace if there is any.Keep us updated, thanksHope this helps ... Bosch Dishwashers

I have an AEG Oko Favorit 8081 dishwasher and it appears that there is no power getting to it [nothing light up] I have checked with a voltmeter and power is getting to the back of the machine. Is there a reset button/cct breaker/fuse somewhere in the washer.


There is no fuse or breaker in appliance.\015\012take outer door panel off and check for breakage in the wiring loom where it enters the bottom of the door. check also the door interlock is operating ok ... Dishwashers

Ariston LSI 41 dish washer had intermitant problem of green light not coming on when main power switch turned on and machine not working, the circuit had beed repair before. I played around and got the machine to go through a full circle once then would not go again. So I have put a new circuit board with switch etc. still the switch panel light dose not come on, i found bad connection in connector which comes from small plug on circuit board, (two red wires )I have checked for power to board. W


... Ariston Technologies Dishwashers

No power My dishwasher Model DMR77 quit working yesterday during a wash cycle. No power ie, no display light or tones. I am getting power to the unit, checked with a volt meter. I am thinking Power supply, or is there a reset on the unit.


Hi,\015\012 The main PSU is part of the control board. You may be lucky to find an aged fuse to replace, but it's more likely a power transistor that's fried.\015\012\015\012Unplug and remove the control board to see which bit's toa ... Samsung DMR77LHS Tall Tub Dishwasher

Seems like the washer is not getting power. The cord has a big plug with two buttons with little lights. Lights do not go on. I think they did at on point. Is the plug toast or is there some trick or could it be another issue?


The lights are gcfi circuit interupter indicators you should be able to push them in to reset them if they dont check where you are plugging them in to see if that is causing the problem. ... McCulloch FH160G Pressure Washer

Kenmore 13599K600 stopped working. Panel board doesn't respond - no lights, no response. Power getting to unit... checked at hard wire ends behind kick plate panel and power is reaching the unit.


Had the same issue and had to replace both the board and the fuse. Six months later, same issue again. It might be when the "Sani Rinse" is used as it dies at the end with some water left but the water is very clean. Possible defect? ... Kenmore 13599 / 13594 / 13592 Built-in Dishwasher

MDBH945AWW maytag dishwasher panel lights will not light up. checked breaker and was not tripped. Hardwired circuit. will check tomorrow to be sure power gets to dishwasher. Suspect have panel control failure. In which case should I box it up for the local dump.


These control boards do not have fuses on them. I opened mine up when the front panel touch pad stopped working and the LED indicators were anemic. This is a sign of the ribbon cable connections have oxidized. The ribbon cable connects the touch p ... Maytag MDBH945AWW / MDBH945AWQ / MDBH945AWB Built-in Dishwasher

My dish washer just stopped working, no power no lights no nothing. it is plugged in and the circuit breaker is not tripped the wires for to the plug are tight and i didnt find an loose wires, the gfc plug is not tripped either, any suggestions?


This machine has no power, and i would suspect a broken wire but you say the trip did not trip,have you got a voltage tester?if so set to x1k or until when you touch both points it workes.with the plug in hand put one point on the right plug ter and ... GE 24 in. GSD3630Z Built-in Dishwasher

The lights on the control panel do not come on so the dishwasher won't start. We have checked the electric box and it is getting power. What do you think it is?


... GE 24 in. Profile PDW9200J Built-in Dishwasher

The karcher pressure washer was working one day then just stopped working the next day .Thepower light comes on when i press the on switch but nothing happens .So the power is getting to it but will just not fire up .Please could you advise


... Karcher Pressure Washers

My dishwasher was running (Model # MDB9150AWB) was running and stopped. No lights on the front at all. Checked, and it is getting power from the 110 line at the connection to the wires in the lower (stationary) panel. Any thoughts on whether there is a circuit board that needs to be replaced?


... Maytag MDB7100AWB Dishwasher

Power to the dishwasher, but I can not get it to work. The washer is only a year old. The lights come on, but it will not run. Is there any kind of a reset that I can't find?


From your description it sounds like your control panel/keypad is bad. If you are getting lights when you choose a cycle but no response when you push start then you control panel is bad. \012 ... Amana 24 in. ADB1500AW Built-in Dishwasher

The control panel on the front of the machine will not light up and will not activate any of the functions on the dishwasher. The machine is getting power into the main connection box.


Hi,\015\012 \015\012Checked whether you have accidentally locked the control panel or not, push and hold the 3 key for 5 seconds and the dishwasher will activate. \015\012OR ... Dishwashers

Just stopped. I have an Amanna dish washer that is only 2 years old and it just stopped. It has about an inch of water in the bottom. I have power to the unit. No buttons show any lights or reaction when pressed. How do I test the latch buttons?There are 4 wires leading to the latch assembly, can I jump them to see if the latch is the problem?


Should be able to but it will run withdoor open if you do that so be careful. Have you tried holding in on the door and see if it will work? ... Dishwashers

My bosch dish washer will not come on.I checked to see if their is power and their is, no lights on door or any thing.


... Bosch 24 in. SHU43 Built-in Dishwasher

I have an electric power washer model PW181000AV with about 25 hours on it. Got home from my winter retreat and used the power washer about 1/2 hour on the driveway. Everything worked fine. Went to complete the job the next day, and the motor would not power on. No sounds at all, like it wasn't getting electricity. Did the standard trouble shooting with ground fault and on my own electrical system. Been using the same outlet for all the time I have owned the power washer, so distance is no


... Campbell Hausfeld Pressure Washers

Have a Westinghouse 905 dishwasher (guessing approx 5-10yrs old). When I turn it on it's starts is cycle as expected then stops after about 10mins and loses all power (can't turn it on or get any lights to light up for sometime almost like it needs to cool down) at this point the dishwasher is full of water. It is not the pump however as as soon as you can get power to it (sometimes some hours later) and turn it on the first thing it does is pump out the water. Any ideas??


It is likely the thermal relay is tripping. This could be because if you are feeding hot water to inlet the temperature of water is too high, or the dishwasher heater is faulty and overheating the water. Or it is also possible the thermal cutout is s ... Westinghouse Dishwashers

My DD 603 has burnt out the power board marked 34740453-G. It tripped the circuit breaker at the power box. It is burnt out on the board where the loom connects for the upper washer. It is burnt vertually in the centre of where the loom joins to the power board and the centre of the loom. I am wondering if something else has gone wrong with the washer causing the power board to burn out, or can i just replace the power board?


... Fisher and Paykel 23 in. DD-603 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1338 seconds