Having problems with your Haier ESD312 24 in. Built-in Dishwasher ?

Have power to unit, but no lights. Is there some kind of on board fuse or circuit breaker


Answers :

Repair Help & Product Troubleshooting for Haier ESD312 24 in. Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Have power to unit, but no lights. Is there some kind of on board fuse or circuit breaker


... Haier ESD312 24 in. Built-in Dishwasher

Whirlpool dishwasher Model#GU3200XTPS0 No power to unit, Control panel does not have power check the circuit and outlet, are OK. is there any fuse inside the unit? is circuit board has any fuse?


... Whirlpool 24 in. GU2500 XTP Built-in Dishwasher

Kitchen circut was accidently turned off. Now whirlpool gold disher will not work(unit was not running and the door was not closed all the way when circuit was turned off, All circuit breakers are on) There are no lights on display when door is closed completely, and it appears to have no power. Worked fine prior, what could it be? The unit has not been removed from under the counter yet. Is there a fuse or circuit breaker on the unit? If so where is it located? Other troubleshooting ideas


Hello- Turn power off. Remove kick panel and cover for power wires. Check connections. If these are ok, most likely suspect is a fuse at the control. This is a little harder to get to. Remove inside door panel screws. Unplug wires and remove panel. F ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Bosch DW model SHU53A05UC/17 was working fine until yesterday evening. Went to turn it on and now get nothing. No lights, no power zip. It's on its own 20amp circuit. Checked the fuse and it's not blown. Flip the breaker on/off a few times anyway to make sure. I was installing a floor and used my miter saw on the sump pump circuit (diff from the DW circuit). It blew the fuse a few times. Any chance, on a diff circuit, it spiked and damaged a board in the DW? What part (part #) would


... Dishwashers

An electrical panel breaker switch was replaced after the microwave and dishwasher both lost power. The microwave works after replacing the main panel breaker. However the dishwasher will not show any power. Checked the internal circuit board, no burned areas, cannot find an internal GFI reset, what can I do to get power restored to the main control panel or even the unit itself? Rick C


1)check any fuse in the circut board.(blown off)\015\0122)check any loose connection of neutral (or)phase wire to the machine(or)in the switch. ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

No power unit went dead checked power to base of unit ok also shut off breaker for 10 minutes to see if it will reset, no luck. Also removed inner door panel to reveal circut board to look for a reset or small fuse, none evident.


... General Electric GLD5960NSS Stainless Steel Built-in Dishwasher

House circuits OK, power to unit. No power within dishwasher as if it was not pluged in. Is there a circuit breaker or fuse inside? the modle number is WP920?WDB4. (The Question mark is unlegible)


Did you check the door switch for continuity? That will kill all control power. Just a thought.\012 GOOD LUCK ! ... Whirlpool DP920PF Dishwasher

Our KUD1021RBL2 has no power, I have checked the electrical connection and the circuit breaker, I cannot find a thermal fuse and I see no physical evidence of problems on the circuit board.


HiThanks for using FixYa. The issue seems to be its electronic control going bad and should be replaced; you can buy the parts from this ... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

We have a 6 year old Jenn Air dishwasher model JDB2150AWP We had a cracked door close unit which we replaced but got a short while restoring connections I am wondering if there is an internal circuit breaker, relay or fuse on these machines that we need to check and possibly replace since we cannot get it to run at all. No power or lights at all. I believe all connections are secure and we replaced the door close unit with new parts.


... Jenn-Air 24 in. JDB2150AWP Built-in Dishwasher

Model 665.15919001 Kenmore Elite dish washer suffered blown fuse last week, and after running two more loads, it appears to have the same problem-no power. The unit is plugged in and the breaker to the circuit is on.


... Kenmore Dishwashers

My DD 603 has burnt out the power board marked 34740453-G. It tripped the circuit breaker at the power box. It is burnt out on the board where the loom connects for the upper washer. It is burnt vertually in the centre of where the loom joins to the power board and the centre of the loom. I am wondering if something else has gone wrong with the washer causing the power board to burn out, or can i just replace the power board?


... Fisher and Paykel 23 in. DD-603 Built-in Dishwasher

Unit does not power up. checked power to unit ok checked power to latch switch - ok appears circuit board is bad. Traced 120v to board. Any other checks before getting new dishwasher?


Hi mgray770,\015\012It sound like you have done a good job already, but just a couple thoughts before you go buy a new one. If the board does nothing then it could be locked, check your owners manual or whirlpool.com for the exact unlock inst ... Whirlpool Dishwashers

Kudc10fxss4 I have a KitchenAid KUDC10FXSS4 w/o any power. Circuit breaker is on, and it's getting power. But there are no lights on the display. I called a parts place to see if I could order a thermal cut off fuse. But the representative stated there is no fuse listed for this model. Any ideas on what would be causing a loss of power? Seems odd/wrong to me that there wouldn't be a fuse. If there is a fuse, would it be located in the door (the control is built into the door, such


... KitchenAid Dishwashers

The unit is a Maytag model MDB5601AWW which it has recently began to lose power at the touch pad. The electrical breaker has been checked to confirm normal voltage. Additional investigation suggests that the unit can be reset by (1) disconnecting the power at the breaker, (2) disconnecting and reconnecting the ribbon cable that interfaces the touchpad with the control board. However, the problem reoccurs after a few normal wash cycles.


It sounds to me then that the display board or touchpad needs replacing,you havn't said that it's not doing it's cycles.so it's not causing any washing or cycle problems.i would replace the display board. ... Dishwashers

There is power to the main circuit control board, but no power exiting. unit will not run. no power to display.


There is a possibility that it could be a thermal fuse located in series with the hot side wire. If you are able to find it, and own an ohm meter, find out if it is open. ... Dishwashers

I have a KitchenAid dishwasher model KUDC10IXWH1 that has no control power. I have already verified that there is 120V at the control board. The unit kept the lights on after the cleaning cycle was done and I couldn't shut them off. I reset the electrical breaker and now nothing works, but the board has power. Please give any advice you might have. I was thinking of replacing the board, but I'm not sure if it is the board or the front control panel. Any way to tell?


... KitchenAid 24-in Built-In Dishwasher White ENERGY STAR KUDC10IXWH

The dishwasher stop during the wash cycle. It did finish draining the water from the tub. The machine is not showing a power signs, I check the circuit breaker and the fuse is not tripped. I open and closed the door and the door latch seems to be working fine. There is just no power to the washer. Usually when a machine breaks down, there still is power or buttons that light up on the front of the machine. I looked on the internet and many say that the fuse could be tripped. No where can I find


... Whirlpool DU912 Dishwasher

I have a kitchen aid dishwasher model kuds01dlsp3. The unit has no power. A repairman found that the power to the unit was fine and then said we needed a new circuit board. The charge would be approx 270. When I look at prices the whole assembly unit cost 179. wouldn't replacing the electronic component be much cheaper?


Hi\015\012\015\012\015\012\015\012\015\012\015\012Thanks for using FixYa. First\015\012thing is to verify that power is available at the power board of the\015\012dishwasher. Open the power board cover and check if the breaker is tr ... Whirlpool Dishwashers

Unit went dead. There is no power (electric) to it. I checked the circuit breaker and even changed the breaker, but no power. Removed the bottom foot panel and did not see any reset button. I don't know what else to look for.


The electronic control board has failed & needs to be replaced,by someone who knows what there doing.GOOD LUCKECO KIZZA ... Electrolux Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher

Our unit is not power on. It's plugged in and was previously working. The fuse is okay at the breaker. Any ideas? Is there a fuse within the unit that I can check? It looks like the screws to get into the lid are not standard. Thanks


... Bosch SRV53C03UC Built-in Dishwasher

My Frigidaire Dishwasher PLD4375RFC is showing 3 blinking lights at the same time when I flipped the power at the circuit breaker off-on: High Temp Wash, Air Dry on the touch pad and PF on the display. It would not respond to anything that I tried. All blinking lights are off and machine does nothing when I open and close the door. Flipped the circuit breaker off-on again to repeat the sequence. I replaced the controller board, as recommended by the appliance guy since he checked and said ele


... Frigidaire PLD4375RFC Dishwasher

Hi I have a bosch diswahser smu 7000. No power when I push button. Manual says its could either be fuse or circuit breaker. Checked breaker its ok. My manual does not say anything about location fuse. Called bosch. And they said they cant tell me. I nee to have a service call. Any help. Thanks.


... Dishwashers

My 1 yr old GE dishwasher model # GLD4900P00WW lost power during the drying cycle & blew the rest of the circuit. An electrician has fixed the rest of the circuit & rewired the dishwasher to it's own switch in the breaker box. The dishwasher still has no power. Is there a fuse somewhere in the dishwasher that could've blown? If so, how do I locate it?


... GE Dishwashers

Lost all power to the unit. circuit breaker not


Hi - I have the same issue. After talking to our local repair shop and asking if there is any thermocoupler or some kind of fuse that can be replaced I was told that it probably is a problem on the controller board. :(\015\012Please post if any ... Dacor ED24 Built-in Dishwasher

Whirlpool gold quiet partner iii quit during a cycle. none of the lights on the control panel work. there is power going to the unit from the breaker box.


... Whirlpool Gold GU2275XTVy Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1011 seconds