Having problems with your Hobart 24 in. LXIH-3 Built-in Dishwasher ?

When we push the Off button the machine won't drain and shut down? this is a Hobart LXIH machine. thanks,


Answers :

Try disconnecting power from the unit either at the plug or the breaker if hard wired. Reconnect the power and turn it on. If the water drains, refills and operates as usual, your problem is likely a bad off button on the membrane switch. Let us know
Repair Help & Product Troubleshooting for Hobart 24 in. LXIH-3 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

When we push the Off button the machine won't drain and shut down? this is a Hobart LXIH machine. thanks,


Try disconnecting power from the unit either at the plug or the breaker if hard wired. Reconnect the power and turn it on. If the water drains, refills and operates as usual, your problem is likely a bad off button on the membrane switch. Let us kn ... Hobart 24 in. LXIH-3 Built-in Dishwasher

I have a brand new GE disherwasher GLDA690. When I open it and then shut it the NOrmal Wash button and the machine turns on. There is no way to shut it off unless I hit the reset button and then it drains and shuts down in a minute or so. But anytime I open and shut the door the machine starts. Why? Thanks


... GE GLDA690MWW / GLDA690MBB Built-in Dishwasher

Hobart lxih everytime i add soap i get a service code e4 and the machine stops shut the machine off and it restarts just fine add soap and shuts down i use a powered saop made for under the counter dishwashers even when i run a delime agent thru the machine it the does the same what to do thanks for help david


E4 indicates water level has not reached top water sensor. Check for proper flow-water pressure to machine (15-25psi) and clean sensor in wash tank ... Hobart 24 in. LXIH-3 Built-in Dishwasher

Hobart LXIH won't complete delime cycle. Enters delime mode and executes the delime cycle properly until about a minute or so into the rinse phase. Machine shuts off abruptly with E5 code mostly, sometimes E4 code. Changed the control board, didn't solve the problem. The LXIH runs the normal wash/rinse cycle every time without any problems. This is a nearly new machine that actually don't need delimed, planning on selling it and it must work perfectly. I know some would program the delime notifi


... Hobart 24 in. LXIH-3 Built-in Dishwasher

Whilpool gu2300xt,wash cycle lights wont light,when i push start button goeswt calcell and drain and you can here drain pump then it shuts off


It is likely there is some fault with the float switch. Which means the dishwasher thinks it is overfilled with water and tries to empty out to protect itself. This is why the pump turns on as soon as you try to run the dishwasher. Refer ... Whirlpool Gold 24" Tall Tub Built-In Dishwasher - White-on-White

ASKO dishwasher D3122 drain pump wont stop pumping and the machine wont respond when we press any of the program or start/stop buttons. the program light is flashing. We can turn the power off with the main switch on top of the door but when turning it back on the pump starts pumping again. please tell me how to fix this problem so we can get it up and running again.


... Asko D3122XLSS Stainless Steel Dishwasher

Inlet/drain light on. i know it drains OK because if i pour water into bottom and close door and turn on i can hear it draining water out. it wont fill. i have cleaned everything and taken base off and cleaned and checked float and all ok. i have tried every combination of holding buttons down and trying to reset but machine just makes low humming noise and after about 5 seconds the red light comes on again.


... Miele 24 in. G646SC Plus Free-Standing Dishwasher

Asko d3120 i hear the dishwasher running ( the cycle i s not running just the sound of it )and it wont shut off unless i unplug it i cleaned out all the water and the drain hose is clear i pressed the on/off button together with the cycle on button to no avail.


If what is mentioned is correct to me, the motor or pump is running at times and you can hear the humming when the machine is plugged on. Your resetting also does not help to get the machine to run the program. It seems to me that the error is in the ... Asko 24 in. D3120 Dishwasher

Viking dishwasher M# DFUD142-PSS drains a little bit only then starts refilling, start button is blinking. When pressing the 2 buttons to drain have to press several times until responding then it drains just fine, also no push button light is on when pressing for drain. After doing all this machine worked fine for one wash only, then the same problem again after the wash cycle the water stays in the machine. Please help, thank you


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Dishwasher not draining properly or not draining at all issues\015\012can arise due to different reasons ... Dishwashers

My ariston dishwasher not pumping out water checked drain not blocked now auto and rapid buttons flashing and machine wont respond any ideas??


There should be a small cover at floor level. Open this and behind it should be the pump. Remove the pump cover to see if it is blocked.Also check the internal filters to see if there is any blockage between the tub and the pump. ... Ariston Technologies Dishwashers

I have a model 665.13463K901. It will not run thru cycles. At startup it sounds like water is trickling in. Then the machine shuts off. If water is poured it will run until the cancel drain button is pressed.


... Kenmore Dishwashers

My Hobart LX30 will not hold water for wash cycle, when the wash button is pressed the machine drains and the arms dont spin


... Hobart Dishwashers

Drainage Problems My ASKO D3120 doesn't drain properly leaving water in the bottom. I have had this problem before (2 yrs ago) and called the helpline who told me how to reset the machine by pressing the buttons in a particular order which fixed it immediately. Now when I call them they claim this can't be done and they will have to send a technician. Sounds like a money making exercise to me. Does anyone know how to reset through the programming function? Next time I'll write it down and wont h


Turn off the dishwasher by pressing the on/off switch on the top left of the dishwasher. Wait 5 seconds. Press and hold the program button on the right side of the front of the dishwasher. As you are holding the program button, press the on/off sw ... Asko 24 in. D3120 Dishwasher

Have a whirlpool ADP 951 and no manual for it. Is was working fine and now the red light in the left hand corner is on and machine wont fill. When I start it by holding the button on the right hand side in, it will drain for about 30 seconds and then stop and green start light flashes. Can anyone offer a solution?


Some mod have codes / could be suds lock or slow drain . i would ( if front loader ) clean out pump . hope this helps . **** ... Dishwashers

The wash cycle seems to take hours. the water wont drain away and i get a little blinky light on the front. i dont have the manual either so i dont even know what the arrow buttons mean on the front of the machine


... Zanussi 24 in. IZZI ALU Built-In Dishwasher

Our hobart machine just shuts off and wont come back on again. All the lights go off.


Always put mod#, ser#, and ml# when stating problem, sounds like the switch membrane is bad. hopefully your dishmach. is an lx18,lx30 ... Dishwashers

MY TECHNIKA DISHWASHER WONT DRAIN THE WATER SO IT STOPS HALFWAY IN THE CYCLE. THIS HAPPENED BEFORE AND THE TECHNICIAN MAUALLY DRAINED IT BY PRESSING A SERIES OF BUTTONS AND IT WORKED FINE. WHERE CAN i FIND OUT WHAT BUTTONS TO PRESS TO DRAIN IT MYSELF. THANKS


... Dishwashers

Whirlpool Quiet Wash Plus dishwasher Model DU920PFGZ3. Worked fine until I replaced the insinkerator and forgot to punch the drain plug leaving water standing on the bottom of the machine. I punched the drain opening, and pushed the cancel/drain cycle button. It drained fine but since no water comes from the spray arms. I have removed the arm all the way down..NOTHING!! Some research indicated it could be the water inlet valve. When the buttons are pushed, it cycles but no spray or water.


... Dishwashers

I have a Hotpoint Aquarius dishwasher (FDW60) The 3hr and 12hr lights are on and the machine won't respond to any other buttons pushed therefore I have not been able to reset the machine (that is if the delay start has actually been activated). It started with the machine not draining however I was able to drain it manually so that rules out any blockages. Please help...The manual doesn't have any troubleshooting advice for those lights... Thanks


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. When 3hr (Prewash) and 12hr (drying) light flashes it indicates\015\012the fault in the heating ci ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Kenmore Elite dishwasher Model #665 1597 2992 Machine fills with water but thereafter it neither washes nor drains. Machine will not drain when I advance the cycle by pressing the Cancel/Drain button. There was a report that there was some noise when the machine first failed. I do not hear anything when I try to run a cycle. What might the problem be? How does one turn the motor manually to see if it is bound up by something? If it is the motor do I want to pay an extra $70 to $100 and


... Dishwashers

Smeg dishwasher model DI 612 C type 12053 good morning After selecting a program and shutting the door the drain pump starts and runs for 2 seconds then stops. The machine makes a bleep noise then the drain pump starts again running for 2 seconds then stops again and the cutting in and out process continues and the machine never reaches its selcted cycle. No alarm lights are displayed. I have filled the machine with water so that the filter is submerged and the level is


... Smeg Dishwashers

Dishwasher fills with hot water. Float OK - water feed stops when full. Motor humms but no water spray (in all opperating modes). Cancel selection (with cancel button) and close the door. The water drains then the unit shuts off. Water feed OK. Drain Cycle OK. Looks like spray pump hung but do not know. Cannot find a reset button (as with disposal) or way to free hung pump motor. I did see glass pieces in the drain. Possibly a small piece hanging the motor.


If you found broken glass inside the machine some has likely migrated to the pump. about the only way to fix that issue is to remove the pump and either replace it or disassemble it and clean it out. ... KitchenAid 24 in. KUDP01FL Built-in Dishwasher

I have a 3 year old delonghi dishwasher and have followed all the suggestions for error E4 on this ste and the water still wont drain from the machine and the error re appears. i have drained out all


... Dishwashers

Just got a used F&P Smart Drive 5.5 MW059. First few times I used it wouldn't always start on certain settings but once it did start it ran through just fine. On the fourth use, it was very difficult to get it to start and it just stopped after it filled up. Pausing and restarting, shutting of machine and retrying did not help. Was able to advance to rinse mode and got machine to drain water; however, instead of going into spin mode it just attempted to drain continously. I let it do its th


Did not realise this is a washing machine and not a dishwasher.\015\012\015\012Looks like some consultant has already been dealing with you on this problem.\015\012\015\012Hard to say if it is a simple as an inlet solenoid val ... Dishwashers

When I press the start button, Bosch dishwasher (model SHY56A 05UC) just keep running the motor pumping the water out of dishwasher, irrespective of: 1) the wash cycle it is on, 2) whether the door is closed or open, 3) whether I cancel drain cycle, as told by Bosch Cust Svc in following steps: - "Cancel Drain" by pressing 'Quick Wash' and 'Regular Wash' buttons together for a minute until it shows 0* - Shut power off for a minute and wait for a minute - Restart on Quick Cycle. Paid


What is happenig i believe and has happened to me 2 times is that the water level float that is on the left side of dishwasher is stuck.\015\012\015\012Either remove side panel and flick lever or pull dishwasher out and tap lower portion ... Bosch SHY56A02 / SHY56A06 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1086 seconds