Having problems with your Hobart 24 in. LXIH-3 Built-in Dishwasher ?

Lxi hobart not pulling rinse aid i used a screwdriver across prongs on board to make it run manually but still not coming out


Answers :

Try replacing the "squeeze tube" inside the dispensing unit. Over time the tube flattens out. If the tube is flattened no chemical will be drawn from your jug.
\015\012
\015\012Disconnect inlet and outlet hoses on rinse aid dispensing unit.
\015\012Remove 4 screws and pull off outer face of dispensing unit. You can watch the dispenser operate with the face off if you wish, as long as the hose doesn't fall out (which it won't).
\015\012Remove squeeze tube and install new tube.
\015\012Reassemble inlet and outlet hoses (be sure to not mix up which tube/hose goes on top and which on bottom).
\015\012
\015\012Also possible that the hose from the chemical jug to the dispensing unit has a hole/crack or otherwise. If the hose has a leak it'll lose suction and draw air in from the leak and not pull chemical.
Repair Help & Product Troubleshooting for Hobart 24 in. LXIH-3 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Lxi hobart not pulling rinse aid i used a screwdriver across prongs on board to make it run manually but still not coming out


Try replacing the "squeeze tube" inside the dispensing unit. Over time the tube flattens out. If the tube is flattened no chemical will be drawn from your jug.\015\012\015\012Disconnect inlet and outlet hoses on rinse aid dispensing uni ... Hobart 24 in. LXIH-3 Built-in Dishwasher

Maytag Dishwasher Model MDB4100AWQ When I start the Light Wash Cycle: Washer fills with water, heater comes on (I checked it with a volt meter--120 volts), timer runs, motor never runs, before the timer gets to "rinse" the heating delay light on the door comes on and the timer stops. The heater is still on (120volts) nothing further happens it just boils away on the water in the washer. Note: If I manually forward the timer to "rinse" the motor will kick in and run but does not pump out w


Most common d/w power is 120 volts, check for 120 volts with a  ... Dishwashers

I have a KitchenAid Dishwasher KUDIO1iLBS2 and none of the lights come on and if I press any of the buttons nothing happens. The unit is getting power to it as I shocked myself. I did ordered and replaced the control board and still nothing is happening. Any suggestions or ideas? Is there a reset button or is there a possible fuse that is out that would make the lights not come on? Please help.


... KitchenAid Dishwashers

GU980 dishwasher I have a buzzing sound when the washer is in drain mode. The manual indicates there might be something in the Power Clean Filter, and that it will go away when the object grinds up. I called Whirpool, and they said the same, and to run for 2-3 cycles to make go away. 2-3 cyles later, noise is still there. I noticed a nub off the rack that looks like an end peice of metal broke off from rust. My guess is it's stuck in the PCF, and will not grind up. I removed the nut, lower spray


The nut holding the inpeller has to come off it is probally frozen\015\012if it snaps off then the pump assy willl have to be replaced or at least the motor, you need to get below the impeller to see what is down there though, or let it run as ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

I have a Whirlpool Dishwasher model number DU8400XB-1 it has leaked at the bottom left side for a while and now all the way across. I removed the inside of the door and saw that the splatter shield had come loose. I put it make in place but still have leaking. any advice


Drum maybe the problem ... Dishwashers

My bosch excel dishwasher has the following fault: start the cycle, water starts to fill but then check water light comes on and it then starts to empty again. Pump then keeps going. I have checked the hose and even swapped it round with my washing machine one but this makes no difference. I have cleaned all the filters and taken off the cover to check the 'propeller' as sugested in the instruction manual. But no joy - check water light still illuminated and willnot continue with cycle. - Help!!


This unit im sure has a water flowmeter that measures the water intake.. if this cannot read then the unit shuts down to avoid flooding.. \015\012it needs replacing... it is attached between the valve and the side tank or attached to the tank d ... Bosch Dishwashers

Amana dishwasher making loud noise when running. nothing stuck, sounds like it is coming from the motor. still wahses dishes, no burning smell.


... Amana Dishwashers

Ariston LSI 41 dish washer had intermitant problem of green light not coming on when main power switch turned on and machine not working, the circuit had beed repair before. I played around and got the machine to go through a full circle once then would not go again. So I have put a new circuit board with switch etc. still the switch panel light dose not come on, i found bad connection in connector which comes from small plug on circuit board, (two red wires )I have checked for power to board. W


... Ariston Technologies Dishwashers

When we switch our Beko DE 2541 on its running straight away with the stop/start button being pressed. On the last successful cycle completed it just carried on making a noise like it was running and has been doing the same ever since. We have tried tipping the machine at 45 degrees as advised but it is still making running noise and not finishing.


Sounds like you have a water leak. The machine is fitted with a leak detection device that runs the drain pump constantly as a safety mechanism. If you want to look your self you will need to pull the machine out and tilt it back and if possible remo ... Beko Dishwashers

Dishes are still dirty. I have used every kind of dishwasher aide, half loaded it and dishes are still dirty, I let the water run until very hot before starting the washer. The washer says you don't have to rinse but I do and they still come out dirty. Also black nasty stuff comes up from my garbage disposer.


Suggest the problem may be a plumbing issue - likely substantially blocked drain system, so the dirty wash water cannot properly pump out but rather remains in the dishwasher.\015\012\015\012Suggest getting a plumber in to "snake" out you ... Dishwashers

Help! My dishwasher runs thru it's cycles but when I open it I find my second detergent cup still full of soap and my dishes still dirty. I have an older maytag dishwasher but have never had this problem with it. I've tried running a short prewash cycle with the soap despenser open to wash out the soap from the open second despenser but it doesn't wash it out. I know water is coming out of the spray arms but can't see if the arms are spinning although when running it does sound like they ar


Hi,\012There are three common problems that cause the Soap Dispenser or Cup not to open. I have a tip that will explain these problems in detail....Dishwasher Repair Problem ... Dishwashers

I have a GE dishwasher model GLDL560N10SS. I noticed a burning smell coming from it the other day and then realized that although I can hear water running into the dishwasher when I start it, it never actually runs in the sense that the water is pushed through the various outlets to wash the dishes. I'm assuming that it is because the unit is dry and the heating element is still coming on that it is causing a burning smell. If I open the unit and reset it, it pumps the water back out into the si


The problem sounds like it is in the water inlet selonoid. Pull off the bottom panel and this is the part that the main water line hooks to there is a selonoid and it has a plugg inconnection to it unplugg it and check for power when the unit is supp ... Dishwashers

We live on an island in the Caribbean and we have a LG dishwasher (model LDF 8812) that has worked fine for a year, but has recently stopped washing effectively. At first, the top part dishes were coming out still soiled from food. Now the bottom part dishes are coming out soiled as well. We checked both the Owner's Manual and the Service Manual and none of the troubleshooting suggestions appear to be relevant to our problem. The water here is very hard, and the water pressure is low and fluctua


You really need to replace the O ring . Could cause leaks and low wash pressure without it.You may also try running a solution of WHITE vinegar and water through the machine every six months as it helps desolve any lime scale (which is going to ... LG LDF8812 Stainless Steel Built-in Dishwasher

I have a Bosch dishwasher, model #SHU43C02UC/14, which has stopped working - no water enters the inside nor is there any drain cycle - just nothing. At the same time, I had to have the new control board put in as part of the Bosch recall. The tech comes out, puts in the new board - still nothing. He says something is wrong with the board even though the problem existed before the new board was installed. He takes everything back to his shop and tells me he's trying to contact Bosch tech support


... Bosch Dishwashers

Smasungdishwasher DMT610RHS error codeCE showsup. eventhough the is not locked in, it still runs with error code CE, but the water is not coming in. but the motor is running. unless I plugged out, it keeps running. I shut off, but not responding power ONOFF.no response to any button on the control pannel. but keeps running.


... Samsung Dishwashers

Our ESD310 has a message of OP on the screen. It will come on and run on its own if the door is shut, counting down from 2. When I can get it to turn on and start a cycle it runs a bit, skips a bunch of time, runs a little more, and then skips time again counting down from 2. The high temp wash button will light up on it's own while running. The cancel button does not work. It acts as if it has a short, makes funny noises, and I'm afraid it's going to catch on fire.


... Haier ESD310 24 in. Dishwasher

MAYTAG MDB7600AWQ DIAGNOSTIC CHECK USING CONTROL BOARD AUTO AND MANUAL, ARE GIVING ME A HIGH CURRENT WASH MOTOR DIAGNOSIS.(NORMAL WASH FLASHING) THE BOARD ITSELF CHECKS OUT OK. ALL FUNCTIONS WORK AS THEY SHOULD.WASHER FILLS THEN ATTEMPTS TO RUN FOR (ABOUT 3 SECONDS) IT WILL DO THIS 3 TIMES THEN BOARD GOES BLANK. ALSO, THE WASHER WILL FILL WITH THE DOOR OPEN??? BUT WON'T ATTEMPT TO WASH. REPLACE WASH MOTOR?? THANKS lYNN


I would agree.. Here is a site for you to copy and paste in your address bar that I think will be helpful:http://home.howstuffworks.com/how-to-repair-a-washing-machine.htm/printable ... Maytag Dishwashers

Sometimes I can run the dishwasher with no problems. Sometimes i will run it and leave the house and come back 5/6 hours later and it is still running on the wash cycle but it is only putting out heat and no water. So its drying up the soap on the dishes and not really washing anything, and it get stuck on that cycle


... Magic Chef 24 in. DU4500 Built-in Dishwasher

My dishwasher gets stuck on Hot Start option. It runs fine otherwise, but every time I use the hot start option, it just keeps running and won't automatically run through the entire cycle. I manually have to come back and turn the knob.


... GE Dishwashers

LG LDF6810ST had OE error. Disassembled found no obstructions blew air through and vacuumed hoses to air gap and to disposer, no obstructions. Never heard pump run when starting cycle, so replaced drain pump. Still doesn't run. Looked at the service manual, and the only other suggestion is repair circuit? Is this the circuit on the bottom right of unit or the pcb up top? Wires and connections all look fine. What else could it be. Any suggestions appreciated!


Hi,Usually my First Response to this Common Error is :-Most likely pump trap is clogged up. Access it behind small door at front. Drain water out through small hose that is there otherwise water will be all over the floor when ... LG LDF6810ST Stainless Steel Built-in Dishwasher

The dishwasher makes a horribly loud sound when running. I think it has to do with the lower "spinner arm". When I push it manually, it wobbles and makes noise. So I am guessing that spinning at higher speeds would cause much more noise. Can I fix it?


It's noisy\015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012\015\012\011\015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012 ... Whirlpool Dishwashers

Made funny noise while running; opened the door and removed some items; now won't run at all; both sprayers are free and turn; all lights on panel will come on; will not start when restarted or cancelled; water still in bottom.


Set the controls to off then power off at the mains for 30 mins and then power mains back on and run a drain program or a full wash program. If the water won’t drain away than the most likely problems are the door interlock switch is faul ... Dishwashers

My KitchenAid dishwasher (model KUD101TJWH0) suddenly is making noise from the motor area while inputing water into the unit, whether in the rinse or washing cycles but makes no noise in the draining cycles. I have pulled the unit out while still connected, cleaned any debris from the filter screen below the lower water spokes and can hear the noise very plainly by the motor but I know how sound can travel with the piping. Is the sound only coming from the electric drive motor attached to the


... KitchenAid Dishwashers

Dishwasher Worked Fine For Many Months. Really Quiet. Started Making Loud High Pitched Noise When Running. It Still Runs Good And Cleans. But, The Noise Is Very Noticable.


We had the same problem, started at low level and progressed to the point that we only ran dishwasher late at night. Picked up a motor / pump assembly for $110.00 from a local parts store. Was a very easy fix actually. Only 1 screw mounting motor to ... Kenmore 24 in. 16032 Built-in Dishwasher

I have a bosch millennium series SHU9905UC. There is still water at the bottom of the dishwasher from the last time it was run. I think it may not have completed the cycle as a few bowls were still dirty. Now when I try to put the washer on and press a cycle, no light is coming on at all. It seems dead. Is there anything I can try before calling in service people?


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1562 seconds