Having problems with your Hobart 24 in. LXIH-3 Built-in Dishwasher ?

Hobart LXiH Add Detergent

\015 Hello everybody, \012i have a hobart lxih dishwasher. When i turn on the system i have seen `sump temperature` (75 F) and ADD DETERGENT on the display even if the detergent bottle isn`t empty all the time. Also i am not sure that if `sump temperature=75 F` is ok for this machine?? Should it be higher like 110 F ??\015

Answers :

Repair Help & Product Troubleshooting for Hobart 24 in. LXIH-3 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hobart LXiH Add Detergent


... Hobart 24 in. LXIH-3 Built-in Dishwasher

Hobart lxi detergent dispenser reprogramming - Hobart 24 in. LXIH-3 Built-in Dishwasher


... Hobart 24 in. LXIH-3 Built-in Dishwasher

Hobart lxih everytime i add soap i get a service code e4 and the machine stops shut the machine off and it restarts just fine add soap and shuts down i use a powered saop made for under the counter dishwashers even when i run a delime agent thru the machine it the does the same what to do thanks for help david


E4 indicates water level has not reached top water sensor. Check for proper flow-water pressure to machine (15-25psi) and clean sensor in wash tank ... Hobart 24 in. LXIH-3 Built-in Dishwasher

I am on the ship, we purchased Hobart AM-15-5 door type dishwasher. Hobart did not provide the detergent dispenser (because they do not make them) and we do not need preloaded ones from Ecolab. Is there a manufacturer that makes only the dispensers that we can fill with our own detergent and that are compatible with AM-15-5? Where can we find it?


You have a few options for getting commercial grade detergent pumps which can be used with commercial dishwashers like Hobart.\015\012\015\012In case you do not have the manual for your dishwashwer you can get it ... Dishwashers

Hobart lxih error code e7 - Hobart 24 in. LXIH-3 Built-in Dishwasher


... Hobart 24 in. LXIH-3 Built-in Dishwasher

How to add detergent in the dishwasher (frigidaire)? there are two placeholders. one of them is covered. add detergent in both? Close the cap or not?


Detergent in one... finisher in other, yes close them both ... Dishwashers

Hobart LXIH dishwasher


You can add a small amount commercial dish soap to the wash chamber before pressing the wash button. ... Hobart 24 in. LXIH-3 Built-in Dishwasher

Hobart LXI you seem to know a lot about the hobart, maybe you can help me. My hobart Lxi high temp is just now out of warranty, i am mechanically inclined, and need to adjust my detergent and rinse aid pumps. How difficult is this and how can i go about doing so. Both the pumps are running too much product.


Question--As of today if you look at the display does it read add detergent or add rinse aid?Im asking you this because theres a chemical pump circuit board that senses the chemicals on this d/w.And if the d/w displays those the d/w will keep dumping ... Dishwashers

Detergent error I keep getting add detergent message. The bottle is not empty, the pickup line is submerged in the detergent & it tests acceptable. i also get an E7 error code once in a while. Thanks


I'm a hobart tech---been away for awhile.What is the model lxih,lx30?Let me know if you still have a problem with it. ... Hobart 24 in. LXIC-5 Built-in Dishwasher

I have Hobart under counter hot water dish washer with out a detergent dispenser I'm using Eco lab finish detergent I'm putting in 1/2 table spoon per load and am destroying the finish on my aluminum platters and filling my 18/8 s.s. Flatware Ecolab says finish is safe for all metal surfaces Am I using too much detergent per load


Hi\015\012\015\012 \015\012\015\012Yes you are right, using too much detergent can cause this\015\012issue, use less then half table spoon, if the issue remains then the problem is\015\012with the unit not getting enough water or ... Hobart 24 in. LXIH-3 Built-in Dishwasher

Hobart lxi8h e3 error - Hobart 24 in. LXIH-3 Built-in Dishwasher


... Hobart 24 in. LXIH-3 Built-in Dishwasher

Whirlpool Dishwasher GU2548XTP- Dishes still dirty after it has run, especially the top rack. 5 (?) yrs old. Runs and grinds intermittently, no water seen under unit. Sometimes I add more water when it grinds, then it runs very quiet. Sometimes it doesn't seem to fill enough. Water supply good, inlet screen inspected not clogged. Not a lot of pressure shooting the water around the inside of the unit, as the detergent that bleeds through the slotted half of the detergent flip door isn't r


The inlet valve is OK, therefore the control board was not the problem. The impeller pump is noisy and inefficient, and must be replaced.Here is the part: ... Dishwashers

E3 Error code on hobart lx30 dishwasher. - Hobart 24 in. LXIH-3 Built-in Dishwasher


... Hobart 24 in. LXIH-3 Built-in Dishwasher

Hobart dishwasher door will not shut - Hobart 24 in. LXIH-3 Built-in Dishwasher


... Hobart 24 in. LXIH-3 Built-in Dishwasher

Hobart LXi, e5 error code - Hobart 24 in. LXIH-3 Built-in Dishwasher


... Hobart 24 in. LXIH-3 Built-in Dishwasher

I have a Hobart LXI glasswasher which is using too much liquid detergent. Can you tell me step by step how to adjust the detergent pump.


... Hobart 24 in. LXIH-3 Built-in Dishwasher

Hobart dishwasher AM15-2 This machine is installed and we need to install detergent and rinse chemical. How does this detergent get introduced into the machine? We had 1 gallon containers left here but I can not see how they can work,


... Hobart AM15-2 Dishwasher

HOBART LX-30 P2 ERROR CODE - Hobart 24 in. LXIH-3 Built-in Dishwasher


... Hobart 24 in. LXIH-3 Built-in Dishwasher

LX-18 Hobart need 2 detergent pumps. Can I buy these aftermarket or must they come from hobart


... Hobart 24 in. LXIC-5 Built-in Dishwasher

Hobart lx18 no power to detergent pump, during the wash cycle there is no power present at the connections for the pump, during the rinse cycle the sanitizer terminal will pulse power and the rinse aid and sanitizer pumps will run, is the relay board bad? With the top drawer open and running the led for detergent never lights up during the wash cycle.


You have to go into program and activate the detergent pump.sounds like somebody deativated the det. program ... Hobart 24 in. LXIC-5 Built-in Dishwasher

Hobart LXIH won't complete delime cycle. Enters delime mode and executes the delime cycle properly until about a minute or so into the rinse phase. Machine shuts off abruptly with E5 code mostly, sometimes E4 code. Changed the control board, didn't solve the problem. The LXIH runs the normal wash/rinse cycle every time without any problems. This is a nearly new machine that actually don't need delimed, planning on selling it and it must work perfectly. I know some would program the delime notifi


... Hobart 24 in. LXIH-3 Built-in Dishwasher

Recently my Maytag dishwasher has been leaving glassware filmy and not cleaning silverware and dishes as well as it had previously. I had a repairman look at it and he said I should use the "accu temp" setting for hotter water. I've used two dishwasher cleaner products and nothing has improved the results. I've heard that dishwashing detergents no longer contain phosphorus and that is the reason the glassware looks milky. Is there something I can add with the detergent to remedy this problem o


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... Maytag Dishwashers

Maytag Dishwasher model Number DWU7802AAM. purchased 1996. We add detergent to the Main Wash cup and now it does not open to release the detergent during the wash cycle. Never had this problem before.


There is a small motor on the back of the cup, inside of the door. This is a wax motor. It is a small red plunger style motor with two electrical connections. If the mechanism is not worn or broken then the power to the motor needs to be ... Maytag Dishwashers

Hobart glass washer lxi error code e3 - Hobart 24 in. LXIH-3 Built-in Dishwasher


... Hobart 24 in. LXIH-3 Built-in Dishwasher

How to clean probes lxih - Hobart 24 in. LXIH-3 Built-in Dishwasher


... Hobart 24 in. LXIH-3 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0440 seconds