Having problems with your Hobart AM14C-155 Dishwasher ?

Need to know AM 14 rinse cycle water useage

\015 I need to know how much water the rinse cycle uses at a given pressure--for example, 20 psig, or whatever . Does anyone have any data they've measured (or calculated)? I don't have the service manual in front of me as I type this, but I believe the rinse cycle is relatively short, like 10 seconds.\015\012\015\012THANKS!! Lee\015

Answers :

12 second sof rinse used about 0.8 gallons at that presurre
Repair Help & Product Troubleshooting for Hobart AM14C-155 Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Need to know AM 14 rinse cycle water useage


12 second sof rinse used about 0.8 gallons at that presurre ... Hobart AM14C-155 Dishwasher

Hotpoint dishwasher machine go's through wash cycle, through to the end, after dry cycle ends there is always 2 inch's of water left in it that doesn't drain out' but some water is added when new cycle is started, then throughout wash cycle whenever water drains it never drains completely, always leaves 2 inches of water before adding more water to begin rinse cycle. what do I need to do?


... Dishwashers

Our 8 year old integrated 2 draw dishwasher (top draw) has a problem on the rinse cycle and constantly beeps and water at the bottom of the draw remains. I have cleaned out all the grit and stuff residual water and tried to use again. But alas there appears to be a blockage still on the rinse cycle. Can you help or do I need to get a plumber? Thanks...Louise


Sorry i lost you my breaker tripped ... Dishwashers

Leaking dishwasher The dishwasher leaks a stream of water at the base -bottom left corner whenever it goes into the final rinse cycle. It does not leak when it is in the wash mode. This leak just seemed to develop suddenly. There was no build up -ie a small stream of water. I just noticed a big puddle on the floor one day after dishwasher had completed its cycle water leak in the left side ,bottom ,husband states a small drip,drip and we do not know what to do or replace. No water standing


I just had this same problem and it was caused by a small plastic seal on the bottom of the door. My friend owns an appliance store and he said this is a common problem for this model of dishwasher. The part was $68 and the labor was $60. I could ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

KitchenAid dishwasher KUDS24SEBL does not drain after rinse. It goes through wash cycle, drains water completely , then it fills water for rinsing, runs and after that it does not drain. Cancel does not work after that. Water is very hot inside the tuba t that time. The dishwasher needs to be left for an hour or so before the cancel button can drain the water out.


... LG LDF6810 Built-in Dishwasher

Hi, my name is GAD. i work at a conference center. our model is quite an old version of the MH65-70 - maybe 1985? How do you adjust the water temp for both the rinse and wash cycles? the gage reads too hot. we have someone here who can service it, knows how to work the electrical, but does not know where to adjust the water temp. Is it a dial? a bolt adjustment? how do we lower the water temp sensor?


Hello Gad\015\012Send me the serial No. of your unit and let me see whether we are talking the same machine. \015\012The one I'm talking about have 3 thermostate with dial to adjust the temperature 1 for Hi temp safty no dial fixed tempe ... Moyer Diebel 28 in. MH65-70 Free-standing Dishwasher

Hello, my Hoover D7610 dishwasher has developed a problem, I would appreciate your advice.On starting a wash it appears to be working OK through what I believe to be a rinse cycle but then after about 20 minutes water pours out from the bottom of the door. Manually clicking the timer-programer forward stops the leaking but the machine needs manual advancement except for the last 2 cycles when the timer seems to work OK. After the 1st cycle there is no more water leaking from the machine but all


... Hoover Dishwashers

My KitchenAid dishwasher (model KUD101TJWH0) suddenly is making noise from the motor area while inputing water into the unit, whether in the rinse or washing cycles but makes no noise in the draining cycles. I have pulled the unit out while still connected, cleaned any debris from the filter screen below the lower water spokes and can hear the noise very plainly by the motor but I know how sound can travel with the piping. Is the sound only coming from the electric drive motor attached to the


... KitchenAid Dishwashers

It went thru the whole cycle and when I opened it up - there was water still left in the bottom - hit the cancel/drain button and nothing happened. Unhooked the drain line to the drain pipe under the sink and no water came out. How do I find out if it is the pump ? If I take it out - what do I need to look for and what trouble shoot things do I need to know. I live about one hour from the nearest town - so I would like to find out the problem - before I call a repairman and maybe fix it myse


... Kenmore 24 in. 17462 / 17464 / 17469 Built-in Dishwasher

Kenmore 17369 When cycle starts... it sounds terrible (crackly sounding).... doesn't sound like the water is coming into the dishwasher. If I add water to the machine during a rinse cycle...it will wash and drain on its own.... Then I hit cancel. Please help.. I can't locate the owners manual.. Do you know where I can get one.. I understand that you can open the bottom up and see if there is anything lodged in the bottom of the dishwasher. Please help! thanks Cheryl


The problem is your water inlet valve. If you remove the panel at the bottom of the dishwasher you will see\015\012either a copper hard pipe, or a flexible steel hose leading into the\015\012water inlet valve.BE SURE TO CUT OF ... Kenmore 24 in. 17362 / 17364 / 17369 Built-in Dishwasher

I am buying a hot water heater for my dishwasher A hobart am14c model, need to know how much water is needed for the entire wash/rinse cycle?


... Hobart 42 in. AM14C-154 Free-standing Dishwasher

Bosch Dishwasher My 8 year old Bosch is not draining. It will not go past 1 minute on the rinse cycle, and 13 minutes on the regular cycle. For the past few weeks I have noticed a lot of bubbles in the bottom of the dishwasher after it is done, but it was draining. Now it's full of water and will not go past the 1 minute mark. I need to fix this, I can fix this, I just need some expert advise on how to do this myself. Thanks!


What is the model #?... there are 2 buttons when pushed together it will drain the water out..try the button to the left next to power scrub... and economy...hold the 2 buttons for 3 sec. you will hear you drain pump running.. if you don't hear any ... Bosch 24 in. SHU43 Built-in Dishwasher

My GE dishwasher drains fine after wash cycles. However, After rinsing, about 2 inches of water is left in the tub. The drain runs for 30-35 seconds at the end of each wash cycle, but only 4-5 seconds after the rinse. What do I need to do to fix this?


Many dishwashers use a drain valve with an electric solenoid. When electricity flows to the solenoid, the valve opens and diverts the water to the drain. Sometimes the solenoid, or the diverting lever, sticks and prevents the dishwasher from dr ... Dishwashers

Ok i need help i have a Hobart C44A and it is not rinsing at all could this be the final rinse solonoid valve all the machine does is alarm out cause of no rinse. I checked in side to make sure that it isnt our controler and there is no rinse water coming out of the jets. I know that the actuator is working properly to tell it when to rinse or do i have a bigger problem


... Dishwashers

My Kenmore built-in dishwasher is running its cycles normally, but no water is coming into the machine so it runs the cycles dry (even a rinse cycle). Can you advise? If a part is needed, is it an expensive one? Thank you!!


Sound like the inlet water valve is to blame here - or else the main controller board relay is not telling it to open. Further testing will be necessary to determine which is the cause.If it is the board - you are better off getting a new ... Kenmore 16602 / 16604 / 16609 Built-in Dishwasher

Hobart LXIH won't complete delime cycle. Enters delime mode and executes the delime cycle properly until about a minute or so into the rinse phase. Machine shuts off abruptly with E5 code mostly, sometimes E4 code. Changed the control board, didn't solve the problem. The LXIH runs the normal wash/rinse cycle every time without any problems. This is a nearly new machine that actually don't need delimed, planning on selling it and it must work perfectly. I know some would program the delime notifi


... Hobart 24 in. LXIH-3 Built-in Dishwasher

Long cycles My dishwasher (approx 7 years old) will run in the wash cycle for hours...until I physically turn the nob to "rinse"; then it will stay in that cycle until I advance the knob to the final (expel water) stage. I checked the filter and the blades - no obstructions. Also, when completed, the dishes are hot, so I know the heating element is working.


Http://www.thisoldappliance.com/library/bosch_dw_guide.pdf\012\012\012 ... Bosch 24 in. SHU43 Built-in Dishwasher

No rinse My KitchenAid KUDS25SH washes, but there no water for rinse cycle iT is Whirpool, and will wash bt will not rinse. Problem just started after someone that did not know how operated it. What can I do.


Put it on the rinse cycle and shut off , cycle.\015\012Reset the breaker .\015\012Vitally\015\012 ... Whirlpool GU2700XTSB / GU2700XTSQ / GU2700XTST Built-in Dishwasher

Drainage problem My dishwasher drains on every cycle except for the last rinse cycle, so I know it isn't clogged. I always have about an inch of water in the bottom of the dishwasher when it completes the last cycle.


My hotpoint dishwasher hda487a-01 is not pumping out the water ... Hotpoint 24 in. HDA3740G Built-in Dishwasher

AM-14 rinse cycle water useage


The psi should be in the green on the gauge,20-25.The 10 second rinse cycle is the default setting. ... Hobart AM14-253 Free-standing Dishwasher

I need a manual for prestige pfd12ssu dishwasher and more urgently I need to know how to rinse once the dishwasher has been accidentally switched off before it has finished its cycle


... Dishwashers

I need a manual for prestige pfd12ssu dishwasher and more urgently I need to know how to rinse once the dishwasher has been accidentally switched off before it has finished its cycle


... Dishwashers

My PDW9280LOSS GE Profile diswasher runs and cleans fine. However, the high heat(sanitize cycle as well) does not finish ther job. A while back I changed the element due to hard water damage. I beleive I need a control module and I need to know if there is any sequence to reconnect for reprogramming (the new one)it? Or anyother ideas? Thanks


Hi,Before replacing that module I would check for power at the element first to confirm that there is no power....coming from the module...As far as the change out goes... just make sure the power is off when changing... then ... GE 24 in. PDW9280LSS Built-in Dishwasher

KitchenAid KUDC25CH Dishwasher Just installed a new control board, last week after some lengthy emails we decided it was probably the control board , control board in now in, as far as I know the dishwasher cycles thru all three of the small lite rinse buttons ad it may have finished completely, there wasno water in the bottom of the washer so all was pumped out and the dishs were dry......the large rinse button on the panel is blinking. I open and close the door but the light contiues to blink


The system does not allow me to view what other consultants have suggested to you about the problem with your dishwasher.\015\012\015\012Before you try anything else, get a Finish dishwasher cleaner kit from the supermarket and run the di ... Dishwashers

Dishes on top rack on not getting clean on the outside e.g. the outside of an inverted cup is dirty and dirty water is collecting in depressions. There doesn't seem to be a mechanism to rinse the dishes from the top. Also water not hot on any cycle so probably need a heating element. Where can I purchase one near 85204 zip code


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... Ariston Technologies L63SNA Stainless Steel Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1839 seconds