Having problems with your Hobart Dishwashers ?

No power working on a hobart modal sr24cdishwasher I have no power to the incomeing water solenids


Answers :

Hi,
\015\012
\015\012Have you actually tested with a voltage meter to see if there is power to the connections on the solenoids?
\015\012
\015\012Firstly check the inlet tap, there maybe a filter that is blocked. make sure water flows out into a bucket from the tap
\015\012
\015\012If there is power across the connections then the electronic unit which controls the dishwasher is working ok and the solenoid is mechanically stuck closed. If there is no power then you will need a new electronic unit.
\015\012
\015\012of course the electronic unit only sends a signal to the solenoid valve when the unit calls for water so you would have to watch the voltage meter as you run the unit.
\015\012Also the unit will not fill with water if the previous step in the cycle wasn't completed. for example if the unit doesn't drain then it won't fill with water.
\015\012Hope this helps
Repair Help & Product Troubleshooting for Hobart Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

No power working on a hobart modal sr24cdishwasher I have no power to the incomeing water solenids


Hi,\015\012\015\012Have you actually tested with a voltage meter to see if there is power to the connections on the solenoids?\015\012\015\012Firstly check the inlet tap, there maybe a filter that is blocked. make sure water f ... Hobart Dishwashers

Hobart LX30 Hey I just bought a Hobart Lx30 and we don't have a power source that can handle the 50 amp requirement. We got it at an extremely good price so we are trying to work around it. I was told that disconnecting the water heater would allow it to work in a standard 120 volt outlet. I did that and now I have another issue. The machine wont run unless the water is 160 degrees. How do i disconnect the sensor that restricts the temp so that I can run the machine at a lower temp?


Hopefully you took the suggestion to run the correct 50 amp 208-240 service to the unit.Converting the unit to an LX30C has a couple of pitfalls. The LX30C is connected directly to the incoming water supply, which should run 120-140 degre ... Hobart 24 in. LXIH-3 Built-in Dishwasher

My Delonghi Dishwasher keeps turning off. The dishwasher is turned on at the power point. The water is turned on. Okay When I press the POWER botton on the front it wont stay on. I have to keep my finger on the POWER button and then press the START button for washer to work. If I do this it will then pump out any water in the bottom and start to work. ***BUT when you take your finger of the POWER button the washer just turns off and stops working. Do you have any idea what could be the problem p


Yes, the power button is faulty. by pressing the power button forcefully, you are in effect allowing the contacts to close. Replace it. ... Dishwashers

Hobart commercial under the counter diswasher LXIC Model Number 130016. DELIME light comes on every day at startup. Machine will immediatly run (in DELIME mode I think) for about 5-10 min and then get E4 error. We unplug power to the unit let it set, replug it back in after 3-4 cycles of this, it will eventually work perfect for the entire day. I have replaced the Sensor that is on bottom front of the unit in the water trough. ( I replace the sensor to the right if you are looking at the un


Q have your run a descaler . to rid the machine of its deposits . in order for the machine to run properly the parts and pump / screens must be clean . / descaling for deliming . dishwasher and icemakers is comm ... Hobart LXIC-6 Dishwasher

I have error E:15 with a flashing water tap sign - I've tried the following: a) Clean filter at the bottom - now flushes out with b) remove power - return power c) remove and clean fiter for incoming water at a sort of valve Nothing! when I attach power it continues to flush out (even without water) if I put water in it evacuates without problems. The tap does supply water I've check and with more than sufficent flow and pressure! ...Help .....Thanks Gary


Hello Gary,\015\012\015\012You didn't specify the brand or model number of the dishwasher, but I suspect it's a Bosch, in which case the E:15 error with the flashing tap sign and the drain pump running continuously means the anti-flood pr ... Dishwashers

I just bought a used LG LDS 5811ST stainless steel built in dishwasher. The previous owner said he bought it 4 years ago. It's in great shape but doesn't work. It powers up but the water is not pumping into the dishwasher. The previous owner said that he thought it was the pump. He said he took it apart once and cleaned a bunch of crud out of some hoses and it worked for a while then started making funny noise and stopped. When i got it home i powered it up and connected water hose. It seems to


Rom the Service Manual:"1E INLET ERROR Not reached to the normal water level in spite of 10 min. water supply.The Hall sensor is OK?Check the frequency of Inlet Water by the Test Mode." ... Dishwashers

Hobart LX30H leaking at door. Power drain works.


Leaking at the bottom edge of the door can be caused by the lower spray arm having a split or crack which allows water to spray directly at the lower door instead of up. A close inspection of the lower arm or watch it work with the door open. You'll ... Hobart Dishwashers

I have a washer model 1805 (1800 PSI). Everything works but there is always leaking of water (sprays) when I use it. The leak is not from where the water hose connects to the washer, but where the black piece attached to the hose is connected to the body of the washer. I can still do a decent job of power washing, but am wondering if the leaking of water is reducing the power of the washer.


Yes, leaking water will reduce the pressure. Sounds like you need to replace the O-Ring inside the connections on the pump. This is where the pressure hose connects to the pump. If you look carefully inside that connection you will see an O-Ring. Use ... Campbell Hausfeld PW1805 1800 PSI 15 GPM Pressure Washer

Matsui mf145 my dishwasher not working power& water on power light on next 2 light on but can't program it not been use for last 18 months


... Dishwashers

Kenmore model 16309. The dishwasher has power and water but the motor does not seem to be working. It hums for a second, but quits. The timer is working and the water seems to be coming in fine. but the arms are not turning. Any thoughts?


Hi\015\012\015\012 \015\012\015\012The timer is working, unit has power and it also fills\015\012water, all this indicate that it is the motor that is bad and should be replaced\015\012to solve this issue. Moreover, the hum sound ... Kenmore 24 in. 16309 Built-in Dishwasher

Hello, We have a Candy Diswater that is just arround 2 years old. When it starts it takes water and then you hear the washer going into loop. It tries to do something els but doesn't seem so. If you open the door you can see water inside but no progress or heating. If you also try to change the program it doesn't change as well. Before it got to this point sometimes we used to unplug the power and tunr it off and then ON and then it works. However, now this procedure is not working an


Quite possibly could be the timer and could also be the main control board as well. Sometimes unpluging it will help for short times but if a serious problem persists it will only be a temp fix... ... Dishwashers

Ken wood kdw60w10 dishwasher no hot water, there seems to be no power to the inline heating element, showing 30ohms resistance and power directly applied when removed from the dishwasher and it heats up. No fault codes on panel, works normally apart from no hot water, any other ideas? Many thanks


... Dishwashers

I am working with a Hobart C44A diswasher with a 15KW water basin heater and a Hobart bosster heater. What is the minimum water temperature I can supply to the dishwasher and maintain 160 rinse temperature required?


Hi,140F min water entering temp.http://www.instawares.com/Prod_PDF/HOB-C44A263.pdfheatman101 ... Hobart AM14-253 Free-standing Dishwasher

Quit working during wash cycle, about 6 liters of water left in bottom, looks like it quit during rinse cycle. There is power to the door switch and door switch works shutting off power when door is opened. However the control panel does not respond to any push button. I have had a problem in the past with moisture from the door vent getting into the control panel area causing the push buttons to become eratic.


The capacitors in the control panel could be bad or have burnt out. Do check all connnections and if necessary, check the continuity of the power to and from the control panel with an ohm/voltmeter. ... Dishwashers

I have an Electrolux EIDW 6105GB1. The washer fills with water then immediatly drains back out, the lights all flash and the trouble code light under the kick panel indicates the wash pump. It has done this before and I took the pump out and checked it with power direct, then returned it to the main control board plug and it was working and pulsing it's speed as it should. It worked fine for several weeks and now it's doing it again. Is it possible that there's a problem with the water float ins


Hi\015\012\015\012The issue is either with the wash pump that is going bad or\015\012the motor itself that is unable to run. As the washer fills and then drains\015\012immediately so the pressure/float switch should also be checked. Hope ... Electrolux EIDW6105GW 24 in. Built-in Dishwasher

No Water Coming Into SHU43C05UC/12 Bosch Dishwasher: We have a Bosch Dishwasher, model number SHU43C05UC/12. It has been working for more than 4 years, but yesterday I notice that although I hear a motor sound, there is no water in the dishwasher. The LED display on the panel seems to be working all right. I ran a diagnostic pressing and holding Power Scrub and regular wash button then pressing the on/off button. Got C1 at start then P0 and the Regular wash and Quick wash flashing on/off. How c


... Dishwashers

My dishwasher is a powerpoint tw 23 and will not work, there is power to it, water supply and has recently stopped working. at first pushing the door in after shutting it closedt worked but not anymore. the latch is working fine also. can you please help kind regards Conor


... Dishwashers

My dishwasher model number kuds30ixbl2 isn't working at all. Went to load it to find standing water in the bottom and none of the lights work. There is power to the dishwasher though


... Dishwashers

Our Dishwasher is not draining. We tried to run a test cycle and noticed there is no power. We checked the Electrical Panel and noticed that an unmarked breaker was tripped. We turned it on but still have no power. All other electrical items are working in the house. Is the power being cut off as a fail-safe function due to the water not draining? How do I fix the drain/pump? Please Help!


Hi,No, the water is a result of the dishwasher going off mid-cycle...Take the front kickplate off and see if you have power at the makeup box...you will need an electrical meter to check that...if there is power there then you have ... Dishwashers

No power dishwasher stop working in middle of cycle. water still in the bottom no power,lights nothing .there is power coming from panel


Check the thermal fuse located on electronic control 2 inch square fuse problalby no continuity through it, Replacemant comes with wires attached and instructions for installation ... KitchenAid KUDR01TJ Dishwasher

Karcher 2.35. used it for about an hour, working fine. Suddenly motor stopped. Checked fuse and conections...all good but no go. Disconnected water hose and gave it a rest. As I was putting it away, connected to power and motor worked. Connected hose and motor won't work!! HELP! Thank you, Cliff Taylor


... Karcher Pressure Washers

So I found this power washer for sale. The seller claims that the washer generates a good stream of water, not just full power. He also mentions that after a few minutes the engine starts to bog down like it is working extra hard. Does this sound like a pump issue? Could something be clogged or would the pump need to be replaced? Or should I avoid this power washer?


Don't buy a power that doesn't work.There are many expensive parts on a power washer. If it was cheap and simple to fix, the seller would fix it and the washer would not be for sale.Would you buy a car that doesn't work? Especially ... Pressure Washers

My hotpoint hda3220z07bb has no power at all , turning the timer dial gets no response at all, but I do have power to the motor, water inlet and the interlock works fine, the unit appears dead but there's power there.


CHECK DOOR LATCH OR TIMER BAD ... Hotpoint 24 in. HDA3400G Built-in Dishwasher

GU1500XTLS3 Periodically won't start. Dishwasher has power because pressing cancel causes dishwasher to start draining (even though there is no water). Door switch works because opening door prevents starting drain cycle. No other button on control panel will work except for the 'air dry' / 'lockout' button. Turning off circuit breaker for 15-30 minutes and then turning circuit breaker back on seems to fix the problems but only for a couple uses and then it stops working again. Need ad


This could be the 'fill switch', which is the level sensor. Could be a plastic tube that exerts air pressure into the tube as it fills, make sure it's clear and open. The dishwasher has a sensor that monitors the door being closed too. Some use a hig ... Dishwashers

My dishwasher stop working in the middle of washing cycle. The water has not drained out completely. I attempted to restart the dishwasher but it appears there is no power. I checked the power auto swithch/fuze on the master fuze board. There is still no power going through the dishwasher.


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1249 seconds