Having problems with your Hobart SR24C-4 Dishwasher ?

Where do I get a lower door gasket for a Hobart SR24C dishwasher?

\015 Hello,\015\012The dishwasher leaks out both lower corners of the door whenever we run it. The gasket on the lower part of the door is completely gone. Where do I get a new one?\015

Answers :

A common fault with Hobart dishwashers leaking from the door, is the cleaning plugs dropping out from underneath the wash arms. It causes wash pump water to spray on to the bootom of the tank, and when the arms rotate to a point near the door, it tends to spray out from the air gap at the bottom of the door. The diagnosis by Absolutserv is also correct, the gap is crucial to allow an air gap for thermal expansion. Hope it helps. Simon.
If I'm not mistaken, there is no lower door gasket. Typically, DW doors don't seal. Due to the temp of the water, when you load a rack a burst of cold air is also loaded in the machine. The DW starts a cycle and cause the air to warm and expand. The doors will always gurgle during a cycle.
\015\012
\015\012The key to reducing this is to make sure the level of the unit it proper. Slightly higher in front. The front lower channel should guide the water back into the unit. Also, don't leave the door open unless you're removing or starting a rack. The warmer the cavity stays, the less the air will expand.
Repair Help & Product Troubleshooting for Hobart SR24C-4 Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Where do I get a lower door gasket for a Hobart SR24C dishwasher?


A common fault with Hobart dishwashers leaking from the door, is the cleaning plugs dropping out from underneath the wash arms. It causes wash pump water to spray on to the bootom of the tank, and when the arms rotate to a point near the door, it ten ... Hobart SR24C-4 Dishwasher

We have a hobart sr24h dishwasher which is leaking around the lower portion of the door. Should there be a gasket that runs around the inside tracking of the door or machine and not just across the top?


Hobartcorp.com under service tab click parts then smart parts system tab ... Hobart SR24-H Built-in Dishwasher

Door leak The dishwasher is 2 and half year old and is randomly leaking for at least one year or even more. The leak originally occurred at both lower ends of the door, close to the hinges. The leak was about one liter and the door panel sound insulation soaked with water. After door panel was removed, the leak location was identified at both ends of the lower door gasket. The outside part of the U-shaped gasket was filled with water, and eventually water was spilled on the floor. The leak can g


I had the same problem. On the right side of the tank in Bosch dishwashers there is a steam port. If you place a large object in the right hand edge of the tray, a pressure build up causes the leak. Put large stuff on the left and you should be good ... Bosch 24 in. SHU5305UC Built-in Dishwasher

I don't have a model number right now, but the front door on my Admiral dishwasher is leaking at the bottom. I have changed the gasket inside the door panel at the bottom but it still leaks. This is a rental property and the renters did a job on this dishwasher. I was wondering if they may have pulled another lower gasket off that I didn't know existed. Something like a windshield wiper. The seal I changed was a foam strip 3 x 22 approx. Thanks for your time, Joan


It may not be the door that is leaking if this is an older admiral or whirlpool dishwasher the lever that holds the soap door closed has a little rubber seal that after time will let water in during the wash cycle it the runs down the inside of the d ... Admiral Dishwashers

Whirlpool dishwasher leaking from bottom of door between inner and outer door. Replaced door gasket. float and float switch working. Pump working, tub draining properly. leaks without adding soap or dishes too. Will a bad pump gasket cause water to get between inner and outer door?


... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

We have a Kenmore portable Dishwasher one and a half years old. It ran fine for about 6 months then we saw a water leak from the lower right hand corner of the door. I cleaned the door gasket. It stop leaking for a while. It started leaking again. Cleaned and rest the door gasket again. It is still leaking. Unit drains fine and all other functions are correct. What is the fix?


... Kenmore Dishwashers

I have a Whirlpool DU8500XX3 dishwasher and it began to leak water in the lower right corner of it. I replaced the door gasket but it still leaks at the corner. Would you know whatelse might be causing it to leak only at the lower right corner of the door?


Re:"Would you know whatelse might be causing it to leak only at the lower right corner of the door?"Yes: the overfill switch. Dishasher seals leak only when the gasket ir really worn or when the overfill switch is defective.Replace ... Whirlpool Dishwashers

Hobart Kitchen Aid dishwasher KDS-58. This washer is a champ. Recently it started leaking water from the lower left corner of the door, while the washer is in the wash mode. I replaced the lower seal, below the door, the seal is installed correctly. Not sure what to do next?


... Dishwashers

Hobart sr24c door leaks - Hobart SR24C-4 Dishwasher


... Hobart SR24C-4 Dishwasher

My bosch shx43c05uc dishwasher is leaking from lower door...have taken apart and can see water run into lower door gasket immediately..and onto the floor...any ideas? thanks


... Dishwashers

Door leak I have a small leak between the bottom of the dishwasher door the lower service panel on the dishwashere. I did replace the seal on the inside bottom of the door along with the other parts that come with the door seal. Could there be a gasket leak around the detergent dispenser or the vent at the top of the inside of the door. I did not check the water lever as was mentioned in a previous question on water level, but the float does move up and down quite freely. Any suggestions as to w


I had my dishwasher leaking alot at the bottom of the doo,r and found out that the steam vent was very cloged with gunk. After taking the vent cover off on the inside of the door and cleaning, then putting the vent cover back on NO MORE leaking. Th ... KitchenAid 24 in. KUDS25 Built-in Dishwasher

GE Potscrubber 650 Dishwasher, 13 years old. We want to take the front lower panel off to move the motor fan by hand, as you described for glideston'es post, but we can't figure out how to get the panel off. A repairman told us to remove the three screws at the top of the lower panel -- but they are too close to the upper door panel. The space between the two panels is not big enough to fit a screwdriver or any other tool we can think of. How do we remove the lower panel?


Homeowner with this model:\012I believe you would need to take the door loose by removing the screw on each side of the door near the bottom on the outside. \012\012I would recommend removing the unit whole instead. That way you don't n ... GE Dishwashers

My Kenmore under counter ultra wash dishwasher model 665.15825691 has started leaking at the lower corners of the door. The leaks seem to occur during the final rinse while the water is being heated. I have tried cleaning out the door bottom and the tub edge where the door and tub interlock. There is no gasket in this area.


Happened on my dish washer too. Remove lower rack, remove lower spray arm by removing the center plastic nut, check screws (torx) on outside edge of pump. Tighten these as necessary, mine were loose causing water to spray forward against the tub c ... Kenmore Dishwashers

My Magic Chef Dishwasher, Model DU2JV, leaks badly from the lower edge of the door. The gasket, which runs along the top and sides of the machine to seal the door at those points, seems intact. Please advise since I cannot use the machine as it is.


Hi,\015\012I had to replace the gasket on my own dishwasher and many others even though there was no visible reason why it was leaking. But first check the float switch, that also can allow the water level to get too high and cause it to leak. ... Magic Chef Dishwashers

I have a kenmore model 587.15193400 dishwasher and I need to replace the bottom door gasket. Do I need to take the door apart to get to it?


... Dishwashers

We bought a used LXi hobart dishwasher , it leaks water around door, is there supposed to be a gasket around door


... Hobart Undercounter Dishwasher, Hot Water Sanitation, Fresh Water Rinse, Delime Notification-LXIH-4

The insultation on the bottom of the door is wet. My repairman said water is getting behind the soap dispenser and the rubber gasket around the dispenser is hard. The dishwasher is only 4 years old. Is this possible. The insulation at the bottom of the door is wet. Oddly, this is an intermittant problem. The past two days, with a small load of dishes, there was no leak. Help!!


A reader on another forum found, after much effort, that the solution may be very simple: don't load flexible cutting boards on the right-hand side of the machine.The boards can block an outlet on that wall, presumably leading to a buildup ... Bosch Dishwashers

When the dishwahser door is lowered to unload the bottom rack, I get a small puddle from the top, left side of the door. this is the area where there are vents for the steam that releases during the final stages of the dishwashwer. this puddle happens every single time regardless of how long or short of time after the dishwasher is complete. Is something not working correctly? Or is this just a bad design and condensation is buidling up and this puddle is the result? My wooden floor is taking a


Most dishwashers of this design have a small extractor fan built in if yours is one of these it may not be working if not try adjusting door latch a little tighter hope this helps ... Kenmore Dishwashers

Kenmore model#587(Frigidaire) leaks under door. New install. Had machine for a year plus before install. took off front panel- can see water squirting past lower door gasket as wash arms rotate. cause is water running down door during wash cycle piles up in the channels molded into the lower left & right side of the wash tub and pushes out the sides of the lower gasket. looks like a design issue- called SEARS, they just want to sell me a new gasket! go figure. any ideas on a fix?


It does sound like an inner door seal ,however If you get upset at Sears and complain they may help you as they say the squeaky hinge gets the oil..And with Sears the more you squeak the better your chances of results ...Good Luck ... Dishwashers

Model 587784100 My 18inch Kenmore apartment-sized portable dishwasher leaks when running and needs a new main rubber gasket (where the door seals the washer), and a new collar of some sort of white hard plastic collar at the very bottom of the spinning washer arm (which I believe helps make it spin more freely and not "chatter"?) My question is: Is it possible foe a handy person to replace these parts (looks fairly easy), or should I get a proper Kenmore/Sears repairman to fix it?


If you think you can do it then do it. it is normally not any harder than it looks. now because i work there i would say call them :) but you can change those parts fairly easily ... Kenmore Dishwashers

I am trying to fault find a Hobart AM15 ML-130038 dishwasher. Wash cycle does not start automatically after the water level activates the level switch & energizes the contactor? To get the wash cycle to start you need to open and close the door.


... Dishwashers

Dishes on lower rack are not getting very clean, the soap dispenser on the door still has a lot of soap left in it. By soap I mean "Gel Dishwasher Detergent".


Check the water intake screen for sediment. Sometimes if sediment partially clogs the screen, the water pressure is lowered significantly enough to cause these conditions.\015\012\015\012If you send me the make & model of your DW I'll tell ... GE Tritonr XL GSD6260JCC Dishwasher

Kenmore dishwaser model# 665.15764000 I turn the dishwasher on and as soon as it begins to was water comes out from the bottom of the door. What could cause this? If its a bad gasket what should I ask for and where can I get it, and is it expensive?


... Kenmore Dishwashers

363.14572000 Do i need to remove the screws on the inside of the dishwasher door in order to get the gasket fully insalled?


... Dishwashers

Hello, I have a Kitchen Aid dishwasher, model KUDS30IVWH3. The dishes have not been getting as clean lately, the bottom is decent but the top rack is not getting very clean. Also, when I open the door after the cycle is done, there's a bunch of detergent at the bottom of the door and on the floor of the dishwasher, like it isn't getting sprayed all over or something. Don't know if I have to check the water intake valve or if maybe the sprayers could be partially clogged.


... KitchenAid Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2298 seconds