Having problems with your Homelite Gas Pressure Washer: 2700 psi 2.3 GPM UT80522D ?

Homelite ut80522d pressure washer motor reves up and down then dies

\015 Ut80522d motor reves up and down then dies,replaced fuel line spark plug air filter still no better\015

Answers :

It's surging... your carburetor needs to be serviced. It's not giving the proper air fuel ratio to the engine...\015
\015
BriMaxSmallEngineRepair\015
Gibbstown,NJ
Repair Help & Product Troubleshooting for Homelite Gas Pressure Washer: 2700 psi 2.3 GPM UT80522D

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Homelite ut80522d pressure washer motor reves up and down then dies


It's surging... your carburetor needs to be serviced. It's not giving the proper air fuel ratio to the engine...\015\015BriMaxSmallEngineRepair\015Gibbstown,NJ ... Homelite Gas Pressure Washer: 2700 psi 2.3 GPM UT80522D

Throttle problems Homelite pressure washer model UT80709A. bought it 10 months ago with no problems and stored it for last 9 months. Before doing so, drained gas, oil. Brought out of storage a few days ago, filled with fresh gas, oil, cleaned air filter. Starts great first try but after about 30 seconds the throttle starts visibly revving the motor a litlle at first then gradually faster and faster until it seems to flood and die. Then you cant start for about an hour and its the same story. Hav


... Homelite Pressure Washers

I started working with the Karcher KB4040 pressure washer and all was well for 1-2mins, then it sputered a bit and all power died. All hoses were still attached properly, it hadn't blown a fuse in my house and the fuse in the plug of the washer is working fine.When I switch it on I get nothing. Do you think the motor has packed in? I borrowed the machine from my neighbour who's away on holiday, so don't know much about age of the machine. Any advice much appreciated.


If the water is in anyway impeded, like kink in hose the unit turns off and goes into protection mode. That it it shuts down for a pewriod of time depending on how hot it may have got.\015\012When its rested try it again ensuring you definitely ... Karcher 1750 psi Electric Pressure Washer

Honda Pressure Washer Black Max 2600 Psi 161cc Problem: manual choke pulled on when starting. When attempting to turn off the choke the motor dies. This occurs no matter how long the engine runs for.


... Honda Black Max 2600 PSI Pressure Washer

I have a hoda pressure washer it stats right up and while i was cleanning the wood fence i let go of trigger during about 10 min, and the motor started dying i pulled the trigger and it pick right up again any ideal what would make that do that? but one time i let it quit and i couldn't get it started,i had to wait about 5 min. then it started back up again.thanks


A couple of things, what makes the engine change tone and revs is pressure, depending on the age, it may have excessive calcium build up in the pump, there may have also been a build up of crud or a wasps nest in the end of the hose when you connecte ... Devilbliss DeVILBISS Devap DVH2600 Gas-Powered Pressure Washer

Troy built 2350 psi 2.0 gpm. pressure washer. starts onne then dies. will not start again. has briggs and straton motor. has been sitting up for the winter. have changed spark pulg. checked air filter that is clean, has oil and gas.


... Pressure Washers

Excell pressure washer honda motor---have fuel flow---fresh---only runs when carb cleaner sprayed--then dies..........


Sounds like the carb is badly clogged internally. If you can remove it yourself, you can soak it overnight in a can of carb cleaner. But keep in mind some of the internal passageways in the carb are as fine a human hair and soaking may not work, it ... Karcher 2500 PSI Pressure Washer

Husky pressure washer model GCV 160 with honda motor will not start. Starts when starter fluid is sprayed into carb, but then dies immediately. Fuel is getting into bowl under carb.


I have the same problem lol ... Pressure Washers

Owners manual Homelite pressure washer - Homelite Pressure Washer. Honda 2700 psi 2.4 GPM Gas Pressure Washer


... Homelite Pressure Washer. Honda 2700 psi 2.4 GPM Gas Pressure Washer

Pressure washer pump pressure kills gas motor


The pressure regulator valve is stuck take it apart and clean it ... Annovi Reverberi Sjv3g27d Pressure Washer Pump 2700psi 3.0gpm Ar

Pressure washer, motor runs fine until trigger is engaged.


... Pressure Washers

Shark pressure washer with honda 5.0hp motor when in use spraying with good pressure it the pressure shuts off and motor sounds like its about to shove a rod through the cases shut it off restart it andd the same thing occurs all fluid levels good pump and motor. water pressure from hose bib good. may b low water pres. for short time due to possible kink in hose reel not sure


What type pump oil to usefor karcher 2400 psi ... Honda Pressure Washers

Homelite 105 bar pressure washer - Homelite Pressure Washers


... Homelite Pressure Washers

I accidentially sprayed water on the pressure washer motor and got it wet and the pressure washer stopped and won't start up. Will it start back up after things dry out or is the motor broke?


Yes it most likely will, BUT you need to dry OFF ALL electrical items well.\015\012\015\012Check also that you haven't dislodged anything from the system.\015\012\015\012If it still will not go, you may need to use WD40 or similar water d ... Pressure Washers

I have a 3000 PSI Honda pressure washer. The motor


Your nozzle could be plugged or partially plugged. Also, try running it with the high pressure hose taken off to flush the pump. ... Honda Pressure Washer PSI 3000

I have a Generac pressure washer, model #01450-0, with a Honda 5hp motor. The motor runs fine, but the pressure hose pulsates as if the pump is intermittently making pressure, and the pressure out of the sprayer is about half of what it should be. A friend suggested replacing the seals in the unloader. I bought an unloader kit, replaced everything and it still runs the same. It will build a small amount of pressure, spray for a few seconds, then the pressure dropps to almost nothing. Any help ap


Take a small diameter wire and poke thru the discharge hole of the spray head to clean out.\015\012Second time in 6 months that I had the same problem. The problem is alway in the spray head. ... Pressure Washers

I have a Karcher 330 electric power washer. When connected and set to highest pressure (on variable wand) I get no motor action unless I reduce wand setting, then I get a little boost but not much. If I use high pressure conical wand I get high pressure sometimes, other times motor does not go and no pressure is delivered. I have replaced the high pressure hose.


Just wondering. have you tried it without an attachment to see what kind of pressure you get ... Karcher K2.26 Electric Power Washer

My Karcher K3.48M pressure washer remains in the low pressure mode even when I return the pressure nozzle to the high pressure position. How can this be corrected. The pump seems to build up the pressure because when I release the handle the pump motor stops. This is a fairly new pump which was purchased in the latter part of last year(2010). Could this have been caused by the detergent I have been using which is an automotive shampoo? Please help I love this washer and for the times that I u


... Karcher PSI Electric Pressure Washer

If while pressure washing I let off the wand trigger it looses pressure and I have to turn of the washer motor and wait for the pressure to return.(seems like some kind of vapor lock problem)When the pressure returns I hold the trigger and restart the washer. If I let off the trigger we go through the same process again. this is a g3050


Hi and welcome to FixYa, I am Kelly. \015\012 This is most often caused by the bypass / un-loader valve located on the high pressure output side of the pump. The valve will either have a stem type valve with a knurle ... Karcher 2500 PSI Pressure Washer

11 hp honda motor on landa cold water pressure washer runs good except when trying to pressure wash the motor & pressure go up & down pulsating bbruummmmmbbbbrrruummmmbbbrruuummmmwhats the problem and how to fix it?


... Honda Landa PG 3500 PSI Pressure Washer

Hi- I have a Simoniz S1600 pressure washer and usually when I first turn it on, the motor turns on to build up pressure. Now the motor won't kick in no matter what I do. Water still comes out of the gun as a small stream but there is no pressure. There are no reset buttons on the exterior of the machine. Thanks!


... Pressure Washers

I have a DeVilbiss pressure washer, Serial# 2251136878, Model# WVRH2421, Radial Pump# D28703, with a 5.5hp honda motor. It has no pressure. If the pump can't be fixed, is there another brand of pump that will fit this model pressure washer?


THE PUMP FITS THE MOTOR and the pump i always use is a ROYALPUMP made in Italy and they are long lasting and easily serviced ,any of the Italian pumps are good ... Pressure Washers

Pressure washer stalls and dies


The pressure release valve is sticking ... Craftsman 2500 PSI Briggs & Stratton Powered Pressure Washer

When i turn on my k499m pressure washer the motor seems very week and the pressure is non existant has anyone ever come across this problem before i havnt tried anything to fix it yet but the water is flowing into it ok it just seems as if their is something wrong with the motor or pump


I have come across this before, it can be that the motor has burned out and in that case it can be better to purchase a new machine. \015\012\015\012It could also be the capacitor which is not a very expensive item to replace. What the ca ... Karcher Pressure Washers

I change oil on my 3700 psi honda motor pressure washer motor and pump and after i done that the tigger rope is to hard to pull looks like some who is pressure some where can some one help me whit this problem .. thank you


Most likely has nothing to do with oil change. Have someone hold the trigger on handle open to relieve pressure on system/pump , this will make engine turn easier when you pull rope. ... Karcher 2500 PSI Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1067 seconds