Having problems with your Homelite Pressure Washers ?

Oil change pressure washer

\015 Where is oil drain plug in 2600 psi pressure washer\015

Answers :

Repair Help & Product Troubleshooting for Homelite Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My Troy Bilt power washer (using Honda GCV160 engine) has no pressure coming from the pump. I checked the water flow, everything seems fine. I believe the pump needs oil added, however, I can't seem to firgure it out (how to add oil to the pump). I did notice that previously, I used to see drops of oil coming from under the pump. I I have a bad seal, can I add oil and test the pressure before I change the seal? Please advise.


I had a similar problem. Turns out I had left the hose disconnected and some sort of wasp built a paper type nest inside the washer tube that the hose connects to. I had to take the pump off and take apart and then cleaned it out with a screw driver. ... Honda Black Max 2600 PSI Pressure Washer

I have a troy build pressure washer model number 020337 Do I need to change the oil in the pump, and if yes how do I drain it and what kind of oil. I know how to change the engine oil


The pump requires no maintenance and no oil change. It is lubricated for life. ... Karcher 2500 PSI Pressure Washer

I have a John Deere 3800 psi pressure washer, it stopped having pressure in the middle of a job. No restrictions and still turns on and sounds great. Checked pump oil and it was a milkshake green. Changed pump oil and still doesn't have pressure.


... Pressure Washers

How to change oil in a pressure washer


From the manual CleanShot 2050 Briggs and Stratton\015\012\015\012Change Pump Oil\015\0121. Drain engine oil and fuel from pressure washer\015\0122. Use an 8 mm allen wrench to remove black pump oil cap between high pressure ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

Changing oil on a high pressure washer with Comet Water Pump


... Comet BXD2527 Pressure Washer Pump

How to change the oil in the pressure washer - Coleman Pressure Washer PW0881800


... Coleman Pressure Washer PW0881800

Hi. I have a Briggs & Stratton 2800PSI gas pressure washer. I can get it to start, but after about 5 min, then it quits. I have cleaned the carb, change oil, changed plug, new gas, cleaned/checked air filter. Nothing will keep it running. Wondering if it may be not enough water pressure, but would that cause it to stop like that? When it runs, it does a good job, but it stops just as you get going. Do you have any other suggestions? Thanks!


If it wont start, check for spark.how you do that,ok take the spark plug wire out put it close to the sparkplug(use some gloves or something to insulate your self from get electric shot from the spark) find some one who pull the start rope, if you do ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

My Karcher 2400 PSI pressure washer is not starting after about 5 years. What type of spark plug and gap should I change the old out with and what kind of oil do you recommend. I don't think I have ever changed the oil but way less that 50 hours on the machine. Thanks


... Karcher 2500 PSI Pressure Washer

How do I change oil to pressure washer? - Karcher 2500 PSI Pressure Washer


At the bottom of engine you will notice a plug take it out and oil will draine out .... replce it then fill at top where u see oil dipstick ... Karcher 2500 PSI Pressure Washer

Changing oil in Mi-T-m 2500 pressure washer - Pressure Washers


... Pressure Washers

I have two questions and would greatly appreciate some help: - What oil to use in the pressure pump of a Ryobi Pressure Washer RY80030? - How much to put in? The pump model is MTP092150 from FAIP. As per the manufacturer, the oil is not to be changed or topped up by the end-user, I know, I know, but brought to a service center instead - I certainly don't want to do that, and there is none close to my place anyway. The reason I need this is that I had to take the pump apart and a


... FAIP Non Marking Pressure Washer Hose 4000 Psi, 50ft. Length

Changing pump oil on ryobi pressure washer model ry80030 guy oil leaking out of breather on pump do I also need to change seals and if so how do I do this


... Karcher 2500 PSI Pressure Washer

I have DeWalt3750 psi pressure washer, its been long time since I used it, now that I wanted to use it, I can not start it. I already changed the oil and filled it up with new oil but still can not start, What is wrong with the washer? thank you


Here is the long answer with everything we learned while using a power washer twice a day for years::This assumes you did not turn power washer over or on its side to drain oil, or dirty oil will flow into carburetor requiring complete carburet ... Dewalt 3800 PSI Pressure Washer

I bought a troybuilt pressure washer used and i changed the motor oil and ran it maybe 5 minutes. later i checked the oil level again and it shot out the cap and i noticed the pump oil level is also almost to the top of sight glass. Does anyone know whats wrong?


If you left it sit for a while & did not turn the fuel tap off,it may have flooded and therefore the oil level would have risen causing the oil to over flow.\015\012\015\012always turn the fuel tap off when not using your pressure wahser. ... Honda Pressure Washer PSI 3000

Changing pump oil on pressure washer


... Pressure Washers

How to change pump oil on craftsman pressure washer #580.767302


... Craftsman Pressure Washers

Oil change pressure washer


... Homelite Pressure Washers

Won start Was using the pressure washer 1st time this year and started on the second pull. Ran out of gas shut-off also noticed it needed oil. Believe, I put too much oil so, I drained some and added gas. At first, there was no resistant in the pull so waited an hour and tried again. This time the resistant was there on the pull but still would not start; no attempt even to turn over. It's been a couple of days...changed the spark plug although, hardware guy said nothing was wrong with it..still


... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

What type of oil do I use for the 2550PSI pressure washer engine and how do I change the oil completely?


To empty the oil you tip it over on it's side. The type of oil to use is car oil and depends on the temperature where you live. The manual is available at http://staging.us.kohler.spectracom.com/pdf/owners_manual/101%5C020273_0_om-Domestic.pdf and ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

My pressure washer is bogging out and shutting off. It will run fine for a bit then it starts sputtering and shuts off. I changed the oil right before this started happening and yesterday i changed the sparkplug and it seemed to be working fine until I used it today on the driveway.


SOUND LIKE FLOAT IS STICKING ... Dewalt 3800 PSI Pressure Washer

I have a Karcher g 2500 vh gas pressure washer and I can't find what oil to use when changing the engine oil. It's not in the owner's manual that I down loaded and I'm not able to find this info on the internet... Can you help?


... Pressure Washers

Pressure washer cuts off when I pull trigger on wand. I changed the oil it is getting better but seems the oil sensor is cutting it off.


Float may be sticking in carb. ... Karcher 2500 PSI Pressure Washer

Simoniz CL11 Pressure Washer Oil Change, Oil Type and amount


... Comet BXD2527 Pressure Washer Pump

I change oil on my 3700 psi honda motor pressure washer motor and pump and after i done that the tigger rope is to hard to pull looks like some who is pressure some where can some one help me whit this problem .. thank you


Most likely has nothing to do with oil change. Have someone hold the trigger on handle open to relieve pressure on system/pump , this will make engine turn easier when you pull rope. ... Karcher 2500 PSI Pressure Washer

Change oil in craftsman 6.75 hp pressure washer


... Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0698 seconds