Having problems with your Honda 2004 CR-V ?

Where is carburetor located? - Honda 2004 CR-V


Answers :

A 2004 honda crv have fuel injection so you will not find a carburetor
Repair Help & Product Troubleshooting for Honda 2004 CR-V

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Where is carburetor located? - Honda 2004 CR-V


A 2004 honda crv have fuel injection so you will not find a carburetor ... Honda 2004 CR-V

Honda 2700 psi GC160 pressure washer will start with starter fluid in carburetor but wont stay running? Changed sparkplug cleaned carburetor, Added fuel cleaner then let set and drained all fuelandadded new. Seems as if their is no fuel going from the tank to the carburetor?


... Pressure Washers

I am needed to locate an owners manual for the honDA GX-200 PESSURE POWER WASHER. I PURCHASED IT LAST SUMMER AT BUCIETTS IN JACKSON MO I CAN'T REMEMBER IF I EVEN GOT A MANUAL. COULD YOU HELP ME LOCATE ONE


You can get the gx-200 manual on link below. This is just for the motor only. If you need one for the pressure washer I need to get the model #.\015\012\015\012 ... Honda Pressure Washers

2001 honda accord main relay location


... Bosch 0332209150 Main Relay

Where is carburetor located on homelite pressure washer 2500 psi


... Pressure Washers

It spits gas out of the carburetor when I try to start it! Generac with a G24 engine 5.5 honda


If its spiting gas out of the carb then that is compression coming out of where it should be going in. My thought is the intake valve is not closing properly ( remaining open) to allow compression to come back the intake . It could be simple a buildu ... Pressure Washers

Tthere is gas leaking from the carburetor on a Honda GCV160 pressure washer. Runs fine.


... Honda Pressure Washers

I have a troy built power washer powered by honda. It runs for 10 - 15 minutes and then dies. I have replacced the ignition coil, spark plug, rebuilt the carburetor, checked fuel flow and placed the unloader valve and it still dies. Once it dies and the pressure is released it repeats the problem. Any suggestions?


... Honda Pressure Washer PSI 3000

I have a honda excel 2500 psi , where would the pressure relief valve be located?


Many of the excel units don't come with a pressure relief valve but instead a thermal relief valve, it really depends on the model number of the pressure washer. You should only replace the thermal relief valve if it is leaking. ... Honda Karcher G2400HH-R Pressure Washer

Honda 13.0 gas leaking from bowl on the bottom of carb. Engine was breathing hard and starting to send white smoke out of muffler prior to stalling. In a carburetor type car i would say the float was stuck open. This is a DeWalt 3300.


That would be the first thing I would look at would be grit in bowl stopping the float from moving freely or a hole in the float. Hope this helps. Thanks ... Dewalt 3800 PSI Pressure Washer

Honda 3600 psi 0-13hp model # exhp3640-1 has low water pressure


... Honda Pressure Washers

Where is the oil drain plug located on a Homelite 2700 psi 2.3 GPM Honda Gas Pressure Washer?


There is drain plug, surprisingly. You basically have to tip the washer over to the side opposite of the exhaust. I like to take the wheel off first. It is much easier this way. You don't want oil to get in the exhaust Or you could get something lik ... Homelite Ut80993 Honda Gas Pressure Washer

I need to clean carburetor on 340gx honda pressure washer. How would I do this?


Don has it about right. Step by step: Back out both air filter wing nuts, remove top filter assem. Use 10mm socket to remove two nuts and one bolt, needle nose pliers to remove fuel line, Slide carb 1/2 way off bolt studs and remove spring from molde ... Honda Pressure Washers

Honda pressure washer model # exhp3640-1 3600psi 0=13hp has low water pressure out of triggers motor does not engage for higher pressure


... Pressure Washers

Where is the oil drain plug located on a Homelite 2700 psi 2.3 GPM Honda Gas Pressure Washer?


... Homelite Ut80993 Honda Gas Pressure Washer

Bosch SHU43C My Bosch SHU43C is stuck with the drain pump running. I ran the self-test and it gave me the fault code 4 wich indicates a filling fault. The washer is empty and all wash cycles display the correct number of minutes for the cycle. It counts down to 0, but the pump continues to run. Does this indicate a stuck float, or is the problem with the control board? Where is the float located? Are diagrams/pictures available on-line anywhere? I've done some searching, but haven't found any. R


My SHU43C is just over 3 years old. I had a similar problem recently. First, there were a few floods. Then, the Bosch only drained non-stop. Even when I used the Cancel Drain buttons the drain pump would run without stopping. When I ... Bosch 24 in. SHU43 Built-in Dishwasher

Locate diagram of intake manifold runner control for po661 code cr-v honda 2002


... Honda 2002 CR-V EX 4WD

How to remove, clean and replace carburetor, on Troy/Built Pressure Washer with Honda GVC 160 Engine ?


... Pressure Washers

Hi I have a LG LD-2052 dishwasher. It gives me an E 0 error - the water does not pump out when I open the machine after a few minutes when started to wash and message of E 0 appears? Have cleaned an


... LG Dishwashers

Honda small engine carb. cleaning


Honda jets thread into the main venturi where the float bowl bolt goes. you jut need a blade/ flat screwdriver to thread it out. becareful they are only brass and thread it out and the emulsion tube should come out as well fairly easily. you may need ... Karcher 2500 PSI Pressure Washer

Pink vinyl tube under carburetor has fuel-smelling drip


No look to see if the clamp it on good it may have a pin hole in it best thing to do is relace it any auto store will have it...Good Luck ... Honda Pressure Washer PSI 3000

How to change carburetor in homelite pressure washer 2500 psi


... Pressure Washers

Honda GX390 stalling in go cart


I believe its the the oil sensor. The engines are equipped with a low oil sensor and when you go around turns, accelerate, decelerate, the oil will flow from side to side and throw the sensor off, causing the engine to shut off. Remember, this is bec ... Honda Pressure Washers

Oil fill for Honda GX390 reduction case


... Honda Pressure Washers

Home Depot has a lawn mower with the Honda GCV160 Electric start version engine. They also have a pressure washer with the Honda GCV160 engine. I have a disability that makes it difficult to pull the starter rope. I would like to get the electric start on the pressure washer. My local Honda bike shop service center said they use different blocks. Can I get a pressure washer pump mounted to the Honda GCV160 Electric start version engine? If necessary, are there adapter plates that can be purchase


... Karcher 2500 PSI Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0358 seconds