Having problems with your Honda 2500 PSI Gas Pressure Washer ?

Will not take detergent from resevour - Honda 2500 PSI Gas Pressure Washer


Answers :

First check the intake line, filter and the brass fitting on the pump for obstructions. It clear it's usually because you are using a high pressure tip on the gun while trying to spray detergent. The only way the system can pull the detergent into the water stream is if you are using a soap tip (usually black) on the gun.
Repair Help & Product Troubleshooting for Honda 2500 PSI Gas Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Will not take detergent from resevour - Honda 2500 PSI Gas Pressure Washer


First check the intake line, filter and the brass fitting on the pump for obstructions. It clear it's usually because you are using a high pressure tip on the gun while trying to spray detergent. The only way the system can pull the detergent into ... Honda 2500 PSI Gas Pressure Washer

WHAT WILL HAPPEN TO A CRAFTSMAN GAS POWERED 2500 PSI PRESSURE WASHER IF SOMEONE RUNS DIESEL THROUGH IT AS A DETERGENT OR DE-GREASER? WILL THIS RUIN THE SEALS IN THE PUMP? OR CAN THIS PROBLEM BE REVERSED WITH A FULL TAKE APART AND CLEAN UP OF ALL PARTS?


If you want to run a very small amount through the engine to help clean carbon deposits I would say that was fine as long as you only used 1-2 ounces to the gallon. But if you want to run diesel through the pump itself I would not recommend this. ... Pressure Washers

Honda 11.5hp pressure washer wont start - Honda 2500 PSI Gas Pressure Washer


... Honda 2500 PSI Gas Pressure Washer

Owners manual Homelite pressure washer - Homelite Pressure Washer. Honda 2700 psi 2.4 GPM Gas Pressure Washer


... Homelite Pressure Washer. Honda 2700 psi 2.4 GPM Gas Pressure Washer

Hondar 2500 pressure washer wont start - Honda 2500 PSI Gas Pressure Washer


... Honda 2500 PSI Gas Pressure Washer

My Honda 2600 psi power washer will not pull to start. It was running great then I allowed the neighbor to borrow it. He ran the washer till it was out of gas and proceeded to refuel and at this point it would no longer start. The pull cord is out about 4-6 inches out and I am concerned about taking the casing off myself. Fearing that it may throw more off on the unit. If i take the casing off are there any spring loaded parts that will dismount? What should I do? Spark Plug? Turn


You should be fine to take the recoil off, there shouldn't be anything that shoots out at you. You might want to check the oil level on the engine, many of the Honda engines won't start unless there is enough oil in them. If your oil level is fine, c ... Honda Pressure Washer PSI 3000

Simpson pressure washer winterize - Simpson PS3200 Powershot 3200 Psi Direct Drive Cold Water Gas Powered Pressure Washer W/ Honda Engine


... Simpson PS3200 Powershot 3200 Psi Direct Drive Cold Water Gas Powered Pressure Washer W/ Honda Engine

No soap to power washer honda gcv 190 - Honda 2500 PSI Gas Pressure Washer


... Honda 2500 PSI Gas Pressure Washer

I have a Honda GCV160 5.5 HP engine, CV-2400-1MHC, 2400psi, 2 GPM Chore Master MI-T-M gas pressure washer, about 5 years old (the manual is dated 2005). I am the second owner and the first owner told me he did not use it very much. I just bought it in July 2010. When I adjust the nozzle the only setting that will clean my timber deck is the high pressure with the narrowest flow. At this setting it will take forever to clean the deck. The setting with a broader coverage and high pres


... Honda Pressure Washers

The power washer is not taking in the soap. - Briggs & Stratton Briggs Stratton Vanguard OHV 3000 PSI Gas Pressure Washer


... Briggs & Stratton Briggs Stratton Vanguard OHV 3000 PSI Gas Pressure Washer

Not getting enough pressure for washing - Honda 2500 PSI Gas Pressure Washer


It could be a couple of things The first thing is the easyest and most likely one of your pump body valves is stuck or damaged do you see the 6 brass caps on the pump body you need to remove them all one at a time be careful not to damage the o rings ... Honda 2500 PSI Gas Pressure Washer

Honda gcv160 wont dipenve detergent - Craftsman 2600 PSI Honda Powered Pressure Washer


... Craftsman 2600 PSI Honda Powered Pressure Washer

I have a Husky 2600 Psi 2.3 GPM Honda powered gas pressure washer. When i turn it on the motor runs fine, But when i squeeze the trigger the water is not pressurized when it comes out. How do i fix this problem?


... Honda Pressure Washers

I have a Karcher G2600 OR Pressure Washer, 2600 psi, 2.5 gpm. PN 1.194 506 0. gas engine works fine and water flows fine but pump is not adding pressure to stream. Checked and cleaned inlet water filter.


... Pressure Washers

I need to know what kind of oil the pressure washer takes, I noticed it has a place for oil on the engine and another neat the pump. The product is a honda pressure wave 220 PSI Model NO 2225cwh-2


... Honda Maxus Prosumer MX5223 Pressure Washer

Honda gcv160 wont dispence detergent - Craftsman 2600 PSI Honda Powered Pressure Washer


It will not draw soap while using pressure take out the nozzle or use the large black nozzle ... Craftsman 2600 PSI Honda Powered Pressure Washer

No water pressure - Simpson WB4200 Water Blaster 4200 Psi Cold Water Gas Powered Pressure Washer W/ Honda Engine


... Simpson WB4200 Water Blaster 4200 Psi Cold Water Gas Powered Pressure Washer W/ Honda Engine

I have a homelite honda pressure washer 3100 psi less than 2 months. I used it and after 2 week tried to use it again it ran fine but very rough on idle. Replaced gas and added stabilizer still rought


... Psi Pressure Washers

It start then stops running - Honda 2500 PSI Gas Pressure Washer


Have you checked to see if it has a good strong spark? Remove plug, put back on coil wire, put end of spark plug next to the engine head bolts. Then turn the motor over a few times and watch the spark plug to see if a good strong jumps across from pl ... Honda 2500 PSI Gas Pressure Washer

I have a Husky 2600 PSI pressure washer. Started up and used for about 20 minutes - turned off to take around back and now the pull cord is tight and has a clicking sound when trying to pull. Has oil and fresh gas. Suggestions?


... Karcher Pressure Washers

What kind of oil does the karcher gas powered pressure washer take its a Honda engine with 3000psi


10W30 ... Karcher Pressure Washers

Starts up and after a few seconds cuts out - Honda 2500 PSI Gas Pressure Washer


Hi Debra,Before it cuts out, try pushing the the choke back in.If there are more symptoms or details that night be relevant, please include them in a comment response.Best regards, Mike ... Honda 2500 PSI Gas Pressure Washer

What valve lash should me GX 390 be set at? - Simpson Taskmaster Industrial Gas Powered Pressure Washer 4000 PSI @ 3.5 GPM Honda GX390 Engine And 50' Non-Marring Hose #TM4000BD


Inlet .006 exhaust .008 ... Simpson Taskmaster Industrial Gas Powered Pressure Washer 4000 PSI @ 3.5 GPM Honda GX390 Engine And 50' Non-Marring Hose #TM4000BD

My BE Honda 5.0 2900 psi pressure washer has oil in air filter. I believe it is because my buddy left it tilted to the side in th ecar when he borrowed it. How can I fix it? It is probably low on oil as now due to this. How much oil does it take? As there is no dip stick to check the level, Do I need to empty it all out and refill it


Hi there ibharti sounds like gx 160 honda ohv engine \015\012\015\012replace the air filter if it has been wet with oil, , remove the float bowl and check for oil in the carb, blow the jets out, top up the oil to the point o ... Honda Pressure Washer PSI 3000

Assembly I recently purchased a pressure washer from Home Depot. It is rated at 3100 psi. It is a comet pump with a honda gas engine. The assembly instructions recommended that I remove the plug on the top of the pump and replace it with a vented plug that was provided. However, none of the other enclosed manuls talk about the vented plug. Am I reading the assembly insturctions correctly. Should there be a vented plug ?


HI your machine would have been delivered with a blanking plug in the pump. You will need to remove this and fit a vented pump or your pump will build up too much pressure inside. ... Comet BXD2527 Pressure Washer Pump
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1253 seconds