Having problems with your Honda Engine Gc160 Gc190 Gcv135 Gcv160 Recoil Starter ?

Put new rope on recoil spring

\015 Honda gc160\015

Answers :

Repair Help & Product Troubleshooting for Honda Engine Gc160 Gc190 Gcv135 Gcv160 Recoil Starter

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Put new rope on recoil spring


... Honda Engine Gc160 Gc190 Gcv135 Gcv160 Recoil Starter

The spring-loaded flip-up door for the soap dispenser on my Kenmore dishwasher is broken. It seems the spring has come undone. I have had two repairmen come by and neither could put the spring back in. It seems senseless for me to get a new dishwasher just because of this stupid little spring. Help?!!


... Dishwashers

KitchenAid Dishwasher KUDP01FL: Called repairman to replace balance link kit. Then door extremely stiff to open & heard loud pop when one of the ropes came off the roller. Repairman came back & put rope back on & replaced door seal, then the door won't close & he claims need a new door latch. When he left, door again extremely stiff to open & heard same loud pop when one of the ropes came off the roller. Now he says he can't fix it and to call someone else. I now have three problems: (1) The doo


May have bent door hinges,, need to check all alignment of door, hinges and latches... ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

I have a Husky 2600 PSI power washer with the Honda GCV160 engine that I can't get to start. It was okay when I purchased it from Home Depot last spring but now I've tried putting new gas in it, spraying carb cleaner, new spark plug, and it still won't start. I only ran it for about 30 minutes when I first purchased it. The guy at the service desk at Home Depot told me that the water hose should be attached and turned on while trying to start. Is this true or would this be starting the motor und


You can eliminate the motor by unbolting the pump from it and then if it will start the problem is with the pump or the unloading valve.If it does not start with the pump removed then you check for spark and get the carb cleaned or have a kit put in ... Karcher 2500 PSI Pressure Washer

I have a Bosch dishwasher, model #SHU43C02UC/14, which has stopped working - no water enters the inside nor is there any drain cycle - just nothing. At the same time, I had to have the new control board put in as part of the Bosch recall. The tech comes out, puts in the new board - still nothing. He says something is wrong with the board even though the problem existed before the new board was installed. He takes everything back to his shop and tells me he's trying to contact Bosch tech support


... Bosch Dishwashers

Pressure washer has been sitting up for about 2 years.. worked perfectly before I parked it.. lol.. But, I put a new spark plug on, cleaned the filter, sprayed carb cleaner in it drained the gas tank and added new gas.. But it still does the same thing.. It starts in the choke position, runs awhile, and then shuts off. While its running, I tried to put the switch in the run position and it kills. Just wanted to see what an expert would say about the matter before I Brake it down. thanks


... Briggs and Stratton 020275 Elite Series 3400 PSI Portable Gas Pressure Washer

Motor has been sitting for a while changed out old gas put new in drained carb bowl put new spark plug wont stay running


Here is the long answer with everything we learned while using a power washer twice a week for years::It sounds like could be one of the problems listed below or a combination of those things.1) The exhaust is partially blocked. Che ... Pressure Washers

Briggs 6.75hp Will Not Start and it's Brand New!


Is there leaking on hthe head? (wet?) Can you see or smell gas there? = gasket. Is there gas in the oil? Pull the dipstick and smell it...might even be really thin. = piston or rings. Pull the plug and see if you can get a view of the piston when ... Karcher 2500 PSI Pressure Washer

IDL750 - Fuse trips when turned on. HELP! We had some electricians here to install a new electrical socket for a new fridge. They put the new socket in the same wiring as for my existing dishwasher!! The first time I tried to start the dishwasher cycle with the new fridge plugged in, the circuit box fuse tripped. Now, even with the fridge turned off, the dishwasher makes the fuse trip when turned on. Is there a fuse inside the dishwasher that has blown and needs to be replaced? or a ground brea


Hi.The first step is understanding if the problem is the socket or the appliance. Find an extension long enough to reach a different socket. Move the appliance to reach the power cord, and connect the dishwasher to a different power sock ... Indesit 24 in. IDL700 Built-In Dishwasher

Hi just had new dishwasher put in its a diplomat intergrated dishwasher aca9102, only used it once and started beeping towards the end of the cycle. thought it might be coz i didn't put salt in it, and had tablets instead of detergent so put salt in and detergent in but couldn't get rinse aid. started the program on normal wash but started beeping 10 beeps straight away and the first three lights out of 6 are flashing on the control panel. could it be coz theres no rinse aid in it? please someon


Dear tracy83, \015\012\015\012we have an aca9102 diplomat dishwasher since april 08. we now have a fault with dishwasher but cannot locate our manual. could we arrange rto have a copy of your manual? sorry for being up front but cannot ob ... Dishwashers

Im having a problem desiding how to hook my drainage pipe up from the dishwasher i cant put it next to the sink cause theres no room so i have to put it on the other side of the kitchen could i connect new pvc pipe to the drainage pipe underneath the floor or do i have to put it above the trap


You can put a new verticle pipe up from under the floor and put the drain hose in that. make sure the vertical pipe comes up to about worktop level and make sure there is a water barrier in it or you will get a nasty smell ... Dishwashers

Spring broken in soap dispenser Neff dishwasher. How do you fit new spring. One of the spring arms is stepped-does it go certain way round?


... Neff 24 in. S4456 Built-in Dishwasher

PRESSURE WASHER WONT START PUT NEW OIL IN NEW SPARK PLUG NEW GAS


Check your ignition, sounds like you are not getting fire. Also check to see if it has an instrument that want let it start if the oil is to low. It could have Malfunctioned. Also double check your oil and make sure there's enough in it. ... Briggs & Stratton Pressure Washers

I have a Troybilt pressure washer (model 020240) with a 6.75 HP BS engine (6BSXS.1901VH). The starter cord snapped and will not recoil. I took a look and the recoil spring is bent up. Is there a way to replace the recoil starter assembly on this engine? If not, what are my options? Thanks.


... Briggs & Stratton Pressure Washers

TV static I just installed a new dishwasher. When it is running, it causes static lines on the TV. Prior to the new dish washer, I did not have this problem. It is wired correctley, and not on the same circuit. As I stated I did not have this problem until the new dishwasher. I called the service people for the dishwasher, and they stated they could not help me. Have you got any ideas, or do they make some type of filter I can put on the line to the TV.


There should be a suppressor fitted to the mains terminal block on most dishwashers. if this is not the case you will have to get hold of one you plug in. regards ... Dishwashers

Pressure washer will not stay running. Have put in new fuel, new plug, new oil. Will not start until I spray some ether in carb, then it will start and run for about 3 seconds, then stall. will not restart without another shot of ether. What should I try next? thanks


... Briggs & Stratton Gas Pressure Washer 20244

There is no tension on my recoil spring, how do i fix that


... Pressure Washers

Maytag model mdbtt70aww. After the end cycle. open the door and found detergent tab on the bottom and the main wash cover is opened. Maytag diswasher model MDBTT70AWW. Put dishes and so forth in the dishwasher. Put detergent tab and jet-dry rinse agent in the pre-wash section. and close the cover. Start wash cycle after done over door and found the detergent tab on the bottom new the heater. The cover to the main wash is opened. Dishes are are clean. Wish someone would tell me


... Dishwashers

Model#du900pcdb4 soap dish spring broke.how do i reasemble the new spring and all the plastic parts ?


This is not easy you can by a kit for dispenser but it easier to change complete dipsenser. ... Dishwashers

The spring on the door broke (loud sound) and now the door is heavy and doesn't stay up unless we latch it each time. How do we find instructions for installing a new spring?


Its hard to find instructions but go to sears parts direct and order parts .you will see the location of the parts and a image that should put uyou in the right direction ... Frigidaire PLDB998A Built-in Dishwasher

I have a Whirlpool Quiet Partner 3. It sat up for a few months because the control panel went out and it took a while to save up and order a new one. Now it blew the thermal fuse. I put a 15amp automotive fuse in it to try it, and it runs until it fills up and blows the fuse again. I am trying to figure out how to test the motor and the heating element to see if they are shorted. My local repair shop told me that they want to replace my new panel with their panel first, and that after that


A 15amp automotive fuse is rated for a 12VDC system in an automobile, not a 125VAC houshold electrical system in an appliance. I don't think your automotive fuse can handle the start current being drawn by the main wash pump as the dishwasher starts ... Dishwashers

Wand was leaking. took apart wand, found bad washer and put new one on.....how does one put the @#%!! thing back together? Thankyou, Tony


... McCulloch FHH18A Electric Pressure Washer

My Whirlpool GU2400XTP dishwasher keeps blowing the fuse. It sat up for 6months because the control panel went out and I couldn't afford to get a new one. Finally replaced the panel and the thermal fuse blew during the first wash cycle. I tried to put a 15AMP fuse in it's place to check it out before I bought a new thermal fuse and it too blew during the first cycle. Any ideas?


Are you replacing the wires along with the fuse? It is important to change the wires too as they are usually the cause for the fuse blowing. Be sure and get the fuse kit that includes the wires. \015\012\015\012Is your water too hot? Hot ... Whirlpool GU2400XTP Built-in Dishwasher

Ariston LI 670 S dishwasher. I put in a new circuit board and dishwasher only goes through first cycle of whatever setting I put it on. Soap door doesn't open and next cycle doesn't start. Any suggestions? -Alfredo [email protected]


... Ariston Technologies Dishwashers

I HAVE A NEW CRAFTSMAN PRESSURE WASHER WITH KEY START. I HAVE USED IT ONCE AND WHEN I TRIED TO START IT IT WAS HARD TO START HAD TO PULL START IT. NOW IT WONT START. LET PRESSURE OUT HAVE HOSE OH AND RUNNING, NEW SPARK PLUG HAS OIL, GAS FILTER FINE.HAS GOOD COMPRESSION, BUT WILL NOT FIRE GET SOME RECOIL. GETTING GAS TO SPARK PLUG AND GETTING SPARK. IM LOST PLEASE HELP.


... Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0462 seconds