Having problems with your Honda GCV 160 pressure washer ?

can you replace the washer in the wand of a Honda GCV 160 pressure washer

the wand leaks

Answers :

Repair Help & Product Troubleshooting for Honda GCV 160 pressure washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Husky pressure washer with a Honda 2600psi engine. Problem is, no water will come from the pressure hose. I connected the water w/out the pressure hose and water flows thru strongly. I then connected the pressure hose w/out the wand and water flowed thru the hose fine. When I connect the wand and pull the trigger, nothing. I have replaced the wand and that was not the problem. Please help.


Check the quick disconnect to the wand these are spring operated and can get stuck ... Pressure Washers

Need to replace hose on my honda gcv 160 5.5 pressure washer , any suggestions...


... Campbell Hausfeld PW2575 Pressure Washer

I have a Karcher 330 electric power washer. When connected and set to highest pressure (on variable wand) I get no motor action unless I reduce wand setting, then I get a little boost but not much. If I use high pressure conical wand I get high pressure sometimes, other times motor does not go and no pressure is delivered. I have replaced the high pressure hose.


Just wondering. have you tried it without an attachment to see what kind of pressure you get ... Karcher K2.26 Electric Power Washer

New honda pressure washer maybe had it 2 years and only has about 3 hours on it, I was using it yesterday and it started fine and after running for about 10 min it shut down like i turned the kill switch, it has oil and gas but seems to have lost compression. It is a Honda overhead cam GCV 160, pressure washer is a Troy Built model


... Pressure Washers

I have a Generac pressure washer, model #01450-0, with a Honda 5hp motor. The motor runs fine, but the pressure hose pulsates as if the pump is intermittently making pressure, and the pressure out of the sprayer is about half of what it should be. A friend suggested replacing the seals in the unloader. I bought an unloader kit, replaced everything and it still runs the same. It will build a small amount of pressure, spray for a few seconds, then the pressure dropps to almost nothing. Any help ap


Take a small diameter wire and poke thru the discharge hole of the spray head to clean out.\015\012Second time in 6 months that I had the same problem. The problem is alway in the spray head. ... Pressure Washers

No pressure to the wand. Motor runs and pressure gauge reads 4000 psi.Feels like no power in the wand Is a Honda pressure washer model #BEEX-2965HWCOMX.


... Honda Pressure Washers

No soap to power washer honda gcv 190 - Honda 2500 PSI Gas Pressure Washer


... Honda 2500 PSI Gas Pressure Washer

Pressure washer dies when wand pressed - Honda Karcher G2400HH-R Pressure Washer


... Honda Karcher G2400HH-R Pressure Washer

My pressure washer doesn't start/work when I attach my wand to the trigger. It works fine when I take it off, but there is no pressure, just normal water coming out. I'm thinking I may need a replacement wand?


... McCulloch FH160G Pressure Washer

I have a XR 2600 Honda pressure washer. After using it for about an hour, the pressure dropped drastically. I turned it off. I started the following day to finish the job and the pressure was a steady "stream" coming out of the wand - no pressure to clean the concrete. Can you tell me what might be wrong?


Change the spark plug. ... Honda Pressure Washers

I have an Honda 415 GCV 135 pressure washer 2200PSI how do I change the oil where?


... Honda Pressure Washers

Honda GCV 160 5.5 pressure washer dies when I pull the gun trigger


... Pressure Washers

I have a Honda gc160 5.0 pressure washer. All fluids are fresh. Water is hooked up with plenty of pressure but the water pressure is up and down then goes completely out. No water will come out of the wand? Please advise. Thank you.


Needs new pump ... Karcher 2500 PSI Pressure Washer

Honda pressure washer model # exhp3640-1 3600psi 0=13hp has low water pressure out of triggers motor does not engage for higher pressure


... Pressure Washers

Engine starts up on honda 2500 pressure washer water comes out wand but will not get up to pressure


Have you checked the hydraulic fluid level in pump? ... Honda Maxus Pressure Washer MX5222

I have a troybilt 3300 psi pressure washer with a gx390 honda engine. Replaced carb with new one . washer now will start and runs fine under load but let off water and carb goes up and down and backf


... Pressure Washers

I have a Honda 2500 power washer and I was using it then all of a sudden the pressure stopped from coming out of the wand there is water coming out from the main garden hose but it seems that the hose to the wand is not getting water what should I do...


... Honda Maxus Pressure Washer MX5222

Honda GCV 190 won't start - Honda Pressure Washers


... Honda Pressure Washers

Honda GCV 260 won't start - Honda Pressure Washers


... Honda Pressure Washers

We have a Honda / Husky Pressure Washer 2600 PSI GCV 160. Pressure from gun is way off.


... Honda Pressure Washer PSI 3000

My honda gc 160 pressure washer i have to take the tip off the wand to get it to get to have pressure.


With the tip removed you have pressure? or you have flow. Usually, with no tip you have very little pressure with lotsa flow. Sounds like tip clogged up. Have you tried other tips? If you hold the tip up to the light you should be able to see through ... Honda 2500 PSI Gas Pressure Washer

My Husky pressure washer 2600 psi powered by a gcv 160 Honda. Engine starts no pressure other then from water source and soap is not being dispensed


It sounds like the (RMW 2.2 G24) pump has gone out. Mine had this problem after about 6 hours of use. I was able to order a new pump for around $160.00, and then installed it myself. Go figure it was just out of warranty. I think my next pressure was ... Pressure Washers

My Honda GCV160 Pressure washer runs great, but isn't creating any pressure out of the nozzle. Not even a drop out of the wand. Its been on hiatus while I've been recovering from an injury for 3mos. It worked great the 3 years prior. Is there a kit and a schematic to rebuild this pump at a novice level?


Take hose and gun off pump.Start engine.See if pressure comes out of pump.Next, remove water hose and look at filter washer.Clean or replace filter washer.Turn on water and it should come out of pump on other side. ... Honda Pressure Washers

Honda gas powered pressure washer--runs great and I get pressure throughout the system but nothing comes out of the wand itself. There seems to be no clog throughout the system . I have cleaned all parts. When the unit isn't started I can get flow throughout the system


... Pressure Washers

My Honda gcv 160 is leaking oil - Honda Black Max 2600 PSI Pressure Washer


... Honda Black Max 2600 PSI Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1196 seconds