Having problems with your Honda Gx110 Gx120 Gx140 Gx160 Gx200 5.5hp Bare Muffler ?

Engine cranks on first pull but can't get throttle to reve up speed for tilling?

\015 Replaced air filter, rebuilt carb, ajustments have little effect. only reeves up when runs out of gas. throttle lever movement produces little effect.\015

Answers :

Look for a spring between the throttle and the governor arm
Repair Help & Product Troubleshooting for Honda Gx110 Gx120 Gx140 Gx160 Gx200 5.5hp Bare Muffler

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Engine cranks on first pull but can't get throttle to reve up speed for tilling?


Look for a spring between the throttle and the governor arm ... Honda Gx110 Gx120 Gx140 Gx160 Gx200 5.5hp Bare Muffler

Have a dd603 with an issue...took off the arm and the metal silver disk (the ones with holes) to get to the wash impeller-(the thing with blue blades) the wash impeller will not spin-which I think is part of my problem, since i looked at the lower drawer and was able to spin the blue blades easily...was also able to pull it right out. Cant pull out the upper wash impeller!!!! Really want to get this fixed before my husband gets home and I get the lecture about how I purchased a cool looking d


Lol I don't know a lot about dishwashers, just do him good and tell him afterwards, and then hire a mechanic to look at it.Why would you want to pull the propellers off anyway? The top one doesn't pull off because it's screwed on, and the botto ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I can get the motor to start but it idles rough and does not get to full throttle before shutting itself off. Also very little water pressure coming out of gun at highest throttle speed when it does run very briefly.


You need to probibly just clean out the carb. ... Pressure Washers

Throttle problems Homelite pressure washer model UT80709A. bought it 10 months ago with no problems and stored it for last 9 months. Before doing so, drained gas, oil. Brought out of storage a few days ago, filled with fresh gas, oil, cleaned air filter. Starts great first try but after about 30 seconds the throttle starts visibly revving the motor a litlle at first then gradually faster and faster until it seems to flood and die. Then you cant start for about an hour and its the same story. Hav


... Homelite Pressure Washers

Karcher k 2400 hh engine starts but i cant get to throttle up


... Karcher 2500 PSI Pressure Washer

Checked everything, all knobs in the right position but after pulling the cord many times it won't crank up, this is the first time I am trying to use it, it is a Homelite 2600


Hi, even though i am stating the obvious , please check that you have petrol/gas in it , the fuel tap is turned on and that there is oil in it ( it has a internal oil alert switch that stops the machine running if there is little or no oil in it and ... Honda Pressure Washer PSI 3000

Hi i have inherited a karcher kb9040.it has only been used 4 or 5 times so i dont realy know how it should sound when. water is suplied to it it surges when you pull the trigger you only get the presure of a good hose pipe jet should the motor speed up when trigger is pressed regards ****


Hi there!\015\012 when you got as good as pipe pressure,you need to accelerate the speed motor to have a good pressurise water for your purpose,the pressure washer has a surge regulating valve as you trigger water gun the pressure blow up, ... Pressure Washers

Had something in pump had service guy fix it he cant get code le out i dont want to pull it out cuting power di not fix can you help


LE error code is a water leakage underneath the sump pump. There is a sensor with 4 wires. Could be corrosion on it or there is actually a leak underneath. You best bet would to go take the underneath appart look at the sensor and look for signs o ... Samsung Dishwashers

Starting problem will not stay running spray starter fluid will run till out, itis like it is not getting fuel new fuel added just cant keep it running. any suggestions/ Never had this problem before, thanks scott


I had the same problem and what I did fixed mine. I got it running with the starter fluid then pushed the linkage (Rod) on top of the carb and ran the engine wide open (by pushing the linkage), then released... then wide open again. I did this 4 or ... Karcher G3025OH Pressure Washer

Ariston dishwasher as 150 opened door during cycle to put a dish in closed door washcontinued but water came out since then cant seem to get any water in macine seems to start wash but no water and first lihgt flashes


... Dishwashers

My honda gx motor labous when i pull the lance lever,so i cant get full pressure, i have changed the plug,and cleaned the carb,it runs fine on idle, it has a interpump w73, but i dont think its the pump at fault


Check the govenor and make sure that it is free to move ... Honda Pressure Washer PSI 3000

I have a G863scvi intake drain light is flashing unable to retrieve a repair manual it seems we cant get one? Any way screens are clean Im about to pull this unit out does no good if your unable to fi


... Miele 24 in. Incognito G863 SCVi Built-In Dishwasher

Mdb6709awb1 wont start anymore at first i had to pull up and hit start key severa times to get it to go now nothing..


... Maytag MDB6709AWB - MaytagR JetcleanR Plus Dishwasher

I try to pull the rip cord but it just gets stuck and i cant start it how do i fix it


IF YOU HAVE BEEN USING THE PRESSURE WASHER AND THEN TURNED IT OFF,THERE WILL STILL BE PRESSURE IN THE HOSE.YOU WILL NEED TO SQUEEZE THE TRIGGER ON THE GUN WHILE YOU START THE ENGINE. ... Karcher G3025OH Pressure Washer

Telmann Dishwasher TEL 12DWM. Dishwasher started to make weird wooshing start-stopping sounds at the beginning of the wash cycle so I stopped it. Since then the lights are on but wont go regardless of where the switch is set to. Have pulled the pump off and the inlet pipes and blown to remove any blockage but still no luck. Cant get into the water jet part due to connectors that require specfic tools to remove and replace. Any thoughts?? thanks in advance, Michael


... Dishwashers

I have a Briggs and Stratton power washer Quantumpower 5hp water driver series 1750 PSI 2.0 gal min model # WGV1721 . I got it used and it was always a bit hard to start but always started. Pull cord frayed and broke I bought new cord and a neighbor replaced for me. Now it does not want to do anything when pulled. I can't get top cover off that has screws with round holes instead of phillips or standard slots to get to pull cord winding


Spray well with WD-40 or similar, and take a small chisel, on it's edge, and hit hard enough to allow chisel to dig in to head of screw, making a "V" like slot in the head, then angle chisel slightly and start tapping in direction of loosening(counte ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

Pressurewasher runs fine then shuts down and cant pull


Same thing happened to me and I found out that water was getting into the carb filter media. Try taking the carb filter cover off and see if the foam filter is wet. If so, try starting without the filter and see if it works. \012\012THis issue use ... Pressure Washers

Why cant i get h2o to come out of my honda pressure washer? i disconnected hose, and no flow..was just workin fine other day


... Troy-Bilt 020528 Gas Pressure Washer

Dishwasher problems I have a counter top dishwasher and it's not cleaning things like it used to i think its clogged but i cant get to the drain because it is in the bottom i tried draino but it didn't work i also tried unscewing the bottom but i cant get that part out i think there is somthing stuck in there.


First thing to check water hose that connect at back of machine. pull the screen out and clean it. use a pliers. I run my under water then use a q-tip if its clog to clean the rest.\015\012\015\012Then pour a cup of vingar in machine and ... Danby 22 in. DDW396 Free-standing Dishwasher

We bought an aeg favorit 50674 dishwasher ,last week and yesterday i went to open the door to get the dishes out and the door wouldnt open.i tried again but noticed that it had caught on yhe side panel and was bending the panel.not wanting to make it worse i phoned the comit store that sold me the machine they said it was not their fault and wasnt covered on the warrenty .i still cant get my dishes out cant you help.thanks caz ivey


... AEG Dishwashers

Troy bilt 2600psi 2.3gpm model 160 pressure washer, I hooked everything up like normal, It cranked up fine, when I pulled the trigger on the gun it stalled. When I try to crank it back up the cord wont even pull like its stuck any suggestions would really help me tks..


This sounds like the pump has dead headed. I.e. the unloader valve is sticking. Unhooking all of the hoses should eventually allow everything to free up. Once it is free what you should do is add about 3 ounces of oil into the water inlet connecti ... Pressure Washers

I have a Whirlpool DU810SWLQ0 that will not drain. I've pulled the unit out, snaked the drain tube, pulled the motor/pump, and pipe assemblies, and cleaned the food trap, which I also removed. I've run the dishwasher with a bit of bleach, and the water will pump in, get processed by the agitator, and be heated. When the rinse cycle comes, dishes get covered in food, and are never clean. Waste water was being used for a clean rinse. I've run the dishwasher with the drain dangling in a bucket,


Refer the wash system assembly dwg. Check if the ball (item 21) is sitting correctly. If it is out of ali ... Dishwashers

Honda gc160 when I first pull it. It wants to start. Then dies in 1/2 second. I have put a new fuel punp, plug, and coil on it and opened the carb at float. cleaned it there. it will not do anything after the first pull untill 15 min latter, then it does the same thing ?


... Pressure Washers

8hp honda engine on log splitter. costantly stalls as governor opens throttle to maintain rpm. engine starts to stumble then stalls. When revved with throttle acts similar. somewhat better when hot, somewhat better at half choke. have pulled carb and checked bowl, float, pulled main jet checked, blew carb out but no better. No dirt or gum in carb, looked new. all gaskets looked good. engine has low hours.


... Honda 8 HP Engine

Cant get to the filter on a Quiet Guard 2 Kenmore dishwasher


Water is forced through the spray arms of a dishwasher by the unit's pump and motor assembly. The force of the water propels the spray arms, spraying water and detergent onto the dishes on the dishrack. Depending on your model, you may have onl ... Kenmore Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0741 seconds