Having problems with your Honda Karcher G2400HH-R Pressure Washer ?

Not enough pressure

\015 Got a 2400 psi karcher pressure washer and it is surging. Not a steady spray. We put in a new spark plug. drained gas and carburator. Used new treated gas. Still surges? \015\012\015\012I have a pressure washer that surges whenever I press on the wand. The pressure is on for about 2-3 seconds and then it dies down like a water hose pressure for the same amount of time. It keeps doing this the whole time I press on the wand\015

Answers :

Change the sparkplug
Repair Help & Product Troubleshooting for Honda Karcher G2400HH-R Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a model du1145XTPQ dishwasher. I doesn't seem to fill with enough water so I have to add with every cycle. The repairman says that there is no filter and my water pressure wasn't high enough. The water company was out and said water pressure was at 75pounds and that was not my problem. Is there a filter somewhere that might be cloged? thanks


The dishwasher has a float switch which detects if the dishwasher is filled. If the travel of the float is not sufficient it may be triggering early and causing the inlet valve to shut. Also see page 21 in the ... Whirlpool 24 in. DU1148XTP Built-in Dishwasher

Hi ..I have an Excell gas pressure washer model no. Exwgv2121-3 with Faip 2100 psi 2 gpm vertical shaft pump..the problem is that there is water leaking from every weep hole at the bottom of the pump when running. Oddly enough,the pump still puts out significant pressure but less than it should due to the leaking water. What is the most likely cause of this?..is it the high pressure water seal(s)? If so,how do I repair it?


... Pressure Washers

No pressure I have a husky 1750, With all connections clear of any obstructions the pressure washer turns on sounds normal, but when you pull the trigger there is no way near enough pressure to do anything..The gun and H/p hose is brand new..Any ideas?


It is probably air locked....Here's what you need to do. Connect the garden hose, and HP hose, but not the gun. Turn on the water, and let it run while you make sure that there are no high points in the garden hose that can trap air....Work the hos ... Pressure Washers

I have a bosch aquatak 1300si the pressure has dropped off considerably.It usedto cut out automatically when it reached operating pressure and only cut in again once you started to wash ,now it runs constantly but does not achieve enough pressure to wash effectively


... Pressure Washers

I have two DeVilbiss issues: First, on my pressure washer, I no longer get pressure on "high" mode from the hose. I prime the pump but it doesn't seem to be creating enough force for a high pressure. Second, on my generator, the gas from the gas tank leaks out. The tank is plastic or poly and don't know if it's a gasket issue.


... DeVilbiss Pressure Washer Hose 3600 Psi 25'

Not enough water Pressure to clean dishes, 6yr old Bosch


Replace the pump, if you go through the trouble of repairing the pump and all the disassembly and then more problems will probably ensue. As far as location it is usually located under the washer. Accessed through the front service panel. Make sure y ... Electrolux 18 in. ESL4114 Slim-Line Built-in Dishwasher

Our Kitchen Air KUDIo1Ilbl6 DW is 6 years old. The dishes are no longer getting clean. It sounds different in the washer. I question the pressure is high enough inside the unit. I ran vinegar through the unit, did not seem to matter. The temp is 140 the pressure from our well is the smae as when we installed about 55 psi. I checked te screen it seems to be clean. Any thoughts


Hi\015\012\015\012If you are observing that the dishes are not clean, then you'll need to follow certain steps to be sure where exactly the issue. First thing to check for is the detergent cup and spray arms. Check if the dishwasher's sp ... KitchenAid 24 in. KUDI01ILBS Stainless Steel Built-in Dishwasher

Have a LG model LD-14AW2 dishwasher which has done good service for many years However, it now sems not to have enough water pressure to operate all the rotary sprayers at the one time - thereby not cleaning properly Have purchased a manual and raken the whole machine apart looking for a partial blockage of the water ways - non found - all looks perfect - still no water pressure I would suspect the pump - however, would have thought a pump either gave full service or stopped - not parti


Hi The issue seems to be with the float switch assembly that is bad and should be replaced. Float assembly is found inside the dishwasher's tub, on the bottom. The water that ... Dishwashers

Dishes don't get very clean. Especially anything oily or greasy. I don't think the water hot enough or the pressure isn't good. House water pressure is fine. Using gel soap.


If they have a residue or spots the problem is hard water. www.dishwasherfilter.com has a product to solve this problem once and for all. It filters the water going into ... Dishwashers

Pressure washer is not sending out enough water to pressure wash


Did you rate this? We are having a problem with self rating by our experts. If you did not rate this or do not believe it warrants a rating of very helpful please rate it as NOT HELPFUL. Experts cannot override your rating and seems to be the o ... Coleman Powermate DuraBuilt 1400 PSI Pressure Washer

I just bought a used Kenmore standalone dishwasher and ran it for the first time. The dishes on the top did not get clean and the soap did not come out of the closed soup dish. at one point I took a shower and was wondering if that might have influenced the water pressure enough to cause the problem. Is the soap supposed to open during the wash and could the poor water pressure prevent the top shelf from getting properly washed?


The inlet filter is probably clogged. Try letting it fill up. Open the door to stop it right after it starts to wash Pour a gallon or two of hot water in and see it it works better Stop and do this everytime it goes to fill up. If the door opens ... Dishwashers

The pump doesn't seem to put out enough water pressure to turn the various revolving heads/nozzles in the washer - all washing heads are operable (ie unblocked) while the S shaped nozzle at the base and the small round nozzle at the top/ceiling of the cabinet do revolve slightly or slowly - but the two main nozzles spout water but not enough to revolve Is this a defective pump or a partially blocked pump ? - or something else - I have checked everything else and they appear to be functioning


It will be helpful to know the make and model number of the dishwasher to diagnose the problem you have.\015\012\015\012Generally this is attributed to a blocked chopper assembly in the wash circuit but hard to be sure if your model has o ... Dishwashers

Is there any way to get more water or higher pressure to my Frigidaire 300 Series dishwasher? The water in the kitchen has good pressure, but we can't get enough into dishwasher. Chip


Make sure the water supply valve to the dishwasher is fully open. There may be a internal main valve trouble restricting the water flow. Disassemtle to fix.\012\012Dishwashers are typically filled by one of two methods: ( ... Frigidaire Dishwashers

There is not enough water pressure to properly operate. (House pressure is unchanged..)


Make sure you have the appropriate size inlet water line. if it is to small it won't provide the necessary amount of water. This is usually the problem, you may have a pump issue, but check the inlet line size first ... Kenmore Elite Stainless Steel 24" BuiltIn Dishwasher with TurboZone Rotating Spray Jets 13103

I have an shx65905uc bosch dishwasher that runs and works except for that there is not enough water pressure to rotate the top wand or operate the top sprinkler. The bottom wand does have water and turn and does the top but it is not enough to turn it. If i remove the bottom wand and plug it off then the top will work properly. I have cleaned all screens and removed the plate to access the pump and all seems fine. Any Thoughts


... Bosch SHX65P05UC Dishwasher

Water pressure My wife put a cast iron pot over the agitator in the the dishwasher, now there is not enough water pressure to bring the agitator up or even make it spin.


... GE 24 in. GHDA986KSS Built-in Dishwasher

Not enough pressure through the hose - Pressure Washers


This issue usually comes from a clog in the output of the pump. Isolate the clog by checking one item at a time.\015\012\015\012SAFETY FIRST!\015\012\015\012With the engine OFF, disconnect the output hose from the pump. ... Pressure Washers

DISHES ARE NOT COMING CLEAN BYPASSED THE DOOR LATCH TO WATCH CYCLES,LOOKS LIKE THERE IS NOT ENOUGH WATER PRESSURE TO ACTIVATE THE WATER TOWER AND ROTATING ARM?WATER PUMPS OUT BUT NOT ENOUGH TO MAKE THINGS MOVE?


I had the same problem and fixed it by disassembling the lower spray arm and return filter, and cleaning all the junk out.\015\012Most dishwashers have 'risers' that bring the water up to the top\015\012sprayer or arm located under the top rack ... Dishwashers

It appears that there is not enough water pressure through the sprayers to to wash food 'deposits' off the plates and dishes.We have well water and it has a some what high lime content so I suspact that there is some calcium / lime clogging in the machine. I thought of removing the pressure pump to see if that is clogged up but before doing this, have you any other sugestions(i.e run vinegar through the pump? ). The holes in the sprayer . rotating arms appear to be clean.The machine has been e


The water-inlet valve lets water enter the machine. Make sure it’s not clogged. There is a screen on the inside of the valve, this sometimes gets clogged up with debris. There is a video of this at ... Kenmore 24 in. 16032 Built-in Dishwasher

Husky ran great for couple of hours. Now no pressure at all. Water comes thru for suds, but no near enough. Engine runs fine but will not build pressure. Checked for trash blockage-all clear. Thanks, Ed [email protected]


Same old problem... water admitance valve sticking.\012\012Remove the valve spool and clean the bore with crocus cloth on a dowel rod.\012\012Replace O rings and lube lightly with plumber's grease. Reassemble... good as new! ... Honda Pressure Washer PSI 3000

Porter cable pressure washer starts great, but there's not enough pressure. PSI is 3000


Check the seals and o rings on the connections could be sucking air ... Porter Cable Cable Commercial Pressure Washer PCH3200

It does not seem that my dishwasher arms are putting out enough water pressure. the top arm does not spin at all the water just spits out of them. my water pressure has not changed in the house and it does this with nothing loaded in it.


Sounds like the water pump is clogged,remove hose and **** out with shop vac,thanks-mike ... Kenmore Dishwashers

Hi, I'm trying to find out at what pressure(psi)the water supply needs to be at in order for this model to run(frigidaire dishwasher pld2855rfc3). I have well and not sure that the pressure is high enough? Thank you! Jason


Normally 15-25psi is operating range ... Dishwashers

My Kitchen Aid KUDS01DJSS0 seems to have water going to the upper spray arm (I see water coming out of the unit just beneath the upper rack), but the pressure doesn't seem to be high enough to clean the upper rack. No evidence that water is coming out of the spray arm on the very top. Lower rack dishes seem to clean OK. I have already removed the whole upper spray arm assembly and inspected the flapper valves that the middle sprayer goes into. I suspect that it's not making good enough contac


... KitchenAid Dishwashers

The engine will start but I'm not getting enough pressure when I press the the sprayer gun. Water is coming out but no pressure. Not sure what to do.


This can be caused by three different components. Either your unloader valve has failed, your valves have stuck open in the head of the pump or your water seals are worn. If you get an initial jolt of pressure when you squeeze the trigger then we kno ... Karcher 2500 PSI Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0638 seconds