Having problems with your Honda Karcher G2400HH-R Pressure Washer ?

Could someone please help me i have a lavor 160 superwash and every lance works except when i put the turbo lance on i get full pressure for a few seconds then goes low then high etc etc it has 2 be something simple so please anybody all advise needed thanks


Answers :

Repair Help & Product Troubleshooting for Honda Karcher G2400HH-R Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Could someone please help me i have a lavor 160 superwash and every lance works except when i put the turbo lance on i get full pressure for a few seconds then goes low then high etc etc it has 2 be something simple so please anybody all advise needed thanks


... Honda Karcher G2400HH-R Pressure Washer

When I turn on the shop force 1750 electric power washer I get water pressure in intermittent time frames. For example, it may run for a second then stop for ten seconds, then start again for three seconds then stop for 3 seconds then start for a half a second then stop for five seconds etc. until ?. This type of pattern continues for at least ten minutes, which is when I give up. I have tried adjusting the the water hose pressure, high, low. middle, nothing changes. This happen when I have the


The usual cause of this is sticky Orings in the water admitance valve.\015\012\015\012Take the valve apart and clean the bore with crocus cloth wrapped around a rod and replace the Orings and lube with a bit of plumber's grease and reasse ... NIB Shop Force Universal Pressure Washer Accessoriesnib

Hi i have bought a RAC HP 132 jest washer and it constantly blows the rubber wahsers around the attachements when using the lances. I have tried water pressure high at tap, low etc. Any suggestions? Thanks Shane


... Pressure Washers

I have a Pressure problem on my PowerCraft pressure washer. On initial switch-on the machine runs at low pressure. If I then rotate the end of the lance to detergent application mode and then rotate it back to high pressure mode the high pressure kicks in and all is well. Is the lance faulty?


... Pressure Washers

I have a kitchenaid dishwasher, SS, model # KUDIO1ILBL6. When you press the ''normal'' button to run it, nothing happens. Tried other cycles and same thing, the green light goes on above the cycle but its just not starting. I tried resetting by opening, pressing high temp scrub then energy saver dry, high temp scrub, energy save dry, then close and hit cancel. Is there any other combo to reset it? or does it sound like something else is wrong? thanks!


... KitchenAid Dishwashers

Replaced al of the valves but still will not operate on high preasure. Will build to high preasure only for a couple of seconds then back to low preasure.


Your bypass pressure valve is weak and needs replacing,its letting water pressure bypass the pump going to the pressure gun ... Northstar Pressure Washer 3000 PSI

High limit light goes on and unit shuts off about 20 seconds into start of cycle. Disconnected both wash and rinse heater elements problem continues Disconnected white wire at high limit thermostat problem continues disconect white with blue tracer problem continues whacked thermostat with pliers no luck whacked rinse heater thermo with plers no luck relay for rinse heater clacks and unit shuts down


Well, while I must admit that "Percussive" maintenance, sometimes works, as you have discovered there is more to servicing than, just "Giving it a good whack" lol.\015\012\015\012The problems with these units, is usually to do with the Thermost ... Jackson 25 in. TempStar HH Free-standing Dishwasher

When I switch my karcher k4.97 washer on it just sits and pulsates(on off on off etc.)When I squeeze the trigger it runs perfect,but emits a very low pressure.Then when I release the trigger it reverts back to pulsating. I have tried the popular fixes like cleaning lances,filters,making sure its not airlocked etc.I have even fitted new parts(seals to the pump etc).There are no leaks what so ever.


You have an internal crack in the out let head of the machine very comon in thease machine and not expencive to fix ... Alfred Karcher K 5.93 M Electric Pressure Washer

Rockworth Powertask Pressure Washer : model no AROW4P seems to rev flat out, hav to put choke in middle to use so not to fast revs. Im sure it used to rev higher and lower according to use of lance. could it be something to do with 3 valve things if so how could i tell if ok. put clean fuel in. oil level ok.another problem is when switched on water comes straight through lance,trigger makes no diffrence. please help


... Pressure Washers

When I use my Karcher pressure washer it works perfectly until I release the trigger. Instead of remaining silent until I pull the trigger again the motor intermittently, at approx 2/3 second intervals, starts and stops. Could you please advise what is causing this to happen please.


What it is doing is keeping the pressure up in the hose. It is completely normal for it to do that. they all do it. Listen to others in use and it will do the same thing. Nothing to worry about. ... Karcher Pressure Washers

My drawers are both flashing F1 and sound as though they are in high gear. I have unplugged them. Please advise. Please give detailed instructions.


F1 signifies that the flood sensor in the rear of the cavity on the \015\012bottom drawer has been activated. This is caused by water leaking into \015\012the rear of the drawer. I have had the same problem with my own and \015\012also repaired a ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I have a tpw 2200 pressure washer that has lost high pressure. i have low pressure but not high pressure.rn The machine i have is a titan tpw 2200 if some body can tell me what is wrong please help. Thank john


Pour a large amount of liquid TSP into the fresh water inlet where the garden hose connects and let is sit for a couple of days.\015\012This is how I fixed my pressure problem ... Pressure Washers

Model KUDI02CRBS1 I used to be extremely happy with my KA dishwasher, but lately dishes are coming out milky and gritty, some dishes still semi dirty. After cycle is complete top inside of door is dirty and soap dispenser door open but some soap remains. Please advise to help me trouble shoot. Please, list from most obvious/simple to worst case etc. Thank you G


Hi\015\012If you are noticing that the dishes are not clean, then there are a few things to check for. Check the soap powder if it's kept in a dry environment. Also try replacing the powder with something like a gel or liquid. Next ... KitchenAid Dishwashers

My Kitchenaid ModelKUDI01TJBL0 only leaks at initial start up. Just after the water fills, the first few seconds of the wash cycle. It pours out the front door for a couple seconds than no more for the rest of the wash. It is level, no cracked arms, or loose pumps.Splash guard is in place. The float seems to be working, not too much water in the bottom. I am stumped. Although I do feel that it has something to do with the level of the water being too high, when the arm starts turning, it makes a


Is the unit level or leaning back if leaning back it is morelikey filling too much if level make sure the float moves up/down easy if not clean ... KitchenAid 24 in. KUDS25 Built-in Dishwasher

Not cleaning my dishwasher goes thought all it's cycles,but when it is done the dishes are still greasy and the top dishes are still dirty.i have checked the water pressure the psi is 64. i have also cleaned all the wands and drain.can you please give me something less to do.my dishwasher is only 3 yrs old. i have not been able to use it in about a year know.


Check the wash arms make sure that they can spin ... open in mid cycle check water level and arm spin...also check water temp... hope it helps ... LG 24 in. LDS 5811ST Stainless Steel Built-in Dishwasher

Dishwasher top drawer was dead so i was told to change the heater under the drawer i did that but now i got more broblems the top drawer lights up just beeps for a second and does nothing as for the bottom which did work before now works for 1 full minute and then just flashes on and off iam confused can tou please advise me joseph.


Hi,Whenever the Drawer is Dead, there could be a couple of Reasons. First, it could be a Bad Heater Plate or Bad Control Board on the Front.You could remove the Control Board and Check.More often, you would find visually, that they are Ho ... Fisher and Paykel 23 in. DD-603 Built-in Dishwasher

Portable Dishwasher I have a older model portable dishwasher. It works great and until it goes out I would like to keep it. I am wondering how or what I will need to make the dishwasher a non-portable. I get so tired of moving it across the kitchen floor. Is there anyway I can hook something up to my lines underneath the sink so it will stay where it is? it is only about 10 ft away from my sink but that it alot of moving around when it is full of dishes. Please help. [email protected]


I sent you and email with some instructions, Look to hear from you soon!! ... Kenmore 17252 Free-standing Dishwasher

I have a belling IDW604 it starts to fill and the program light flashes but it stops within 15 seconds or so. When I open the door it has just filled the bottom filter with water. I have no error code. Any advise please?


I have the same problem .i searched the net and cant find a solution .any help would be great ... Belling 24 in. IDW603 Built-in Dishwasher

I am getting a clicking/ticking noise (1 click/second) from my Maytag (model MDB9100)dishwasher after it goes through its auto clean normal wash cycle. At the end of the cycle the arrow = clean and the clicking sound is there. I opened the washer door for about 1 minute noted the soap containers are empty, dishes clean, machine still hot/steamy. Closed the washer door and the clicking sound resumes. Please advise.


This is the heated dry timer going through the drying cycle until the dishes are dry. The dry cycle runs on a timer and it will click through the cycle until it finishes the amount of time preset on the timer to dry the dishes. ... Maytag MDB9100A Dishwasher

Westinghouse Silhouette 906 dishwasher cuts out after pre-wash, sometimes goes through cycle to rinse, then cuts out. Obtained service from sole dishwasher technician in Ballarat - he was very discourteous, claimed to have corrected fault, charged $125.00. Fault not fixed - that was many months ago but don't want him back. Please advise


... Dishwashers

I have a Honda gc160 5.0 pressure washer. All fluids are fresh. Water is hooked up with plenty of pressure but the water pressure is up and down then goes completely out. No water will come out of the wand? Please advise. Thank you.


Needs new pump ... Karcher 2500 PSI Pressure Washer

The sprinkle light is blinking of my miele turbothermic plus dishwasher. hence the time stops. when i check the sprinkler (the low one), there seems to be no problem, no dirt, turning goes smoothly etc. jelle vanhijfte


... Dishwashers

Low flow Please advise how to disassemble Delta shower head A112.18.1 I have the handle portion apart but can't find the key to removing the head portion. Your help would be appreciated. Gene


... Dishwashers

My dishwasher makes the sound like it wants to start but doesn't. I had this problem about 4 years ago but the repair man would not allow me to see what he did. It took him all of 30 seconds to do something under the front of the dishwasher. I do not have the money to call the repair man again. Please help. I have a ge dishwasher.


You my have allowed your dishwasher to sit for a while. The seals in the motor and the pump can get frozen. Sometimes high minerals in the water can stick the seals together not allowing the motor to run and it hums.\015\012\015\012 ... GE 24 in. GSD4320Z Built-in Dishwasher

I have a Whirlpool ADF951, it has power to it and was working fine, the power light is on and the green light to the far right of the cycle lights is flashing, I can only get any response if I hold the start button in for about 10-15 seconds, The machine stops the light flashing and makes the noise like it is starting , that goes for about 20 secs then returns to the flashing light stage, any idea's please


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If the light flashes, pauses, and then repeats. When\015\012the dishwasher doesn't sense a water tempera ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1078 seconds