Having problems with your Honda Maxus Pressure Washer MX5222 ?

Pressure washer won't pull the from the soap dispenser

\015 There doesn't appear to be any soap moving through the tube. Used to work, but doesn't seem to anymore. Any thoughts??\015

Answers :

Nozzle dirty, clean out nozzle with small diameter wire. Soap dispensing only happen at nozzle low pressure setting
Repair Help & Product Troubleshooting for Honda Maxus Pressure Washer MX5222

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The soap will not dispense--how can I fix it? ... My Aquatak 150 pro x wont draw detergent from the two small detergent tanks at any ... soap not pulling on low pressure. opposite water going thru pick up into container The check valve on the .


... Bosch AQUATAK 150 PRO X Pressure Washer

Pressure washer won't pull the from the soap dispenser


Nozzle dirty, clean out nozzle with small diameter wire. Soap dispensing only happen at nozzle low pressure setting ... Honda Maxus Pressure Washer MX5222

2050 PSI Gas Pressure Washer - 20244: my excell pressure washer wont start. pull start t...


... Briggs & Stratton Gas Pressure Washer 20244

Soap wont feed thru hose on pressure washer. - Pressure Washers


... Pressure Washers

I have a Ridgid 3300 PSI pressure about 1 year old. Works great on pressure but stopped dispensing soap its not stopped up but just wont pump soap out of container, the hose does not have a hole in it


... Ridgid Rd80702 3300 Psi 3.0 Gpm 7 Hp Subaru Ex21fi Ohc Gas Powered

Pressure washer soap dispenser - Pressure Washers


... Pressure Washers

Pressure washer soap dispenser - Pressure Washers


... Pressure Washers

I cant pull the cord in my pressure washer it feels like it stuck thiere is no pressure in it it wont pull


Take the sparkplug out and see if you can pull the cord then. If fuel comes out of the sparkplug hole the carburetor is leaking gasoline in to the engine filling up the cylinder causing the lockup. The carb has to be rebuilt. Another problem mice lik ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

Soap feed The soap feed hose on my Karcher 2650 does not suck up the soap into the washer. I pulled off the connector piece that the hose is connected to. I can blow through the hose. There is a little metal finger thing that you can tell pushes up into place when the water pressure is high. It seems like it is supposed to drop down and allow some soap through when the water is running. I found a loose(attached to nothing) gasket, looks like a little donut. It was just free floating in t


I fixed mine works good too, watch my video step by step i put it on youtube ... Karcher G2650HHR Gas Pressure Washer

HONDA PRESSURE WASHER WILL NOT PULL SOAP..SPRING TURNED IN FEED


... Honda Maxus Pressure Washer MX5222

Water coming out of the soap dispenser on the pressure washer


I would suspect a piece of debris is caught under the injector ball valve. It may also be clogged with soap if you failed to flush it clean after the last use. Disassemble the valve and give it a good cleaning. Be careful as there is a small ball bea ... Karcher PSI Electric Pressure Washer

Powerbase pressure washer doesn't dispense soap


... Pressure Washers

2200 psi husky briggs and stratton pressure washer used 2 years never used soap dispenser trying now is not drawing soap no longer have manual to see how to connect adjust can you help?


After a long none use, I tried to wash my driveway and powered on the washer,it did, but when i tried to engage the power washer by pressing the wand lever, it did not engage. What can I do to get the power washer working? ... Briggs & Stratton Gas Pressure Washer 20244

Comet 2.5 Gpm pressure washer pump wont **** soap anyone know what you have to do to make it start sucking soap


I have found many comet pumps to be plumbed wrong from the factory. Look on the side of the soap injector and look for the flow arrow, make sure its in the right direction. If it has worked in the past,then take it apart and replace the spring, check ... Comet GXD2527G Pressure Washer Pump

Homelite soap dispenser - Homelite Pressure Washer. EZ Clean 1600 psi 1.3 GPM Electric Pressure


... Homelite Pressure Washer. EZ Clean 1600 psi 1.3 GPM Electric Pressure

The pull cord on gas pressure washer wont allow me to pull it as though it is tangled up, But when i removed the housing, it woorks just fine


Sometimes the housing gets bent slightly. A lot of the housings have little taps or prongs that get slightly bent. I would take the housing off make sure it not bent or warp, to make sure there is nothing to block the free flow of then cord flowing. ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

I HAVE A NEW CRAFTSMAN PRESSURE WASHER WITH KEY START. I HAVE USED IT ONCE AND WHEN I TRIED TO START IT IT WAS HARD TO START HAD TO PULL START IT. NOW IT WONT START. LET PRESSURE OUT HAVE HOSE OH AND RUNNING, NEW SPARK PLUG HAS OIL, GAS FILTER FINE.HAS GOOD COMPRESSION, BUT WILL NOT FIRE GET SOME RECOIL. GETTING GAS TO SPARK PLUG AND GETTING SPARK. IM LOST PLEASE HELP.


... Pressure Washers

Honda pressure washer won't pull chemical. Line is not kinked. Removed intake fitting anf checked for clogs - not clogged. Appears to be drawing but not enough to pull the clorox bleach from the bottle. Using the soap fitting so that's not the issue either.


... Honda 2500 PSI Gas Pressure Washer

Pull cord wont pull - Pressure Washers


Ok i assume it is a gas powered pressure washer, if the pull rope wont pull out at all you either have a locked up motor or pump if it is out and wont go back in or recoil then the spring under the engine cover has either broke or come unwound.also i ... Pressure Washers

My Husky pressure washer 2600 psi powered by a gcv 160 Honda. Engine starts no pressure other then from water source and soap is not being dispensed


It sounds like the (RMW 2.2 G24) pump has gone out. Mine had this problem after about 6 hours of use. I was able to order a new pump for around $160.00, and then installed it myself. Go figure it was just out of warranty. I think my next pressure was ... Pressure Washers

I have an almost brand new husky pressure washer (one of the big ones). It has been a life saver so far. just the other day it shut its self off. its gas powered so of course i checked the gas and oil. then tried to start it back up. but when I try to pull the pull string it wont come out more than about 3 inches. i payed 400$ cash for it to use on the trucks. does anybody know how to fix that? thanks


IT SOUNDS LIKE YOUR FLY WHEEL IS BAD OR NEEDS TO BE ADJUSTED ... Pressure Washers

Troy bilt 2600psi 2.3gpm model 160 pressure washer, I hooked everything up like normal, It cranked up fine, when I pulled the trigger on the gun it stalled. When I try to crank it back up the cord wont even pull like its stuck any suggestions would really help me tks..


This sounds like the pump has dead headed. I.e. the unloader valve is sticking. Unhooking all of the hoses should eventually allow everything to free up. Once it is free what you should do is add about 3 ounces of oil into the water inlet connecti ... Pressure Washers

Pressure washer wont **** soap


... Coleman Powermate DuraBuilt 1400 PSI Pressure Washer

Fix soap dispenser on xtreme dw-1840 bv pressure washer


It will only draw soap when your using the large fitting they don't draw with the high pressure nozzles ... Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1051 seconds