Having problems with your Honda Maxus Pressure Washer MX5222 ?

Spark plug number

\015 What is the champion spark plug part number\015

Answers :

Repair Help & Product Troubleshooting for Honda Maxus Pressure Washer MX5222

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Spark plug number


... Honda Maxus Pressure Washer MX5222

What is the spark plug number for a karcher honda 5hp 2500psi pressure cleaner


... Karcher 2500 PSI Pressure Washer

I have a power washer, craftsman &.0 horsepower, 2900 psi, 2.3 GPM model number 580.752410. i was starter to wash my car, and stops? i change the spark plug, andput new oil in there. still do not working. some one helme in this problem.


... Craftsman 3000 PSI 27 GPM Briggs Stratton Powered Pressure Washer

What spark plug does a powermate pressure washer take model number pw0102405


... Pressure Washers

Washer won't start tried everything , I could think of changed spark plug tried new gas , Two things that bother me are . if i take out the spark plug and put my thumb over the spark plug hole theres no pressure and the wire that comes from the coil to shut off the pw it has continunity from the coil to the pin that sticks up to shut off the pw but it also has continuity from the coil to all parts of motor.


... Pressure Washers

11 hp honda pressure washer engine won't start. No spark at the pkug, bought a new coil and still no spark. This sysem only has a coil off the fly wheel and the spark plug. I even changed spark plug. Use the unit the other day, shut it down and on restart it won't start. Also, I disconnected the kill switch and the il lvel sensor so nothing was going to ground.


If you replaced the coil,check the wire and boot,check with meter for continuity.could be loose connection to spark plug ... Honda Pressure Washer PSI 3000

Troy built pressure washer won't start. It has a Honda 160 CVG motor. I used it for about a year and then it stopped working. I've replaced fuel and spark plug. Spark plug is soaked every


... Karcher 2500 PSI Pressure Washer

I HAVE A NEW CRAFTSMAN PRESSURE WASHER WITH KEY START. I HAVE USED IT ONCE AND WHEN I TRIED TO START IT IT WAS HARD TO START HAD TO PULL START IT. NOW IT WONT START. LET PRESSURE OUT HAVE HOSE OH AND RUNNING, NEW SPARK PLUG HAS OIL, GAS FILTER FINE.HAS GOOD COMPRESSION, BUT WILL NOT FIRE GET SOME RECOIL. GETTING GAS TO SPARK PLUG AND GETTING SPARK. IM LOST PLEASE HELP.


... Pressure Washers

HOW DO I FIX MY HUSKY MODEL HU80520 PRESSURE WASHER, IT WONT STAY RUNNING AFTER REPLACING THE SPARK PLUG? WHAT IS THE RIGHT SPARK PLUG FOR THIS UNIT?


... Pressure Washers

Won't start I have checked the spark plug and I have good saprk. I have checked the fuel sysstem and the primer bulb injects fuel. I have removed the head and cjecked for engine damage and all cycle correctly. Vaves opne on time piston shows no dmagae. side walls are smooth and not damaged. This engine was working fine but the pressure washer needed some O rings replaced. I have tried to start it with and without the pump attahced. Evrything on the engine looks fine. I removed the spark plug and


... Briggs & Stratton Briggs Stratton 2550 Psigaspressure Washer

I have a Troy Built 2500 PSI pressure washer with Honda 160 CVG motor. It won't start. I've replaced the gas and spark plug. Every time I pull the spark plug out it's soaked. Not sure


... Pressure Washers

Hard starting 6hp Briggs and Stratton power washer engine. I poured a teaspoon of gas into the cylinder; reinserted the spark plug and with one pull in ran fine. This is a choke start engine and it may take 12 to 15 pulls to start on a cold engine. The unit is clean. The air cleaner is new. The spark plug is new. The unit is 2 years old with very little use.


Hello. I have this same machine. Go to the auto parts store and get an aerosol can of starter fluid. Have a helper squirt some into the air intake while you start it. Then continue to squirt a little starter fluid as it runs for the first two mi ... Campbell Hausfeld Pressure Washers

I have a Pressure Washer VR2500 , 6.5 horsepower / 2500 PSI number on side 123K12-0134-E Residential - Excell. I do not know which is the oil drain plug for the Pump on the bottom. There is an Allens Wrench plug on the side. However when removed nothing comes out. There is also an Alans Wrench like plug towards the back, that does not want to come out. Which one is the correct plug and do you have a picture as I could not order an Owners Manual on-line? Please Advise!


Hi and welcome to FixYa, I am Kelly \015\012First here is the owders manual: \015\012http://www.excellpressurewasher.com/documents/p ... Comet GXD2527G Pressure Washer Pump

What spark plug does a Homelite 2200 PSI pressure washer use?


... Homelite Pressure Washers

Hi my scorpion squirt pressure washer won't start spark but no fuel at spark plug fuel is going into the carby


... Pressure Washers

Got spark, no fire. Dipped plug in gas. Not ENOUGH spark?


Ok lets assume for a moment that it does not even fire with gas inserted into the spark plug hole. Given that we have to assume there may not be any compression. Have you tested the compression? \015\012\015\012Just for girns lets do s ... Briggs & Stratton 020324 3700 PSI Pro Series Pressure Washer

Should my washer plug spark when plugged in


... Kenmore Pressure Washers

My power button cover broke on the dishwasher and I figured out the part number I needed, but when I put it back together I got the wires crossed on the board and door switch. Now the control lights up , but the dishwasher will not run a cycle. THe question is does the plug on the door switch have to be a certain way, because there are three wires and you can connect the plug both ways. I did turn the plug, but it still does not run. Did I break the switch? Bosch SHU9956uc/14


The wires do have to be a certain way on the door. Otherwise a door open can tell the board that's it shut and vice versa. The easiest way to do it, is test the switch with an ohmmeter, place the meter on the switch, push button in and see if the rea ... Bosch SHU9956 Built-in Dishwasher

Have a genarac pressure washer when trying to start the engine catches half way through the pull with spark plug out it cranks fine


... Briggs & Stratton Power Products 1539 Pressure Washer

Cant get to spark plug on troy bilt 2700 pressure washer


... Pressure Washers

Very Hard to Pull Cord to start engine on Northstar Pressure Washer. When I remove spark-plug it is very easy to pull cord. With plug reinserted it is extremely difficult to pull cord to start engine.


On the Honda motors very hard pull starting with no start ck for broken rocker on exhaust or intake, I've already repaired two with this problem...... ... Northstar Pressure Washer 3000 PSI

I do need the igniter for the burnner / my igniter i think it is the wrong one , it is too shot and the spray of oil do not fire/ i think the 'plugs' is little short to ignite on the spray , comes on and off / but i have sparks all times, only dos not get fire , do i need longer plugs !!!do go under the noze of spray!!


Send me a email at [email protected] I am an dealer for Northstar and many other brands of pressure washers. I need the model number off the machine if you have it. I can get you th ... Northstar Gas - Powered Wet Steam & Hot Water Pressure Washer 2700 Psi, 2.5 Gpm

I have an Excell VR2500 pressure washer with B & S 6.5 HP engine. It was running fine, but then stalled out and now will not start. Has clean gas and full oil. I pulled the spark plug it is producing a sufficient spark when starter cord is pulled. Any ideas what might be causing the problem? Please help.


The key things to check are the spark plug, the air filter, the fuel. If those are all new and in good shape then you probably have gum in the carburator. Get a can of starter fluid and a helper. One person squirt the starter fluid into the air in ... Briggs & Stratton Pressure Washers

My Maytag dryer blower and drum won't move...I re-plugged in the dryer and the plug-in sparked and then it the dryer stopped working...Is there a fuze to replace ?


You have a dead short to ground. ... Dishwashers

I have a mid 60's 6 hp Tecumseh engine on a Troybilt tiller. I used it to till my front yard and it ran fine. I let a friend use and it quit on him after a few minutes. It will not start. It has spark at the spark plug. I have thoroughly cleaned the carburetor by taking it apart, soaking it in cleaner, blowing out all holes and passages. I made sure the tiny holes in the power valve at the bottom of the fuel bowl are open. I have taken this carburetor apart five or six times over the years an


... Karcher 2500 PSI Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0478 seconds