Having problems with your Honda Pressure Washer PSI 3000 ?

Starts right up and as soon as it gets warm it shuts off but will start right up again


Answers :

Sounds like the choke is not operating properly
Repair Help & Product Troubleshooting for Honda Pressure Washer PSI 3000

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Starts right up and as soon as it gets warm it shuts off but will start right up again


Sounds like the choke is not operating properly ... Honda Pressure Washer PSI 3000

Pressure Washer I have a Porter Cable pressure model no.PCH2401.It works fine for 5 minutes,then I can hear the motor loading down and then it stalls out. I tried to start it and it was very hard to pull on. disconnected the water supply and if was very easy to pull and started right up. I noticed the pump was very hot.This unit has a thermal relief valve on it,shouldn't it have released when it gets to a certain temperature .I was thinking maybe this is why it might be shutting the motor


Any leaks from connection at pump to gun and wand assembly if so the valve is detecting leakage and open up again without u squeezing trigger it builds up in the head.if your trigger gun is leaking internally then you will need to replace the gun thi ... Pressure Washers

I have a Bosch SHU43 dishwasher, about 6 years old. After starting a cycle, it will run for a while, perhaps 1/2 to 2/3 of the way through the cycle, then shut off. After 10-20 minutes it will start up again, run for a few minutes, then shut off again. It ends up taking about 12 hours for a cycle to finish. The problem started off somewhat intermittent and has gotten worse over the last few weeks. I've checked the electrical box in the front right bottom, and the connection is good. I've even


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012I`m not sure since you didn`t mention it or perhaps I just interpreted it this way, but is it consistent at the same time or approximately or is ... Bosch 24 in. SHU43 Built-in Dishwasher

I have a hoda pressure washer it stats right up and while i was cleanning the wood fence i let go of trigger during about 10 min, and the motor started dying i pulled the trigger and it pick right up again any ideal what would make that do that? but one time i let it quit and i couldn't get it started,i had to wait about 5 min. then it started back up again.thanks


A couple of things, what makes the engine change tone and revs is pressure, depending on the age, it may have excessive calcium build up in the pump, there may have also been a build up of crud or a wasps nest in the end of the hose when you connecte ... Devilbliss DeVILBISS Devap DVH2600 Gas-Powered Pressure Washer

Engine starts runs good for 2 or 3 min the quites, will start right back up and run for 3 or 3 minutes, then shut off, will restart and run for 4 or 5 min then shut off.,


... Pressure Washers

My Frigidaire Dishwasher FDB1050RES2 gets stuck in a rinse cycle. The light on the front will be lit "clean" but the bottom of the washer is full of water. Opening the door does not turn off the "clean" light. For me to get it to run, I have to unplug it, plug it back in, push the start button until the ?washing? light comes on. I then push the start button once more and the dishwasher will begin to drain. I open the door as soon as I hear the water stop draining into the sink drain. This


By the descrition you are giving you will need to replace the main control board.Part number 154568401.you may also need to check the float switch.The part will run about 110.00 dollars from a local parts store ... Frigidaire 24 in. FDB1050RE Built-in Dishwasher

My pressure washer is bogging out and shutting off. It will run fine for a bit then it starts sputtering and shuts off. I changed the oil right before this started happening and yesterday i changed the sparkplug and it seemed to be working fine until I used it today on the driveway.


SOUND LIKE FLOAT IS STICKING ... Dewalt 3800 PSI Pressure Washer

The dishwasher pump will not shut off. Keeps going even after the dishwasher has been emptied of all water. Then the beeping sounds starts and will not shut off.I took it out thinking that I could get to the pump to see if there was something stuck in it but can only get limited access to it


Depending on the model, your float is off the switch\015\012 it is a round piece in either corner, that should float up and down\015\012 if you remove your toe kick and look at the bottom of that, you will see where the float comes throu ... Dishwashers

I have a Kenmore dishwasher (model 363.14478791). I hadn't used the dishwasher in a month. I turned on the dishwasher tonight and noticed nothing was happening, but I was getting a clicking sound. I moved the dial to the right to off. As I moved the dial to the right, there were lots of clicks and clunks. I started over and turned the dial to the start position. Some water went in, but then nothing happened again. I clicked forward one click at a time. Sometimes water came in. Then water star


... Kenmore Dishwashers

I have full power to the washer, but as soon as i hit start to begin the cycle, i lose all power. i then have to unplug it and then plug it in again and then i get power back agin. as soon as i hit start again i lose all power to washer again. im thinking maybe the mother board is shot????


... EuroTech 24 in. EDW154E Built-in Dishwasher

Dewalt Pressure washer keeps shutting off for no reason. plenty of gas and oil, water running to it. starts fine and as soon as I start spraying it shuts down.


... Dewalt 3800 PSI Pressure Washer

I have a 1 year old ridgid 3300psi 3.0gpm 7hp subaru fuel injected EX21FI engine. Once warm the engine will periodically surge for 30s to 2minutes. Wondering what i can do to fix the problem, it has done that since new. Also, once it is warm and you shut it off, you have to wait at least 30m to start it again...almost like it floods itself when it is shut down? Thanks


... Ridgid Rd80702 3300 Psi 3.0 Gpm 7 Hp Subaru Ex21fi Ohc Gas Powered

My pressure washer starts fine, shoots water OK. After running for 5-10 minutes cleaning siding I shut off machine. I go to start it again within a minute or two and the thing feels like it's just about seized. If i wait until the motor is completely cool, it will pull start freely and start right up. I think something is wrong with the pump, not the engine.


Your pressure washer may not have an ez-start valve installed from the factory. Without the ezstart valve, you will need to hold the trigger on the wand open to release the pressure to easily start your engine. This link will show you wh ... Briggs & Stratton Pressure Washers

Maytag Quiet Series 800 dishwasher won't start. The only button that I can get to work is pressing and holding the locking feature--that light eventually comes on. A couple of times I came back in an hour or so or the next morning and hit the start button and it started right up. Now it won't start at all. VERY FRUSTRATING!


... Maytag 24 in. MDB6100A Built-in Dishwasher

Dishwasher I have a whirlpool dishwasher that does not appear to be getting hot water. The washer water is cold initially and only seems to get warm once the heater in the base of the machine heats it. The hot water supply line does not get hot so I presume no water is being supplied. Is the water supposed to be hot at the start. If yes could this be caused be a faulty inlet valve and if so how can I check. The dishes are dirty especially on the top rack. Thanks for your help. David


Gendos is on track with his question. I have the same dishwasher and it doesn't get enough hot water to clean the dishes and runs for hours because the heating element wasn't designed to heat water, just maintain it. The only solution we have found ... Whirlpool GU2400XTP Built-in Dishwasher

I have a Kenmore dishwasher, and when we shut the door, without starting a ccyle or anything, the motor will start going!! When we do start a cycle, it will get stuck at some point during the cycle and won't sanitize or show the "clean" display light as being lit.


... Kenmore Dishwashers

Just got a used F&P Smart Drive 5.5 MW059. First few times I used it wouldn't always start on certain settings but once it did start it ran through just fine. On the fourth use, it was very difficult to get it to start and it just stopped after it filled up. Pausing and restarting, shutting of machine and retrying did not help. Was able to advance to rinse mode and got machine to drain water; however, instead of going into spin mode it just attempted to drain continously. I let it do its th


Did not realise this is a washing machine and not a dishwasher.\015\012\015\012Looks like some consultant has already been dealing with you on this problem.\015\012\015\012Hard to say if it is a simple as an inlet solenoid val ... Dishwashers

Gets to the end of the cycle (1 minute left on countdown) and just keeps running, does not start the "dry" mode. will run until i open it and when i shut it it goes 13 minutes left on the countdown but then gets stuck at 1 minute again. does not drain. has been doing this awhile, but until now it would simply finish the cycle when i opened, closed and reset it. now it just gets stuck again.


Hello,Welcome to FixYa.Based on your description ... Bosch SHU5315UC Dishwasher

GE PDW7300 dishwasher - must slam the door shut to get a light on the panel and when the START button is pressed, it looks like the dishwasher is cycling thru a wash, but there is no water. When I press the START cycle again, it seems like it thinks its pumping the water out for a few minutes, then the light will go off. If I start it again and push really hard against the door, I can hear the water go on. But if I stop pushing the door, the water stops. The dishwasher was installed in 2001, but


... GE 24 in. Profile PDW7300G Built-in Dishwasher

WHEN THE START BUTTONIS PRESSED DOWN THE 2 LIGHTS ON THE RIGHT OF THE PANEL LIGHT UP BUT WHE THE BUTTON IS RELEASED THE LIGHTS GO OUT AND THE WHEN THE DOOR IS SHUT THE MACHINE WILL NOT RUN


... Electrolux 23 in. ESL6114 Built-in Dishwasher

Kenmore Dishwasher- Console panel not working right , sometimes it starts and then shuts off in the middle of the cycle. Sometimes multible function lights are flashing but dish washer won't start


... Kenmore Dishwashers

Whirlpool quiet partner II shuts down right after start. Model number DU1345XTVB


... Dishwashers

Have a Westinghouse 905 dishwasher (guessing approx 5-10yrs old). When I turn it on it's starts is cycle as expected then stops after about 10mins and loses all power (can't turn it on or get any lights to light up for sometime almost like it needs to cool down) at this point the dishwasher is full of water. It is not the pump however as as soon as you can get power to it (sometimes some hours later) and turn it on the first thing it does is pump out the water. Any ideas??


It is likely the thermal relay is tripping. This could be because if you are feeding hot water to inlet the temperature of water is too high, or the dishwasher heater is faulty and overheating the water. Or it is also possible the thermal cutout is s ... Westinghouse Dishwashers

I can get the motor to start but it idles rough and does not get to full throttle before shutting itself off. Also very little water pressure coming out of gun at highest throttle speed when it does run very briefly.


You need to probibly just clean out the carb. ... Pressure Washers

My Husky HU 80709 gas pressure washer starts (most of the time) but if I shut it off to answer a phone call, etc.,I cannot get it started again. It's like it has a vapor lock or something. Any ideas what is wrong, suggestions to fix it, will be very appreciated. Thanks! [email protected]


I have the same power washer. \015\012\015\012When you go to restart it you need to hold the sprayer nozzle so the their is no pressure in the hose. It is even better if you take the tip off the spray nozzle and then while holding the spray no ... Honda Pressure Washer PSI 3000
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1404 seconds