Having problems with your Honda Pressure Washer PSI 3000 ?

I need the small valve that the soap pick up hose attaches to for a Honda 6.5hpGX200; 2800psi and the end of the spray nozzle


Answers :

Repair Help & Product Troubleshooting for Honda Pressure Washer PSI 3000

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I need the small valve that the soap pick up hose attaches to for a Honda 6.5hpGX200; 2800psi and the end of the spray nozzle


... Honda Pressure Washer PSI 3000

Model 01902 2350 psi . engine runs fine , sprays out nozzle but lower pressure and water sprays out plastic elbow on relief valve , that is supose to **** in soap if used , cant hold finger over spray from elbow , high pressure , took apart relief valve and plastic valves all orings are ok , brass pump seals look ok , all back together , still blows out elbow . ?? plastic spools were out by somebody else , not sure if they are in right , cant find picture to compare .


It sounds as if the non return valve in the elbow is the wrong way around .The o-ring normally goes in first then the ball then the spring. Try it and good luck. ... Pressure Washers

During installation of new dishwasher when I was attaching drain hose to pump I saw a small red rubber fap attached to end of pump discharge nozzle. Is this a backflow prevention or something to keep


It is a back flow preventer. Leave it alone and attach the drain hose. ... GE Profile PDW8400J Built-in Dishwasher

Honda GVC 160 lost pressure - noticed small black valve (back - rear) after pressure builds up , short spray then nothing - hot water comes shooting out the black valve - did something pop off?


The small black valve is called a thermal relief valve. If it is open you will have no pressure. If the water is getting hot enough to pop that valve, there might be internal problems with the pump. ... Karcher 2500 PSI Pressure Washer

I have a Frigidaire FDB125RHBO. The spray arm tower assembly is not working correctly it appears to be loose. The spray arm is not going around as near as I can tell. Water is going in the dishwasher fine. The soap dispenser is opening but there is still soap on everthing at end of cycle.


... Dishwashers

Bought suction hose for karcher in order to use water from bucket. Have attached hose but there is no water being sucked from the bucket . One side of hose attached to washer the other dropped in bucket is this right? The end in the bucket has no suction, and a depressable valve that seems to be impeding the water suction. Do I remove this valve ?


... Karcher 26408500 Pressure Washer 25Foot ExtensionReplacement Hose

Frigidaire model F71C12PHS0 is not washing, it goes through the cycle and when the door is opened the soap container is open with soap still in it. We have run it with the door open to see if it is spraying and it is. The heat is working because when we open it at the end of cycle it is hot. Yet soap is still there and dishes are not clean. Thanks to anyone who can help me trouble shoot this.


... Frigidaire 18 in. FDR252RB Built-in Dishwasher

The soap will not dispense--how can I fix it? ... My Aquatak 150 pro x wont draw detergent from the two small detergent tanks at any ... soap not pulling on low pressure. opposite water going thru pick up into container The check valve on the .


... Bosch AQUATAK 150 PRO X Pressure Washer

Hi, I have a Fisher Paykel DD603I (integrated) dishdrawer unit. The bottom drawer soap dispenser has water in it after it runs (and leftover soap), and there is a small amount of water sitting in the bottom of the drawer. The dishes don't get totally clean. I have removed and cleaned the spray arm, drain filter, filter plate and bottom of tub. Found nothing clogged or particularly dirty. Put all the parts back in and everything moves freely. Ran it empty, and same problem occurred.


Hi Dishwashers use Bi-Metal strip to allow the dispenser to open/close. This strip when heat up causes the soap door spring to open up the dispenser. If this strip is not heated doe ... Fisher and Paykel Dishwashers

I have a craftsman w/ honda model # 580752060 pressure washer. Started washing & after about 10 min. lost all pressure, no water comes from nozzle while engine runs. Cut off engine & nozzle sprays


You have a clog somewhere ... Craftsman 2600 PSI Honda Powered Pressure Washer

Honda Hydroquick Model# B435M will not take in soap solution from valve, I allready checked valve for restictions and found none. Whats the problem?


... Honda Pressure Washer PSI 3000

I am trying to use the soap...i know i have to use the low pressure nozzle but which nozzle do i attach it to under the machine


... Pressure Washers

Hi there I have a Miele G663 scvi dishwasher. The inlet/outlet light is flashing. I have cleaned the non return valve and filter at the bottom of the machine. I have also removed the water inlet pipe which has a large filter on at the end where it attaches to the water pipe. I have blown through this pipe and it is quite difficult to get air through. Do you think it is a filter that is blocked? If this is the case are they easy to attach to the bottom or the machine or would I have to get


... Miele 24 in. Incognito G663 SCVi Built-in Dishwasher

My G832SC is not draining at the end of the cycle. It runs the entire cycle, and the dishes appear to be clean. The soap dispenser has opened and the dishes are rinsed. However, the dry cycle doesn't run because the machine doesn't drain at the end. The intake/drain light is flashing. If I reset the machine and start a new cycle, it will perform an initial drain and the water level does go down. We checked the tri-filter and the valve pump thing, rinsed both. Checked the hose under the sink. We


... Miele Slimline G832SCi Built-in Dishwasher

Kitchenaid dishwasher - small pieces of food are left on otherwise clean dishes. Water level comes to about 1 inch below heater coil. I ran it without dishes (or soap) and added about a quart of water so that level came to about 1/4 inch below heater and that's when I noticed food pieces on drain surfaces (nylon filter under bottom spray arm unit and circular plastic "trap" surrounding it). Spray arms holes are clear and water is hot.


It sounds as if you figured the solution out. The holes in the spray arm(s) get plugged by small debris, (tooth picks, seeds, bits of plastic like candy wrappers, etc) and the water does not reach the dishes to wash and rinse effective ... Dishwashers

My dishwasher has stopped cleaning plates properly. It makes everything wet but at the end of the cycle the detergent block is half dissolved at the bottom. I have just run a cycle and opened the door during this. The bottom is full of soap suds and water and the top spray bar is dripping water after I open the door but when I close and then reopen a few secs later the top spray bar has definetly not rotated. The water is also not hot, this dishwasher is a cold fed only machine so I guess the el


Hi, \012 \012I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms onli ... Zanussi 18 in. ZSF4123 Slim-Line Free-standing Dishwasher

The dishwasher does not appear to be draining properly any more. There is soap residue on the door after it runs. Also ther s a small pool of water by the food drain after the cycle ends. The glasses all have a residue on them after the washing cycle ends


Hi,The scum, film and white\012residue problems have started since the reduction of\012phosphates in dishwasher detergents.Here is a tip that\012will help you to solve the problem of films, residue, and scu ... Asko 24 in. D3121XL Free-standing Dishwasher

I have an LG dishwasher lds5811ww -- for about 1.5 years. Purchased it at Best Buy. The soap dispenser is not emptying completely anymore. The upper rack is in its uppermost position. I suspect that the top two spray bars are not turning around because they have not changed positions when I suddenly open the dishwasher while in operation. The spray nozzles do not appear clogged. Any suggestions?


If your dishwasher is cleaning poorly, check these:\015\012\015\012Water-inlet valve\015\012Internal filters\015\012Drain valve\015\012Spray arms\015\012Water temperature\015\012Detergent cup\015\012Water-inlet valve Most cleaning problems are ... LG Dishwashers

The upper spray arm on our dishwasher has become detached from the back of the machine, and there is no obvious means of reattaching it. Are there some clips perhaps that have snapped on the part which attaches to the back wall of the d/washer (part number PP-TD20 - it's a 4 by 1 1/2 inch long rectangular shape with rounded ends) or does this piece somehow need to be taken apart (how - i can't see how i might do this?) and the transparent 2nd layer underneath get attached first? Thanks, Sarah.


What exactly the brand / model of your unit.?Let me know.Thanks ... Dishwashers

Honda 2400 psi before it went out i cold tap the end of the wand on the ground and the pressure would return now when pull the trigger there is no pressure only a fine spray .its a karcher with a honda motor thanx


Hi, there is a small ball bearing inside the nozzle on the end of the lance , this can get jammed or missaligned and the nozzle orifice can get blocked , clean this or replace the whole lance with another 200 Bar lance .hope this he ... Honda Karcher G2400HH-R Pressure Washer

Frigidaire dishwasher pld2850rdc2...upper spray arm fell. I twisted off the top w/ 8 teeth around the circle. A white circle attaches, but doesn't hold the spray arm tight. Am I missing a part, or is the small white circle thing busted.


... Frigidaire 24 in. PLD2850 Built-in Dishwasher

I have a portable kenmore ultra wash 2 bought used, I see where drain hose ends up at with some type of valve at end in sink area (that also hooks to faucet) but what is supposed to direct water into sink looks like it would spray out


... Kenmore 17252 Free-standing Dishwasher

Power washer problem - water is spraying into my soap dispenser


This can happen if you use the wrong soap, you must use pressure washer cleaner, it does not foam. ... Psi Blue Max 2200 High Pressure Gas Power Washer

I need the 1/8 in. one way valve that allows the soap to mix with the spray.


I've had good luck getting parts from rental centers. Since they have to repair what they rent, a lot of times they have the small parts at the shop. good luck. ... Psi Blue Max 2200 High Pressure Gas Power Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1021 seconds