Having problems with your Honda Pressure Washer PSI 3000 ?

New pressure washer runs starts and runs for 30-45 minutes with no problems then dies and will not restart. Once it cools for a few minutes it will restart but will die again quickly. If it is allowed to sit for 30+ minutes it will run for another half hour but then dies again. Changed oil, gas, checked all obvious areas. Any suggestions?


Answers :

Try removing the carb bowl and check for dirt/water etc , also if the machine is over heating it may be getting vapour locked
Repair Help & Product Troubleshooting for Honda Pressure Washer PSI 3000

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

New pressure washer runs starts and runs for 30-45 minutes with no problems then dies and will not restart. Once it cools for a few minutes it will restart but will die again quickly. If it is allowed to sit for 30+ minutes it will run for another half hour but then dies again. Changed oil, gas, checked all obvious areas. Any suggestions?


Try removing the carb bowl and check for dirt/water etc , also if the machine is over heating it may be getting vapour locked ... Honda Pressure Washer PSI 3000

When i run the washer after 10 minutes it starts to leak oil the motor starts to labour and then gives up iof you ask it to wash it just hums if you leave for half an hour it goes again but then develops the same problem


... Karcher K2.26 Electric Power Washer

I have a Briggs & Stratton Pro 3400 pressure washer that I got new last year and used for maybe 5 hours and it worked great. Have had it stored since then with stabilizer in the gas (I didn't run it dry) and now it won't run for more than a minute or two without dying. A dealer said it was probably bad gas and I now know that even with the stabilizer I should have run it dry last year before storing. Everything is like brand-new including plug and air filter so it must be the gas/carberator gunk


... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

MSV3024 pressure washer backfired after 2 hours of continuous use, then died. i was able to restart it but pulling the trigger kills the engine. i was able to pull the trigger rapidly and keep it running but holding the trigger down killed it again. now it won't restart. can it overheat? it has a full tank of gas.


... Simpson Pressure Washers

John Deere 3300 PSi pressure washer shutting off while in use.Everything appears fine Oil level,Gal level,Air cleaner ok etc.. May run 2 minutes or 12 minutes then spudders a bit then Bang "Off" as if i turned it off.May or may not restart after a couple of pulls.


John Deere will replace the cap for free; they acknowledge the vendor who supplied Briggs & Stratton gas caps provided faulty caps. Call 1-888-228-3068 then 1 (English), 2, 1 and a technician will ask you for model number and Serial Number ... Dewalt 3800 PSI Pressure Washer

Husky Model HU80833 Pressure Washer. Just took it out of the box, starts right up runs about 1-2 minutes washing then dies. I checked the oil, and made sure it has fresh gas. Help


Send it back under warranty ... Pressure Washers

My 2700 new last year worked fine last season and for about an 2 hour this season but then stalled and will not run now. When tryint to restart - It will fire up for 2-3 seconds and then dies. Any


... Craftsman 2700 Max Psi Pressure Washer 23 Max Gpm

Bosch dishwasher Dishwasher runs much longer than timer, stays at 88 minutes for an hour! When I open it and then close again, timer will say 90 minutes! It will run for hours till cycle is completed! Most of the time dishes are still wet.


Hello guest. seems you have a leak in the base. Looks as though motor is washing dishes but actually its the drain pump thats been activated which doesnt allow the timer to proceed forward. ... Bosch 24 in. SHU53 Built-in Dishwasher

My pressure washer starts runs for 3 minutes or so then dies won't start for about 10 minutes. Then starts again dies starts dies... Bad gas?


... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

While using my B&D PW 1600 power washer, the unit started to cut in and out. I thought that it might have overheated, but it had not been running 20 minutes. After letting it sit for 10 minutes to cool, the pump will not run. It has now sat for over an hour, unplugged and still will not run. Any suggestions? Tony [email protected]


A valve where to hoses are connected to maybe plugged up Here is a video on how to repair it without spending a dimeThe video is for a different brand although all have the same valve to make these pressure washers to operate ... Black & Decker Pressure Washers

My pressure washer starts, runs for 3 minutes or so, then dies, won't start for about 10 minutes. Then starts again, dies, starts, dies... Bad gas?


... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Hello, I have a couple year old brigs and strattion upright pressure washer. It has always ran great untill recently. It will run for a acouple minutes before dying, like it is starving for fuel. i give it a couple of minutes, it starts right back up and again dies after a couple minutes of use... I have takin the float bowl and float off and cleand the gas tank and fuel line. everything seems to be in order. Do you have any ideas what it could be? I have not tuched the top side of the carb sinc


Check the oil level in the engine itself. Verify that your oil reservoir is full, then try again.You may also want to refer to the owners manual for other trouble shooting tips. Click this link to go to your manual.http://www. ... Briggs & Stratton Gas Pressure Washer 20244

John deere's 3000 psi pressure stops after running for 3 to 5 minutes. Then wait for at least 10 to 15 minutes to try to restart it. Then it runs for 3 to 5 minutes and stop.


This sounds like the bypass valve is sticking. It needs to be lubed with a VERY good waterproof grease. ... Psi Pressure Washers

Bosch dishwasher SHX46A -cycle runs too long (4 hours)- items still wet. The economy cycle also runs too long - should be about 80 minutes and it ran for 200 minutes.


It sounds like there's a problem with the dishwasher's heating element. The dishwasher uses the heating element to heat the water to certain temperatures, and it will wait (run for extra time) for the water to reach this temperature, and may eventua ... Bosch 24 in. SHX46A05 Stainless Steel Built-in Dishwasher

I have a Bosch SHU66C02. I opened the door to stop it from running temporarily, while it was sitting not running, it leaked all of the water out of the bottom right corner of the door, and when I went to start it later it just hummed but the timer didn't go down for over an hour. I tried to put more water in but as soon as I started I could hear the water added to drain. I turned the breaker in the fuze box off to it and let it sit for over an hour, but when I restarted, the timer was still at


... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

The engine starts cold after 2 or three pulls, runs ok initially, but seems to have slightly less power. After a few minutes I can turn off the choke. When teh engine warms up and runs for about 15 minutes, there is a definite power decrease and the motor sounds like it will stall. If I paly with the choke, it does not stall, but has little power to pump water. If the engine does stall or it is turned off, it will not restart until it cools down.


I would first try draining the carb bowl, if you look at where the choke lever is and look below that you should see a clear red tube with a flat head screw below that, if you just turn the screw out the carb will drain. If you still have an issue yo ... Karcher G3025OH Pressure Washer

13 hp honda pressure washer 3000 psi 4gal/min Hard to start and dies out after 20 seconds after the engine gets hot and running after multiple starts the engine will stay running but then dies every 30 minutes


There are a couple of things that can cause this problem. The first thing to check is if you are loosing spark. Dying after it gets hot sounds like to stater is failing in the engine. If you loose spark this is more than likely the issue. If you are ... Honda Landa PG 3500 PSI Pressure Washer

The washer will run about 2 min. then die. i have checked the oil, air filter and gas. it has good presure when running then it acts like its out of gas by stalling and dieing. Problems with Mi T M 13 Hp, Honda Ohv, Compressor, 3500 Psi 3.7 Gpm, Belt?


It is possible that the oil pressure switch is not functioning properly or you have a lighter oil in the machine than is recommended.Post a comment if you need more assistance. ... Honda Pressure Washers

Maytag 300 series dishwasher growls like a bad bearing and runs a few minutes then pumps the water out having restart the load. finally after several restarts it will run and finish the load growling every now and then.


This is your pump making noise. It could be the impeller is loose or possibly a bearing. The pump is relatively easy to replace if you have the desire... ... Dishwashers

I have a Bosch SHU43 dishwasher, about 6 years old. After starting a cycle, it will run for a while, perhaps 1/2 to 2/3 of the way through the cycle, then shut off. After 10-20 minutes it will start up again, run for a few minutes, then shut off again. It ends up taking about 12 hours for a cycle to finish. The problem started off somewhat intermittent and has gotten worse over the last few weeks. I've checked the electrical box in the front right bottom, and the connection is good. I've even


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012I`m not sure since you didn`t mention it or perhaps I just interpreted it this way, but is it consistent at the same time or approximately or is ... Bosch 24 in. SHU43 Built-in Dishwasher

My problem is with a Eurotech Model ED254EG timer will not continue running thru the cycle properly. i.e. In "Light Load" position the timer starts with 59 minutes but actuall runs for 2 1/2 to 3 hour


... EuroTech EDW242C Stainless Steel Built-in Dishwasher

Have a PD2800 that has started to leak oil. lowered the oil level slightly but it started to again leak oil after just a minute or two of running from a cold start. Oil seems to be coming either from around the oil drain plug or from underneath the motor mounting plate. any ideas? Richard


Hi,There is a nice Troubleshoot article :-http://www.the-power-washer-advisor.com/pressure-washer-pump-repair.htmlHope i helped you.Thanks for using "Fixya". ... Dewalt Pressure Washers

I have a powermate 2400 pressure washer. Worked great until today, now I start it, runs and sprays fine for about 1 minute or so then it dies. What is going on, only about a year old.


... Coleman Powermate Pressure Washers Turbo Nozzle With Wand 2400 Psi And

I have a powermate 2400 pressure washer. Worked great until today, now I start it, runs and sprays fine for about 1 minute or so then it dies. What is going on, only about a year old.


... Coleman Powermate Pressure Washers Turbo Nozzle With Wand 2400 Psi And

Pressure washer will run fine for about 2 minutes then backfire and shut down. I'll wait 5 minutes and get another 2 minutes of use. The oil and gas are both full.


... Dewalt DPH3100 Gas Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0910 seconds