Having problems with your Honda Pressure Washer PSI 3000 ?

How do you drain any water that might be in the

\015 Honda Powerstroke Pressure Sprayer: How do you drain any water that might be in the Pressure Washer so that it doesn't damage something by freezing on a cold night?\015

Answers :

Once you have finished with the machine, and it has stoped running and has the inlet hose disconnected., leave the engine switch in the off position and while holding the pressure gun trigger on, pull the starter a few times to pump out any excess water. If it has been a cold night you could leave the machine somewhere a bit warmer for half hour before using it.
Repair Help & Product Troubleshooting for Honda Pressure Washer PSI 3000

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a hotpoint dishwasher model# HDA1000G00WH. until recently never noticed rinsed water not drained after washing/rinse cycle completed. water level just above the drain cover. i removed the cover to see if i might find something clogging the drain screen but found nothing. i removed the plastic water "return" line & it was not plugged. thinking about pulling the dishwasher out, disconnect the plastic line connected to the bottom of the dishwasher, then remove the "bowel-like" container wher


Take out the pump. You should find a broken rubber flapper indide blocking the outlet tube. Cheap to repair. ... Hotpoint 24 in. HDA3740G Stainless Steel Built-in Dishwasher

Hum in Kitchen Aid Dishwasher Model 8531529. Stated last night. No hum when filling or draining - only during the wash cycle. Can still hear the water spinning inside during the wash cycle, but hum is loud. The water does fill & drain completely/correctly. Any ideas? Might this be an easy fix? or a likely repair man call? Thanks!!


Hi\015\012\015\012The hum sound that you hear is from the motor that is not\015\012working or is about to go out, the motor should be replaced. Hope this\015\012helps...please post back for further assistance.\015\012\015\012Dani ... KitchenAid Dishwashers

Maytag HDB8600AWW Dishwasher had been making noise (thought might be water valve, like previous DW), eventually stopped draining water, water now in bottom, I've let sit for couple weeks, looked inside, water was gone, I tried running again, it filled with water, but heard humming control panel noises for first time, then shuts itself off. Also, my handle needs replaced. Please let me know as soon as possible. Thanks in advance. David Weaver


Hi David\015\012\015\012The hum and all the noise that you have mentioned in your post states that the issue is with the pump and motor assembly. Please check the drain hose and try to clean the drain pump filter for any clogs, obstructions. Af ... Dishwashers

Hi :) We have a Bosch slimline dishwasher type SRS56A02 GB/08 - it doesn't draw in water - the timer counts down but nothing happens. We checked these pages and cleaned the filters on the inlet water line but no change :( I saw that it might be the inlet water valve - is this easy to get to - do we need to take off panels? if so, is there a manual available please? Over the past week or so it had got noiser - it was at its quietest while the water was draining out of the machine.


... Dishwashers

My dishwasher (Optima G2420) had an error F13 for sometime. By turning it off and restarding it would work. But now drain/intake light flashes and nothing is happening. We have checked the triple filter, the filter where water comes in ect. It drains the water but it appears that it cannot take water in. There is a white unit that the intake water goes in and I think that might be the proble.


... Miele Optima G2420SCi Stainless Steel Builtin Dishwasher

FDB105OREC4 My dishwasher is not cleaning my dishes. I push the start button and water seems to be trickling in then it stops and no sounds protrude from the machine for several minutes. Eventually another loud motor seems to turn on and drain the water out of the machine. The soap dispenser usually opens and the soap block that usually dissolves is setting on the bottom of the machine. It seems the water is plenty hot but the rotating washer arms might not be moving. Please help me find the par


... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Not draining goes through the cycle but is not draining. I have pulled the filter, cleaned it. Took off the drain hose from the new garbage disposal amd tried to syphin out the water no luck. I have not pulle the dishwasher yet. It just started to do this ands we just had to replace the garbage disposal. Might this have caused the garbage disposal to burn out as well?


Did you remove the plug in your disposal so the dishwasher can drain??? ... Bosch 24 in. SHU43 Built-in Dishwasher

How do you drain any water that might be in the


Once you have finished with the machine, and it has stoped running and has the inlet hose disconnected., leave the engine switch in the off position and while holding the pressure gun trigger on, pull the starter a few times to pump out any excess wa ... Honda Pressure Washer PSI 3000

Maytag mdb7100awb dishwasher is leaking from the bottom right corner. starts to leak almost immediately upon starting it. I then opened it and found that the entire tub is filled with water, looks like it is overfilled. I wonder whether it is overfilling and there might be a clog in the drain or if it's the seal/gasket? where are the drains that i need to check for blockage?


Take off the bottom panel there are 4 screws you got take they are 1/4 inch screws \015\012once the panel is off turn on the dishwasher and see where exactly the leak is coming from ... Maytag MDB7100AWB Dishwasher

Won't drain, I think it might be clogged. I don't know how to get the thing that spins (washes) the water around out so I can take off teh drain cover.


Hello CA Johnson, Without the brand and model number for your particular dishwasher, I can only provide you with some general information that should help you out.\015\012\015\012First, open up the dishwasher and remove the lower dish rac ... Dishwashers

The problem started with it not draining correctly and leaving water in the bottom - my husband took it apart and found a bolt in the drain. He removed it and now it won't start. It appears to not have power to the electrical panel- we have reset the breaker several times - left the breaker off for 10 minutes thinking it might erase the memory - I've asked for instructions to reset and I keep getting info that is very far removed from this model. I know it has a protocol because a repair


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012\015\012The reset on your dishwasher is as follows, ( I can't locate your particular model number...but its madw be whirlpool so there are only a couple of possible sequences ) however depending ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Kitchenaid (KUDM01TJWH0) Shortly aftter starting my kitchenaid (KUDM01tJWH0) dishwasher, smoke began coming out of the door. I opened the door and smelled a strong electrical smell. It is now completely dead. I drained the water out of the water line, thinking it might be plugged, but still nothing. What should my first move be to determine the cause? Breakers are fine. I think it is was purchased approximately 2001. Thank you!


Wires where thy bend at bottom of door and heating element....water in motor ... KitchenAid 24 in. KUDM01TJ - Multiple Color Built-in Dishwasher

Miele Inspira G2180 SC SF dishwasher problem We start the Normal cycle and after the dishwasher fills up with water the units starts beeping, all six program lights start to flash, and the water drains out. The lights remain blinking. What might be the problem please? Dan


... Dishwashers

Kenmore Elite dishwasher Model #665 1597 2992 Machine fills with water but thereafter it neither washes nor drains. Machine will not drain when I advance the cycle by pressing the Cancel/Drain button. There was a report that there was some noise when the machine first failed. I do not hear anything when I try to run a cycle. What might the problem be? How does one turn the motor manually to see if it is bound up by something? If it is the motor do I want to pay an extra $70 to $100 and


... Dishwashers

I have a kitchenAid dishwasher and am getting a humming noise. it fills with water and will drain when you hit cancle. i think there might be something in the pump how can i access it to find out. is there any other things i can try. I have added CLR to try and brakfree any gunk thoughts


The motor is stuck free it up manually ... KitchenAid Dishwashers

Hello, My Kitchenaid dishwasher has water coming out of the drain valve which is located on top of the sink. I figure that something might be clogged. Suggestions on how to approach this? Where would I find the model number? Thanks


Look around the edge of the tub opening where the racks pull in and out for the model # ... Dishwashers

I have a miele washer unit model G7881. it has failed towards the end of the cycle showing F22 and still has water in the bottom... Might this be a failed drain pump?


Failed or blocked most likely blocked ... Dishwashers

I have a frigidaire dishwasher that is not draining, water is siitiing in the bottoim, cant figure out what might be clogged, dont have a manual


... Frigidaire Dishwashers

Water comes out of the vent/overflow at the back of the sink when the dishwasher drains. Is there a sceen/trap that might be clogged? where? how do i clean it?


Hi there,\012Well A clog in the drain line or air gap (if there is one) is the usual reason that a dishwasher won't drain. Often the problem is at the point where the drain line attaches to the garbage disposer or household drain line. If ... KitchenAid Dishwashers

Miele dishwasher drains take in water to wash but does not wash,wash motor does not kick in [start].what might be the problem?


Circulation pump may be stuck/siezed. Sometimes they can be freed up, and sometimes they need to be replaced. Depends on the nature of its fault. ... Miele Premier-Plus Built-in Dishwasher

The washer cycle stopped without warning, i thought the timer or the timer motor but it is not the timer works fine and so is the motor. but the timer motor runs til the washer motor starts than is the timer stops and the washer is working but not cycling so no rince or drain or soap etc... just pumping water. if you can tell me what might be the problem, thank you. like i said the timer stops when the washer motor start.


... Jackson JPX-300L Dishwasher

It starts running then stops - starts pumping in water then stops, etc. burning plastic smell near top... doesn't leak, gets power, but begins to fill, then stops - might start to drain (pump), but then that stops too...


... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Water is not draining after wash. What might be the cause?


\012\012Check for hose kinks or food plugging drain hose. Start at the drain port exit ( there are others, this is just ... Jenn-Air 24 in. DW861 Built-in Dishwasher

My whirlpool dishwasher model# du930pwsb0 will not drain all the water out of tub at end of cycle. what might be the problem?


Water level sensor is loose or malfunctioning most likely ... Dishwashers

I have an electrolux dishwasher Model # EIDW6105GS1 that for the second time has stopped working and all the lights at the top control panel are flashing...what might this mean? I removed the panel down below the door and it appeared to be a drainage problem. The first time it happend was about 1.5 yr after purchase...(No more warrenty and no extended warrenty)...I drained the water in the pan below and it worked once again. After about a month I am having the same problem.


... Electrolux EIDW6105GB 24 in Builtin Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1317 seconds