Having problems with your Honda Pressure Washer PSI 3000 ?

Only runs when I supply fuel directly to the carberator


Answers :

Need to do a compresion test and a possible a valve job
Repair Help & Product Troubleshooting for Honda Pressure Washer PSI 3000

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Only runs when I supply fuel directly to the carberator


Need to do a compresion test and a possible a valve job ... Honda Pressure Washer PSI 3000

Fuel running out the end of carberator - Briggs Pressure Washers


Float stuck in carberater ... Briggs Pressure Washers

I have a troybilt xp 2600 with honda engine,when i turn on the fuel petcock valve fuel drips directly in back of air filter.anyone familiar with this type of issue?


This sounds like a foreign object in the fuel inlet valve. You will need to go through the carb and clean/replace parts as needed. ... Pressure Washers

Stored for a year. i changed the spark plug and the fuel. i also cleaned the carb. water runs through the pump. but it wont stay running. it wants to start but only runs for a few seconds. i think it might be a fuel flow problem but im not sure.


Sounds like the float my be partially stuck closed. It allows enough fuel to run a few seconds then the engine uses it faster than the float lets the fuel back in. I would remove the float bowl and flip the float up and down a few times to make sure ... Honda Pressure Washer PSI 3000

Starting problem will not stay running spray starter fluid will run till out, itis like it is not getting fuel new fuel added just cant keep it running. any suggestions/ Never had this problem before, thanks scott


I had the same problem and what I did fixed mine. I got it running with the starter fluid then pushed the linkage (Rod) on top of the carb and ran the engine wide open (by pushing the linkage), then released... then wide open again. I did this 4 or ... Karcher G3025OH Pressure Washer

I have a excell 2500 psi max honda 5.5 ho vr2522 2.2 gpm presser washer and has been stored for about a year, still looks brand new and has only been used twice before, it has oil and was stored with no gas in the tank, i put fresh gas in the tank and blead the fuel bowl until fuel ran out like it should, the washer wont start, ive checked the turn on switch as well and the fuel cut off knob, i spayed gas in the carb and it fired up but stopped running as fast as it began to run, its not getting


... Honda Black Max 2600 PSI Pressure Washer

I have Frigidaire FDB956RBC1 diswasher. I have to turn off the water to fix the faucet. When I turned the water back on, water did not go to the diswasher when I used it. The diswasher runs normal except with no water going into it. The water runs find at the facet. There is separate water supply underneath the sink for the faucet and the diswasher. I wonder if there is a mechanism with the dishwasher that stop the water from going into the dishwasher after the water supply been turn off. I did


FRIDG... EXPERT HERE \012\012\012Welcome to fixya\012\012Hello\012\012 \012\012 ... Frigidaire FDB956RB Built-in Dishwasher

Hi. I have a Siemens SE65E331GB Built in Dishwasher with an aquastop system. The problem is that it seems to be stuck at the end of a cycle. The pump is constantly running when stitched on. I won't top after a reset and it continues to run even if you open the door. The water supply light also comes on indicating that there is no water getting to the machine. I have tried resetting the aquastop as per the advice in other threads. This has helped in that the water supply light now stays


... Siemens Dishwashers

Im replacing a frigidaire with a whirlpool and the problem I'm having is the electrical connections. My old Dw had two elec cords running to it. One small one that runs in the same direction as the drain and water hose runs the other is a slightly bigger elec cord that runs straight out the back of the cabinet unit and I cant tell where it goes. But it has on it anaconda w dutrax type nm 12/2 with grounding 600 volts.Do I need both elec cords for the new whirlpool or just one? All the online vid


Hello. Older houses offer all kinds of challenges. In the long run though, that is part of the joy of life. \015\012\015\012You need three things to hook up a typical dishwasher:\015\0121. The hot water source which goes to fee ... Dishwashers

Whirlpool Dishwasher GU2548XTP- Dishes still dirty after it has run, especially the top rack. 5 (?) yrs old. Runs and grinds intermittently, no water seen under unit. Sometimes I add more water when it grinds, then it runs very quiet. Sometimes it doesn't seem to fill enough. Water supply good, inlet screen inspected not clogged. Not a lot of pressure shooting the water around the inside of the unit, as the detergent that bleeds through the slotted half of the detergent flip door isn't r


The inlet valve is OK, therefore the control board was not the problem. The impeller pump is noisy and inefficient, and must be replaced.Here is the part: ... Dishwashers

I have a Siemens SE25A836GB/35 dishwasher. the program is running and it sounds as if the pump is running all the time. I have tried resetting the program but to no avail. I have checked the filter CLEAR and the water supply is okay. The display in the front which state time to run on the program is blank can you solve the problem?


... Siemens 24 in. SE25A836GB Hi-Line Free-standing Dishwasher

Kleenmaid DW8 top washer does not operate. Apparent blockage in the water supply tube which runs up from the bottom water supply. How do I remove the bottom assembly comprising the main filter, waste trap and micro filter? I appears that these must be removed to access the water supply tube mentioned above.


... Dishwashers

I have a XR2500-1 that starts with carb cleaner sprayed into it, but will not continue to run. The fuel pump is pumping fuel, it has fuel and it is good.


... Pressure Washers

I have a Miele Built-In Icognito 658/850 SCVi. The intake/drain light is on, and I have followed the directions in the manual. The light turns off after I follow the directions and the unit turns on but there is no water running through the unit. When I open up the unit, the light is then on again.


Check to see if the water \015\012\011\011\011shut-off valve (located under the sink, it is an electromagnet valve, located at the pipe's entrance to the machine) is open. If you get water to \015\012\011\011\011the dishwasher, but there is still no ... Dishwashers

Leaking from under dishwasher. Has run great since 1996. Under counter model in manufactured home. Chnaged to drop in pellet dishwasher detergent and it ran great. There is no water inside the dishwasher circular drain. We never use the heating coil to dry the dishes. We have turned off the water supply line under the sink to the dishwasher. Cool clear water is running out from under the bottom right corner. The hot water heater is right next to it and everything is dry and warm under it which i


Hi,Depending on the model you have this could be a couple of things. The most likely suspect is the water inlet valve. What I would recommend to do is take the bottom toe panel off, typically there are either 2 or 4 screws holding this pa ... Dishwashers

My lawn mower with a Briggs motor Wont start, has spark fuel is good , the unit is approx 5 years old, but seldom used, worked great last year, drained the fuel, and stored it for the winter.Refueled it and wont start. I can getting started if I pour a little gas down the carb, but naturally it wont run long. I'm thinking needle and seat, any help would be appreciated. Thanks


... Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer

Water will not run into diswasher. Water supply is on, but water will not run into machine.


Hi,Here is a tip the will elaborate on your problem more, but the bottom line is that you need to replace that fill valve...Dishwasher ... Dishwashers

Honda GC 160 Engine, I had the carb replaced about 1 year ago, now its doing the same thing. At first it wouldnt start at all, I cleaned the carb, then it started would speed up and die. I then took the carb off and cleaned the jets, now it starts with the choke in the closed position only, at high speed it sputters and dies, but will I run it at med speed it runs but will die with tiller has a load, also when you put the choke to open it always dies. I dumped all the gas, and checked the fuel


This really sounds like a carb problem, good to hear that you are taking the carb all the way off and soaking it, this is the best way to clean a carb. I don't think it would be the fuel pump, they either work or they don't. I would check the governe ... Karcher 2500 PSI Pressure Washer

The check water supply indicator is alight. I have checked the incoming supply and this is ok, the filter is not blocked. If I try to run the dishwasher I just end up with water at the bottom of the machine and the programm will not progress any farther.


My phone has frized and i forgot the pasword ... Neff 24 in. S5555X0GB Built-in Dishwasher

Bosch SHX46A (6 years old) Selected regular cycle, pressed On and closed door. Cycle did not start normally. Pump runs, but no water is coming into the DW. I confirmed the water supply line is turned on. I opened door, turned off On/Off switch, then poured water into drain. Then turned On/Off switch on. DW began pumping water OUT of the DW. Also, it doesn't matter if the door is open or closed - if you turn the DW on, the pump will run. I suspect a problem with the electrical controls, or perha


From your description, I doubt that the problem is door latch is the cause.\015\012\015\012The first thing that a modern dishwasher does before it begins to fill with water is run the drain pump.  It appears that this DW is not progressing ... Bosch Integra® 500 SHX46A0 Dishwasher

Hello, I have a couple year old brigs and strattion upright pressure washer. It has always ran great untill recently. It will run for a acouple minutes before dying, like it is starving for fuel. i give it a couple of minutes, it starts right back up and again dies after a couple minutes of use... I have takin the float bowl and float off and cleand the gas tank and fuel line. everything seems to be in order. Do you have any ideas what it could be? I have not tuched the top side of the carb sinc


Check the oil level in the engine itself. Verify that your oil reservoir is full, then try again.You may also want to refer to the owners manual for other trouble shooting tips. Click this link to go to your manual.http://www. ... Briggs & Stratton Gas Pressure Washer 20244

We have a Bosch dishwasher supplied with softened water - does a great job. However, on the most recent run, the soap door didn't open properly and the soap puck (we use those two part liquid/powder that dissolve) was only partially dissolved. Our stainless steel cutlery now has a hazy film all over it, something that handwashing and a subsequent successfully-executed dishwasher run didn't remove. It's expensive cutlery, less than a year old, and a wedding gift from my mother who lives next d


Sounds like the you need to see if your using a proper rinses / drying aget like turbo dry. Fill it up and you should be good for 40 washes. If it continues you may have a bad control unit. ... Dishwashers

Sandy glasses The dishes on the top rack come out with a sandy residue on them....we have tried running it with the jet dry dishwasher cleaner, the vinigar and baking soda...have taken apart and checked all filters and water supply...no help with any of that. I also wonder how much water should be in there when it is running...shouldn't it cover the heating coil in the bottom? My water level is just below the coil.


A simple cleaning with any form of citric acid(tang0 on a regular basis(depending on how hard water is) will cure this "proublem"\015\012\015\012Cleans the internal filter and breaks up hard water residue(calcium) ... Whirlpool GU2400XTP Built-in Dishwasher

Pressure washer will not start, cylinder has fuel in it. i think it was filled with diesel. i change the fuel, and the spark plug. still no start. if i spray it with carb or brake cleaner it runs fine.


Pull the fuel hose from the carburetor and let some drain out. Drain the carburetor float bowl. Are there H an L mixture adjustments? Preset each 1-1/2 to 2 turns CCW from CW stop. Get it running with spray if you have to, then adjust the mixtures fo ... Pressure Washers

The dishwasher doesn't seem to have nearly enough water in it. The upper sprayer arm doesn't seem to be spinning when running (I open the door and look really quick) and the lower one looks like it barely spins and barely sprays water. The dishes are barely wet and the soap is just laying on the bottom. The water is on, there are no kinks in the supply line. It sounds like it is running, and pumps pumping, but being brand new I am not sure what it should sound like. It certainly doesn't sound li


I would lift the drain pipe higher. approx. 1/2 the height of the dishwasher . also rechack incomming water supply. Make sure no blockages and the like. Try again. ... Bosch Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0939 seconds