Having problems with your Honda Pressure Washer PSI 3000 ?

Oil milky white in pump - Honda Pressure Washer PSI 3000


Answers :

It may have a slow water leak inside the pump.
\012change oil and monitor the new oil.
\012if it goes milky the next time you use it then it has a bad leak and the seals will need to be
\012replaced,otherwise the bearings will rust & seize
Repair Help & Product Troubleshooting for Honda Pressure Washer PSI 3000

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Oil milky white in pump - Honda Pressure Washer PSI 3000


It may have a slow water leak inside the pump.\012change oil and monitor the new oil.\012if it goes milky the next time you use it then it has a bad leak and the seals will need to be\012replaced,otherwise the bearings will rust &am ... Honda Pressure Washer PSI 3000

I need to know what kind of oil the pressure washer takes, I noticed it has a place for oil on the engine and another neat the pump. The product is a honda pressure wave 220 PSI Model NO 2225cwh-2


... Honda Maxus Prosumer MX5223 Pressure Washer

I have an excel pressure washer 11 hp Honda engine. water is leaking into the cat pump 4hp40gl causing the oil to become milky, after the washer sits overnight the oil clears up. Any and all help will be appreciated. Thanks


... Caterpillar Cat Pump Pressure Washer Pump 3SP30G11

I have a Coleman powermate clean machine pressure washer 2500 psi 2.36gpm and has a 6x200 honda 6.5 horse motor. I just bought at a garage sale.It started just fine when I got home and in less that 2 minutes quit. It says the engine will stop automatically when low on oil. what kind of oil should I use and for the pump what kind of oil do you use?


... Coleman Pressure Washer PW0881800

Dear Sir?madam, I bought a CV-240 4 MBC HONDA PRESSURE WASHER , 2400 PSI , 5.5HP, It is 4 stoke overhead, cam single cylinder , October, 2010 from NATIONAL HARDWARE SUPER CENTRE – GUYANA. I used this equipment sparingly during this year. I have 2 – 450 gallons plastic water tanks to supply the pressure with water. Recently, water is not coming out through the pressure hose. I talked to a technician, and he opened the water pump and there is some white plastic valve, one was broken and he repl


... Karcher 2500 PSI Pressure Washer

I change oil on my 3700 psi honda motor pressure washer motor and pump and after i done that the tigger rope is to hard to pull looks like some who is pressure some where can some one help me whit this problem .. thank you


Most likely has nothing to do with oil change. Have someone hold the trigger on handle open to relieve pressure on system/pump , this will make engine turn easier when you pull rope. ... Karcher 2500 PSI Pressure Washer

My Troy Bilt power washer (using Honda GCV160 engine) has no pressure coming from the pump. I checked the water flow, everything seems fine. I believe the pump needs oil added, however, I can't seem to firgure it out (how to add oil to the pump). I did notice that previously, I used to see drops of oil coming from under the pump. I I have a bad seal, can I add oil and test the pressure before I change the seal? Please advise.


I had a similar problem. Turns out I had left the hose disconnected and some sort of wasp built a paper type nest inside the washer tube that the hose connects to. I had to take the pump off and take apart and then cleaned it out with a screw driver. ... Honda Black Max 2600 PSI Pressure Washer

What type of oil goes into the pump - Honda Pressure Washer PSI 3000


YOU NEED AN OIL THAT IS THIN & CAN COPE WITH HIGH TEMPERATURES.\015\012I USE & RECOMMEND HYDRAULIC OIL ... Honda Pressure Washer PSI 3000

Water mixing with oil in pump section - Honda Pressure Washer PSI 3000


The seals are bad. Your pump needs a rebuild or replacement. ... Honda Pressure Washer PSI 3000

Pump oil is getting milky - Dewalt 3800 PSI Pressure Washer


... Dewalt 3800 PSI Pressure Washer

How much oil in pump for black max 3000 - Honda Black Max 3000 Psi Pressure Washer


... Honda Black Max 3000 Psi Pressure Washer

Got a Dewalt 3800 PSI Pressure Washer with 4.0 GPM with a Honda GX 390 gas engine. Tipped it up to roll it out to my truck and got a big puddle of water with what looked like Pump oil in the puddle. Can you help???? It is less than a year old with 10-15 hours on it.....


Could very well be. Did you check the oil level and condition of oil? If its too full or if its light brown milky, then water has entered crankcase. Pressure washer pumps cannot stand to ever let run dry. Even a little. Also excessive idling will ov ... Dewalt 3800 PSI Pressure Washer

What oil is requierd for the pump - Honda Black Max 2600 PSI Pressure Washer


See the attached link for the correct oil for the pump on this machine. \015\012\015\012http://www.wmpcs.com/index.php?main_pa ... Honda Black Max 2600 PSI Pressure Washer

I have a John Deere 3800 psi pressure washer, it stopped having pressure in the middle of a job. No restrictions and still turns on and sounds great. Checked pump oil and it was a milkshake green. Changed pump oil and still doesn't have pressure.


... Pressure Washers

I temporarily misplaced (not lost for good) the owners manual for my honda pressure washer : engine and pump. I do not want to run my machine again until I verify the pump oil content/level. On the pump itself, at the top, there is a black, unscrewable oil cap, with blue-ish oil in it, BUT NO DIP STICK! How do I check the level? What kind of oil, specs etc? Thanks!


Http://www.ultimatewasher.com/download/honda-engines/gc160.pdf ... Karcher 2500 PSI Pressure Washer

North star eletric hot 2000 psi 3.5 gal per min oil pump had blown shaft seal. replaced with new pump. put small allen plug in return port. I have oil flow to the pump but none comes out port leading to burner even with shutoff switch removed and pump turning. Installed test gage 0 pressure. Took off bypass line and ran into can. pumps small amount of fuel into can that way but with uneven flow & small bubbles. nomatter what I do I just can't get fuel outlet port to burner. pump # A2VA-7116 pl


... Northstar Pressure Washers

How much oil in pump...Craftsman 2200 PSI pressure washer


Hello:Best to use NON DETERGENT 10W30. Be sure you fill the reservoir only 1/3 to less than 1/2 full. ... Briggs & Stratton Pressure Washers

My BE Honda 5.0 2900 psi pressure washer has oil in air filter. I believe it is because my buddy left it tilted to the side in th ecar when he borrowed it. How can I fix it? It is probably low on oil as now due to this. How much oil does it take? As there is no dip stick to check the level, Do I need to empty it all out and refill it


Hi there ibharti sounds like gx 160 honda ohv engine \015\012\015\012replace the air filter if it has been wet with oil, , remove the float bowl and check for oil in the carb, blow the jets out, top up the oil to the point o ... Honda Pressure Washer PSI 3000

Had the Northstar 3000 psi Pressure Washer for 2 months and it started leaking oil from the pump during use. Took it to Northern and they are replacing the pump under warranty but said it was likely because I was using quick connects on my garden hose coupling and that was restricting the water flow making the pump overheat. They said never to use quick connects on the garden hose unless the opening is at least 5/8". Does anyone make such a quick connect? I hate having to screw the garden hose o


It is easy to check if your hose and quick connects are supplying enough water to the pump. Your pressure washer gallon per minuite requirements are printed on the machine and also on the pressure tips in GPM. Your post indicates 2.5 gpm but check yo ... Northstar Pressure Washer 3000 PSI

Oil for a troy bilt 2550 psi pressure washer pump


What fluid and how much is required in the Troy-Bilt 2550 power washer pump? ... Briggs & Stratton Pressure Washers

I have a Honda pressure washer with Cat Pump 3dx29gsi, it runs rough when I pull the trigger and after 5 min of running, oil starts to spit out of small hole on red fill cap on pump


Sounds like you need to open the pump and inspect the pistons and seals. It appears that the seals & or pistons are worn and the water is by passing into the crankcase of the gear box. A sure sign oil coming out of the filler cap & the oi ... Caterpillar CAT Pump Pressure Washer Pump Oil

I have a Karcher G2600 OR Pressure Washer, 2600 psi, 2.5 gpm. PN 1.194 506 0. gas engine works fine and water flows fine but pump is not adding pressure to stream. Checked and cleaned inlet water filter.


... Pressure Washers

Assembly I recently purchased a pressure washer from Home Depot. It is rated at 3100 psi. It is a comet pump with a honda gas engine. The assembly instructions recommended that I remove the plug on the top of the pump and replace it with a vented plug that was provided. However, none of the other enclosed manuls talk about the vented plug. Am I reading the assembly insturctions correctly. Should there be a vented plug ?


HI your machine would have been delivered with a blanking plug in the pump. You will need to remove this and fit a vented pump or your pump will build up too much pressure inside. ... Comet BXD2527 Pressure Washer Pump

190 honda engine only runs on choke? - Honda 50 W Ar Pump 2500 Psi 25 Gpm Pressure Washer


Pour a large amount of carburator cleaner into the gas tank \015\012run the engine for five minutes then shut it off and let it sit for a couple of days.\015\012then start it and see if it runs any better\015\012the longer you let i ... Honda 50 W Ar Pump 2500 Psi 25 Gpm Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1343 seconds