Having problems with your Honda Pressure Washers ?

The gasket is there.

\015 BXD 2525 Comet Water pressure Pump. I e-mail a problem and the answer i got was that a gasket is missing. Check ok The problem again is that the hose is connected to pump and the wand hose is connected to pump turn water on and the water sprays out of the hose connection of the pump and no water comes out of wand when i press trigger. Start machine and the spray shoot out lightly out on wand but no pump nose at all. I was thing that the unloader may be stuck or bad could i be in the right area. or could you give me something i can check before i start buying and replacing parts. The machine is only 4 yrs. old but been used only about 8 to 10 times and that maybe a lot. I change the oil looking for discolor or siliver in oil like metal but found nothing but clear oil. If i had to replace the pump where can i get a good price to buy and what information do i need to no. How hard is it to put on.\015\012thank you for all your help\015

Answers :

Repair Help & Product Troubleshooting for Honda Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Spilling water I have a Kenmore 665.15762 model dishwaher from Sears and it is spilling water throu the low part of the door. The draining is working well, is like as if the gasket is not good. I checked the gasket, but the only one I see is lateral and up and in good condition. Could be the floater too high ? Should I replace tge gasket ? Thanks for a quick reply. Viorika Aresteanu, Pierrefonds


... Kenmore Dishwashers

Kenmore model#587(Frigidaire) leaks under door. New install. Had machine for a year plus before install. took off front panel- can see water squirting past lower door gasket as wash arms rotate. cause is water running down door during wash cycle piles up in the channels molded into the lower left & right side of the wash tub and pushes out the sides of the lower gasket. looks like a design issue- called SEARS, they just want to sell me a new gasket! go figure. any ideas on a fix?


It does sound like an inner door seal ,however If you get upset at Sears and complain they may help you as they say the squeaky hinge gets the oil..And with Sears the more you squeak the better your chances of results ...Good Luck ... Dishwashers

Bosch SHU4302 DW has a leak in the bottom left. I cleaned the gasket etc. but no luck. Slow leak drip by drip in the wash cycle. This model does not seem to have the steam vent that other Bosch models have. I can clearly see the water past the gasket on the left, but not the right. But the gaskets on left and right seem to be located identically. Any help in resolving is appreciated. Best Regards


I've got a 4306, and while it never leaked, the bottom door gasket did seem to chemically melt over the years.I replaced it a few months ago. I don't know that a steam vent is needed as the gasketing system never allows any steam pressure ... Bosch Dishwashers

Bottom door gasket is caked with gunk of 1996 Miele dishwaher model G 880. Is this the gasket getting old and disintergrating, or is it just debris build up? Is it advisable to replace gasket on older models? No sign of leakage, yet.


Hello,\015\012This does sound like debris build up.You can try and clean it off but be careful you dont damage the rubber.If after cleaning it still looks pliable and does not leak then it will be ok.\015\012\015\012Hope this helps. ... Dishwashers

I have a Kenmore 16919 dishwasher that recently is leaving black debris on dishes. I have found what to appears to be gasket material laying in the bottom of the tub and have found loose pieces on the door at the bottom, is this pieces of a failed gasket?


Yes, it sounds like it is time to have the Kenmore Service man over to reseal your dishwasher to keep that soapy water inside where it should stay. Like any rubber product, gaskets degrade over time, and exposure to caustic dish-cleaning products do ... Kenmore Dishwashers

The inner gasket came out of the unicouple for the sink. How do I put the gasket back into the unicouple?


... GE 24-7/8" Convertible Portable Dishwasher - White-on-White

Water is leaking from the head gasket on the Annovi Reverbri pomp Modle #xcrv4g35h. I am looking for a gasket. [email protected]


... Annovi Reverberi RMV2.5G27D Pressure Washer Pump

Melted rubber gasket, black rubber residue inside dishwasher I had a problem with the latch not connecting and therefore could not turn on the dishwasher. After, two months with Sears repairmen, dishwasher still did not work. I noticed as I put my head into the dishwasher to check on a buildup of residue this black glue all over the inside. Repair man stated it was animal fat. After spending some time looking at the situation under the door and inside I determined it was the gasket. He o


That is because Sears highers nimrods. sorry for the honest answer but it is the truth. Just a tip any time you get a Sears tech in your home and the first thing they do is get on the phone with tech support it's a bad sign that they DO NOT KNOW WHAT ... KitchenAid 24 in. KUDS25SH Built-in Dishwasher

My power washer sprung a leak down in the pump housing with a gasket between two cast pieces of the pump. Is this just a simple matter of replacing the gasket and also what may have caused this? It is factory reconditioned unit directly from Briggs and has only been used four times.


... Briggs & Stratton 3000 PSI Pressure Washer

I have FGHD2433KF1, and there is a leakage from the splash guard. I open the front cover of the door and noticed that when a large amount of water rushes against the front door, water comes over the gasket and fills the splash guard. The dishwasher stops the water when the water is just about to reach the top of the guard, but sometimes the water comes over the top of the guard. That is when the leakage occurs. I noticed that there has been a replacement gasket for some of the Frigidaire dis


Make sure the dishwasher is level. If the water is leaking from the door, you should replace the door gasket. ... Frigidaire FGHD2433K 24 in Builtin Dishwasher

How to install a gasket on a kenmore dishwasher. I have a Kenmore dishwasher and have put the gasket around the door but there's extra pieces on both ends and can't figure out where to attach them on the underside of the door.


... Kenmore Dishwashers

Hi, We have a Frigidaire dishwasher machine 1500 series with fully electronic control. It is a new unit, has been installed nearly 4 months ago. The other day, when I went to take the dishes out of it, I notice that the rubber gasket that seals the door had come off somehow. Along with it I saw, sitting on the bottom, two pieces that looked like part of the seal, but I didn't know where they came from. I put the rubber gasket back on, but now the pieces and now the dishwasher will leak when runn


... Frigidaire Dishwashers

Frigidaire dishwasher model GLD2250RDC0 leaks from the bottom of the door. Just replaced the bottom gasket. Not helping. Noticed that the foam insulation on the bottom of the door is soaked. So, if it's not coming through from the gasket, what's causing the leaking on the inside of the door and through the foam insulation? Thanks for any help you can provide.


You may want to check the door alignment itself. Many people open and close the door improperly and when they load it sometimes they put pressure on the door in one corner or the other. Check to make sure the door is completely shut and shut proper ... Dishwashers

TDB662RBR0 dishwasher leaks. Tub/door gasket is stiff and split. What is involved in replacing the gasket?


The gaskets are held on around the perimeter with screws or should be. Remove them and the gaskets. You may want to soak new gasket in the tub for an hour in hot water to soften it up, makes it much easier to install. Sinc ... Tappan MDB531RF Dishwasher

Bosch d/w model shu6806. Leaking lower door gasket. have new gasket but would like manual instructions on replacement. must door be removed? Any particular warnings? Charles


I have had the same problem and finally stumbled upon the answer today!\015\012\015\012If you are looking inside your dishwasher, look mid way up the right\015\012side wall and there is a valve/hole...if that hole is covered up (e.g.\015\ ... Bosch 24 in. SHU43 Built-in Dishwasher

Water is leaking from the door (bottom) and some got through the air vent at upper left corner!? I just repalced the heating element gaskets, so they are not to blame this time. door gasket?


... Frigidaire 24 in. PLD3460 Built-in Dishwasher

My LG6810ST leaks out the bottom of the door because the DOOR gaskets is deformed. I need a source for the replacement gasket and the removal / installation instructions.


... LG LDF6810ST Stainless Steel Built-in Dishwasher

I need to replace the large gasket in the front of my Whirlpool Gold dishwasher. I have the part W10082795. Is there a trick to it or do I just pull out the old gasket and wedge in the new one?


Take exact center of new gasket and start installing at the exact cent of top of door. very simple. ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Water leak have the Ge triton dishwasher (Model # GSD5320D02BB, bought it n 2001) and currently have very small amount of water leaking out of the door during a run cycle. I did check levels when running and that seems to be fine......meaning the dishwasher is level and not an over-flow problem. My next thought is maybe it is a faulty door gasket. So my question is, where is the door gasket located and how do I replace it? (and where do I order this part from?). Looked for diagrams to follow and


They are in the bottom left and right of the door opening. GE likes to use L-shaped, molded and ribbed seals on most of their models - hopefully also on yours. Typically these can be removed by hand and easily replaced without taking anything apart. ... GE Tritonr XL GSD6260JCC Dishwasher

I have a model 665.1576 or 1676 my paperwork does not have the number on it and no part number on he machine, but I ordered parts from the catalog which matched. about 7 years old, stopped draining, so I changed the Seal kit, pump base seal, impeller, plus drain cover gasket but not the pump gasket could not find it, reinstalled, pump works but much slower and times out, have to hit drain button to get all water out. Keith


... Kenmore Dishwashers

Door leak The dishwasher is 2 and half year old and is randomly leaking for at least one year or even more. The leak originally occurred at both lower ends of the door, close to the hinges. The leak was about one liter and the door panel sound insulation soaked with water. After door panel was removed, the leak location was identified at both ends of the lower door gasket. The outside part of the U-shaped gasket was filled with water, and eventually water was spilled on the floor. The leak can g


I had the same problem. On the right side of the tank in Bosch dishwashers there is a steam port. If you place a large object in the right hand edge of the tray, a pressure build up causes the leak. Put large stuff on the left and you should be good ... Bosch 24 in. SHU5305UC Built-in Dishwasher

The pump is leaking from the small gasket coming out of the side. Can I get a new gasket? [email protected]


Yes, but, why don't you check fist the gasket, maybe it just came out and need to put it back on track with glue sealant so that it won't come no more, if the gasket is not broken. if broken, just go to sears warehouse and give them the serial number ... Dishwashers

Kenmore dishwasher door leaks replaced gasket still leaks model#665.15669992 gasket replacement sears #3376927


Check your overflow float inside the machine. it looks like a small hat or cone. it should move freely up and down. if it is stuck down, the water will continue to flow in. the gasket is designed to stop splashing water. it is not an underwater ... Kenmore 24 in. 15689 Built-in Dishwasher

I don't have a model number right now, but the front door on my Admiral dishwasher is leaking at the bottom. I have changed the gasket inside the door panel at the bottom but it still leaks. This is a rental property and the renters did a job on this dishwasher. I was wondering if they may have pulled another lower gasket off that I didn't know existed. Something like a windshield wiper. The seal I changed was a foam strip 3 x 22 approx. Thanks for your time, Joan


It may not be the door that is leaking if this is an older admiral or whirlpool dishwasher the lever that holds the soap door closed has a little rubber seal that after time will let water in during the wash cycle it the runs down the inside of the d ... Admiral Dishwashers

Not sure the model number. But the large gasket in the bottem of the dishwasher almost seems to be desinigrating. I thought it was mold but you wipe the gasket with a paper towel and the plastic comes off. the residue is also clinging to the silverware rack.


Hi,\012That\012is not that hard to fix and you can easily buy the parts yourself\012online...Here is a tip that will help you with the online\012buying...How to Buy ... Kenmore 24 in. 15932 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0174 seconds