Having problems with your Honda Pressure Washers ?

No pressure!! when i turn on my pressure washer no pressure comes out of it why is that?


Answers :

You have an air lock. Here's how to fix it:
\015\0121. Connect the hoses, and turn the water on. Work the supply hose in such a manner as to displace any air in high points in the hose through the pump. Let the water run for several minutes, then connect the gum. Turn the water back on and let the PW come up to 'house' pressure, and pull the trigger to depressure the system rapidly. This displaces any trapped air. Do this several times, until you get no traces of air at the gun. Crank the PW; it should come up on full discharge pressure. If it does not, shut the engine off, and repeat the displacement maneuver. This time, start the engine while holding the trigger of the gun down. This will act as an unloader, and should give you full pressure.
\015\012Best regards, --W/D--
Repair Help & Product Troubleshooting for Honda Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a campbell hausfeld 2450 pressure washer with water coming out of a brass hose nozzel right next to where you screw the high pressure to the pump as soon as you turn the water on from the house, start it up and high pressure comes out of it and the hose about half pressure, any ideas?


This is called the chemical injector which enables you to insert the hose for you to dispense the soap and or chemical by utilizing a soap nozzle .apparently inside this barb you will find a ball a spring and a o-ring,find the replacement parts or ki ... Campbell Hausfeld Pressure Washers

I have a northstar pressure washer mdl.157182D,S/N:157182. Pressure washer works but does not have much pressure coming out of the nozzle even when the adjustment knob is turned all the way in.


... Northstar Pressure Washers

No high power water pressure coming out of my model #580.768030 pressure washer. The same pressure comes out when the pump is turned off.


You should dismantle and clean the manifold from the pump , it is sticking. Common ... Comet BXD2527 Pressure Washer Pump

Hi- I have a Simoniz S1600 pressure washer and usually when I first turn it on, the motor turns on to build up pressure. Now the motor won't kick in no matter what I do. Water still comes out of the gun as a small stream but there is no pressure. There are no reset buttons on the exterior of the machine. Thanks!


... Pressure Washers

Using a Bosch 1600W Pressure washer Aquatak 110 plus Was adjusting the twist pressure sleeve to get HIGH pressure and water supply stopped and sleeve seems fixed/seized. I turned power ON and OFF and turned water tap ON and OFF but still no water coming out of the nozzle. What do I do now?


... Pressure Washers

When i turn my pressure washer on it works for a few mins then smoke comes out of it and it cuts off. i bought it last year and only used it once and this happened when i have tried to use it this year. its a karcher pressure washer thanx


Sounds like a motor problem. ... Karcher K2.26 Electric Power Washer

I have a Karcher 3.99 Pressure Washer. The motor appears to be working and water is passing through the machine when turned to the detergent application setting. However when the lance is tightened to turn on the pressure, no water is coming through. The Karcher is just over 1 year old David


Hi I have a karcher 3.99 the motor comes on and water comes out however thre is no pressure i have tested the lance on my brothers washer and this is ok what is wrong ... Karcher K 5.85 M Electric Pressure Washer

I have a XR 2600 Honda pressure washer. After using it for about an hour, the pressure dropped drastically. I turned it off. I started the following day to finish the job and the pressure was a steady "stream" coming out of the wand - no pressure to clean the concrete. Can you tell me what might be wrong?


Change the spark plug. ... Honda Pressure Washers

My pressure washer is a G 2500 oh n i have no pressure coming out, it turns on but no pressure.


Good news, your engine runsBut your pump may be badHere's how to test your pumpCheck oil as outlined lower downDisconnect the washer hose and gunConnect water hose a ... Karcher 2500 PSI Pressure Washer

No pressure!! when i turn on my pressure washer no pressure comes out of it why is that?


You have an air lock. Here's how to fix it:\015\0121. Connect the hoses, and turn the water on. Work the supply hose in such a manner as to displace any air in high points in the hose through the pump. Let the water run for several minutes, ... Honda Pressure Washers

I have a Comet BXD 2525 G pressure washer pump which is giving me some problem. (Maybe) I hook the water up to pump and the pressure hose up to the pump, turn on the water and the water sprays out of the water connection at the pump. I check the hose to see if it was clog ok and the next was a the water connection ok. It's like the water is not going int the pump. When i start the pressure up the water come out of gun but no pump running like it should. The next thing i was going to look at i


The water inlet needs a gasket like all hose connections. If its gone the pump may be starving for water. ... Comet Pressure Washers

Husky 500 2200 psi. starts and runs ok, but no pressure through the wand. hooked up garden hose to power washer turned water on and it comes through the hose ok, but start up and put wand on and no pressure.


... Pressure Washers

I have a Husky 2600 Psi 2.3 GPM Honda powered gas pressure washer. When i turn it on the motor runs fine, But when i squeeze the trigger the water is not pressurized when it comes out. How do i fix this problem?


... Honda Pressure Washers

Power washer starts no problem but when turned on and activating the trigger on the pressure washer gun, water no longer comes out. The gun itself was replaced not long ago. What could be the cause?


The tip could be plugged up ... Honda Pressure Washers

Frigidaire dishwasher (Electrolux FDB750RCB0) does not move water through the hose to the upper wash/spray bar. The lower wash/spray bar has pressure enough to turn. With the dish washer out from under the counter I can see the water rise very slowly up the translucent hose. If I remove the check ball under the stem assembly in the motor in the bottom of the tub, water flows, but I'm not sure if the top bar turns then (with the door open I see water coming down from the top, but never saw


... Dishwashers

When i turn on my k499m pressure washer the motor seems very week and the pressure is non existant has anyone ever come across this problem before i havnt tried anything to fix it yet but the water is flowing into it ok it just seems as if their is something wrong with the motor or pump


I have come across this before, it can be that the motor has burned out and in that case it can be better to purchase a new machine. \015\012\015\012It could also be the capacitor which is not a very expensive item to replace. What the ca ... Karcher Pressure Washers

Karcher pressure washer K2.65M has smoke coming from the back as soon as it is turned on


... Karcher Pressure Washers

The power washer turns on and everything but the water does not come out with much pressure. What seems to be the problem


... Craftsman 2500 PSI Briggs Stratton Powered Pressure Washer

My electric pressure washer's motor will not start. the 110 plug has a test/reset fuse on it. when i plug it in the light comes on. i push test- it turns off but motor does not run. i push reset and the light stays on.


With the water faucet turned fully on and the power switch on squeeze and hold the trigger for at least 10 seconds to let the water flow push the air out and then it should start up. ... Campbell Hausfeld PW1750 Electric Pressure Washer

Pressure washer won't turn over with water turned on


... Karcher Pressure Washers

The last time I used the pressure washer was running fine. A few minutes later I tried to start it up and could barely turn it over. I removed the recoil and could turn it a little easier backwards. The motor is a Honda GC190 on a karcher pressure washer and has 20 -30 hours of running time. Thanks Clint


... Karcher 2500 PSI Pressure Washer

Water coming out of the soap dispenser on the pressure washer


I would suspect a piece of debris is caught under the injector ball valve. It may also be clogged with soap if you failed to flush it clean after the last use. Disassemble the valve and give it a good cleaning. Be careful as there is a small ball bea ... Karcher PSI Electric Pressure Washer

Northstar Hot Water Pressure Washer (model #157322) While using the pressure washer the safety relief valve activated venting steam and hot water from it... I immediately shut it down and let it cool down. After it was cool, I turned on the water supply again and the relief valve was still spewing water from it. My neighbor said it was probably the "unloader" valve was stuck or damaged. I called around my area and it seems as though no one services my pressure washer.. Is there a manu


... Pressure Washers

Turn water on then actuate wand trigger. Pressure washer leaks when wand trigger is actuated and has very low pressure/flow output. After releasing trigger the pressure cycles on - off at approx 1 second interval. I suspect that the plasstic oulet tube is leaking causing low pressure leak out of bottom when trigger is actuated and causes pressure switch to cycle when the trigger is released. Any Help? This pressure washer is approx 18 months old!


You gave a very close solution yourself for the problem. But other leakages can cause such symtoms.Forexample a leaking head or a leaking chemical inlet. These can be caused because the spill valve (pressure control valve) is stuck. When this valve s ... Karcher PSI Electric Pressure Washer

Karucherr pressure washer, no water coming out


... Karcher 1750 psi Electric Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1148 seconds