Having problems with your Honda Pressure Washers ?

Need a bearing for a honda 5.0 pressure washer gc160 xr2625 ser 2651048039


Answers :

Repair Help & Product Troubleshooting for Honda Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Need a bearing for a honda 5.0 pressure washer gc160 xr2625 ser 2651048039


... Honda Pressure Washers

I have a Honda GC160 pressure washer that pulses and has low pressure except for initial burst when I pull the trigger. Need to fix. How?


... Honda Pressure Washers

Pressure washer serial#0493, model # 3504cwhbd, I need the name of the pressurer washer company,it has a 13HP Honda engine and stainless steel carage


... Pressure Washers

Honda pressure washer model # exhp3640-1 3600psi 0=13hp has low water pressure out of triggers motor does not engage for higher pressure


... Pressure Washers

I have a Honda gc160 5.0 pressure washer. All fluids are fresh. Water is hooked up with plenty of pressure but the water pressure is up and down then goes completely out. No water will come out of the wand? Please advise. Thank you.


Needs new pump ... Karcher 2500 PSI Pressure Washer

I have a Northstar pressure washer powered by a honda GC160 engine. The last time i used it, water leaks from the bottom of the unit, whether it is running or not. When running, the pressure is fine. I have felt underneath and it appears that the water is coming from the second opening from the rear. Is there a pressure relief valve there. I have a manual but cannot find any descriptors for underneath the motor.


This is a piston seal issue. You can get a kit to rebuild the pump. ... Comet AXD 3020 G Pressure Washer Pump

Remove the lower wash arm (1) by turning the nut (4) clockwise (right) lift the arm off, there is a bearing (3) (small thin plastic washer) under the arm, be sure not to loose it. Lift the tab on the back of the feed tube cap (2) and swing it to the right and lift up, this may need a bit of pressure to release it This is for my Whirlpool dishwasher DU1100XTP. I'm putting it back together and can't remember if the plastic washer goes on top or underneath the feed tube cap. Also how do I remo


This is not a tuff job plastic washer goes on top . and torx screws . you use a proper torx tip for the screw size . ( you can go to sears parts .com and put in model # and see a good break down of the wash arm s and t ... Dishwashers

What type of oil is needed for a Honda GC160 Power Washer? Honda 2500 PSI x 2.3 GPM.


The type of oil recommended for that engine is SAE 10W-30 and the capacity is 0.61 quarts. This and more can be referenced at the website at the end of this solution. I was able to find the owners manual of your particular engine. http:/ ... Honda Pressure Washer PSI 3000

I NEED A WIRING DIAGRAM FOR A HONDA GX390 - Honda Pressure Washer PSI 3000


I can get a wiring diagram in a day or two. E-mail me if you still need one ... Honda Pressure Washer PSI 3000

How to check fuel pump for honda gc160 - Honda Pressure Washers


... Honda Pressure Washers

I need to know what kind of oil the pressure washer takes, I noticed it has a place for oil on the engine and another neat the pump. The product is a honda pressure wave 220 PSI Model NO 2225cwh-2


... Honda Maxus Prosumer MX5223 Pressure Washer

My Troy Bilt power washer (using Honda GCV160 engine) has no pressure coming from the pump. I checked the water flow, everything seems fine. I believe the pump needs oil added, however, I can't seem to firgure it out (how to add oil to the pump). I did notice that previously, I used to see drops of oil coming from under the pump. I I have a bad seal, can I add oil and test the pressure before I change the seal? Please advise.


I had a similar problem. Turns out I had left the hose disconnected and some sort of wasp built a paper type nest inside the washer tube that the hose connects to. I had to take the pump off and take apart and then cleaned it out with a screw driver. ... Honda Black Max 2600 PSI Pressure Washer

Flywheel won't budge on Honda GC160 pressure washer.


... Pressure Washers

Karcher pressure washer with Honda GC160 engine only runs on chok


You need to remove the carb bowl, then with a small flat screwdriver remove the jet. ( on the side, at the bottom of stem.) take a small wire or toothpick and clean the gunk out of the jet, reassemble and open fuel valve, start, and pat yourself on y ... Karcher 2500 PSI Pressure Washer

Home Depot has a lawn mower with the Honda GCV160 Electric start version engine. They also have a pressure washer with the Honda GCV160 engine. I have a disability that makes it difficult to pull the starter rope. I would like to get the electric start on the pressure washer. My local Honda bike shop service center said they use different blocks. Can I get a pressure washer pump mounted to the Honda GCV160 Electric start version engine? If necessary, are there adapter plates that can be purchase


... Karcher 2500 PSI Pressure Washer

Honda GC150 pressure washer manual


... Pressure Washers

I NEED A FUEL PUMP FOR A HONDA 5 HORSE - Karcher 2500 PSI Pressure Washer


... Karcher 2500 PSI Pressure Washer

The oil in my gc160 Honda pressure washer is getting water in it some how. Could it be something with the water pump gasket or what? And I can get it started but can't keep it running un less I keep spraying starter fluid in the carbar. Please help ?


... Karcher 2500 PSI Pressure Washer

Need a free diagram of Honda Husky 3000 PSI pressure washer that labels parts


... Honda Pressure Washer PSI 3000

Pressure washer with Honda Engine GC160 only run with choke fully closed.


The carb is clogged. It needs to be cleaned, or replace. Keep in mind some of the carb passageways are as small as a human hair so they are difficult to clean which is why I mention replacing. You can try using carb cleaner etc in the gas, but I d ... Karcher 2500 PSI Pressure Washer

I need to clean carburetor on 340gx honda pressure washer. How would I do this?


Don has it about right. Step by step: Back out both air filter wing nuts, remove top filter assem. Use 10mm socket to remove two nuts and one bolt, needle nose pliers to remove fuel line, Slide carb 1/2 way off bolt studs and remove spring from molde ... Honda Pressure Washers

My porter cable 2400 psi pressure washer will not start. has honda engine gc160. pulled plug and put up against frame and it has spark. It's full of oil.


... Porter Cable Cable Commercial Pressure Washer PCH3200

NEED A LONGER WAND - Honda Black Max 2600 PSI Pressure Washer


What size wand are you looking for? The most popular sections of wand that we sell are 8 ft and 12 ft. ... Honda Black Max 2600 PSI Pressure Washer

I need a manual for Honda SPD-220 - Pressure Washers


... Pressure Washers

Was using pressure washer (Troy Built 2600psi Honda engin 5.0 GC160) when it just stopped! tried to pullstart and flywheel wont turn. any ideas


... Karcher 2500 PSI Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0855 seconds