Having problems with your Honda Pressure Washers ?

How do you operate a EX-CELL EXWGC2225 pressure washer

\015 EX-CELL model # EXWGC2225 with 2200 PSC, 2.5 GPM, 5000 cleaning units, with a Honda engine GC160 , 5.0\015

Answers :

Repair Help & Product Troubleshooting for Honda Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do you operate a EX-CELL EXWGC2225 pressure washer


... Honda Pressure Washers

Karcher G 4000 Sh pressure washer will not attain any pressure as a general rule, occassionally it will operate as its suppose to.


... Pressure Washers

Premium Ex-Cell Pressure Washer EXH2425 - Pressure Washers


... Pressure Washers

Where can I find craftsman pressure washer 1500psi operator's manual I am not able to locate a manual for a Sears 1500 psi pressure washer. Do you know where I may be able to find one?


... RTO 1500 Psi High Pressure Washer,very High Quality

Ex-cell pressure washer 2000 psi - Pressure Washers


... Pressure Washers

The Hom Model No. 308653045 gas-operated cold-water pressure washer has a spring-loaded control on it and I am assuming that this control regulates the output pressure of the water from the pump . . . for example, 1500 psi to 2700 psi. Is it correct to assume that this control regulates the output pressure of the pump. If the control is a pressure regulator, how does one use it and, EVEN MORE IMPORTANT, can one under-adjust or over-adjust the control to a point where THE CONTROL OR THE PUM


... Homelite Pressure Washers

Karcher 520M Pressure washer won't operate at high pressure


I had the same problem - good water inlet pressure, no output pressure, even though the lance and handle seemed to be clear and working find.\015\012\015\012I found that the electrical switch wasn't being operated correctly by the spill valve a ... Karcher 2500 PSI Pressure Washer

Low or no pressure on EX-Cell XR2600 pressure washer


... Pressure Washers

5.5 HP Honda on a Karcher pressure washer. Will only run in full choke mode. When choke is closed for normal operation, motor conks out. I have removed Air filter and inspected operation and butterfly is operating correctly. What to check next?


Fuel mixture screw ... Pressure Washers

I have a model PW 2200 gas pressure washer. It suddenly lost it's high pressure the other day after working fine for @10 minutes. It's getting plenty of water, but the engine doesn't seem to rev up to give it the high pressure. The operating instructions say to check the oil in the engine, and the PUMP before starting, but I haven't found any place to check for an oil level in the pump????Any ideas, I'm very confused.


... Pressure Washers

I have a 5HP Honda engine installed on a Excell pressure washer. While the engine readily starts, it will not continue to run unless I keep the choke setting nearly completely closed. When I activate the pressure gun, it seems to generate adequate pressure, however, when the trigger is released, the engine continues to run at the same rpm instead of the normal variable rpm that most engines operate at during idling periods. The engine will always cease running when I push the choke rod all the w


... Honda Pressure Washers

Operating Manuals Karcher 302 presser washer - Pressure Washers


Do you want a "how to use the machine" or "parts diagrams" or "how to repair" ?"how to use" is the same for all pressure washers...........i guess you own a KB 302 1.994-923.0 but karcher dont list this "operators manual"this ... Pressure Washers

My Karcher 4000 SHR Pressure Washer pressure pulses when operating. I have checked with Karcher Technical Support and all their trouble shooting procedures except checking the unloading valve. Where is this valve, how do I get to it and how do I lubricate it?


It sounds like your unloading valve is crudded up with mineral deposits and stuck in a partway open state. look for a plastic cover with a silver snap on top; pry off the silver snap and lift off the plastic cover; next remove the two screws on the ... Honda Karcher G4000RH Pressure Washer

Campbell Hausfield Pressure washer model 1549. After a few years of storage, I cannot prevent the powerful spray leaking from the connection between the Gun and the Lance. I replaced the O-Ring, and tried other means unsuccessfully. Spray from the joint is almost as powerful as spray from the lance nozzle. The Briggs and Stratton engine has been cleaned and operates well. The pump operates well. But the lance connection refuses to seal.


Hello,Most likely, the housing has split and seal is not being made. There is a chance that the hose is leaking where the fitting is crimped on (my experience, but different pressure washer). Are you able to see a leak when turned off b ... Campbell Hausfeld Pressure Washers

Hi there I have a Bosch SGV4313GB/17 Dishwasher the problem is there insuffient water pressure to feed the washer arm and they are not rotating Ihave cleaned the arms and circulation pump impeller with white vinegar ,I have also overriden the door switch and operated the dishwasher with arms removed and the circulation pump seem to be working but with insuffient pressure also the machine does not fill to the depth it did when it was fine! How does one tell if it is the impeller or the


Ours is a SHU3300UC/06 model, basic model which we bought in 1999 so have had 9 years of trouble free service.Recently\015\012we noticed that there was soap left in the soap dispenser after the\015\012machine had finished all the cycles. On fu ... Dishwashers

My 1750 psi campbell hausfeld pressure washer will operate at first until I release the trigger on the wand. Then it won't restart. If I wait for a while it will run again. Sounds like the pressure switch.


Common with that washer...it has a wabble pump. Release the trigger, if by pass does not engage, stalls engine. You can however keep using it, all you have to do is keep trigger pressed, and when you are cranking engine, depress trigger with the fr ... Pressure Washers

DeVilbiss Pressure WAsher EXH2425 Honda engine GC160qha pump DAPC axcial cam. When using washer sprayer both the engine and pump seem to operate normally. As soon as I let off the trigger of sprayer the engine dies. Help?


Hi and welcome to FixYa. I am Kelly \015\012Take a look at your engine parts manual here: \015\012\015\012 ... Pressure Washers

When i operate the switch on my karcher pressure washer the power wash does not operate.


But water comes out the end right? just under hose pressure only I bet. \015\012I have one of these units and every time I think it has gone bad I manage to find the problem.\015\012This unit not only has the switch on the front that needs to be on b ... Karcher 1750 psi Electric Pressure Washer

Pressure gauge needle stays in max position running or not. otherwise pressure washer operates normally.


Pressure gauge is probably "sprung". Unless it bothers you, ignore it. Even expensive industrial pressure gauges fail regularly - I have seen a truck load worth of them (all brands and types) that read pressure even after being disconnected from pi ... General Easy Bolton 4 Gpm3500 Psi Pressure Washer Pump

Karcher pressure washer 2.54 possible thermal switch operated


... Karcher Pressure Washers

Test reset switch wont operate for my b&d pressure washer


The main fuse in the g.f .c.i.ground, fault, circuit, interrupter,is damage.cut it of and purchase one at the supply storeand join it backimportant replace it with a new one,due to the fact it's safety devise, ... Pressure Washers

I need to download an operating manual for dewalt DP3100 pressure washer


How's this ... Pressure Washers

The pump doesn't seem to put out enough water pressure to turn the various revolving heads/nozzles in the washer - all washing heads are operable (ie unblocked) while the S shaped nozzle at the base and the small round nozzle at the top/ceiling of the cabinet do revolve slightly or slowly - but the two main nozzles spout water but not enough to revolve Is this a defective pump or a partially blocked pump ? - or something else - I have checked everything else and they appear to be functioning


It will be helpful to know the make and model number of the dishwasher to diagnose the problem you have.\015\012\015\012Generally this is attributed to a blocked chopper assembly in the wash circuit but hard to be sure if your model has o ... Dishwashers

Cannot draw soap or cleaning solution from a bucket. Is their a adjustment screw to make it draw. Pressure washer works fine with just water. Lost the operators manual.


You first must slide the nozzle forward to the low pressure setting for it to inject any detergent. It will only draw the detergent in low pressure mode. If it still will not draw up the detergent, then the injector may be clogged. It must be through ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

Have whirlpool dishwasher model DU1055XTSS2 and the top rack water wheel does not spin. Operated the washer with door opened and it gets water but doesn't spin. There are no restrictions to the jets on wheel and the wheel turns feeely. The only thing i can figure is inadequate water pressure....


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0594 seconds