Having problems with your Honda Pressure Washers ?

How to run Honda gx340 ohv pressure washer - Honda Pressure Washers


Answers :

Repair Help & Product Troubleshooting for Honda Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to run Honda gx340 ohv pressure washer - Honda Pressure Washers


... Honda Pressure Washers

Engine will not turn-over. It is a Honda 11 HP, OHV on a Karcher Pressure Washer. It was running fine for about 45 minutes. All of a sudden it stopped. When I tried to start it again, the engine is bound up so that the pull rope will not pull out at all. It has plenty of gas. The crank case is full of oil, not over full.


Pull the spart plug out and see if you can pull it. Sometimes the carb will flood the engine to a point that they get hydrolic lock.If it does free up then I suggest cleaning the carburator before trying to start it again.If it does not free up the y ... Karcher 2500 PSI Pressure Washer

The last time I used the pressure washer was running fine. A few minutes later I tried to start it up and could barely turn it over. I removed the recoil and could turn it a little easier backwards. The motor is a Honda GC190 on a karcher pressure washer and has 20 -30 hours of running time. Thanks Clint


... Karcher 2500 PSI Pressure Washer

New honda pressure washer maybe had it 2 years and only has about 3 hours on it, I was using it yesterday and it started fine and after running for about 10 min it shut down like i turned the kill switch, it has oil and gas but seems to have lost compression. It is a Honda overhead cam GCV 160, pressure washer is a Troy Built model


... Pressure Washers

I have a Generac pressure washer, model #01450-0, with a Honda 5hp motor. The motor runs fine, but the pressure hose pulsates as if the pump is intermittently making pressure, and the pressure out of the sprayer is about half of what it should be. A friend suggested replacing the seals in the unloader. I bought an unloader kit, replaced everything and it still runs the same. It will build a small amount of pressure, spray for a few seconds, then the pressure dropps to almost nothing. Any help ap


Take a small diameter wire and poke thru the discharge hole of the spray head to clean out.\015\012Second time in 6 months that I had the same problem. The problem is alway in the spray head. ... Pressure Washers

I have a 5HP Honda engine installed on a Excell pressure washer. While the engine readily starts, it will not continue to run unless I keep the choke setting nearly completely closed. When I activate the pressure gun, it seems to generate adequate pressure, however, when the trigger is released, the engine continues to run at the same rpm instead of the normal variable rpm that most engines operate at during idling periods. The engine will always cease running when I push the choke rod all the w


... Honda Pressure Washers

2-yr old troy-bilt pressure washer with honda gcv160 engine. seems to run well, but when trigger is pulled get full pressure for less than 5 seconds before reducing to house water pressure. when left running, looks a black plastic pressure relief valve starts blasting hot water. appreciate whatever insight you can give. Thx


It sounds like an air lock. Try this: With the machine off, connect the hose to the washer and let it run for several minutes to get all of the air out of the hose, and to purge any air out of the pump. Shut off the water, and connect the high pre ... Briggs & Stratton Pressure Washers

I have a honda 2600 pressure washer. After running fine for a couple of seconds the water will stop flowing out the tip. It is receiving water,but will not flow it to the pressure hose. I even disconnected the pressure hose and no wate was flowing out. When I shut the pressure washer off it would then flow water to the hose again. Please help


This is a symptom caused by a sticking Unloader valve. The Unloader valve is inside the pump outlet body under the large black knob. \015\012Example picture : ... Honda Black Max 2600 PSI Pressure Washer

I have a Northstar pressure washer powered by a honda GC160 engine. The last time i used it, water leaks from the bottom of the unit, whether it is running or not. When running, the pressure is fine. I have felt underneath and it appears that the water is coming from the second opening from the rear. Is there a pressure relief valve there. I have a manual but cannot find any descriptors for underneath the motor.


This is a piston seal issue. You can get a kit to rebuild the pump. ... Comet AXD 3020 G Pressure Washer Pump

Pressure washer Honda Craftsman pressure washer 2400 PSI that runs for a little bit and then shuts off for no reason.


... Karcher 2500 PSI Pressure Washer

Hello, I own a Honda Pressure Washer (Porter Cable Model) with a Cat pump 2600psi and 6.5 hp. An Excellent machine for the past 7 years. Last fall I noticed it was not producing the full pressure but still Engine was running strong. This past weekend. started it up and used it for about 1 hour still with minimal pressure at full throttle. Then pressure was totally cut off. I stopped and started the engine the engine and it had minimal pressure again. Same thing happened again. I stopped the engi


... Honda Pressure Washers

Pressure washer with Honda GX160 5.5 HP OHV-Starts easily but...


What about the linkage between the governer and the carb. Is that working and not binding? ... Honda Pressure Washer PSI 3000

I have a Honda GX110 petrol pressure washer, it runs but the pressure is poor. If I turn the red knob on the pump no difference is noticeable. Also the pressure gauge is faulty but I don't think this should affect the pressure??


You should check with the manufacturer for a pump kit for this washer.\015\012\015\012If it's a good unit they should have the stuff to freshen up the pump so it runs like new.\015\012\015\012Have you checked the oil level in ... Karcher 2500 PSI Pressure Washer

Honda pressure washer 5hp will only run with the choke on. Was running fine for about 1 hour


Always burn FRESH number 1 fuel in this engine and make sure there is a screen on the spout of the can or plastic jug. ... Pressure Washers

Honda gas power pressure washer runs for awhile then cuts off.


Did you pour all of the old gas out before you started to use it. Sometimes condensation builds up in gas tank when stored. You need to dump old gas an put in new gas. ... Honda Karcher G4000RH Pressure Washer

I have a troybilt 3300 psi pressure washer with a gx390 honda engine. Replaced carb with new one . washer now will start and runs fine under load but let off water and carb goes up and down and backf


... Pressure Washers

No pressure to the wand. Motor runs and pressure gauge reads 4000 psi.Feels like no power in the wand Is a Honda pressure washer model #BEEX-2965HWCOMX.


... Honda Pressure Washers

11 hp honda motor on landa cold water pressure washer runs good except when trying to pressure wash the motor & pressure go up & down pulsating bbruummmmmbbbbrrruummmmbbbrruuummmmwhats the problem and how to fix it?


... Honda Landa PG 3500 PSI Pressure Washer

HAVE A DEWALT PRESSURE WASHER WITH 6.5 HONDA ENGINE THAT WAS STORED FOR A COUPLE OF YEARS. IT WILL START BUT ONLY RUN FOR3-4 SECONDS WITH CHOKE ON THEN KILLS. WAIT A MINUTE OR SO, PULL ROPE AND WILL RUN FOR ANOTHER 3-4 SECONDS. WON'T RUN CONTINUOUSLY. PUT FRESH GAS AND CLEANED BOWL UNDER CARB. ANY OTHER TIPS? THANKS, FOREST


Look for plugged filter anywhere in fuel line. ... Pressure Washers

My honda pressure washer runs put there is no pressure when i pull the trigger. we have checked the oil and everything, the water comes out just no pressure.


Check to see if you have an obstruction in the hose or tip. If clear you have a problem with the unloader valve. This valve sometimes gets stuck and continually recirculates the water not allowing you to build pressure. Sometimes you can remove and c ... Honda Maxus Pressure Washer MX5222

Honda GCV160 5.5 on a pressure washer runs only intermittently


The problem is the plastic float in the carburetor, it's not adjustable and after sitting up with gas in it it distorts. Save yourself the trouble and buy a new one, you can get them online for $15-$20. ... Campbell Hausfeld Pressure Washers

WhaT KIND OF OIL do we use in a Honda gx340 pressure washer?


... Honda Pressure Washer PSI 3000

Egine runs but there is no water pressure. - Honda Pressure Washers


With engine off, pour liquid TSP into the water inlet port (where the fresh water hose connects)\015\012Let this sit in the pump for at least two days.\015\012Then connect the garden hose to the inlet and let run for a couple of minutes w ... Honda Pressure Washers

190 honda engine only runs on choke? - Honda 50 W Ar Pump 2500 Psi 25 Gpm Pressure Washer


Pour a large amount of carburator cleaner into the gas tank \015\012run the engine for five minutes then shut it off and let it sit for a couple of days.\015\012then start it and see if it runs any better\015\012the longer you let i ... Honda 50 W Ar Pump 2500 Psi 25 Gpm Pressure Washer

Engine runs but no pressure - Honda Pressure Washer PSI 3000


Many people forget to shut down the "CHOKE" after a cold start up. ... Honda Pressure Washer PSI 3000
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1240 seconds