Having problems with your Hoover FH50220 MaxExtract 60 Pressure Pro Carpet Extractor ?

Brushs wont turn - Hoover FH50220 MaxExtract 60 Pressure Pro Carpet Extractor


Answers :

Repair Help & Product Troubleshooting for Hoover FH50220 MaxExtract 60 Pressure Pro Carpet Extractor

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Brushs wont turn - Hoover FH50220 MaxExtract 60 Pressure Pro Carpet Extractor


... Hoover FH50220 MaxExtract 60 Pressure Pro Carpet Extractor

Hy; I have a karcher 580 I had to replace gun complete so I bough a simoniz xe01-001 at simoniz.osirus.ca/ for your info 69$ complete ***.I install NOW I get pulse up & down ONLY when trigger is press I turn valve down i only get 10% of pressure if i turn valve up that is when it start pulsing pressure up & down it wont keep pressure up ... Bob...


Most likely problem is that the tip is too small causing Unloader to bypass or restriction/debris in tip. Install clean tip of proper size or 1/2 size larger (example from 2.5 gpm to 3 gpm ) to prevent slow pulse. If tip is clean and /o ... Karcher 2500 PSI Pressure Washer

I have a bosch 110 plus pressure washer the problem i have is i turn on washer squeeze trigger and works fine when i release trigger and press again it wont work and trigger seems to have pressure on it


... Bosch AQUATAK 110 Pressure Washer

My pressure washer wont turn on....its been a while since i last used it so i am thinking it might be a spark plug but its jammed in there. ANy advise


PRESSURE WASHER WONT TURN ON ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Hotpoint DF33. Wont empty pump is trying to turn. think piece of plastic stuck from off metal gauz filter . I have machine tuned on its side ,with side covers off. have tried back flushing with water mains pressure and sucking with vacuum . HELP Brian S


... Kitchen and Much More Dishwashers

Was using pressure washer (Troy Built 2600psi Honda engin 5.0 GC160) when it just stopped! tried to pullstart and flywheel wont turn. any ideas


... Karcher 2500 PSI Pressure Washer

The soap will not dispense--how can I fix it? ... My Aquatak 150 pro x wont draw detergent from the two small detergent tanks at any ... soap not pulling on low pressure. opposite water going thru pick up into container The check valve on the .


... Bosch AQUATAK 150 PRO X Pressure Washer

I have a kohler command pro 8.5 on a porter cable pressure washer. Yesterday it started just fine. Today I pulled the start rope and there was no resistance and the engine did not turn over. The pull rope rewound just fine and I tried again with the same result. After several tries it caught just a little near the end of the pull and the engine started. What is the cause of this problem?


... Porter Cable Pressure Washers

Karcher wont turn on - Karcher Pressure Washers


... Karcher Pressure Washers

My Aquatak 150 pro x wont draw detergent from the two small detergent tanks at any pressure or lance setting.The machine is new. I have tried priming the pickup tubes.


... Pressure Washers

I have a Pro Force 2400 with a Honda gc160 motor that has no pressure. I had some sand in the hose and turned it on. Sand probably got in the machine. What can I do


... Pressure Washers

2050 PSI Gas Pressure Washer - 20244: my excell pressure washer wont start. pull start t...


... Briggs & Stratton Gas Pressure Washer 20244

I have a 1300 psi 1.6 gpm campbell hausfeld pressure washer and it wont pressure up the water


... Pressure Washers

Using a Bosch 1600W Pressure washer Aquatak 110 plus Was adjusting the twist pressure sleeve to get HIGH pressure and water supply stopped and sleeve seems fixed/seized. I turned power ON and OFF and turned water tap ON and OFF but still no water coming out of the nozzle. What do I do now?


... Pressure Washers

Hi- I have a Simoniz S1600 pressure washer and usually when I first turn it on, the motor turns on to build up pressure. Now the motor won't kick in no matter what I do. Water still comes out of the gun as a small stream but there is no pressure. There are no reset buttons on the exterior of the machine. Thanks!


... Pressure Washers

What type of oil to use in pressure pro 2500 - PressurePro Pressure-Pro Home Owner 2500 PSI Pressure Washer


Engine 10w30 hd pump is 30w non detergent ... PressurePro Pressure-Pro Home Owner 2500 PSI Pressure Washer

Karcher 6.85 replaced seals as they were worn out and passing water into the oil now when I turn it on motor runs turning water on water comes out of outlet (which is ok??) but does not pressurize with hose disconnected. My Bosch pressure cleaner passes water through but when pump is started it pressurizes. Is it bypassing? Thanks in advanced


... Pressure Washers

Pressure wont start, small backfire, black smoke


... Karcher 2500 PSI Pressure Washer

Pressure hose wont stay attached to karcher unit


... Karcher K3.540 Electric Pressure Washer

Karcher 520M wont operate at high pressure


The solution is very simple. All you have to do is change the spill valve.\015\012This because the spill valve is not worth servicing. The actual problem is that the spill valve is leaking from its bottom-part seating. When you close the gun ... Karcher 2500 PSI Pressure Washer

Lock wont turn off . i hold the heated dry button for more than 3 seconds and it still wont turn off. tried resetting with breaker swicth No luck


I would be more likely to believe that it is the locking solenoid.You say the light is faint, which leads me to believe that there is a high amperage draw from this locking mechanism. Remember, the locking solenoid should definitely affte ... Dishwashers

The last time I used the pressure washer was running fine. A few minutes later I tried to start it up and could barely turn it over. I removed the recoil and could turn it a little easier backwards. The motor is a Honda GC190 on a karcher pressure washer and has 20 -30 hours of running time. Thanks Clint


... Karcher 2500 PSI Pressure Washer

I have a Karcher K3.91M pressure washer that pulsates when the trigger is released (off). It works fine when turned on, pressure seems OK. Before this started the unit would just turn off until I again wanted to use it. Is it a problem ? Correctable? All connections seem tight & I see no leakage.


... Karcher K 5.85 M Electric Pressure Washer

ASKO dishwasher D3122 drain pump wont stop pumping and the machine wont respond when we press any of the program or start/stop buttons. the program light is flashing. We can turn the power off with the main switch on top of the door but when turning it back on the pump starts pumping again. please tell me how to fix this problem so we can get it up and running again.


... Asko D3122XLSS Stainless Steel Dishwasher

Heller HDW12 at first it wouldnt do a complete cycle, now it wont do any cycle. I can turn it on, it has power it just wont wash, it makes a noise but its not washing. The tap is turned on. Could you please help me as I live in Kalgoorlie and it takes weeks to get a plumber, and he's not cheap...probably cost me my first born!!!! regards B Hughes


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1215 seconds