Having problems with your Hotpoint 18 in. BCI45 Slim-Line Built-in Dishwasher ?

Hotpoint BCI 45 two lights from left flash

\015 Hi,\015\012\015\012I have Hotpoint BCI45 dishwasher which stoped working. The washer fills with water then does nothing else. After sometime the two lights from the left start flashing?\015\012\015\012Can anyone help?\015

Answers :

HI. this is a control fault. this control is unable to run a complete wash cycle due to this malfunction. the logic chips are damaged on the control/timer circuits. Replacing the control board will fix this issue.

You stated you have already initiated a reset sequence. this reset procedure will usually, fix a minor control glitch but, in this case, the control has major damage and, it should be replaced.

To confirm my diagnosis, i suggest you to unplug the unit for 5 minutes. if the unit continues to stop or cease to continue with the cycle, this will confirm control/timer failure. replace the control/timer circuits in this case as asap if possible.
This is most likely a blockage in the filter try thoroughly cleaning the filter and starting the cycle again as normal if this doesn't work then it will be the water solonoid valve alarm turn the washer off for 2 mins then on again and start cycle if it continues to happen you need to phone hotpoint on 07870066066 or www.theservicecentre.co.uk and they can help you. hope it's something simple. Anthony
Repair Help & Product Troubleshooting for Hotpoint 18 in. BCI45 Slim-Line Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hotpoint BCI 45 two lights from left flash


HI. this is a control fault. this control is unable to run a complete wash cycle due to this malfunction. the logic chips are damaged on the control/timer circuits. Replacing the control board will fix this issue.You stated you have alrea ... Hotpoint 18 in. BCI45 Slim-Line Built-in Dishwasher

I have an Hotpoint LS12 -EV03 integrated dishwasher. It will not start/fill. The forst two lights on the left hand side of the light cluster are flashing at the same time. There is a small amount of water also at the bottom of the machine


... Hotpoint 23 in. BFI62 Built-in Dishwasher

Hotpoint dishwasher sdw60p.c has two flashing lights, 4and 6 from left why?? I saw the same problem had another custamer What should I do ?


... Dishwashers

Hotpoint dishwasher sdw60p.c has two flashing lights, 4and 6 from left why?? help please


... Dishwashers

Matsui dishwasher Matsui MS452S slimline - second wash light flashing and unit doesn't fill. Tilting it backwards allows water to leak out from the left rear corner then it runs correctly for minute or two before numerous beeps sound and unit cuts out with light flashing again. How do I get into the base to see if there are any leaks? Unit less than 2 yrs old.


... Dishwashers

LFT 114 Hotpoint dishwasnher. Two flashing lights on the control panel. Light 1 & 2 are flashing. The machine is not working! Could you advise us what the problem might be.


... Dishwashers

Hotpoint wf310 set wash,it starts then after about 20 seconds the on/of light and the lights to the far left flash


You will have to check the error code number which you get as per the blinks.\015\012f01 light 4, motor triac f02 light 3 motor, jammed/ tacho f03 lights 3&4 Ntc fault f04 ... Dishwashers

I have hotpoint fridge freezer FFU 4DK. The lights keep flashing, no Interior Light on ,I switched it all off, turned back on reset the the two dials to off , tuned it back ok. Was ok for a few hours then happened again.


... Hotpoint Ariston Fridge Freezer Door Handle C00111164

Hotpoint LFT228A on off light flashing and error code 3 showing. Water left inside dishwasher.


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

My DW60 Hotpoint stopped in the middle of wash. all panel lights flashing at the top left. water colected at the base. tried to restart with a fresh cycle. program selection successful. drained all the water. loaded fresh water. but giving grumpy noice and not the usual thrust start.


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Dishwasher Hotpoint LFT114 - The dishwasher does not finish it's cycle. Two of the settings lights flash when dishwasher has stopped.


... Hotpoint Dishwashers

LFT 114 FAULT TWO FLASHING LIGHTS - Hotpoint 24 in. DWF32P Free-standing Dishwasher


... Hotpoint 24 in. DWF32P Free-standing Dishwasher

My hotpoint dishwasher keeps going off it starts the cycle and you can hear water coming through but after about a minute or two it stops and the second and fourth lights flash all the time does anyone know why?


I am assuming you have tried the possibility it is the water inlet circuit which could be faulty.\015\012\015\012Check page 13 of the ... Hotpoint 23 in. BFI62 Built-in Dishwasher

Hi!, my Ariston L64 dishwasger refuses to start. It seems to reset OK when the dial is turned fully to the left. After the beeps I select a cycle and nothing happens for some time, then eventually the first two lights begin flashing together.That is as far as it goes. Can you help me fix this problem please? Donna


... Dishwashers

Two program lights flashing,machine stops - Hotpoint 23 in. BFI62 Built-in Dishwasher


Check that the door is closed all the way and that the door switch is not faulty. Also check drain, drain screen, and pump to make sure they are not clogged, leaky, or loose. ... Hotpoint 23 in. BFI62 Built-in Dishwasher

AFTER I TURN MY HOTPOINT BFV62B DISHWASHER ON AFTER ABOUT 1MIN IT STOPS AND THE GREEN LIGHT SECOND IN FROM THE LEFT STARTS TO FLASH.


... Hotpoint 23 in. BFV62 Built-in Dishwasher

Hotpoint bfi620 The dishwasher starts washing. A few minutes later it stops and two of the green leds start flashing (the second one and the fourth one from the left). It has not been washing properly for the past few weeks. It will not complete a cycle at all now. can anyone help with this problem or can it be repaired


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

My hotpoint BFV62 dishwasher wont complete a wash, the second light from the left flashes what does this fault code mean?


... Hotpoint 23 in. BFV62 Built-in Dishwasher

Hotpoint BTV62 left most light flashing, drain pump running all the time any idea Thanks


... Hotpoint 23 in. BFV62 Built-in Dishwasher

I have a hotpoint bc 1450 that is suddenly not fully emptying and i have two flashing green lights on the control panel


... Hotpoint 18 in. BCI45 Slim-Line Built-in Dishwasher

Good morning. I have a KitchenAid KUDM01TJ with a constantly flashing "Rinse" light. when I hit the "Cancel" button, it too flashes in the same time with the Rinse light. I left the machine alone, came back a few days later and saw that the issue had resolved itself - but I didn't use the machine. A few days later, the "Rinse" light was flashing again and naturally, I hit "Cancel" to see if the same thing happened and it did. This time the lamps are still flashing. I read through the other repo


No its not the problem of button secquence.its the problem of keypad circuit this is creating this problem.as the circuit is getting overheated and it stops working.the key pad sometimes functions and sometiomes doesnot.in this case the key pad circ ... Dishwashers

Whirlpool Quiet II (DU110XTPB1)... Two problems (maybe it's one)... Start/resume light flashing and won't stop. I have tried on the different button combinations from this website and other websites and none of them seem to make a difference. The flashing continues. That's problem number one. Problem number two is that it seems to go into some sort of washing cycle in completely random intervals. When it's in one of the random washing cycles the following lights are on; Normal Soak and scour


Hope it's under warranty, maybe logic board, poor motor design causes main PCB failure ... Dishwashers

When starting my Bauknecht GSFP 5586 dishwasher the program is set for rinsing and the start light flashes two blinks, then again two blink etc. I cannot get the program to change. When I hold the Start button for 2 seconds, the progress light flashes at END for a moment then reverts back to the double blink sequence. I have checked the filter and it is well seated and clean. What can I do to start the program selection again?


Ok, so I had the exact same problem with the exact same model. NOT 7 blinks and to buttons that you do not have.\012I will tell you what I did as I do not know what (if any) of what I did fixed it (it could be luck but I do not think so).\012 ... Dishwashers

Leak from a De Dietrich Integrated Dishwasher has caused 3 red lights on the left of the Control Panel to flash and also a Blue Light on the right hand side of the Control Panel to flash. On resetting the Appliance Controls, the machine starts pumping out and then closes down, with the Control Panel lights flashing again. Help


Pull the built in unit out and tilt towards the rear right leg and the water will drain on to the floor. The Dishwasher then restarts but the anti flood sensor will reactivate after 2-3 more washes. Do not know final fix yet. ... De Dietrich Dishwashers

Indesit D41 dishwasher to flashing lights on the left , not completing cycle


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1212 seconds