Having problems with your Hotpoint 18 in. DC28 Slim-Line Built-in Dishwasher ?

We have a diplomat adp8352 dishwasher, we have water in the sump

\015 This means it isnt starting.\015

Answers :

Repair Help & Product Troubleshooting for Hotpoint 18 in. DC28 Slim-Line Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

We have a diplomat adp8352 dishwasher, we have water in the sump


... Hotpoint 18 in. DC28 Slim-Line Built-in Dishwasher

Diplomat adp8352 my diplomat dishwasher adp8352 -no water getting into machine


... Dishwashers

I have a integral dishwasher (diplomat adp8352) which fills with water but the impeller at the bottom does not spin round or pumps water, it just makes a humming noise and shuts off after a while? any ideas?


Hello wayne180764,\015\012If the wash arm ( impeller ) is free to move, then chance are the motor that dirves it isbound up or defective. IT may be trying to spin ( the humming noise) but unable to ( for whatever reason).. and then shuts down f ... Dishwashers

How do i drain the water from my diplomat adp8352 slimline dishwasher ? ive took the front black small panel off but can only see electrics. Im hoping draining the water will get it working again . Its stopped working !


... Hotpoint 18 in. DC28 Slim-Line Built-in Dishwasher

Leaking FDW60 I have a Hotpoint FDW60 dishwasher. yesterday it tripped our house electrics and then we had water flooding out of the dishwasher. Through a process of elimination I have now discovered that water is leaking from the drainage sump in the centre of the babse down onto the motor or other electrics. I have looked for loose hoses and there are none visible from the base of the dishwasher, can you give some ideas where the water might be coming from?


Had a similar problem when I removed the lower spray arm for replacement (see http://www.fixya.com/support/t234402-fdw60_dishwasher ) and didn't put the centre retai ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

GE Dishwasher model PDW8200J03BB stopped draining. Removed the drain pump, checked with Voltmeter and there is resistance on ohms X10 of about 3. The flap is in place so water isn't shooting back into the sump inlet. Replaced the sump inlet about 6 months ago because it was deteriorated due to hard water. Pump worked fine after that. Checked drain hoses and air gap. Was able to blow water through. Pump only trickles water out at air gap. Does the pump need replaced?


Clear the line from the air gap to the drain,, if the rest is clear the only thing it can be is the propellers on the pump, i which case you will need to change the pump ... GE 25 in. Profile PDW8200J Built-in Dishwasher

ASKO 1885 Built-in Dishwasher: The water sump fills normally, but the wash cycle does not start. Althought the timer seems to work, the wash cycle motor won't start up in any wash or rinse selection. The spray arms do not spin - no water is being pumped. At the end of the wash cycle time, the water will empty out of the sump. Thank you. TB


Hi, Welcome to FixYa. Based on your description and provided the dishwasher is indeed 1) an Asko 1885 and 2) filling ... Asko 24 in. 1885 Built-in Dishwasher

Disposal plugged up and water backed up into dishwasher. Cleared disposal and dishwasher drain line. Checked around sump but dishwasher won't pump out. Sounds like pump is trying to run. I can blow air through the drain hose from the disposal and get bubbles in the water. Turned off breaker for 1 min. then tried reset. Can hear pump humming.


The pump is humming because its still trying to get all the water out of the unit. Deinstall the dishwasher and pull the entire dishwasher out from under your cabinet. Next step would be to disconnect the drain line from the drain pump and check to ... Dishwashers

Diplomat Dishwasher ADP8352 Will not complete wash Cycle


My Diplomat ADP8352 when running a cycle it will run for ages, doesn't seem to get hot. If i switch off the m/c then switch it on again it dumps the water left in the m/c?\015\012\015\012any ideas? ... Hotpoint 18 in. DC28 Slim-Line Built-in Dishwasher

Kenmore dishwasher Have a kenmore 655.15889020 dishwasher which does not appear to be pumping water fast enough. No apparent blockages. Arms circulate very slow. Enough water in sump. Could it be the motor for some reason is running slow? Or maybe some valve is not closing properly.


Fatubu, are you sure you have the correct model number, Im not finding anything on the posted model. They had an issue on models close to this that had an issue with a twisted or missing seal in the pump assy. causing water to fill the pressure swit ... Kenmore 24 in. 16032 Built-in Dishwasher

Dishwasher filling I have a Diplomat dishwasher. When it fills with water, only a certain amount flows through into the machine and the water backs up and floods the kitchen


Check to see if you have anything plugged ... Dishwashers

Our GE Spacemaker 1860NSS Dishwasher leave water in the sump area


... General Electric Spacemaker® GSM1800N Built-in Dishwasher

Bosch Classixx dishwasher: Initially no water feed and 'water check' light came on. Removed side panel, emptied water from base. Ran OK for a week or so. The problem then repeated so side panel removed, float switch operation checked (OK) drained water from sump below polystyrene float. Ran OK but contents came out dirty and cold - no heat. Side panels off again, water in base but no obvious leak when watched during cycle - still no heat. Help please.


Http://www.repairclinic.com/Dishwasher-Repair-Help\015\012\015\012\015\012\015\012 ... Dishwashers

Whirlpool dishwasher: Model DU920PWKT0; 8 years old Lately, have noticed not full drainage of water at end of cycle... about 1 inch standing (thus 2 inches at the sump). Glasses have had noticeable film on them. Ran the rinse cycle a number of times to explore problem. When I interrupted the cycle, the water on the bottom was soapy, yet no new soap had been introduced. I even colored the water "left" in the tub to see if it was replaced by fresher water. Although it was going through t


Find the 'tech sheet' behind the front 'kick plate' of the machine. This doc will give you a troubleshooting procedure for that specific machine. Check drain line and make sure it's clear and not kinked. Is filter clean?Has machine ... Dishwashers

I have a Bosch Exxcel dishwasher which runs the drain pump constantly even with the door open and despite there being now water in the machine at the cycle wont start. I have checked the warer amtrix and the ffed hose to the sump for blockages. The float switch operates OK but when the water drains down the float drops and the water is pumped in, then the float rises and water leaks out and the drain pump kicks in again and no more ater will come in unless you push the float down. Inside the bas


I am not sure about this model but most models run a drain cycle for a set period at the start of a wash cycle and then move on to normal filling and cycle of machine provided the various switches are at the low level it will carry on to its set cycl ... Bosch 24 in. SGS47E02 Exxcel Free-standing Dishwasher

Gaggenau GM 915-710 UC6 dishwasher will not fill and wash. Close the door, turn lever. Empties water from sump. (drain hose was not clamped above disposal outlet nipple, fixed that) Machine empties sump, but will not stop after sump is dry. Will not initiate fill and wash. Manually stop machine. Can't get control board to do the diagnostic to get an F #. Pressing button 1 and 3 at the same time. A couple of the plastic tabs on the circuit boards plastic support housing that link the


... Gaggenau GI936-760 Dishwasher

I have an LG dishwasher, model LDS 5811ww. The machine fills with water, then stops filling when the error code IE comes on. I have cleaned the inlet filter and the whole inside of the tub, by taking apart the sump filter. There is good water pressure filling the tank. When I turn off the power and restart any cycle, the pump will empty the tank, then begin filling the tank again...until it is stopped by the error code IE again coming on. The other thing I notice is the water level in the tub.


Sounds like you either have a dirty or faulty water level sensor or water temp sensor. Most likely a dirty or faulty water level sensor ... Dishwashers

I have a Diplomat ADP 8242 dishwasher. When i select program dishwasher starts working but then beeps when opened no water has been brought into dishwater and program light 2 & 3 flashing 5 solid. Have tried reset and works like instructions states. But when I have re-tried dishwasher same fault happends again. Any help


... Dishwashers

When I hit the start button on my dishwasher nothing happens. It still "finishes" the cycle but nothing ever cuts on. It doesnt fill with water and the sump pump never engages to drain the water that's not there. Any ideas? I know the inlet water pump works, I've detached it and connected it with a pigtail to an outlet.


Replace the main control board ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Getting error code 1E I've replaced the sump pump, cleaned the screen at the water inlet, checked water flow from the hose. Continue to get the 1E once water has entered dishwasher and begins the wash cycle.


... LG 24 in. LDS 5811 Built-in Dishwasher

Diplomat adp 8520 dishwasher no hot water


Two things to check\015\012check continuity thru heater\015\012remove outer door panel and check for faults in wiring loom\015\012get back to me is these are both ok ... Dishwashers

IDL40 dishwasher, sump slowly fills up with water during it's inactivity period


... Dishwashers

Indesit dishwasher sump keeps filling up with water when turned on


I had a similar problem every time i bailed the sump out by hand and turned the machine back on it would fill the sump or just shut off.\015\012\015\012Having spent ages checking various site it boiled down to one of three things there is ... Indesit 24 in. D61 Free-standing Dishwasher

Diplomat dishwasher ADP8322 water not emptying


... Dishwashers

Diplomat ADP8352 Integrated Dishwasher


I have the same issue how did you fix it? ... Hotpoint 18 in. DC28 Slim-Line Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1959 seconds