Having problems with your Hotpoint 18 in. DC28 Slim-Line Built-in Dishwasher ?

WATER / SALT TANK

\015 NEED A NEW ONE AS OLD ONE IS LEACKING\015

Answers :

Repair Help & Product Troubleshooting for Hotpoint 18 in. DC28 Slim-Line Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Waterside water softener model MC250 Dear Sir, Salt level did not go down during regeneration. I poured 2 pints of warm water to break solidified tablet salt, I found moist salt, but very little water in salt tank. I regenerated. I hear water going down the drain. Please could you tell me which pipe brings water in the salt tank, and what level of water should be visible, How is the water replenished in the salt tank? and how that level is maintained. Would you be kind enough to give me a wate


... Dishwashers

I have a ge water softening system Model # gxsf27e01. It seems to run through the cycle but the water doesn't become soft. I have checked for a Salt bridge and cleaned out the Nozzle and Venturi assembly. Still no help. The water seems to be building up more and more in the salt holding tank. thanks greg e01


... House Brand Aqua-Pure AP102T Whole House Water Filter System

Pump is constantly running - trying to pump out water, although there is no water in the tank. This condition remains the same AT EITHER AND ANY reset positions of buttons ABC or programme buttons. Programme END indicator is NOT lit, LOW SALT indicator lamp is ON, LOW RINSE-AID indicator lamp is ON. No apparent blockages. Supply water water is on and free flow.


Hello, welcome to FixYa.\015\012\015\012Based on your description it sounds like the emergency overfill switch has been actuated.\015\012\015\012Here`s what to do and what to look for. ( unbeknownst to many this is built by B/ ... Neff 24 in. S5543X2 Built-in Dishwasher

Monarch midi meter water softener salt tank is filling up


... Dishwashers

Monarch midi meter water softener salt tank is filling up


... Dishwashers

My softener salt tank fills with water


... GE 30000 Grain Water Softener GXSF30H

The tank where the salt goes should that be filled with water, never used a dishwasher before


Yes it should. Mine is always full of water when I fill it with salt. If there is no water how can the salt dissolve? ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

THE anti flood device has been activated. I have emptied the salt tank, how do I reset the safety valve on the water inlet hose?


Dishwasher is Electrolux ESL64010. How do I reset the anti-flood since the error beeps 3 times. ... Dishwashers

Dishwasher salt tank full of water - Dishwashers


... Dishwashers

Miele 646 sc plus inlet tank solonoid valve on water tank leaking. We moved the machine from one room to another and now this valve is squirting out water. We replaced both door seals thinking that was the problem, then started the machine with a side pannel removed, and saw the jet of water coming from the solonoid valve on the water inlet tank. Any ideas.


... Miele Dishwashers

Hi. Just bought a Blomberg dishwasher & have a question about the water softening feature. What is the appropriate type of salt? The manual says no table salt, no coarst salt. It recommends a highly soluble type salt, fine-grained or powdered. What kind of salt is this? (And, why wouldn't water softening salt pellets work?)


You will find the correct type of salt on the same isle as the detergent in the supermarket.\012\012Regards\012\012Ian ... Dishwashers

Water softener Salt residue remains on the dishes. The water softener is going throught salt like crazy. I fill the salt and make sure that the light is off before I start the cylce. Within the first 20-45 mins the salt light comes on again and the dishes will not wash properly. We have come to the conclusion that the salt is being distributed to quicky but cannot figure out why the light keeps coming on. The switch inside the cap for the salt is set a the min.


Just a thought, I hope the lady did not use table salt :-) ... Danby 17 in. DDW1802W Designer Series Built-in Dishwasher

I have an LG dishwasher, model LDS 5811ww. The machine fills with water, then stops filling when the error code IE comes on. I have cleaned the inlet filter and the whole inside of the tub, by taking apart the sump filter. There is good water pressure filling the tank. When I turn off the power and restart any cycle, the pump will empty the tank, then begin filling the tank again...until it is stopped by the error code IE again coming on. The other thing I notice is the water level in the tub.


Sounds like you either have a dirty or faulty water level sensor or water temp sensor. Most likely a dirty or faulty water level sensor ... Dishwashers

The salt warning light came on (red) and went to put salt in but noticed it was filled with water. I have filled it with salt now and the warning light has gone off but now when I try to select a program it wont. I have drained the water in the salt dispenser but it still wont work! Help!


What is the make and model of the item? ... Dishwashers

Bosch slimline dishwasher SRS560. Unit has had this fault for a while, now going a bit mouldy so keen to repair it. Displays following Symptoms 1) Firstly empty motor drains water. This appears to be fine as I can hear the gurgling of the plug. 2) Then takes water from inlet to fill internal tank. I can hear the water entering the tank, and tap pressure indicates that water is being taken in. 3) The unit then sits there and does nothing for 25 mins until programme ends. I've


... Dishwashers

My karcher 4.0/32 Pe Cage cannot take gravity fed water. Can I bypass the float tank assembly? Would there be any reprecussions relating to the line going back to the burner? How can I solve the problem without disconnecting the float tank or raising the water tank to a point beyond the centre of garvity for ther cube van I have it in?


... Karcher Hose Reel

MY GE WATER SOFTENER QUIT WORKING PROPERLY AFTER 6 MONTHS ,I HAVE HAD SERVICE CALLS AT $150 EACH TO NO AVAIL IT DRAWS SALT BRINE MY WATER HARDNESS IS 17 I HAVE SOFTENER SET TO 22 .I HAVE PRE WATER FILTERS HAVE TRIED DIFFERENT SALTS ALL TO NO AVAIL, NEITHER GE OR HOME DEPOT WANT TO HELP AS NOW I AM OUT OF WARRANTY I HAVE BEEN ILL AND IN THE HOSPITAL (CANCER) THAT'S WHY I HAVE GONE OUT OF THE WARRANTY TIME MODEL GXSF30H PURCHASED 19/02/10


As you have purchased GE water softener and stop working after 6 months,then you need to check it from an expert technician and if he is able to solve this issue,then it good and well, but if this takes more money to repair and not under warranty the ... GE 30000 Grain Water Softener GXSF30H

We have an Rangemaster RDW459F1 integrated dishwasher and there is a strong taste of salt on everything.We indroduced 2 kg of salt into the dispenser after first filling with water as instructed. We live in a hard water area but even so I turned the arrow more to the - side, but it has not made any difference. It did seem alot of salt to put but it was first time being used. Can you help me please? Jackie


Stop using the tablets. they don't work in hard water areas. I think what you are dealing with is hard water deposits. Use "Lemi shine" for your main wash and the packets for your pre-wash. No one has harder water than where i live... Lemi shine work ... Dishwashers

Whirlpool ADP4502 - lights on but no water running - recurrent falshing red light indicating salt low but insoft water area so never used salt before


... Dishwashers

My dishwasher salt container is filled with water, what should i do to get the water out so I can fill up my salt? and does it mean my machine is broken?


... Bosch Dishwashers

Tablet salt I have a water softener installed - can I use the same water softener salt tablets in my dishwasher?


No, you can't do experiments without prior consultation with a technician cause that will hurt your water softener and you can even lose it from working normally. ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Miele g892 scu plus, about 5 years old. when on, all it does is run some motor (humming sound) and flash salt or intake/drain. No program lights on. Sometimes can be reset so rinse light comes on and nothing blinks, but humming motor still runs and salt eventually blinks. I removed toekick panel; there is water in pan. I disconnect drain hose, only a little water came out. Any ideas?


... Miele G892SC SS Dishwasher

Re: Creaftsman 2700 psi washer, model 580.752100 - I cannot use the detergent cleaning tank. The pump forces water into the tank, and it overflows onto the ground. If I try using the washer with the detergent shut-off value in the off position, the water pressue forces the valve completely out of the housing. Is there a simply fix for this or time for a $ervice call? sw


... Craftsman 2700 Max Psi Pressure Washer 23 Max Gpm

I have an Asko 1606 dishwasher. I had a new hot water tank installed in my house, it seems that with the water being turned back on that the black hose from the outlet side of the solenoid has come adrift (not from the solenoid but the other end), it seems that it has to be reconnected to an opaque coloured tank on the side of the machine, is that correct? re Wayne


Yes. ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0754 seconds