Having problems with your Hotpoint 23 in. BFI62 Built-in Dishwasher ?

Will not let me select a program even though there is powre to the dishwasher


Answers :

Try this
\015\012
\015\012Unplugged the electrical cord for 10 mts. plug it back on.
\015\012
\015\012Hope this solve your problem.
\015\012
\015\012Was this helpful?
Repair Help & Product Troubleshooting for Hotpoint 23 in. BFI62 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Will not let me select a program even though there is powre to the dishwasher


Try this \015\012\015\012Unplugged the electrical cord for 10 mts. plug it back on.\015\012\015\012Hope this solve your problem.\015\012\015\012Was this helpful? ... Hotpoint 23 in. BFI62 Built-in Dishwasher

Dishwasher - Bosche - SHV43A03GB - When the main power switch is ON, even with the door open the pump/motor continues to run (ie. Stop-cycle does not operate). However, the wash-program itself does not run, even with the door closed (ie. No water entering the dishwasher, even though water supply is on and feed lines are clear - not kinked). It is like the program is 'stuck' and I cannot seem to get it to reset.


Your door switch is likely faulty and should be replaced. You can get them at partselect.com ... Dishwashers

I have a 2 yr old LG dishwasher model LD-1204M1. We have noticed that the dryer function is stuck on permanently even before we have selected a program and during a program. After a cycle finished the dishwasher would not turn on until sometime later. Any advice or ideas what could be wrong? Thanks


... LG Dishwashers

Dishwasher want let me select a program,but is still beeping.led lights on program selection not lighting up.


Would be helpful if you can post a comment to mention the make and model no. of the dishwasher.\015\012\015\012Have you tried to turn the power off and on at the mains switch? ... Dishwashers

Electicity going to dishwasher but when program dial turned it doesnt start program even though its switched on and door closed


Small amount of water at bottom of dishwasher, electricity is going to the unit no breakers are blown, no light nothing responding on dishwasher ... Kenmore 16872 Built-in Dishwasher

We have had a problem with our dishwasher since "winterizing" it to close the cottage for the winter. We were told to run it for a few minutes with antifreeze in it and then turn off and let it overwinter with the antifreeze in it. Now the machine leaves everything coated with a white film, even though we have a water softener and use jetdry. How can we fix this and is this the proper way to winterize our dishwasher if we close down our cottage and turn off the heat for the winter?


... Miele 24 in. Novotronic G851SC Plus Built-In Dishwasher

We have a candy integrated CDI 1012 dishwasher. After a program has been selected and the door closed. washer sounds as if it will work , but does not sound as though much water going in.The very quickly empties, then a peeping noise sounds. On opening the door the pots are dry , very little water inside, LED light flashing.


... Dishwashers

I have an electrolux esl4115 dishwasher when i turn on 70 degree light stays on and will not let me select any other wash however when door is closed it does not even do 70 degree wash


... Electrolux Dishwashers

I have a KDS-18 dishwasher, and had been working fine until recently. Now it keeps going into a Sani cycle even though I have selected normal wash. Anyway to reset the unit?


In your onwer mannual there is a number call kitchen aid they will walk you through the steps to reset your unit ... KitchenAid 24 in. KUDU02FR Built-in Dishwasher

My dishwasher (kleenmaid brandt super silent DW121TB) appears stuck in a wash cycle; how do I reset the program? I have read the instruction book to no available, tried unplugging power overnight, tried a combination of simultaneously holding buttons in and switching on, letting the machine run all night, drained the water and added clean unsudded water, and none have corrected the situation. There is also a selection lever inside the machine that is not identified in the instructions, it appea


When you say it is stuck in a wash cycle, do you mean the wash arms are continuously running?\015\012Is there water in the base when you open the door?\015\012\015\012Can you try to run the dishwasher in any other program like rinse ... Dishwashers

The program control on my flavel fdw60 dishwasher has all the programs showing up as selected and will not advance onto one single program


... Dishwashers

Why would a dishwasher filter split/break in a meile dishwasher that is not even 3 years old. i have been told that it is not under warranty and that i have to pay the $580 bill even though i feel that it must have been the dishwasher as the maintenance man said that it would have been nothing that i have done. i have had other less expensive dishwashers that lasted a long time. i am going to write to meile and see what they say. what do you think? should i persue this as i feel it was a


At v3 years old, you have no case. you may have dropped something heavy on it ... Dishwashers

I have a Diplomat ADP 8242 dishwasher. When i select program dishwasher starts working but then beeps when opened no water has been brought into dishwater and program light 2 & 3 flashing 5 solid. Have tried reset and works like instructions states. But when I have re-tried dishwasher same fault happends again. Any help


... Dishwashers

AEG Favorit 80820 dishwasher tablet door opens as soon as switched on and door closed. When you put the power on and select a wash and then close the door the small grey dishwasher tablet inside the door can be heard to open as soon as the door is closed. Normally this door remains closed until asked to opened automatically by the dishwasher at the correct point in the selected wash program.


... AEG 24 in. Favorit 80820 Free-standing Dishwasher

Control Panel won't let me hit the start button. The dishwasher is a little over a year old and is used at most once a week. The blue light on the bottom right of the dishwasher seems to no longer light up. The control panel will let me select the wash, but the start button and time indicator does not light up. Not sure if this a real defect and if just a simple exchange of the front control panel will fix the problem? Already tried resetting the circuit breaker and that did not help. Than


... Dacor Epicure ED24 Stainless Steel Builtin Dishwasher

Delonghi trend dishwasher you select programme and it starts and you hear the pump start and expell water and then u hear water going into machine for 10 seconds or so then it stops then programme selected light starts flashing and the dishwasher starts to heat as though it is in the drying part of the cycle


Please provide the full model number of the dishwasher.\015\012\015\012have you tried to turn the power to dishwasher off and back on.\015\012\015\012What program do you start with? Have you tried the rinse only cycle? does it ... Dishwashers

Smeg Dishwasher Hello I have a smeg dishwasher - built in, push button. It has stopped working - the program start and you hear it drain but that's as far as it gets, no water appears to be getting in. A couple of times the last 2 program buttons flash or the rinse light is on when we open it. let me know if you have any thoughts on this - I'd really appreciate it. thanks Diane


Replace the timer/control board ... Dishwashers

2000 G 879 SCVi Miele Dishwasher: Problem: When I turn the dishwasher to on, then select wash program, all the program lights start flashing until I push the "off" button


... Dishwashers

Looks like program in electronic dishwasher has locked into a cycle. the machine will not drain even after resetting it. Also it will not restart any program or cycle after resetting and recycling power. The machine is a classic electronic bosch dishwasher It has worked perfectly for three months


Im a old bosch tech . the problem is the module or the drain pump is stuck. if this helps please give me a 4 thumbs up post thanks. ... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

Even though I turned up the thermostat on my hot water heater, the water in the dishwasher does not seem to be hot enough. Mold is growing in the food grinder and even though I choose the heat dry option, the dishes are never dry. Yet, when I touched the element, I got burned. The dishes are not getting clean because it doesn't seem to be hot enough to cut the grease.


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

When dishwasher is turned on to the cycle mode - it fills with water - heater heats water to the proper temp - pump starts - washer goes through it's complete cycle - even pumping out the wash water and the drying cycle,then shuts down. the problem is that it does not circulate the wash water thru. the spray heads-even though the circ,pump is running.Even though the unit is 8 yrs.old and hasn't run for 6 yrs,my wife&i do our dishes by hand. our unit is a GU1200XTKB0 Serial# FL4617501


The impeller on the wash pump is worn out or the disposer screen is obstructed. Disassemble as needed to investigate the cause. ... Whirlpool 24 in. GU1200XT Built-in Dishwasher

Dishwasher kdw60x10 cant select programe 1 only programe 4


... Dishwashers

No water my kenmore dishwasher is not getting any water. when we try to select normal wash or water miser cycle, the motor turns on, I can tell water is getting to the dishwasher because i can hear it running under the sink and feel it in the flexpipe that feeds the dishwasher. It is not getting anything inside though. Just wondering if you have any ideas. Thanks


SOUND LIKE YOU HAVE EITHER A FLOAT THAT IS STINKING OR A WATER INLET VAVLE THAT HAS FAILED. THE FOAT IS THE LITTLE MUSHROOM LIKE DOME WHICH IS PLACED AT THE FRONT LEFT SIDE UNDERNEATH THE BOTTOM RACK PULL UP GENTLY ON THE FLOAT UNTIL U HEAR A CLICK ... Kenmore 24 in. 15252 / 15254 / 15259 Built-in Dishwasher

Used some washing up liquid instead of dishwasher tablets, after i got rid of all the bubbles and drained it, it no longer starts. If i switch the power off and leave it for a few minutes i can select a prgram it starts and a few seconds later there is a beep and the solid green run light on the program selectoe is flashing over the left hand program button. At this stage pushing any program button does nothing, i have to swith the power off and wait 5 miniutes and the the above patten is repeat


Dear sir vif you have used liquid soap in your dishwasher it will make mountains of bubles to kill all bubles outin a hurry take a sos pad put it in your machine and run the dishwaser this will remove all of the soao instantly try it it really works ... Ariston Technologies Dishwashers

My Frigidaire dishwasher keeps showing the Er uo codo on the display. It used to would finish a load even though it would stop for a while when the error message came up, but now it will not run at all when the error message comes up. I read on this site that the Er uo has to do with the vent. I pulled the dishwasher out and removed the vent. I turned the dishwasher on and the vent opened and closed about three times when the cycle started, then it stopped and the error message came up. Is


Hi. This code is in reference to the vent assembly. This may also be a control fault, as well. To isolate the culprit, you will need to make sure that the vent assembly is not blocked. If it is blocked, it must be replaced. Restricted air flow will c ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2242 seconds