Having problems with your Hotpoint 23 in. BFI62 Built-in Dishwasher ?

My hotpoint dishwasher keeps going off it starts the cycle and you can hear water coming through but after about a minute or two it stops and the second and fourth lights flash all the time does anyone know why?


Answers :

I am assuming you have tried the possibility it is the water inlet circuit which could be faulty.
\015\012
\015\012Check page 13 of the user manual.
\015\012
\015\012If it is 2nd and 4th light (daily and soak) then people have found the problem is heater related. Try the Soak cycle to see if any difference. This cycle does not use heater.
\015\012
\015\012Do you have hard water in your area. If there is scaling on the heater then pour normal water with white vinegar 2-3 table spoons in the dishwasher bottom to cover the heater overnight. Run soak cycle to empty dishwasher.
\015\012
\015\012Not sure if any of this helps. Post a comment to confirm.
Repair Help & Product Troubleshooting for Hotpoint 23 in. BFI62 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My hotpoint dishwasher keeps going off it starts the cycle and you can hear water coming through but after about a minute or two it stops and the second and fourth lights flash all the time does anyone know why?


I am assuming you have tried the possibility it is the water inlet circuit which could be faulty.\015\012\015\012Check page 13 of the ... Hotpoint 23 in. BFI62 Built-in Dishwasher

Hi I have an F&P DW691 dishwasher (manufactured by whirlpool) the reser light is permanently giving two quick sucessive flashes and will not start the machine unless held on for 6 seconds, the machine then starts for a minute then stops and goes back to the two flash reset problem. Does any one know the fault code applications for this model.thanks Mike


Hi, I've got the same dishwasher but with a different fault, there's power down the cable to the d/w but no power lights on the front panel?Thanks. ... Fisher and Paykel Dishwashers

Hotpoint bfi620 The dishwasher starts washing. A few minutes later it stops and two of the green leds start flashing (the second one and the fourth one from the left). It has not been washing properly for the past few weeks. It will not complete a cycle at all now. can anyone help with this problem or can it be repaired


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Matsui dishwasher Matsui MS452S slimline - second wash light flashing and unit doesn't fill. Tilting it backwards allows water to leak out from the left rear corner then it runs correctly for minute or two before numerous beeps sound and unit cuts out with light flashing again. How do I get into the base to see if there are any leaks? Unit less than 2 yrs old.


... Dishwashers

My Dishlex global 300's rinse light is flashing after 5 mins use. About 2 inches of water stays at the bottom of the washer. Bought this second hand and it has not been used for a few months. Do I need to fill the reservoir under the washer or lean it at 45 degrees to dislodge anything in the sump. If you have had the problem of the washer starting its program and then stopping after 5 minutes and the rinse light flashing I would appreciate your advice. Cheers Hyph


The flashing rinse light is an error code. I am assuming that your control board is good because the lights are working. I'm also assuming that this model has two pumps. One for filling and one for draining. The rinse light flashing is probably i ... Dishwashers

I have a built in d1fo4 dishwasher when i put it on it goes for a while then stops with 2 lights flashing, the second and fourth light


... Indesit Dishwashers

Miele Optima G 2430 - The dishwasher will pump water in for 5 seconds with the Intake/Drain light flashing 5 times. Then the light stays on for 5 seconds and it does nothing. This process is repeated for about 10 minutes untill the washer is filled to the just below the door with water. Then the washer starts running for about 1 1/2 minutes and drains the water. Then it all starts over. If I let it do this for a hour - The display reads F12 with the Intake/Drain light flashing.


Hi\015\012\015\012The first thing that should be checked is if its draining\015\012properly as it could be that the drain hose is clogged and needs to be cleaned.\015\012The drain pump also should not be clogged. ... Miele 23 in. Novotronic G841 Built-In Dishwasher

I have a DU1100XTP83 dishwasher and does not run. The clean light flashes 7 times, stops for about a second and then blinks 7 times, etc... Before all this started to happen, and I don't know if it was related, there was an odd odor I couldn't identify in the kitchen.


... Whirlpool Dishwashers

I have whirlpool Dish washer model GU 120 ES (bought in 2001). When we start the dish washer cycle the unit starts for a minute, then the "start indicator" light flashes. As indicated in the instructions, we press the "start button" for five (5) seconds, at this time the washer clears the water out and stops. If you can assist this would be greatly appreciated. Thanks Jeff


I called the service tech.... ... Whirlpool Dishwashers

Maytag mdb6601aww push normal wash button-- nothing happens. push other wash cycles, the lights flash about 30 times then stop-- then nothing happens. tried clearing codes. hi temp wash then heated dry , hi temp wash then heated dry. same problem. also tried normal wash then heated dry 3 times in 6 seconds--- same thing. also tried unplugging unit waiting 10 minutes with no luck. thanks


... Maytag 24 in. MDB6100A Built-in Dishwasher

Dishwasher starts for a couple off seconds and the stops with top two lights flashing


Your latch mechanism is out of adjustment if you lift bottom of door and press on handle with other hand it will remedy until you can adjust latch ... Tricity Bendix Dishwashers

Amana e71195 Five minutes into operation, stopped, all lights flashed, it started again for 5 seconds then turned off for good. Checked and flipped all breakers, no change. What next?


... Dishwashers

When you turn it on , water starts, after a minute or two it stops and lights starts flashing. Then there is a clicking noise.


It appears your timer/main controller/CCU has failed in this instance.For replacement parts - head on over to PartSelect.com or RepairClinic.com and enter in your full model number for a full parts listing.I recommend both sites bec ... Whirlpool Dishwashers

Baumatic (BKD62SS or BKD62W .3) Dishwasher will not do a normal load but will run in a strange start up mode I found. When I press the power button, select a cycle, then press start the dishwasher will no longer do anything. 5 seconds after pressing start it will make a light hum noise, a little like heating water. After about a minute the dishwasher won't have done anything. It will then beep 30 times with the third led on the set of four (don't know what it means) will flash a lot. The beeps t


... Dishwashers

I have a Zanussi DE6850 free-standing dishwasher. Have just put on a 65 degree programme. After approximately 1 minute the machine has stopped functioning and the top two lights are flashing and water remains in bottom of machine. There's also a bad dirty water smell from machine now


Hello,\015\012You seem to have a blockage,have you checked the filters lately.Also check the drain hose and the pipe that the drain hose goes into,if they are clear then the blockage is down in the bottom of the dishwasher in the pipes or the d ... Zanussi 24 in. DE6850 Free-standing Dishwasher

I have LG-12AW2 Dishwasher, it starts for 20 seconds and it stops and the light flashing and for about 10 minute later it gives a code IE what that mean and how to fix it


Hi\015\012\015\012The code IE means its a Water inlet trouble. You need to check clogging of water inlet hose (or hose twist or freezing) and also check water supply. If there is clogging you need to clean it so that the issue is resolved ... LG 24 in. LD-12BS6 Stainless Steel Free-standing Dishwasher

Dishwasher: Kenmore ultra wash sensor quiet guard plus. I'm in a rental so I don't have the manual or model number. A few days ago it just wouldn't start the wash cycle. When you press normal wash then start the no heat dry and lock lights flash every other second or so but nothing happens. I can hit the cancel button and it will make sounds like its trying to drain, and after about 5 minutes stops. I've done the heated wash/ no heat dry sequence to try to reset but no luck. Also tried turn


... Kenmore Dishwashers

Dishwasher starts to work but after 30 seconds stops and two lights start flashing on pannel


Ok so your dishwasher won't do anything... it justs sits there and "Hums" you can't make it respond to any controls, and the ONLY way to Stop it. is to unplug the unit, replugging back in it simply "Hums" again and will do nothing.Now this happ ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Whirlpool ADG957 Fault Code: first and third lights on and fourth light flashing along with start button light flashing. I know this is a fault code but don't know what it means.


... Whirlpool Dishwashers

Kitchenaid kudc03fvss0 dishwasher stopped mid cycle without drying dishes last week and then stopped altogether with lights flashing and full basin. I disassembled filter/pump cover in bottom and cleared several plastic pieces and cleaned chopping blade and screen. After unplugging/plugging and pressing cancel button the pump runs for about 10 seconds and stops with normal and heavy duty lights flashing. What should I check next?


... Dishwashers

I have a Whirlpool ADF951, it has power to it and was working fine, the power light is on and the green light to the far right of the cycle lights is flashing, I can only get any response if I hold the start button in for about 10-15 seconds, The machine stops the light flashing and makes the noise like it is starting , that goes for about 20 secs then returns to the flashing light stage, any idea's please


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If the light flashes, pauses, and then repeats. When\015\012the dishwasher doesn't sense a water tempera ... Dishwashers

Whirlpool Quiet II (DU110XTPB1)... Two problems (maybe it's one)... Start/resume light flashing and won't stop. I have tried on the different button combinations from this website and other websites and none of them seem to make a difference. The flashing continues. That's problem number one. Problem number two is that it seems to go into some sort of washing cycle in completely random intervals. When it's in one of the random washing cycles the following lights are on; Normal Soak and scour


Hope it's under warranty, maybe logic board, poor motor design causes main PCB failure ... Dishwashers

Runs for a few minutes then stops and the program and top right light flash, if i press the power button off then on it runs again for a while then stops again with the flashing lights.


The electronic portion of the dishwasher is going bad. Could be a resister or any other issue..I would check with the manufacture Tech support they will advise you what your options are. ... Zanussi Dishwashers

The machine will run for a couple seconds and then it stops and the lights on the front flash. If you push on the middle it will go awhile longer and then stop and the lights flash again.


... Asko D3122XLW / D3122XLB Dishwasher

When starting my Bauknecht GSFP 5586 dishwasher the program is set for rinsing and the start light flashes two blinks, then again two blink etc. I cannot get the program to change. When I hold the Start button for 2 seconds, the progress light flashes at END for a moment then reverts back to the double blink sequence. I have checked the filter and it is well seated and clean. What can I do to start the program selection again?


Ok, so I had the exact same problem with the exact same model. NOT 7 blinks and to buttons that you do not have.\012I will tell you what I did as I do not know what (if any) of what I did fixed it (it could be luck but I do not think so).\012 ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1012 seconds