Having problems with your Hotpoint 24 in. FDW60 Free-standing Dishwasher ?

Hotpoint dishwasher Aquarius FDW60 - stops during cycle and delicate light flashes - can it be repaired? What is the fault.


Answers :

Switch the machine off and unplug at the mains. Leave for ten minutes, then plug in and switch on. My dishwasher control panel had a mind of its own and did what it wanted including leaving water in the bottom of the machine. The electrics sometimes need re-booting! Hotpoint suggested the solution and it worked for me. Saved me £99 call out charge. Good luck.
Repair Help & Product Troubleshooting for Hotpoint 24 in. FDW60 Free-standing Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hotpoint dishwasher Aquarius FDW60 - stops during cycle and delicate light flashes - can it be repaired? What is the fault.


Switch the machine off and unplug at the mains. Leave for ten minutes, then plug in and switch on. My dishwasher control panel had a mind of its own and did what it wanted including leaving water in the bottom of the machine. The electrics sometim ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

FDW60 Fault Hi, I have exactly the same problem. My dishwasher starts and washes ok but appears to get very hot during the drying phase and then the two lights fast and eco flash warning of a heater problem. I suspect either the heater, thermostat or control PCB. As the rest of the cycle seems of and the water gets hot then I'm assuming the heater and thermostat are OK. When the dishwasher attempts to dry is when the problem starts. Did anyone find out what there fault was? Thanks


Hold down the start key and you will re- set the D/W. Please Rate This !!! Thank YOU !!! ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Dishwasher Fault Hi, My dishwasher is a Diplomat ADP8322 (which i think is a rebadged whirlpool unit) & has been playing up recently. When you start a cycle it is fine for a minute or so then it starts beeping, the rinse light comes on & the light next to the start button flashes 11 times, pauses then repeats. I have read online that this flashing relates to what the fault is, but i cannot find out what fault the 11 flashes relate to. The first time this happened i cleaned out all of the filters


... Dishwashers

I have a Kenmore Elite dishwasher (model 665.1315), and the dishwasher will run through the wash cycle as expected, but when it gets to the heated dry cycle , it doesn't appear to dry. It will then flash a fault code 81 (8 short flashes of the 'clean' light, pause, and then 1 more short flash of the 'clean' light, longer pause, and repeat the code). The dishes seem to be somewhat dry, but there is certainly water on the dishes and on the tub (there is never any water standing in the tub, and t


Hi,Check your heating element.. \012A bad heating element causes many problems in dishwashers...Dishwasher Problems The ... Kenmore 24 in. 15932 Built-in Dishwasher

My SHE4402UC/36 dishwasher malfunctioned all the lights were flashing and the machine was trying to drain. The guy came out and replace the control board. The dishwasher now read 199 on all cycles except the rinse and hold, the santitized light does not come when its done. The repair guy told me the count down timers were flakey on the the Bosch dishwashers and it would learn my dishwashing patterns in time. So 6 cycles later the dishes are still damp at the end of the cycle-the length of the cy


Well its not baloney but it is cheesey. normally changing the module is the cure but it has to be programmed correctly. bosch has a recall so check it out and see because the recall is free and the tech is suppose to know how to program it. go to the ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

New hotpoint aquarius fdl570 dishwasher - fault coming up with the Salt Rinse Aid Washing and Drying lights on and flashing at the end of the cycle.


... Dishwashers

Hotpoint Aquarius dishwasher FDW60; not washing properly, washing cold; items wet and slightly slimy. Delicates light flashing when machine stops.


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

FDW60 Fast and Delicate Lights Flash


This is a bad control board that if replaced will only repeat in a short time .My advice is to contact the manufacturer and complain,you have the right as a consumer to do so. ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Aquarius FDW60 fast 40, delicate 50 flashing


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

I have Whirlpool Quiet Partner III dishwasher, Model number GU2400XTPS3, Serial number FS1820245. I recently had the thermal fuse replaced by an authorized service repair person. My problem is that the dishwasher stops mid-cycle. I noticed that when I try to clean it in the normal cycle, the dishwasher stops with about 46 or 47 minutes remaining, and the green light flashes continuously. I have pressed the Normal and Heated Dry buttons, as well as the Sani Dry and HEated dry buttons to res


... Whirlpool 24 in. ADG7540 Built-in Dishwasher

I have Whirlpool Quiet Partner III dishwasher, Model number GU2400XTPS3, Serial number FS1820245. I recently had the thermal fuse replaced by an authorized service repair person. My problem is that the dishwasher stops mid-cycle. I noticed that when I try to clean it in the normal cycle, the dishwasher stops with about 46 or 47 minutes remaining, and the green light flashes continuously. I have pressed the Normal and Heated Dry buttons, as well as the Sani Dry and HEated dry buttons to reset the


... Whirlpool GU2400XTP Built-in Dishwasher

I am having problems getting dishwasher to restart after I interrupted a cycle. I have done the cancel cycle pressing Normal and Delicate together. The dishwasher emptied then showed a PF signal. Now is it showing a LE signal and all Front display lights are flashing.


You should be able to reset it by tripping the breaker and waiting about 10 minutes. Then reset the breaker. Best regards, --W/D-- ... LG LDF8812 Stainless Steel Built-in Dishwasher

I have a'05 Kenmore Elite dishwasher. Never had a problem before. The clean button keeps flashing. Thought it was an interrupted cycle so I pressed the "Cancel/Drain" button and the motor ran, no water. Once that was done, I tried to start a new cycle and every time I push start, the green clean light flashes and the "Start" button goes off. Any help. Really don't want a repair guy. Thanks in advance


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If the clean light flashes, pauses, and then repeats. When\015\012the dishwasher doesn't sense a water t ... Dishwashers

Repair manual Dishwasher has all lights flashing, won't operate. Shut off elec, at breaker, pressed start/cancel button, then pushed normal wash, it ran through a cycle, but then lights were flashing again. Any ideas?


... Electrolux EIDW6105GW 24 in. Built-in Dishwasher

Error code Hi My FDW60 IS FILLING AND THEN FLASHING TWO LIGHTS THE FAST 40' AND THE DELICATE 50' AND THEN EMPTIES BUT THE LIGHTS CONTINUE TO FLASH AND THE MACHINE REMAINS IDLE. IS THIS A FAULT CODE? MANY THANKS


Hi, did you ever manage to fit a new eliment and how hard was it??! Thanks in advance... Sure it has dies since too! ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

My Hotpoint Aquarius FDW60 dishwasher is not going through cycle - lights on though


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Hotpoint aquarius fdw60. ''fast'' and ''delicate'' lights flashing.


... HP Dishwashers

FDW60 dishwasher Hi My dishwasher is about 15 months old and the problem I have is that it seems to stay on pump and the Ecco45 light is flashing.  A repair company looked at the machine and said that the motor looked like it was leaking and water was getting in the bottom setting off the micro-switch.  He contacted Hotpoint who fitted a new motor today at a cost of £89.85.  Went to use dishwasher tonight and we still have the same problem.  The dishwasher started the washing programme for about


I've just (as of 10 minutes ago) had the same problem. I followed the advice given elsewhere in this forum and removed the bottom cover - water running out so needed a big towel to mop it up. I stood the machine upright and restarted it - no problem! ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Hotpoint FDW60 Dishwasher stops and fast and delicate light flash


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

AQUARIUS FDW60. THA FAST AND DELICATE LIGHTS KEEP FLASHING.


I had the same problem with my Hotpoint FDW60 and read all the online reviews about how baddly made the FDW60 is and after taking it apart I totally agree.\015\012\015\012As the warning lights were indicating a faulty heating element I ch ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

I have a Hotpoint Aquarius FDW 20 dishwasher. Prewash and Wash lights were flashing, machine had stopped and water was at the bottom of the machine. What does this indicate? After removing some debris from the water drainage pump, then reassembling the machine, I now get the pre-wash LED flashing and a motor operating, but no futher progress into the wash cycle. What does this mean?


Dishwasher always full of water at the end of cycle ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

I have a Hotpoint LFT04 dishwasher which has now developed a fault. It runs and then stops mid cycle with flashing 2 and 4 lights as well as the power on/off button. Could anyone assist with the diagnosis as the manual does not help for this combination. From reading other similar models looks like heater or wiring fault?


... Hotpoint Dishwashers

Hotpoint fdw60 dishwasher. Eco light (3rd light) flashing. tried the to tip on side to empty excess water. However, same thing happens on ecah cycle. Any advise


When the eco light comes on , that means that an incorrect water level had been detected.This may be occasional event, or caused by a fault, like probably in your case.Try first resetting and troubleshooting the machine. ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Hotpoint Aquarius FDW60 Machine stops halfway through its cycle & the "fast" & "delicate" cycle LED's are flashing - what is my problem?


This sounds like the heater is not energising usually means the heater has failedalthough a blocked or sticking pressure switch will cause the same problem ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Hi, I have a whirlpool ADG 7340 dishwasher and it's failing to run a full cycle (it just starts beeping constantly about half way through). The light is flashing 4 times so I guess that means it's fault number 4 but I have no idea what fault 4 means & how it would need to be fixed.


... Whirlpool Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2212 seconds