Having problems with your Hotpoint 24 in. FDW60 Free-standing Dishwasher ?

C-467/06 This is my problem its the inlet water and appears to be control valce? can you help' Water leaking on my hardwood floors.


Answers :

If the unit is overfilling make sure the float moves up and down freely if the valve try to tighten the connector where the hose/copper pipe hooks up to the valve
Repair Help & Product Troubleshooting for Hotpoint 24 in. FDW60 Free-standing Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

C-467/06 This is my problem its the inlet water and appears to be control valce? can you help' Water leaking on my hardwood floors.


If the unit is overfilling make sure the float moves up and down freely if the valve try to tighten the connector where the hose/copper pipe hooks up to the valve ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

My 1998 GE dishwasher leaks. Into the floor, now I see stains on the ceiling below. What to check? Door seal is fine. The dishes get washed. Pressure is good to go. No water out of the front of machine, seems to be coming from below. Take panel off and inspect connections? How about line from sink? Is there a site with illustrations or video repair about this specific problem out there? Any help is greatly appreciated...


Check the water connection at the valve to the dishwasher. If the dishwasher only leaks when used then the motor seal is damaged. If leak is constant the the leak is at the supply to the dishwasher from the water supply at the valve\015\012 ... Dishwashers

The nut that attaches to the heating element keeps cracking in half allowing water to leak on the floor. Does anyone know what might cause this problem. Thank you in Advance for your Help.


That usually happens when the material the "Nut" is made from is iron, steel, usually it should be brass or some other non ferrous metal, the constant heat/cool cycle fractures a ferrous one, try to get a brass or even maybe a copper "Nut". ... Frigidaire 24 in. FDB1050RE Built-in Dishwasher

We recently bought a house with a Kenmore 363.16222100 (?) dishwasher. No manual. Monday night it didn't drain properly and leaked some water on the kitchen floor. The cycle had finished when we saw the water on the floor. We bailed out the excess water. I took off the drain cover and insert. I couldn't see an obvious clog problem, but cleaned it out. Then I tried a short cycle, interrupting it to shorten it. No problem. Water seemed to drain fine. I did find a part that looked like a straw and


HelloWelcome to FixyaMy name is Huum,You can find your model dishwashers manual here at this site. this sitehttp://www.managemyhome.com/mmh/lis_pdf/OWNM/L0801624.pdfI feel you should not invest blindly in someone ... Dishwashers

I have a Whirlpool Gold GU3600XTSY0 Model. There is slow water leak from the right side bottom front of the dishwasher. It looks like the water is leaking from a sensor on the bottom. The sensor has a pin protruding that can push up and down...almost like an on/off switch. I am wondering if there is any way to fix this. Water is leaking on my hardwood floors.....


That is your overflow water switch, that tube goes up to the washer, that switch is defective..water from the machine will come thru that hole ... Dishwashers

Hello, I had a problem with my Bosch dishwasher not washing properly. I have fixed burnt out wires, replaced the water inlet valve, AND tested with a new control module. Nothing is helping. When I start the cycle, it completes the initial drain and water does flow into the unit for about a minute, maybe a minute and a half. I can hear the clicking of cycle changes but it is not washing. Eventually it will drain the inch or so of water in the bottom, but it never washes. Any help???


Hi,\015\012\015\012Welcome to Fixya.\015\012\015\012Can you hear the wash motor humming ? I`ve got a "pdf" I can send you regarding this if you want to contact me at ... Bosch SHU9925UC Built-in Dishwasher

Leaking dishwasher There is standing water in the dishwasher when it's not being used. Recently we had a garbage disposal installed and was wondering whether this may cause the water from the sink to settle in the dishwasher. Also, the water rises and leaks on the floor. We have to run a wash cycle to drain and dry out the dishwasher. What do you think the problem is?


It sound like while the assembly of the garbage disposal, you placed the end of the drain line pipe in a lower position than it was before.\015\012Good luck! ... Kenmore 15129 Built-in Dishwasher

Hi there, I owe A GE GSD5911D01SS Perfil Performance Quiet Power III dishwasher. The problem is that during cycle, it leaks water through the left corner, is like the water level is too high, the sensor light lit up, which doesn?t tell me much. This issue doesn?t happen all the time, yesterday was the second time and I have no idea of what it could be the problem. Can anyone help? Thank you.


... GE Dishwashers

I noticed water on the floor (right corner) and my concern is that I have hardwood floors. It is not a lot that I can see but my concern is that water is leaking underneath where I can't see. It is 8yrs old so do I get it repaired or replace? I paid $379 for it.


Are you sure the water is coming from underneath the dishwasher? From the symptoms you described, this sounds like it could be caused by a worn door seal. Over time, these seals compress to the point where they no longer seal correctly, or food part ... Maytag 24 in. MDB4100 Built-in Dishwasher

Leaking water from underneath the front door. Water seems to be leaking through the bottom plastic seal. and sprays against the inside bottom of the door then drips onto the floor. Help


Hi,Leaks under the door can stem from a variety of causes. If your\015\012dishwasher is very old, the tub itself may have become corroded and may\015\012have holes. Inspect your tub; if you see such damage, use an epoxy\015\012patch kit t ... Dishwashers

Disconnected dishwasher and moved out in order to tile the kitchen floor. Ten days later reconnected dishwasher. Turned on water supply to leak check -- no water is getting into the washer. - Ran hot water from sink side to see if that would help, no such luck - Disconnected water line and water is in the line up to the connection point at dishwasher. Looked inside valve of dishwasher for obstruction - no such luck - Disconnected both ends of water line and blew in line to check for obst


... Bosch Evolution 500 SHE45M05UC Stainless Steel Dishwasher

Bosch Classixx dishwasher: Initially no water feed and 'water check' light came on. Removed side panel, emptied water from base. Ran OK for a week or so. The problem then repeated so side panel removed, float switch operation checked (OK) drained water from sump below polystyrene float. Ran OK but contents came out dirty and cold - no heat. Side panels off again, water in base but no obvious leak when watched during cycle - still no heat. Help please.


Http://www.repairclinic.com/Dishwasher-Repair-Help\015\012\015\012\015\012\015\012 ... Dishwashers

Dishwasher is leaking in the front left (if looking at the machine). It isn't a lot, but appears to have been leaking for a while as there is a whole in the floor. It runs great, just has the leaking problem. It's a GE profile Triton Quiet Water III GE 24 in. GSD5360FSS Built-in Dishwasher


\012Hi,\012\012Here\012is a tip that I wrote about dishwashers and them leaking.Leaking\012Dishwasher ... GE 24 in. GSD5360FSS Built-in Dishwasher

We had a problem with our garbage disposal and it resulted with water leaking from our dishwasher. The disposal is fixed, I removed the excess water from the dishwasher. I tried to run the dishwasher empty to clean it. It runs but then the E-2 alert shows on the control panel meaning high water level. I read in the book that I may have to have a service person do some sort of a reset. Is this correct?


Contacted the company and they e-mailed instructions to fix problem ... Asko 24 in. 1895 Built-in Dishwasher

Water leaked all over the floor after completing drying cycle


... Kenmore 15121 Built-in Dishwasher

Dishwasher leaking. I was supplied a flat seal ring of about 100mm dia., 10mm wide & 1 mm thick for the machine when I bought the house. Water on the floor tells me something underneath is leaking for the first time. The machine is about 10 yr old and in very good order .This seal could be the problem so before I go getting service personel in I'd like to know if replacing this and the door seal are jobs a careful handyman can do ?


I would say you could do it with out a tech.More then likely you can find information on the web on how to do it step by step or hey use this site more then likely one of us has had the same problem. ... Dishwashers

Lower drawer F1 error code, I suspect possible seal leak. Very small amount of water on floor. Upper washer control panel cycles rapidly through all programs and back light is burned out. I suspect control board malfunction. Repair facility, or tack it myself?


Yes this means that the machine is detecting water under the bottom drawer. Pull the bottom drawer out and soak up the water with a towel and then the error will go away. This happens often because something gets put in the drawer that's too ta ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

My dishwasher is not cleaning dishes... The cycles work but the dishes do not get clean an sometimes are more dirty if that is possible. I have tried adding jet dry and extra cleaning liquid but get no results. also there are times that the bottom of the washer fills with water unexpectedly and will even leak on to the floor. It doesn't leak when the dishwasher is running... I just don't know what to do other than clean out the spray arms. Please help.


Hi,Check your heating element.. Dishwasher ... Kenmore 15899 Built-in Dishwasher

I have an ariston LSI 62 and the led number 2 its blinking. I already check the 3 solenoid and they are ok, check the water pump, main pump, and heating resitence and its ok. The big problem is that i buy a new control panel the Diwa-m125 and the problem is the same. Is any one that can help me. thanks.


... Ariston Technologies LL64WNA Built-in Dishwasher

New hoover HED 6612-80 dishwasher all indicator lights staying on, manual says due to overfilling with water which is confirmed by water leaking on to floor, how do i solve this problem


Hi, i have same problem with my hoover dishwasher same model as your own, did you ever find out how to fix the problem. your help would be really welcomed. thanks lesley ... Hoover Dishwashers

I have a Tappen whisper quiet dish washer model number 61-1160-10. My problem is that 2-3 hours after use the tub fills up with water and leaks all over floor. there is what looks like a "D" shaped vent or something on the left side of tub about 1/2 way down appears ther is a trickle of water comming out of this.


Ok here's what the problem could be. Under the dishwasher there is a water valve the is where the water line connects to the dishwasher, This may possibly be a blue valve. From the sound of your problem the valve is not quite shutting off possibly ... Dishwashers

My ariston lsv 66 dishwasher will not start washing cycle. It makes the pumping noise as it normally does at the start of the cycle and some water enters the bottom of the machine but then it stops. I have checked to make sure that there are no leaks so the problem is with the filling up of the machine. I live in a hard water area and haven't used anything to help reduce the limescale so expect this to be playing a part. I have tried all the washing cycles but the same thing happens. Any advic


HERE I AM I LIKE THIS JOBE\015\012 PLEASE CHECK THE WATER INLET FILTER I FEEL FROM YOUR DESCRIBE IS IT\015\012 YOU NEED TO CLEAN IT BY ASMALL BRUSH >\015\012 THANKS ... Dishwashers

I have a single draw Fisher and Paykel dishwasher. I stupidly put washing up liquid in the dishwasher which resulted in a F1 problem. Water started leaking under the draw and onto my floor. I turned the dishwasher off at the power point and have cleaned up the leak. Have I damaged my dish washer? How do I fix it?


Ok , F1 means your flood switch has activated, which is underneath the drawer. now they show the F1 fault because of 2 reasons.1st there is still water underneath drawer causing switch to activate. 2nd your activator board which has the flood switch ... Fisher and Paykel 23 in. DD-603 Built-in Dishwasher

I noticed water coming from underneath my dishwasher so I pulled it out from the wall and found that underneath the factory installed installation there was a screw missing that holds the top dishwasher rack. The hardwood floor and bottom of the cabinet is ruined. While finding this problem, I also found rust on the bottom of the rack. Who do I need to speak with about this problem?


Speak with who you purchased the dishwasher from. They will be able to point you in the direction to get a replacement and file a complaint. All of this is provided you bought the machine in the last year. ... Kenmore Dishwashers

Whirlpool adg7540 no water seems to be getting into the washer when I turn it on, but water comes out of somewhere at the bottom and leaks all over the floor. help!


Check your hoses and your main water supply coming into the machine if the nut is loose tighten it up ... Whirlpool 24 in. ADG7540 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1693 seconds