Having problems with your Hotpoint 24 in. FDW60 Free-standing Dishwasher ?

Hotpoint Aquarius dishwasher FDW60; not washing properly, washing cold; items wet and slightly slimy. Delicates light flashing when machine stops.


Answers :

Repair Help & Product Troubleshooting for Hotpoint 24 in. FDW60 Free-standing Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hotpoint Aquarius dishwasher FDW60; not washing properly, washing cold; items wet and slightly slimy. Delicates light flashing when machine stops.


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Whirlpool GU2300 Dishwasher. The machine stops for long periods during the cycle. All lights go out. If the machine is opened before the cycle finishes, it will not resume. If I try to restart, the normal wash light begins flashing. If I then try to cancel, the canel light and the normal wash light flash.


I have reviewed your problem with the Whirlpool GU2300 Dishwasher and have the fallowing suggestions for you.\015\012First, unplug the power to the unit and let it sit for a few minutes. This will clear all internal error messages ... Dishwashers

I have a Hotpoint Aquarius FDW 20 dishwasher. Prewash and Wash lights were flashing, machine had stopped and water was at the bottom of the machine. What does this indicate? After removing some debris from the water drainage pump, then reassembling the machine, I now get the pre-wash LED flashing and a motor operating, but no futher progress into the wash cycle. What does this mean?


Dishwasher always full of water at the end of cycle ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

The machine carries out the wash cyle (eco setting)Machine then stops with lights 2 and 4 flashing. Contents very hot with steam. Cycle not finished. Can stop flashing by switching off for a minute.


Sorry to hear that you are having problems with your Indesit Dishwasher.This is a "common" issue that is easily fixed. The lights 2 & 4 flashing means "Unable to reach temperature to dry". So, what happen here is your DW is trying t ... Dishwashers

Error lights. When I start a wash cycle machine fills begins to wash then empties, then two error lights flash which are fast and delicate can you explain why this happens and how I can resolve the problem thanks. Terry-ann


This is a Circuit Board that is bad (main control).Do not repair this because the problem returns,and returns. ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

My 1yo slimline hotpoint dishwasher LST216 has developed a fault when trying to run the 'normal wash': washing stops after a couple of mins, the lights start flashing and the alarm comes on as soon as the water is being drawn into the machine. When I open the door I can hear a whirling/grating motor noise coming from the bottom of the machine. I have cleaned all filters and have run other programmes to check overall functionality and they all work as expected most of the time. I cannot unders


... Hotpoint Dishwashers

My Frigidaire model GLD2155RDC1, installed in 2007, stopped working after we lost power. When we flipped the circut breaker back on the lights for Air Dry and High Temp Wash started blinking, but none of the other buttons work and when we open the door these lights stop flashing and there is no power for our machine. We tried tripping the breaker a few more times and it kept doing the same thing.


... Frigidaire Dishwashers

Ignis ADL347 integrated dishwasher runs for a few seconds then stops, beeps and light flashes 6 times. I'm told this is due to water not getting into the dishwasher. it was working perfectly until we had a washing machine installed, can't see any pipes that are twisted or crushed but also don't have great access to the back of the washing machine or dishwasher. I have no expertise whatsoever. What should I be checking/trying? Any advice appreciated.


... Dishwashers

New dishwasher (Beko 2542F slimline model). Put it on for 1st time last night -when I got up this morning, the cycle which should have taken just over 2 hours hadn't finished. There's soapy water in the bottom of the machine which hasn't drained and the "wash" light is still on. Looks like the dishes are clean but hasn't moved onto the rinse/dry part. Followed instruction in manual to drain it (hold start stop button till lights flash and should drain in 45 sec) but nothing happened.


... Beko Dishwashers

I have a 4yr old Smeg freestanding dishwasher. Model is DF612SDX. The problem is that a wash cycle will start but about 15 mins in it stops and 2 of the programme option lights (on the left hand side of the programme options), start flashing. If you open the machine the soap dispenser has failed to open. This problem has been a bit of a slow deterioration as we've had a number of washed that have managed to finish and then noticed that although the dispenser has opened it must have been to


... Smeg 24 in. DWF612SS Free-standing Dishwasher

Recently replaced the control board for Electrolux EIDW6105GW1; after nearly a month of working w/o any problems this evening the machine made it through the wash cycle and then stopped working (all lights on wash cycle door menu are flashing). Took kick plate off bottom to check control board and the leak dectector is lit. I can see no leaks in front and am reluctant to do anything else with this POS. I spent nearly $1000 on this 18 months ago and have already sunk over $300 into a new contr


... Electrolux EIDW6105GW 24 in. Built-in Dishwasher

My indesit DIF 04 dishwasher has stopped working the start button, soak button and eco wash buttons are flashing continously, the machine will not turn off I have plugged it out from the socket but once plugged back in the same lights start flashing again


... Dishwashers

Hello, I have a Hotpoint aquarius dishwaher model no. FDW20 when the machine starts its cycle it stops after about a minute and the dryer light flashes along with the wash light, cann you help me. Peter.


Sounds like control switch is faulty. Check wires at motor first for corrosion or arcing. ... Dishwashers

Nordmende dish washer model no. DWSN60WH . when power button is switched on machine gives a buzzing noise for about 10 seconds while the start button is still lighting. Noise stops and light goes off and then wash and end buttons start flashing continuely.


... Dishwashers

ETNA ENF 18500A/5 type: 3.E1.181213221110 36 VLENNL 5 Dishwasher lights are on, and set for running, but the dishwasher does not do anything. Sometimes it makes a slight hum when closing the door, but most of the time, nothing. It stopped running after standard dish washing liquid was put into the machine by mistake. At that time, the machine started and ran through part of the cycle, but did not complete, and did not drain the water. Since then it has not started again. I have remo


... Dishwashers

KitchenAid KUDL03IVWHO Machine seems to stop after the initial water fill. There is power to the machine, the door latch circuity is working, all the buttons on the control pad light up. After selecting any of the wash cycles and pressing start, the washing light illuminates and the machine fills normally to the point where the fill valve stops the inflow of water. At this point the machine stalls, it does not start the cleaning process. I can press cancel and the machine drains normally. I e


Hi,\015\012\015\012You have got to the correct resolution. This is a circuit or most commonly called the board problem. Please find the bellow mentioned link which will help you to get one compatible for your washer.\015\012\0 ... Dishwashers

Samsung DMT400RHS delicate light flashing -- machine stops running.


... Samsung DMT400RHS

I have a Kenmore Elite Dishwasher Model 665.172824000. We think it stopped part way throught the dry cycle. The green "Clean" light has been flashing since in 7 flash cycles non stop. I tried pushing the Cancel button, it starts the drain pump then stops and we are back to where we started. I tried to start a new wash cycle but when I close the door and push the start button it just give 3 quick red flashes and then nothing but the green clean light flashing again. I shut the breaker off fo


So sorry but the partsdirect site for sears locked down my computer. Check where the drain hose connects to your pump and see if there is a small device the hose connects to that has 2 wires going to it. If it does unplug the wires, turn power off, w ... Dishwashers

Zanussi dishwasher, z t i 6865, 6 years old. when put on, normal beep and noise begins;machine pumps away water, stops too early, never finishes a chosen program ( so no end-beep is heard) and the first 2 lights are on, the first programlight(cold wash) flashes. i have checked main-watersupply, cleansed with soda.Nothing helps sofar, please give instructions soon. ellen.


... Zanussi 24 in. DE6544 Built-in Dishwasher

I have a Miele G1140 SCI Dishwasher. When I start it after a couple of minutes the Wash,Drying End Light starts flashing and the machine stops . Please could you advise me if there is anything I can do before calling someone to come and have a look at it.


... Dishwashers

Ignis adl347 dishwasher stops midway through cycle and light flashes 6 times. I'm told this is water not getting into the dishwasher. Can't see anything that would prevent it and it was working until we had our washing machine installed. It's integrated so difficult to access the back. Any ideas welcome. No expertise in this whatsoever. Thanks C


... Dishwashers

I have a haier hdw300 and when I turn it on after a very short time the intensive and normal wash cycle light indicators start flashing and the machine stops. Does anyone have a solution?


... Dishwashers

I have a Triton dishwasher. Last cycle, it completed washing then started drying and started beeping and the drying light is flashing. When I finally opened the latch, the beeping stopped, but the drying light is still flashing. The dishes were clean and warm - they air dried the rest of the way. I have not been able to get the drying light to go off. I have turned the breaker off over night, and flipped back on. The dishwasher goes back to flashing washing, and then clicks to drying and th


Hi,\015\012Make sure the salt level is ok - add 1Kg of salt if you have not done it in a while, and check rinse-aid level if apliccable.\015\012\015\012If this does nothing, then remove the lower kick panel for access to a data shee ... GE Dishwashers

I have model GU3600XTSY2. Sometimes the pots and pans light flashes for no reason. Sometimes I can push that button and it stops. However, the cycle I select to wash the dishes is constantly interupted by the pots and pans (P&P) light flashing. If I push the P&P button, the wash cycle usually starts where it left off. Sometimes it will go back to the beginning of the cycle and begin all over again and get caught in a loop; start washer, P&P flashes, push P&P, begins cycle from beginning, P&


... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

I have a zanussi tempoline dishwasher, I have loaded this as I usually do, turn the knob to the right and select the 2nd programme the light next to this comes on, I have pressed this to start the machine although it seems as if it is going to start this light flashes and the top arrow on the right of this flashes intermitanly, but the machine does not start the wash programme. The 3hr delay button if I had pressed this by mistake which I am sure I have not would light up. When I found it did no


Hi Ruth.The machine can be in error mode. In this case one or more lights in the control pad will stay on or flash and the cycle will not start.One of the most common fault in your situation, and at start of the cycle is no wa ... Zanussi Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1891 seconds