Having problems with your Hotpoint 24 in. HDA100X Built-in Dishwasher ?

After the cycle is completed the bowl fills up with water. It seems to be coming out of a hole on the side of the dishwasher. What is the problem?


Answers :

Replace your fill valve,
Repair Help & Product Troubleshooting for Hotpoint 24 in. HDA100X Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

After the cycle is completed the bowl fills up with water. It seems to be coming out of a hole on the side of the dishwasher. What is the problem?


Replace your fill valve, ... Hotpoint 24 in. HDA100X Built-in Dishwasher

Have SHU43C and have had no problems with it. We usually run it on the Quick Wash cycle, but ran it on the Regular Wash cycle yesterday because the glasses seemed to be coming out spotty. After it ran, there were no lights on the display like there usually are. The washer had run and the dishes were clean, but it has not drained completely. There is still about an inch of water in the bottom, despite removing and checking both the Large Object Trap and Fine Filter (neither which were clogged


The drain pump needs to be replaced or cleared of obstruction. ... Bosch 24 in. SHU43 Built-in Dishwasher

I have a bosch millennium series SHU9905UC. There is still water at the bottom of the dishwasher from the last time it was run. I think it may not have completed the cycle as a few bowls were still dirty. Now when I try to put the washer on and press a cycle, no light is coming on at all. It seems dead. Is there anything I can try before calling in service people?


... Dishwashers

Smeg DWF612WH dishwasher has developed a leak. Water comes out of the rectangular hole on the side of the water softner used to mount what looks like a level or pressure switch. A few seconds after the fill valve opens water leaks out, not a lot just a small trickle. After the washer has filled and goes ito its cycle, it does not leak again. Over the past weeks the problem has got progressively worse.


... Smeg 24 in. DWF612WH Free-standing Dishwasher

Dishwasher, nautilus, doesn't spray water out the top arm? I'm haivng to wash dishes 2 times, and still no better results. I've tried opening the door fast during a water cycle to see which is the problem - can only figure it is the upper arm, the lower arm seems to have water coming out, can't tell if the tower raises completely up.


The jets on the arms can sometimes get blocked with food bits that have got past the filter. This reduces the water flow and rotation of the arms.The arms are easy to remove without tools (they are intended to be removed by the user). ... GE Nautilus 24" Built-in Dishwasher

Whirlpool Quiet II (DU110XTPB1)... Two problems (maybe it's one)... Start/resume light flashing and won't stop. I have tried on the different button combinations from this website and other websites and none of them seem to make a difference. The flashing continues. That's problem number one. Problem number two is that it seems to go into some sort of washing cycle in completely random intervals. When it's in one of the random washing cycles the following lights are on; Normal Soak and scour


Hope it's under warranty, maybe logic board, poor motor design causes main PCB failure ... Dishwashers

I have a Maytag MDB8951bws and I have noticed that the dishes at the end of the cycle do not feel hot but mildly warm and not completely dry. I also noticed that when I select the ''Sanitize'' option the light that tells you the dishes have completed being sanitized does not come on after the cycles are completely finished (the ''clean'' light does come on). One last note I will throw in is that the high temp wash seems to work quite well as a lot of steam is expelled when the door is opened dur


... Maytag MDB8951BW Dishwasher

I have a kitchenaid dishwasher model kuds24se with a problem. I MUST hit cancel before I hit start. Note that it doesn't matter how long it's been since the last cycle. It could be a few minutes or a day or more. I have to hit start to get a complete wash cycle. If I don't hit cancel, the washer goes through some sort of cycle and stops. It seems like a normal cycle but of course it is not because I don't hear any water and, upon completion, when I open the door there is heat but the soap dispen


... KitchenAid KUDS24SE Built-in Dishwasher

Humming noise i have a GE nautilus GSD2200 model which has not been used more than 4 years that is giving me trouble.  it's making a loud humming noise (the noise comes and goes, comes and goes) which seems to be coming from the motor area at the bottom of the unit.  I stopped it in the middle of the cycle, but the water seems to be stagnant at the bottom.  any suggestion on fixing the problem myself?


I have seen this SOOOOO many times in my 35+ years in the appliance repair industry.......it is very typical....here you are this is an answer I provided someone with the exact problem not to long ago..............This is a t ... GE Nautilus 24" Built-in Dishwasher

I have a bosch smu 2000 series dishwasher. it has always worked well with no problems but then all of a sudden a week or so ago, the water stopped coming into the dishwasher to wash the dishes. the faucet and all other water areas continue to work w/o problems (i.e. bathroom, shower etc). in attempting to use the dishwasher, the entire cycle seems to be working, i initially hear what sounds like an initial water discharge when the cycle first starts and during the entire cycle it sounds like it


... Bosch Dishwashers

I have the above dishwasher shv57c03uc just less than 5 years old. The door latch does not engage solidly. when i pust start button left side lights on indicator right does not come on and i have to push on button twice for washer to come on. When it does come on the cycle is real short and it does not complete a full cycle. I an asuming the circuit board is defective!! does this sound right? if so how can i replace the board?where can i get troubleshoooting instructions?


Hi\015\012\015\012You are right it is the ... Bosch 24 in. SHV57C03UC Built-in Dishwasher

My wife opened door during cycle. When she closed door it would no longer run. Looking at problems and recomendations on similar models, I replaced the board. Did not fix the problem. I have checked the fuse and the door switches for continuity and all seem ok. The only lights on the panel that come on are: under cycle- Pots & Pans, Light. Under Options - Heated dry. No other lights work and the dishwasher does not operate.


Hi,\015\012\015\012First off, sorry to hear that you replaced the control board for nothing..in hindsight. So if I understand what you're saying is this, You cannot select any cycles and the unit won't start...because the start button is ... Dishwashers

HI There, thanks for being willing to take my question. We have a 1 year-old White Avanti Dishwasher Model Model DW18/DW19PSS/DW181SS PROBLEM: detergent dispenser often does not fully open, leaving soap in the dispenser even thru the rinse cycle... it seems to get hung up on the upper rack. i can even hear the dispenser door pop open when i open the dishwasher after the cycle is complete, making me wonder if there is enough clearance for the dispenser door to flip completely open. THINGS I'V


... Avanti DW18 Built-in Dishwasher

Incomplete cycle My Miele dishwasher (3 to 4 years old) finishes, leaving the dishes dirty and wet. It seems that it may only be running through part of the cycle - I'm not sure but from the time I set it going to the time it switches off, it seems shorter than usual. The dishwasher is not emptying as it has a pool of water in the bottom. I have tried various settings and have the same problem. the inlet/drain light DOES NOT come on. I have soaked up all the residue on the bottom and cleaned out


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Miele 24 in. Incognito G843SCVi Built-In Dishwasher

I have a Kenmore model 665. It is having an intermittent problem. It goes through the fill cycle, and then stops. Timer does not progress either. Then, at some random moment, it will come back on and finish the entire cycle. This could even be a day or two later. Sometimes it seems a nearby thump will set it off, other times no one is anywhere near it when it comes back on. This happened for a month or so off and on 6 months ago, and then it worked fine for 6 months. Now it's back to it.


Its possible its a door switch thats causing this or the main wire is loose..be careful as you do have 115 volts. i'd turn off power and check where power comes into d/.w and make sure the wire nuts are tight.. the next step is a little more difficul ... Dishwashers

My dishwasher doesn't seem to fill with water. The heat cycle keeps running and never shuts off. I have discovered that there was some hard water buildup in the drain. I cleaned that out and I still have the same problem. It almost seems like it is not completing a cycle and it won't reset.


Sounds like a bad temperature sensor/thermistor or timer. ... Viking 24 in. Professional Series VUD141 (Ultra-Premium) Built-in Dishwasher

Leaking dishwasher i have an 8yr old hoover dishwasher & it leaks on the rinse cycle. It's coming from underneath on the left hand side as you look at it. I've checked the hoses & clips on hoses, which seem ok. It only leaks as the water is coming into the machine on the rinse cyle. Never any other time, not even when it's filling for the wash cycle!


If your dishwasher leaks, check these:Main tub sealDoor gasket or sealWater-inlet valveHosesMain tub sealNote… If the main motor of your dishwasher is mounted vertically, beneath the center bottom of the dis ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Cycles improperly My dishwasher does not cycle properly. It races through the cycles, even when set to pots & pans, in about ten minutes. At first I thought it not filling properly, checked the fill switch, it's fine and water does come in. Then when it's finished it does not always drain completely. I have checked everything on the drain end as well. It seems to have a mind of it's own. I replaced the $145 computer control with no luck. It actually sped up from the original 16 minute ful


Hi there,\015\012\015\012please let me know the make and full model # off your d/w.\015\012\015\012thanks ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Hi, I have a Miele G638 Plus dishwasher and the Red Inlet/Drain light comes on shortly after the wash cycle starts. I have cleaned everything out and the impellor moves freely. I have also made sure the outlet is clear. I have tried resetting and repeating on different washing cycles but it always locks out after the washing cycle starts. Could this be a heater problem as the element looks quite corroded? I have had side panels off and the water appears to flow easily through the sid


Hi\015\012\015\012Thanks for using FixYa. The first\015\012thing that should be checked is if its draining properly as it could be that\015\012the drain hose is clogged an ... Miele 24 in. G638 Plus Free-standing Dishwasher

We have the G841SC+ Miele dishwasher. The intake/drain light blinks and the cycle stops on economy and sani wash before the end light comes on. The normal cycle seems to be able to complete a full cycle. Is there anything we can check.


... Miele Dishwashers

Asko diswasher D3122 - white, built in. For the past 6 months, the dishes are coming out white. I have had the dishwasher for a number of years and never a problem. I had changed to Cascade Complete so I thought that was it, so I switched back to the regular type of Cascade and still have the problem. I tried adding vinegar to the wash cycle and this helped initially but no longer works. I should not have to add vinegar to every load if it worked fine before. A new problem is that in the la


Hi,There have been alot of complaints recently about this...it seems as though the detergent companies have reduce the amount of phosphates in the detergent and that has caused the dishwasher to build up minerals in the dishwasher... then the w ... Asko Dishwashers

2 weeks ago, I had a plumber come and put in a new garbage diposer and since then somewhat old/dirty water seems to be sitting at the bottom after all cycles are done. I calle dhim back and he says that there is no problem in the plumbing but more with the pump. I even use the wt/dry vac and removed water and ran it but still comes back with water at the bottom. also the dishes smell like soap. Help!!!


The plumber did not make an air gap in the dishwasher drain hose when he reattached it to the new disposal. Look under your sink, does the hose (attached to the disposal) go down and through the cabinet? If so, that is definitely the issue. Simple ... GE 24 in. Profile PDW7800 Built-in Dishwasher

Leaking dishwasher The dishwasher leaks a stream of water at the base -bottom left corner whenever it goes into the final rinse cycle. It does not leak when it is in the wash mode. This leak just seemed to develop suddenly. There was no build up -ie a small stream of water. I just noticed a big puddle on the floor one day after dishwasher had completed its cycle water leak in the left side ,bottom ,husband states a small drip,drip and we do not know what to do or replace. No water standing


I just had this same problem and it was caused by a small plastic seal on the bottom of the door. My friend owns an appliance store and he said this is a common problem for this model of dishwasher. The part was $68 and the labor was $60. I could ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Tricity Bendix DH090 water valve closes too early. Insufficient water causes program to stop before first heating cycle. If I switch off, open the machine & pour an extra pint of water in, shut the door & switch on again the wash takes place and completes perfectly to specification. OK so the problem seems to be that level detector No 1 switches off the water inlet valve early and level detector No 2 (apparently) halts the cycle since it detects insufficient water in the machine. I cannot see t


... Tricity Bendix 18 in. DH090 Free-standing Dishwasher

Maytag mdbh955aw during drying cycle steam comes from right side not only the left side where the vent holes are


Is vent cloged if not you got something loose ... Maytag 24 in. MDBH955AW Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1933 seconds