Having problems with your Hotpoint 24 in. HDA2000Z Built-in Dishwasher ?

Does not drain. Water stays in the bottom.

\015 Have a 1980's Hotpoint dishwasher that has stopped draining. What is the problem?\015\012\015\012Allen Simons\015\[email protected]\015

Answers :

If there is an air gap (located in the sink, near the faucet), check to\015\012see if it is clogged. Unscrew the top cap and see if there is anything\015\012blocking inside. Note: If there is no air gap installed, the dishwasher\015\012might not drain properly.
\015\012\011\011\011
If the drain hose is clogged,\015\012the dishwasher would not drain. If there is an air gap installed, it is\015\012very common that a hose going from the air gap into the garbage\015\012disposer is clogged. Remove and clean the hose. Make sure to reattach\015\012the hose before starting the dishwasher.
\015\012\011\011\011
\015\012\011\011\011Note: If you recently had a garbage disposer installed, it is common to overlook removing the drain plug.

Some models have two impellers inside the pump - one, wash impeller,\015\012takes care of the wash cycles, the other, drain impeller, drains the\015\012water out. If the drain impeller is broken (broken blades, shaft), the\015\012dishwasher would not drain. Replace any broken pump components.
Repair Help & Product Troubleshooting for Hotpoint 24 in. HDA2000Z Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a DU8000XX6 series Kenmore dishwasher that won't drain the water properly. There is about a half inch of water in the tub and the float is raised (not sitting on tub bottom). When I lift up the float a little more I can hear the float switch make. I would assume that when the water is high enough the float switch makes and energizes a solenoid valve in the drain to drain the water, but shouldn't it stay open until all the water drains? Lifting the float while the dishwasher is off wo


... Kenmore 24 in. 15142 Built-in Dishwasher

I have a Kitchen Aid KUDS03CTSS3 dishwasher. Dirty water is staying at the bottom and nothing comes out the drain hose during the entire cycle. The drain hose is looped above the kitchen P-trap, although for a time it wasn't. I use a wet vac to get the water out but there is still water below the fine filter. I thought if I could get the fine filter off, I could clean out the bottom as I think that it's full of crud down there that may be blocking things. I can't figure out how to get the l


Hi,Thanks for the follow up. I am glad it worked out for you. If I can Help in the future let me know. http://www.fixya.com/support/c64627-kitchen_aid ... KitchenAid 24 in. KUDP02FR Built-in Dishwasher

My Bosch dishwasher SGS46E26GB/90 makes a knocking noise when started. the timer does not advance and the check water light comes on.There is water in the bottom (up to the bottom of the door) . If I reset the DW the water drains ok. If I mess with the buttons E3 shows on the display the 'quick' light stays on and the eco light flashes. I've checked the filter where the water hose is fastens to the rear. I've cleaned the filters at the bottom of the DW and cleaned out the pump area under them.


... Dishwashers

When dishwasher drains the water not all the water is drained. Some stays standing at the bottom and starts getting an odor after awhile. This is a replacement dishwasher in a 35 year old house. How important is the air release part in the draining situation? I was told by someone that the newer dishwashers have the air release part which was not hooked up on this dishwasher when installed last year. Are there some other possibilities of things that can be checked. Model Number is DU


... Whirlpool DU1055XTS Built-in Dishwasher

Bosch Model SHV46C03UC/14 Dishwasher won?t drain completely. The drain hose is not kinked or obstructed and it drains into the garbage disposal. If I push the combination of two buttons on the panel, I can pump out residual water, but if I don?t, it stays there. It will become foul smelling within a day if I do not manually remove the water. Bosch technical support won?t talk to me unless I am a service technician, but I can handle this as I do all my appliances. The screens at the bottom o


THE DISHWASHER DO NOIT DRY THE DISH ... Bosch Dishwashers

After the initial drain cycle when the first rinse cycle starts the water flows up out of the air vent hole at the top of the water manifold and fills the overflow tray in the bottom of the machine causing engaging the micro switch starting the drain pump which then stays on continually.


... Bosch SHE4AM02UC 24 in. Built-in Dishwasher

My built in Whirlpool adg 9340 washer won't start a cycle at all. It seems to start a cycle and after 1 minute it stops and it starts beeping. Also water remains on the bottom. As soon as the cycle starts it drains that water and brings new water in which stays there. It won't work for more than 1 minute....


... Dishwashers

I had a problem with my dishwasher popping the breaker. I opened the bottom and found burnt up wires. I fixed those and now the dishwasher stays on and begins its cycle (by draining) but the water is not flowing to the machine. It has supply, and I just now replaced the water inlet valve- no difference. The water was working before the breaker issue. I'm wondering if it is now something as simple as a clog somewhere since the washer sat unused for a month; or, if it is something more compli


I read your previous problem. This appears to be separate problems. The first was likely a loose wire. When a wire has a loose connection they build heat and can melt. The current issue would seem like the float switch is stuck. The float switch is ... Bosch SHU9925UC Built-in Dishwasher

Won't drain dishwasher goes through all cycles like normal but when it's finished there is still water in bottom, tried to cancel cycle but water stays. I cleaned all the water out and try it again same thing happened. I cleaned the filter so i don't know what else to do!


Make sure the garbage disposal is clear so the water can exit. After that, you may have something caught in the drain hose or check valve. It would require removing the bottom kick plate to gain access to check. ... Kenmore 24 in. 15689 Built-in Dishwasher

Second new Samsung dishwasher. Water eill not completely drain out. Now is giving a blinking light error. Water stays in the very bottom of machine. We do have a water softener and garbage disposal hooked up. Is it possible that something is wrong with the hook-up?


... Samsung 24 in. DB3710D Dishwasher

I have a Kenmore Ultra wash 665.16522. The water won't drain completely. About 2 or 3 inches of water will stay at the bottom. I wonder if there is a food catcher, and if so, how do I clean it? JSBravo


Hi \015\012\015\012Dishwasher not draining issue usually occurs due to kinked drain pipe, clogged drain filter or drain pump. Check the drain hose for any visible clogging, remove if pres ... Kenmore 16522 Built-in Dishwasher

My Bosch Dishwasher das not drain water after washing is completed. The water level stays below door sealer. I did check it out filter on the bottom and everything simce ok but still dosn't work. Is there enything I can do before calling service??? Bogdan e-mail: [email protected]


Sorry to read about your problem, I hope this helps you out.you have done it allI tried to help you. Please help me and Rate/Vote on my response, thanks and good luck ... Bosch SHU9950 Dishwasher

After any dishwashing cycle, the water does not drain from the basin. This happens with both the top and bottom units. Even after a long time, the water stays there.


In the past I have found that fat has blocked the discharge hose. Push a curtain track (the stretchy ones) down the hose a little way to see if it is blocked, ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Kitchenaid dishwasher Fills with water, goes through all cycles but doesn't wash. Water stays in the bottom not draining.


Motor bad. If you are getting power to the motor then the motor is bad. ... KitchenAid 24 in. KUDS25 Built-in Dishwasher

My dishwasher does not drain the water out it stays in the bottom


I had this same problem on a different model LG. The manual will tell you to check the drain hose. Other "reviews" on the web will tell you that they have replace the main board, motor assembly, and other parts ($$$$). Check the hose first to make ... LG 24 in. LD-12BS6 Stainless Steel Free-standing Dishwasher

Does not drain. Water stays in the bottom.


If there is an air gap (located in the sink, near the faucet), check to\015\012see if it is clogged. Unscrew the top cap and see if there is anything\015\012blocking inside. Note: If there is no air gap installed, the dishwasher\015\012might not drai ... Hotpoint 24 in. HDA2000Z Built-in Dishwasher

GE GHDA485N 10CS Dishwasher that has standing water in the bottom after the cycle completes. I pulled it out and reconnected power and ran a rinse cycle. I could see that water was pumping out the clear drain pipe but there was still about an inch of standing water in the bottom. Any thoughts as to what part has failed. Does the system use a water level switch or a timed drain cycle to determine when the water has pumped out. If it is a timed cycle could a slow drain cause the problem. Thank you


... GE Dishwashers

My dishwasher does not drain after a cleaning cycle. the smelly water stays on the bottom of the washer.


Check the filters (triclean you have to remove the 2 screws on both upper and lower filters inside the machine). Remember how they came apart because you will have to reassemble them 8)\015\012 Check both ends of the flex tube from the dishwash ... GE Dishwashers

MY DISHWASHER WON'T DRAIN ALL THE WAY WATER STAYS IN THE BOTTOM


Hi\015\012\015\012\015\012If the water doesn't drain from your dishwasher, check these---\015\012\015\012Drain line/air gap -- Clog in the drain line or air gap (if there is one) is the usual reason that a dishwasher won ... Dishwashers

Model Sh6806UC/U12, cycle starts at 13 counts down to 1 and stays there, water does not completely drain from the bottom, but does not overflow out when the door is openwildblue.net


... Bosch 24 in. SHU6802UC / SHU6806UC Built-in Dishwasher

After a run, the water stays at the bottom and doesn't drained out. a sound is humming even when the run has finished


Could be your filter in base of dishwasher needs to be cleaned out.\015\012\015\012Remove it and make sure the hole where the filter came out of is cleaned out with cloth before putting the cleaned filter back in. ... Neff 24 in. S5409X0 Built-in Dishwasher

Water is staying in the bottom and not draining


Be sure the screen under the bottom spray arm is free of food particles. You may need to remove it to clean it. You will need to unscrew the cap, remove the arm and clips that hold the screen in place. Make sure the drain hoses are not kink ... Bosch 24 in. SHU6802UC / SHU6806UC Built-in Dishwasher

Dishwasher will not drain. water stays on the bottom of the unit/


Not knowing what make or model you have I can only give you general advice. As a Maintenance Supervisor for an Apartment complex, I run into this all of the time.You will need to start by cleaning out the filter basket. it is under the plastic grate ... Dishwashers

Does not drain, water stays in the bottom of the unit.


Hi,Here is a tip that I wrote that will help you with your dishwasher ... Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher

The water doesn't drain and stays on the bottom of the dishwasher. Have had this problem before.  Dishes are always rinsed prior to loading.  Don't know why it does this, after only two years after purchase.


Probably the dump valve solenoid. ... GE Profile PDW9880NSS Stainless Steel Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1291 seconds